Some stability properties of large-scale baroclinic flows with nonlinear zonal current profile

The stability properties of a baroclinic zonal current with nonlinear velocity profile are investigated. The integral method is applied to the governing eigenvalue equation having the vertical velocity as the dependent variable. Expressed in terms of the Rossby number and the Richardson number, stability criteria, unstable regions in the complexc plane, and the upper bound of the unstable wave growth rate are found. Some differences in the results are noted between the present model and the quasi-geostrophic streamfunction model, particularly in connection with the effect of the velocity profile curvature termU _zz . It is conjectured in the present model that, depending on extreme behaviors ofU _zz , the propagation speed of unstable waves can be greater thanU _max or smaller thanU _min .     

Three‐dimensional simulation of tsunami run‐up around conical island

At the circular Babi Island in the Flores tsunami (1992) and pear shaped island in the Okushiri event (1993), unexpectedly large tsunami run‐up heights in the lee of conic islands were observed. The flume and basin physical model studies were conducted in the Coastal Hydraulic Laboratory, Engineering Research and Development Center, U.S. Army Corps of Engineers to provide a better understanding of the physical phenomena and verify numerical models used in predicting tsunami wave run‐up on beaches, islands, and vertical walls. Reasonably accurate comparison of run‐up height of solitary waves on a circular island has been obtained between laboratory experimental results and two‐dimensional computation model results. In this study we apply three‐dimensional RANS model to simulate wave run‐up on conical island. In the run‐up computation we obtain that 3D calculations are in very good comparison with laboratory and 2D numerical results. A close examination of the three‐dimensional velocity distribution around conical island to compare with depth‐integrated model is performed. It is shown that the velocity distribution along the vertical coordinate is not uniform: and velocity field is weaker in the bottom layer and higher on the sea surface. The maximum difference (about 40%) appears at the time when solitary wave reached the circular island.     

Wave reflection from partially perforated-wall caisson breakwater

In 1995, Suh and Park developed a numerical model that computes the reflection of regular waves from a fully perforated-wall caisson breakwater. This paper describes how to apply this model to a partially perforated-wall caisson and irregular waves. To examine the performance of the model, existing experimental data are used for regular waves, while a laboratory experiment is conducted in this study for irregular waves. The numerical model based on a linear wave theory tends to over-predict the reflection coefficient of regular waves as the wave nonlinearity increases, but such an over-prediction is not observed in the case of irregular waves. For both regular and irregular waves, the numerical model slightly over- and under-predicts the reflection coefficients at larger and smaller values, respectively, because the model neglects the evanescent waves near the breakwater.     

Determination of palladium and platinum in seaweed

Palladium and platinum concentrations were determined for twenty two species of seaweed from the California coast, U.S.A.. A new sensitive analytical technique using atomic absorption spectrometry was developed for palladium in seaweed. For the first time, palladium contents in seaweed were obtained. The contents of palladium and platinum varied from 0.09 to 0.61 ng g^–1 and 0.25 to 1.75 ng g^–1 in dried material, respectively.The average ratio of Pt/Pd found in seaweed was 3.5, while the ratio of Pt/Pd was 4.5 in seawater. Therefore, it is postulated that there is no discrimination for seaweed to accumulate palladium and platinum from the ambient seawater due to the chemical similarity of the metals.     

Probabilistic approach for active control of structures: experimental verification

In our previous study (Earthquake Engineering and Structural Dynamics 2003; 32 :2301), we have developed a probabilistic algorithm for active control of structures. In the probabilistic control algorithm, the control force is determined by the probability that the structural energy exceeds a specified target critical energy, and the direction of a control force is determined by the Lyapunov controller design method. In this paper, an experimental verification of the proposed probabilistic control algorithm is presented. A three‐story test structure equipped with an active mass driver (AMD) has been used. The effectiveness of the control algorithm has been examined by exciting the test structure using a sinusoidal signal, a scaled El Centro earthquake and a broadband Gaussian white noise; and, especially, experiments on control have been performed under different conditions to that of system identification in order to prove the stability and robustness of the proposed control algorithm. The experimental results indicate that the probabilistic control algorithm can achieve a significant response reduction under various types of ground excitations even when the modeling error exists. Copyright © 2004 John Wiley & Sons, Ltd.     

A Review on Marine N2 Fixation: Mechanism,Evolution of Methodologies,Rates, and Future Concerns

Ocean Science Journal - Investigations on marine N2 fixation have gained momentum since 1960s with eventual establishments of relevant methodologies to identify species involved and quantify the...     

夏季对马暖流区黑潮水与陆架水的相互作用──兼论对马暖流的起源

根据1994年8月28日至9月7日韩国“Onnuri”号海洋调查船获得的CTD资料及在调查期间投放的11个卫星跟踪漂流浮标资料,分析研究了东海东北部黑潮水的分离及其与陆架水的相互作用,进而探讨了夏季的对马暖流的形成过程。     

Down-scaled regional ocean modeling system (ROMS) for high-resolution coastal hydrodynamics in Korea

A down-scaled operational oceanographic system is developed for the coastal waters of Korea using a regional ocean modeling system(ROMS).The operational oceanographic modeling system consists of atmospheric and hydrodynamic models.The hydrodynamic model,ROMS,is coupled with wave,sediment transport,and water quality modules.The system forecasts the predicted results twice a day on a 72 h basis,including sea surface elevation,currents,temperature,salinity,storm surge height,and wave information for the coastal waters of Korea.The predicted results are exported to the web-GIS-based coastal information system for real-time dissemination to the public and validation with real-time monitoring data using visualization technologies.The ROMS is two-way coupled with a simulating waves nearshore model,SWAN,for the hydrodynamics and waves,nested with the meteorological model,WRF,for the atmospheric surface forcing,and externally nested with the eutrophication model,CE-QUAL-ICM,for the water quality.The operational model,ROMS,was calibrated with the tidal surface observed with a tide-gage and verified with current data observed by bottom-mounted ADCP or AWAC near the coastal waters of Korea.To validate the predicted results,we used real-time monitoring data derived from remote buoy system,HF-radar,and geostationary ocean color imager(GOCI).This down-scaled operational coastal forecasting system will be used as a part of the Korea operational oceanographic system(KOOS) with other operational oceanographic systems.