Scanning electron microscopy,cathodoluminescence, and Raman spectroscopy of experimentally shock‐metamorphosed quartzite

Abstract— We studied unshocked and experimentally (at 12, 25, and 28 GPa, with 25, 100, 450, and 750°C pre‐shock temperatures) shock‐metamorphosed Hospital Hill quartzite from South Africa using cathodoluminescence (CL) images and spectroscopy and Raman spectroscopy to document systematic pressure or temperature‐related effects that could be used in shock barometry. In general, CL images of all samples show CL‐bright luminescent patchy areas and bands in otherwise nonluminescent quartz, as well as CL‐dark irregular fractures. Fluid inclusions appear dominant in CL images of the 25 GPa sample shocked at 750°C and of the 28 GPa sample shocked at 450°C. Only the optical image of our 28 GPa sample shocked at 25°C exhibits distinct planar deformation features (PDFs). Cathodoluminescence spectra of unshocked and experimentally shocked samples show broad bands in the near‐ultraviolet range and the visible light range at all shock stages, indicating the presence of defect centers on, e.g., SiO₄ groups. No systematic change in the appearance of the CL images was obvious, but the CL spectra do show changes between the shock stages. The Raman spectra are characteristic for quartz in the unshocked and 12 GPa samples. In the 25 and 28 GPa samples, broad bands indicate the presence of glassy SiO₂, while high‐pressure polymorphs are not detected. Apparently, some of the CL and Raman spectral properties can be used in shock barometry.     

Recent extreme slope failures in glacial environments: effects of thermal perturbation

This paper describes recent exceptional slope failures in high-mountain, glacial environments: the 2002 Kolka–Karmadon rock–ice avalanche in the Caucasus, a series of ice–rock avalanches on Iliamna Volcano, Alaska, the 2005 Mt. Steller rock–ice avalanche in Alaska, and ice and rock avalanches at Monte Rosa, Italy in 2005 and 2007. Deposit volumes range from 10⁶ to 10⁸ m³ and include rock, ice and snow. Here we focus on thermal aspects of these failures reflecting the involvement of glacier ice and permafrost at all sites, suggesting that thermal perturbations likely contributed to the slope failures. We use surface and troposphere air temperatures, near-surface rock temperatures, satellite thermal data, and recent 2D and 3D thermal modeling studies to document thermal conditions at the landslide sites. We distinguish between thermal perturbations of volcanic-geothermal and climatic origin, and thermal perturbations related to glacier–permafrost interaction. The data and analysis support the view that recent, current and future climatic change increases the likelihood of large slope failures in steep glacierized and permafrost terrain. However, some important aspects of these settings such as the geology and tectonic environment remain poorly understood, making the identification of future sites of large slope instabilities difficult. In view of the potentially large natural disasters that can be caused by such slope failures, improved data and understanding are needed.     

MHD simulations of the long-term evolution of a dipolar magnetosphere surrounded by an accretion disk

The evolution of a stellar, initially dipole type magnetosphere interacting with an accretion disk is investigated using numerical ideal MHD simulations. The simulations follow several 1000 Keplerian periods of the inner disk (for animated movies see http://www.aip.de～cfendt).Our model prescribes a Keplerian disk around a rotating star as a fixed boundary condition. The initial magnetic field distribution remains frozen into the star and the disk. The mass flow rate into the corona is fixed for both components. The initial dipole type magnetic field develops into a spherically radial outflow pattern with two main components – a disk wind and a stellar wind – both evolving into a quasi-stationary final state. A neutral field line divides both components, along which small plasmoids are ejected in irregular time intervals. The half opening angle of the stellar wind cone varies from 30° to55° depending on the ratio of the mass flow rates of disk wind and stellar wind. The maximum speed of the outflow is about the Keplerian speed at the inner disk radius. An axial jet forms during the first decades of rotations. However, this feature does not survive on the very long time scale and a pressure driven low velocity flow along the axis evolves. Within a cone of 15° along the axis the formation of knots may be observed if the stellar wind is weak. With the chosen mass flow rates and field strength we see almost no indication for a flow self-collimation. This is due to the weak net poloidal electric current in the magnetosphere which is in difference to typical jet models.     

