2060 Chiron back to a minimum of brightness

The results of photometric observations of comet/asteroid 2060 Chiron at the Observatório do Pico dos Dias (Brazil-OPD) and the Observatoire de Haute-Provence (France-OHP) during 1994 and 1995 are presented. The analysis of the data shows a decrease of 2060 Chiron brightness from its peak values of 1988–1991. The absolute magnitude, H_v, varies from a maximum of 6.6 in February 1994 up to a minimum of 6.8 in June 1995. Therefore 2060 Chiron is back to a minimum of activity close to that of 1983–1985. The slope parameter G is found to be G = 0.71 ± 0.15. It is suggested that the H-G magnitude system, generally adopted to present 2060 Chiron brightness, is not the most appropriate due to the cometary activity of this object.     

X-ray imaging of three flares during the impulsive phase

The impulsive phases of three flares that occurred on April 10, May 21, and November 5, 1980 are discussed. Observations were obtained with the Hard X-ray Imaging Spectrometer (HXIS) and other instruments aboard SMM, and have been supplemented with Hα data and magnetograms. The flares show hard X-ray brightenings (16–30 keV) at widely separated locations that spatially coincide with bright Hα patches. The bulk of the soft X-ray emission (3.5–5.5 keV) originates from in between the hard X-ray brightenings. The latter are located at different sides of the neutral line and start to brighten simultaneously to within the time resolution of HXIS. Concluded is that:

1. The bright hard X-ray patches coincide with the footpoints of loops.
2. The hard X-ray emission from the footpoints is most likely thick target emission from fast electrons moving downward into the dense chromosphere.
3. The density of the loops along which the beam electrons propagate to the footpoints is restricted to a narrow range (10⁹ < n < 2 × 10¹⁰ cm^-3), determined by the instability threshold of the return current and the condition that the mean free path of the fast electrons should be larger than the length of the loop.
4. For the November 5 flare it seems likely that the acceleration source is located at the merging point of two loops near one of the footpoints.

It is found that the total flare energy is always larger than the total energy residing in the beam electrons. However, it is also estimated that at the time of the peak of the impulsive hard X-ray emission a large fraction (at least 20%) of the dissipated flare power has to go into electron acceleration. The explanation of such a high acceleration efficiency remains a major theoretical problem.     

Spatial and temporal evolution of soft and hard X-ray emission in a solar flare

We study the spatial and temporal characteristics of the 3.5 to 30.0 keV emission in a solar flare on April 10, 1980. The data were obtained by the Hard X-ray Imaging Spectrometer aboard the Solar Maximum Mission Satellite. It is complemented in our analysis with data from other instruments on the same spacecraft, in particular that of the Hard X-ray Burst Spectrometer.Key results of our investigation are: (a) Continuous energy release is needed to substain the increase of the emission through the rising phase of the flare, before and after the impulsive phase in hard X-rays. The energy release is characterized by the production of hot (5 × 10⁷ T 1.5 × 10⁸ K) thermal regions within the flare loop structures. (b) The observational parameters characterizing the impulsive burst show that it is most likely associated with non-thermal processes (particle acceleration). (c) The continuous energy release is associated with strong chromospheric evaporation, as evidenced in the spectral line behavior determined from the Bent Crystal Spectrometer data. Both processes seem to stop just before flare maximum, and the subsequent evolution is most likely governed by the radiative cooling of the flare plasma.     

Microstructural evolution of the Seridó Belt, NE-Brazil: the effect of two tectonic events on development of c-axis preferred orientation in quartz

The polyphase evolution of the Seridó Belt (NE-Brazil) includes D₁ crust formation at 2.3–2.1 Ga, D₂ thrust tectonics at 1.9 Ga and crustal reworking by D₃ strike-slip shear zones at 600 Ma. Microstructural investigations within mylonites associated with D₂ and D₃ events were used to constrain the tectono-thermal evolution of the belt. D₂ shear zones commenced at deeper crustal levels and high amphibolite facies conditions (600–650 °C) through grain boundary migration, subgrain rotation and operation of quartz c-prism slip. Continued shearing and exhumation of the terrain forced the re-equilibration of high-T fabrics and the switching of slip systems from c-prism to positive and negative a-rhombs. During D₃, enhancement of ductility by dissipation of heat that came from syn-D₃ granites developed wide belts of amphibolite facies mylonites. Continued shearing, uplift and cooling of the region induced D₃ shear zones to act in ductile-brittle regimes, marked by fracturing and development of thinner belts of greenschist facies mylonites. During this event, switching from a-prism to a-basal slip indicates a thermal path from 600 to 350 °C. Therefore, microstructures and quartz c-axis fabrics in polydeformed rocks from the Seridó Belt preserve the record of two major events, which includes contrasting deformation mechanisms and thermal paths.     

