Scattered ground‐roll attenuation using model‐driven interferometry

Scattered ground roll is a type of noise observed in land seismic data that can be particularly difficult to suppress. Typically, this type of noise cannot be removed using conventional velocity‐based filters. In this paper, we discuss a model‐driven form of seismic interferometry that allows suppression of scattered ground‐roll noise in land seismic data. The conventional cross‐correlate and stack interferometry approach results in scattered noise estimates between two receiver locations (i.e. as if one of the receivers had been replaced by a source). For noise suppression, this requires that each source we wish to attenuate the noise from is co‐located with a receiver. The model‐driven form differs, as the use of a simple model in place of one of the inputs for interferometry allows the scattered noise estimate to be made between a source and a receiver. This allows the method to be more flexible, as co‐location of sources and receivers is not required, and the method can be applied to data sets with a variety of different acquisition geometries. A simple plane‐wave model is used, allowing the method to remain relatively data driven, with weighting factors for the plane waves determined using a least‐squares solution. Using a number of both synthetic and real two‐dimensional (2D) and three‐dimensional (3D) land seismic data sets, we show that this model‐driven approach provides effective results, allowing suppression of scattered ground‐roll noise without having an adverse effect on the underlying signal.     

GGR Biennial Review: Atomic Absorption,Inductively Coupled Plasma-Atomic Emission Spectrometry,Neutron Activation Analysis and X-Ray Fluorescence Spectrometry Review for 2008–2009

This review describes developments major and in trace element determination using atomic absorption spectroscopy (AAS), inductively coupled plasma-atomic emission spectrometry (ICP-AES), instrumental neutron activation analysis (INAA), and X-ray fluorescence (XRF) spectrometry that were reported in 2008 and 2009. Publication levels were comparable to those of previous years, except for XRF which showed an increase in the number of articles published in the past 2 years. In terms of number of publications and impact, the most active field was AAS, while INAA was the least active. As expected for well-established and mature methods, novel developments for all four analytical techniques were relatively sparse. For AAS, the most notable publications concerned developments in sample introduction, particularly focussing on solid samples, increasing analyte sensitivity, and higher sample throughput. For ICP-AES, publication of developments in sample introduction, remediation of matrix effects and calibration continues. Compared with past years, there was a clear focus on sample preconcentration methods, but very few publications reporting new hyphenated speciation methods. For INAA, there were several publications exploring the accuracy and robustness of the method, as well as the requirements for INAA to meet criteria for a primary method of measurement. Two other related techniques, delayed neutron activation analysis, and prompt gamma activation analysis, were also described. Hyphenated XRF techniques showed interesting developments in enabling XRF and XRD analysis on the same spot, and further work characterising and calibrating three-dimensional micro-XRF shows promising results for investigating sample heterogeneity.     

Hypervelocity impacts into ice‐topped layered targets: Investigating the effects of ice crust thickness and subsurface density on crater morphology

Many bodies in the outer solar system are theorized to have an ice shell with a different subsurface material below, be it chondritic, regolith, or a subsurface ocean. This layering can have a significant influence on the morphology of impact craters. Accordingly, we have undertaken laboratory hypervelocity impact experiments on a range of multilayered targets, with interiors of water, sand, and basalt. Impact experiments were undertaken using impact speeds in the range of 0.8–5.3 km s^?1, a 1.5 mm Al ball bearing projectile, and an impact incidence of 45°. The surface ice crust had a thickness between 5 and 50 mm, i.e., some 3–30 times the projectile diameter. The thickness of the ice crust as well as the nature of the subsurface layer (liquid, well consolidated, etc.) have a marked effect on the morphology of the resulting impact crater, with thicker ice producing a larger crater diameter (at a given impact velocity), and the crater diameter scaling with impact speed to the power 0.72 for semi‐infinite ice, but with 0.37 for thin ice. The density of the subsurface material changes the structure of the crater, with flat crater floors if there is a dense, well‐consolidated subsurface layer (basalt) or steep, narrow craters if there is a less cohesive subsurface (sand). The associated faulting in the ice surface is also dependent on ice thickness and the substrate material. We find that the ice layer (in impacts at 5 km s^?1) is effectively semi‐infinite if its thickness is more than 15.5 times the projectile diameter. Below this, the crater diameter is reduced by 4% for each reduction in ice layer thickness equal to the impactor diameter. Crater depth is also affected. In the ice thickness region, 7–15.5 times the projectile diameter, the crater shape in the ice is modified even when the subsurface layer is not penetrated. For ice thicknesses, <7 times the projectile diameter, the ice layer is breached, but the nature of the resulting crater depends heavily on the subsurface material. If the subsurface is noncohesive (loose) material, a crater forms in it. If it is dense, well‐consolidated basalt, no crater forms in the exposed subsurface layer.     

