The Scattered Disk Population and the Oort Cloud

The trans-Neptunian belt has been subject to a strong depletion that has reduced its primordial population by a factor of one hundred over the solar system's age. One by-product of such a depletion process is the existence of a scattered disk population in transit from the belt to other places, such as the Jupiter zone, the Oort cloud or interstellar space. We have integrated the orbits of the scattered disk objects (SDOs) so far discovered by 2500 Myr to study their dynamical time scales and the probability of falling in each of the end states mentioned above, paying special attention to their contribution to the Oort cloud. We found that their dynamical half-time is close to 2.5 Gyr and that about one third of the SDOs end up in the Oort cloud.     

MS 1603.6+2600: an accretion disc corona source?

We have observed the eclipsing low-mass X-ray binary MS 1603.6+2600 with Chandra for 7 ks. The X-ray spectrum is well fit with a single absorbed power law with an index of ∼2. We find a clear sinusoidal modulation in the X-ray light curve with a period of  1.7 ± 0.2 h  , consistent with the period of 1.85 h found before. However, no (partial) eclipses were found. We argue that if the X-ray flare observed in earlier X-ray observations was a type I X-ray burst, then the source can only be an accretion disc corona source at a distance of ∼11–24 kpc (implying a height above the Galactic disc of ∼8–17 kpc). It has also been proposed in the literature that MS 1603.76+2600 is a dipper at ∼75 kpc. We argue that, in this dipper scenario, the observed optical properties of MS 1603.6+2600 are difficult to reconcile with the optical properties one would expect on the basis of comparisons with other high-inclination, low-mass X-ray binaries, unless the X-ray flare was not a type I X-ray burst. In that case, the source can be a nearby soft X-ray transient accreting at a quiescent rate, as was proposed by Hakala et al., or a high-inclination source at ∼15–20 kpc.     

Beam Mode Expansion of Corrugated Conical Horns with Phase Correcting Lens: Application to Radioastronomy Receivers

A classical radioastronomy receiver is fed with a corrugated horn and an independent lens, both placed in a cryostat to lower the noise temperature. The beam is focused and directed using a combination of elliptical and plane mirrors. This paper proposes modifying the initial feeding system by placing the lens onto the horn aperture, thereby allowing a size reduction of the horn and lens, and a simplification of their mechanical design. The profiled lens is shaped to correct the phase error on the horn aperture. A quasi-optical model of the horn-plus-lens system has been developed using a Beam Mode Expansion (BME). Results using both a hyperbolic-planar lens and a spherical-elliptical lens, as well as results obtained by using Geometrical Optics (GO) with a Kirchoff–Huygens integration to get the far-field pattern, have been compared with measurements. As a direct application, a full focusing system for the new 40-m radiotelescope at the “Centro Astronómico de Yebes” is presented for the 22, 30 and 45 GHz bands. This paper has developed a QO model for a corrugated conical horn with a phase-correcting lens. This revised version was published online in July 2006 with corrections to the Cover Date.     

Diurnal photometric conditions at Teide observatory and long-term solar irradiance variations

Monochromatic extinction coefficients at four wavelengths have been obtained over a period of more than two years at the Observatorio del Teide (Izaña Tenerife) using a full disc, direct sunlight, quadruple photometer devoted to the detection of integral luminosity oscillations of the Sun. The mean extinction coefficients (0.13 at 500 nm) show a seasonal variation of about 15%, the best atmospheric conditions being in winter and autumn. Moreover, in anyone day the extinction coefficient in the afternoon is always lower than the one in the morning by 7%. A one-year period fluctuation, with an amplitude of 0.035 mag, has been identified in the instrumental magnitudes outside the atmosphere, and is interpreted as the variation produced by the different Sun-Earth distance from winter to summer. Finally, the study made to detect periodic time fluctuations in both, Sun's magnitude and extinction coefficients, has given null results at levels of 0.04 and 1.8%, respectively.     