Low-order stabilized finite element for the full Biot formulation in soil mechanics at finite strain

This article presents a novel finite element formulation for the Biot equation using low-order elements. Additionally, an extra degree of freedom is introduced to treat the volumetric locking steaming from the effective response of the medium; its balance equation is also stabilized. The accuracy of the proposed formulation is demonstrated by means of numerical analyses.     

Throughfall patterns in sugarcane and riparian forest: understanding the effect of sugarcane age and land use conversion

Sugarcane is an annual crop with a dynamic canopy that changes over time mainly because of genetic adaptation. There is uncertainty about the temporal trends of throughfall (TF) in this important commercial crop. In the present paper, we used troughs to measure TF in a third and fourth ratoon and subsequently in a fourth and fifth ratoon. Additional measurements were carried out in an adjacent riparian forest. There were no significant differences between cycles of sugarcane, growth phases and riparian forest. The TF results for ratoon crop and riparian forest in 2011/2012 were 76% and 79.5% of gross rainfall, respectively, while in 2012/2013, they were 79% and 78%, respectively. However, TF was remarkably lower in the riparian forest relative to ratoon from the second half of the culm formation and elongation phase (280 days after harvest) until harvest. Copyright © 2016 John Wiley & Sons, Ltd.     

An open source GIS‐based Planning Support System: Application to the land use plan of La Troncal,Ecuador

Planning Support Systems (PSS) comprise a wide variety of geo‐technological tools related to GIS and spatial modeling aimed at addressing land planning processes. This article describes the OpenRules system, a PSS based on a previous system called RULES. Among OpenRules new features are its architecture, based exclusively on free and open source software, and its applicability to all land use types, including rural and urban uses. In addition, OpenRules incorporates an unlimited number of land evaluation factors and a new objective in land use spatial allocation. OpenRules has been programmed in Java and implemented as a module of the free GIS software gvSIG, with full integration between the GIS and the decision support tools. Decision support tools include multicriteria evaluation, multiobjective linear programming and heuristic techniques, which support three basic stages of land use planning processes, namely land suitability evaluation, land use area optimization and land use spatial allocation. The application of OpenRules to the region of La Troncal, Ecuador, demonstrates its capability to generate alternative and coherent solutions through a scientific and justified procedure at low cost in terms of time and resources.     

Assessment of the acid drainage neutralization capacity and the toxic metals lixiviation of tailing from Guanajuato mining district,Mexico

In Mexico, many environmental problems are generated by large mining activities taking place in several mining districts. These mining activities produce great quantities of residues; large majorities of these have high sulfur content, which could generate acid drainage due to their interaction with the oxygen in the environment. The study area was located in the Mining District of Guanajuato, Mexico with abandoned tailings generated mainly by the gold and silver production. Two areas, called as Monte de San Nicolás (SN) and Peregrina (P) were selected for this study. The results study shows that there was no risk of production of acid drainage, since these tailings contained high amount of carbonates, which neutralized the generation of acidity and consequently decreased the possibility of leaching of some elements. However, not all elements leach in acid pH, as arsenic bound to oxyhydroxides, which is in a basic environment and its increased release by increasing the pH.     

Metal-enriched nanoparticles and black carbon: A perspective from the Brazil railway system air pollution

Having a better understanding of air pollutants in railway systems is crucial to ensure a clean public transport. This study measured, for the first time in Brazil, nanoparticles (NPs) and black carbon (BC) on two ground-level platforms and inside trains of the Metropolitan Area of Porto Alegre (MAPA). An intense sampling campaign during thirteen consecutive months was carried out and the chemical composition of NPs was examined by advanced microscopy techniques. The results showed that highest concentrations of the pollutants occur in colder seasons and influenced by variables such as frequency of the trains and passenger densities. Also, internal and external sources of pollution at the stations were identified. The predominance of NPs enriched with metals that increase oxidative stress like Cd, Fe, Pb, Cr, Zn, Ni, V, Hg, Sn, and Ba both on the platforms and inside trains, including Fe-minerals as hematite and magnetite, represents a critical risk to the health of passengers and employees of the system. This interdisciplinary and multi-analytical study aims to provide an improved understanding of reported adverse health effects induced by railway system aerosols.