GGR Biennial Critical Review: Analytical Developments Since 2014

This GGR biennial critical review covers developments and innovations in key analytical methods published since January 2014, relevant to the chemical, isotopic and crystallographic characterisation of geological and environmental materials. In nine selected analytical fields, publications considered to be of wide significance are summarised, background information is provided and their importance evaluated. In addition to instrumental technologies, this review also presents a summary of new developments in the preparation and characterisation of rock, microanalytical and isotopic reference materials, including a précis of recent changes and revisions to ISO guidelines for reference material characterisation and reporting. Selected reports are provided of isotope ratio determinations by both solution nebulisation MC‐ICP‐MS and laser ablation‐ICP‐MS, as well as of radioactive isotope geochronology by LA‐ICP‐MS. Most of the analytical techniques elaborated continue to provide new applications for geochemical analysis; however, it is noted that instrumental neutron activation analysis has become less popular in recent years, mostly due to the reduced availability of nuclear reactors to act as a neutron source. Many of the newer applications reported here provide analysis at increasingly finer resolution. Examples include atom probe tomography, a very sensitive method providing atomic scale information, nanoscale SIMS, for isotopic imaging of geological and biological samples, and micro‐XRF, which has a spatial resolution many orders of magnitude smaller than conventional XRF.     

Temperature response to future urbanization and climate change

This study examines the impact of future urban expansion on local near-surface temperature for Sydney (Australia) using a future climate scenario (A2). The Weather Research and Forecasting model was used to simulate the present (1990–2009) and future (2040–2059) climates of the region at 2-km spatial resolution. The standard land use of the model was replaced with a more accurate dataset that covers the Sydney area. The future simulation incorporates the projected changes in the urban area of Sydney to account for the expected urban expansion. A comparison between areas with projected land use changes and their surroundings was conducted to evaluate how urbanization and global warming will act together and to ascertain their combined effect on the local climate. The analysis of the temperature changes revealed that future urbanization will strongly affect minimum temperature, whereas little impact was detected for maximum temperature. The minimum temperature changes will be noticeable throughout the year. However, during winter and spring these differences will be particularly large and the increases could be double the increase due to global warming alone at 2050. Results indicated that the changes were mostly due to increased heat capacity of urban structures and reduced evaporation in the city environment.     

Stable carbon isotopes (δ<Superscript>13</Superscript>C) of total organic carbon and long-chain <Emphasis Type="Italic">n</Emphasis>-alkanes as proxies for climate and environmental change in a sediment core from Lake Petén-Itzá, Guatemala

Sediment core PI-6 from Lake Petén Itzá, Guatemala, possesses an ~85-ka record of climate and environmental change from lowland Central America. Variations in sediment lithology suggest large and abrupt changes in precipitation during the last glacial and deglacial periods, and into the early Holocene. We measured stable carbon isotope ratios of total organic carbon and long-chain n-alkanes from the core, the latter representing a largely allochthonous (terrestrial) source of organic matter, to reveal past shifts in the relative proportion of C₃–C₄ terrestrial biomass. We sought to test whether stable carbon isotope results were consistent with other paleoclimate proxies measured in the PI-6 core, and if extraction and isotope analysis of n-alkanes is warranted. The largest δ¹³C variations are associated with Heinrich Events. Carbon isotope values in sediments deposited during the last glacial maximum indicate moderate precipitation with little fluctuation. The deglacial was a period of pronounced climate variability, e.g. a relatively warm and moist Bølling–Allerød, but a cool and dry Younger Dryas. Arid periods of the deglacial were inferred from samples with high δ¹³C values in total organic carbon, which reflect times of greater proportions of C₄ plants. These inferences are supported by stable isotope measurements on ostracod shells and relative abundance of grass pollen from the same depths in core PI-6. Similar trends in carbon stable isotopes measured on bulk organic carbon and n-alkanes suggest that carbon isotope measures on bulk organic carbon in sediments from this lake are sufficient to infer past climate-driven shifts in local vegetation.     

Assessing the institutional capacity to adapt to climate change: a case study in the Cambodian health and water sectors

Institutional capacity is an important element for climate change adaptation (CCA) and the development of such capacity is a great challenge in a Least Developed Country like Cambodia where resources are limited. An important first step to increasing capacity is via an understanding of the level of existing capacity; future priorities can then be subsequently identified. This study aimed to assess the capacity of organizations to implement climate change activities in Cambodia in order to provide such a basis for building capacity. Four elements of capacity were investigated in this research: (1) financial resources, (2) cooperation and coordination of stakeholders, (3) availability and quality of information on vulnerability and adaptation to climate change, and (4) the level of understanding of climate change vulnerability and adaptation. The data were collected through semistructured interviews with a wide range of government and non-government informants across a number of sectors. Results of the study showed that informants perceived capacity for CCA to be very constrained, especially in terms of financial resources and cooperation, and addressing these factors was ranked as the highest climate change capacity priority. Institutional capacity constraints were considered to relate more generally to weak governance of CCA. In light of our research findings, the absence of local higher education institutions in CCA activities should be addressed. The support of such institutions would provide an important mechanism to progress both capacity development as well as partnerships and coordination between different types of organizations and relevant sectors.

Policy relevance

Capacity for CCA within Cambodian health and water sectors was perceived to be very constrained across a range of interdependent factors. Increasing funding was ranked as the highest priority for building capacity for CCA; however, governance factors such as ‘improved cooperation’ were also ranked highly. Improving stakeholders' awareness of the availability of adaptation funds and resources, and their responsiveness to funding criteria, is an important implication of our research, as is improving the mobilization of local resources and the private sector. To address the issue of weak cooperation among stakeholders, improving the coordination function of the National Climate Change Committee (NCCC) regarding stakeholder engagement and capacity building is crucial. Ensuring that CCA activities are based on sound information and knowledge from across different disciplines and, importantly, include the perspectives of vulnerable people themselves, ultimately underpins and supports the realization of the above priorities.