Experimental solidification of anhydrous latitic and trachytic melts at different cooling rates: The role of nucleation kinetics

Two sets of cooling experiments were run at atmospheric conditions for two anhydrous starting latitic and trachytic melts: 1) five cooling rates (25, 12.5, 3, 0.5, and 0.125 °C/min) between 1300° and 800 °C, and 2) a 0.5 °C/min cooling rate from 1300 °C with quench temperatures at 1200°, 1100°, 1000° and 900 °C. Trachytic run-products are invariably glassy. Nucleation is also suppressed in the latitic run-products at the three highest cooling rates. Conversely, in the 0.5 and 0.125 °C/min runs, latites have a crystal content of  90 vol.%. The phases are: plagioclase, clinopyroxene, glass and iron-bearing oxide (in order of abundance). The variable quench temperatures, investigated by coupling experiments with Pt wire and Pt capsule sample containers in set 2, again did not produce crystallization of trachyte, whereas latitic samples are characterized by  10 vol.% of oxides, pyroxenes and plagioclase (in order of appearance), at temperature < 1000 °C. Effects of (preferential) heterogeneous nucleation on sample holders, of superheating degree, and chemical species loss during cooling are absent for both melt compositions. The difference of solidification paths between these two silicate melts can be ascribed only to their small chemical differences. In comparison with calculated equilibrium conditions all the experimental latitic and trachytic run-products revealed strong kinetic effects, interpretable in the light of the nucleation theory. The glass-forming ability (GFA) of trachyte is higher, whereas their critical cooling rate (Rc) is lower (< 0.125 °C/min), in comparison to latitic melts (Rc > 0.5 °C/min). The experimental results carried out in this study can be applied to lava flows and domes; trachytic lavas are able to flow for longer period with respect to latitic ones in a metastable condition. Glass-rich terrestrial lavas, i.e. obsidians, can be the result of sluggish nucleation kinetics due to the relative high polymerisation of evolved silicate melts.     

Impact evaluation on groundwater of the infiltration of an urban wastewater geopurification system placed over a detrital aquifer in a semiarid region (Spain)

Over a period of 4 years and 4 months, the geopurification installations at Dehesas de Guadix (Granada, Spain) were monitored to determine the impact on soil and groundwater of the controlled discharge of urban wastewater, and also to identify the best indicators of the entry of the recharged water into the aquifer. The installations are located in an area where the climate is Mediterranean sub-arid, with an average precipitation of less than 287 mm/year, and a rate of evapotranspiration that is almost three times greater. The system was controlled by determining the balance of majority nutrients and boron in the soil and in the groundwater, both at the points affected directly by the wastewater discharge and at others. The quantity of mass discharged was relatively large (COD 14,656 g/m², NO₃ 85 g/m², NO₂ 4 g/m², NH₄ 2,425 g/m², PO₄ 1,143 g/m², K 1,531 g/m², B 63 g/m²). It was observed that the elimination of nutrients within the soil (COD 97.5%, PO₄ 94.4%, K 59.17%, N _total 18.8%, B 12.69%) was very efficient except for the nitrogen, which nevertheless did not reach the groundwater, as it was eliminated at deep levels of the unsaturated zone. Only 12.69% of the boron was removed, and appreciable, increasing amounts of this element did reach the groundwater. Unexpectedly, none of the majority nutrients behaved as a reliable indicator of the impact on groundwater; despite this, the boron and the bicarbonate did clearly reflect the arrival of the recharged water, and are proposed as the best indicators.     

Coupled hydrogeological and reactive transport modelling of the Simpevarp area (Sweden)

The Simpevarp area is one of the alternative sites being considered for the deep geological disposal of high level radioactive waste in Sweden. In this paper, a coupled regional groundwater flow and reactive solute transport model of the Simpevarp area is presented that integrates current hydrogeological and hydrochemical data of the area. The model simulates the current hydrochemical pattern of the groundwater system in the area. To that aim, a conceptual hydrochemical model was developed in order to represent the dominant chemical processes. Groundwater flow conditions were reproduced by taking into account fluid-density-dependent groundwater flow and regional hydrogeologic boundary conditions. Reactive solute transport calculations were performed on the basis of the velocity field so obtained. The model was calibrated and sensitivity analyses were carried out in order to investigate the effects of heterogeneities of hydraulic conductivity in the subsurface medium. Results provided by the reactive transport model are in good agreement with much of the measured hydrochemical data. This paper emphasizes the appropriateness of the use of reactive solute transport models when water-rock interaction reactions are involved, and demonstrates what powerful tools they are for the interpretation of hydrogeological and hydrochemical data from site geological repository characterization programs, by providing a qualitative framework for data analysis and testing of conceptual assumptions in a process-oriented approach.