Carbon isotope fractionation between graphite and diamond during shock experiments

Abstract— Carbon isotopic compositions were measured for shock‐produced diamond and shocked graphite formed at peak pressures ranging from 37 to 52 GPa. The δ¹³C values of diamonds produced in a sealed container were generally lower than that of the initial graphite. The differences in the carbon isotopic composition between initial graphite and shocked graphite/diamond may reflect kinetic isotopic fractionation during the oxidation of the graphite/diamond and/or analytical artifacts possibly induced by impurities in the samples. The pressure effect on the isotopic fractionations between graphite and diamond can be estimated from the δ¹³C values of impurity‐free diamonds produced using a vented container from which gases, including oxygen, in pore spaces escaped during or after the diamond formation (e.g., 0.039 ± 0.085‰ at a peak pressure of 52 GPa). Any isotopic fractionation induced by shock conversion of graphite to diamond is too small to be detected in natural shock‐induced diamond‐graphite systems related to terrestrial impact cratering processes.     

Monitoring selective availability dither frequencies and their effect on GPS data

Summary The signals transmitted by Block II satellites of the Global Positioning System (GPS) can be degraded to limit the highest accuracy of the system (10 m or better point positioning) to authorized users. This mode of degraded operation is called Selective Availability (S/A). S/A involves the degradation in the quality of broadcast orbits and satellite clock dithering. We monitored the dithered satellite oscillator and investigated the effect of this clock dithering on high accuracy relative positioning. The effect was studied over short 3-meter and zero-baselines with two GPS receivers. The equivalent S/A effects for baselines ranging from 0 to >10,000 km can be examined with short test baselines if the receiver clocks are deliberately mis-synchronized by a known and varying amount. Our results show that the maximum effect of satellite clock dithering on GPS double difference phase residuals grows as a function of the clock synchronization error according to: S/A _effect =0.04 cm/msec, and it increases as a function of baseline length like: S/A _effect =0.014 cm/100 km. These are equations for maximum observed values of post-fit residuals due to S/A. The effect on GPS baselines is likely to be smaller than the 0.14 mm for a baseline separation of 100 km. We therefore conclude, for our limited data set, and for the level of S/A during our tests, that S/A clock dithering has negligible effect on all terrestrial GPS baselines if double difference processing techniques are employed and if the GPS receivers remain synchronized to better than 10 msec. S/A may constitute a problem, however, if accurate point processing is required, or if GPS receivers are not synchronized. We suggest and test two different methods to monitor satellite frequency offsets due to S/A. S/A modulates GPS carrier frequencies in the range of-2 Hz to +2 Hz over time periods of several minutes. The methods used in this paper to measure the satellite clock dither could be applied by the civilian GPS community to continuously monitor S/A clock dithering. The monitored frequencies may aid high accuracy point positioning applications in a postprocessing mode (Malys and Ortiz 1989), and differential GPS with poorly synchronized receivers (Feigl et al. 1991).     

Relationship between footwall composition,crustal contamination,and fluid–rock interaction in the Platreef,Bushveld Complex,South Africa

In the northern limb of the 2.06-Ga Bushveld Complex, the Platreef is a platinum group elements (PGE)-, Cu-, and Ni-mineralized zone of pyroxenite that developed at the intrusion margin. From north to south, the footwall rocks of the Platreef change from Archaean granite to dolomite, hornfels, and quartzite. Where the footwall is granite, the Sr-isotope system is more strongly perturbed than where the footwall is Sr-poor dolomite, in which samples show an approximate isochron relationship. The Nd-isotope system for samples of pyroxenite and hanging wall norite shows an approximate isochron relationship with an implied age of 2.17 ± 0.2 Ga and initial Nd-isotope ratio of 0.5095. Assuming an age of 2.06 Ga, the ɛNd values range from −6.2 to −9.6 (ave. −7.8, n = 17) and on average are slightly more negative than the Main Zone of the Bushveld. These data are consistent with local contamination of an already contaminated magma of Main Zone composition. The similarity in isotope composition between the Platreef pyroxenites and the hanging wall norites suggests a common origin. Where the country rock is dolomite, the Platreef has generally higher plagioclase and pyroxene δ ¹⁸O values, and this indicates assimilation of the immediate footwall. Throughout the Platreef, there is considerable petrographic evidence for sub-solidus interaction with fluids, and the Δ _{plagioclase–pyroxene} values range from −2 to +6, which indicates interaction at both high and low temperatures. Whole-rock and mineral δD values suggest that the Platreef interacted with both magmatic and meteoric water, and the lack of disturbance to the Sr-isotope system suggests that fluid–rock interaction took place soon after emplacement. Where the footwall is granite, less negative δD values suggest a greater involvement of meteoric water. Consistently higher values of Δ _{plagioclase–pyroxene} in the Platreef pyroxenites and hanging wall norites in contact with dolomite suggest prolonged interaction with CO₂-rich fluid derived from decarbonation of the footwall rocks. The overprint of post crystallization fluid–rock interaction is the probable cause of the previously documented lack of correlation between PGE and sulfide content on the small scale. The Platreef in contact with dolomite is the focus of the highest PGE grades, and this suggests that dolomite contamination played a role in PGE concentration and deposition, but the exact link remains obscure. It is a possibility that the CO₂ produced by decarbonation of assimilated dolomite enhanced the process of PGE scavenging by sulfide precipitation.     

Loading and fate of particulate organic carbon from the Himalaya to the Ganga-Brahmaputra delta

We use the evolution of river sediment characteristics and sedimentary C_org from the Himalayan range to the delta to study the transport of C_org in the Ganga-Brahmaputra system and especially its fate during floodplain transit.A detailed characterisation of both mineral and organic particles for a sampling set of river sediments allows taking into account the sediment heterogeneity characteristic of such large rivers. We study the relationships between sediment characteristics (mineralogy, grain size, specific area) and C_org content in order to evaluate the controls on C_org loading. Contributions of C3 and C4 plants are estimated from C_org stable isotopic composition (δ¹³C_org). We use the evolution of δ¹³C_org values from the Himalayan range to the delta in order to study the fate of C_org during floodplain transit.Ganga and Brahmaputra sediments define two distinct linear relations with specific area. In spite of 4-5 times higher specific area, Ganga sediments have similar C_org content, grain size and mineralogy as Brahmaputra sediments, indicating that specific area does not exert a primary control on C_org loading. The general correlation between the total C_org content and Al/Si ratio indicates that C_org loading is mainly related to: (1) segregation of organic particles under hydrodynamic forces in the river, and (2) the ability of mineral particles to form organo-mineral aggregates.Bed and suspended sediments have distinct δ¹³C_org values. In bed sediments, δ¹³C_org values are compatible with a dominant proportion of fossil C_org derived from Himalayan rocks erosion. Suspended sediments from Himalayan tributaries at the outflow of the range have low δ¹³C_org values (−24.8‰ average) indicating a dominant proportion of C3 plant inputs. In the Brahmaputra basin, δ¹³C_org values of suspended sediments are constant along the river course in the plain. On the contrary, suspended sediments of the Ganga in Bangladesh have higher δ¹³C_org values (−22.4‰ to −20.0‰), consistent with a significant contribution of C4 plant derived from the floodplain. Our data indicate that, during the plain transit, more than 50% of the recent biogenic C_org coming from the Himalaya is oxidised and replaced by floodplain C_org. This renewal process likely occurs during successive deposition-erosion cycles and river course avulsions in the plain.