Teleseismic finite-fault inversion of two <Emphasis Type="Italic">M</Emphasis><Subscript>w</Subscript> = 6.4 earthquakes along the East Anatolian Fault Zone in Turkey: the 1998 Adana and 2003 Bingöl earthquakes

The East Anatolian Fault Zone is a continental transform fault accommodating westward motion of the Anatolian fault. This study aims to investigate the source properties of two moderately large and damaging earthquakes which occurred along the transform fault in the last two decades using the teleseismic broadband P and SH body waveforms. The first earthquake, the 27 June 1998 Adana earthquake, occurred beneath the Adana basin, located close to the eastern extreme of Turkey’s Mediterranean coast. The faulting associated with the 1998 Adana earthquake is unilateral to the NE and confined to depths below 15 km with a length of 30 km along the strike (53°) and a dipping of 81° SE. The fixed-rake models fit the data less well than the variable-rake model. The main slip area centered at depth of about 27 km and to the NE of the hypocenter, covering a circular area of 10 km in diameter with a peak slip of about 60 cm. The slip model yields a seismic moment of 3.5?×?10¹⁸ N-m (M_w???6.4). The second earthquake, the 1 May 2003 Bingöl earthquake, occurred along a dextral conjugate fault of the East Anatolian Fault Zone. The preferred slip model with a seismic moment of 4.1?×?10¹⁸ N-m (M_w???6.4) suggests that the rupture was unilateral toward SE and was controlled by a failure of large asperity roughly circular in shape and centered at a depth of 5 km with peak displacement of about 55 cm. Our results suggest that the 1998 Adana earthquake did not occur on the mapped Göksun Yakap?nar Fault Zone but rather on a SE dipping unmapped fault that may be a split fault of it and buried under the thick (about 6 km) deposits of the Adana basin. For the 2003 Bingöl earthquake, the final slip model requires a rupture plane having 15° different strike than the most possible mapped fault.     

Implications for the water level change triggered moderate (M ≥ 4.0) earthquakes in Lake Van basin, Eastern Turkey

The water level in Lake Van has shown alternating rises and decreases in history, causing economical, environmental and social problems over the littoral area. The water level changes were obtained to be in the order of 100 m between 18000 and 1000 B.C., in the order of 10 m between 1000 B.C. and 500 A.D. and relatively stable and fluctuating in the order of a few metres during the past 1500 years. The most recent change of the water level took place between 1987 and 1996, during which the water level increased episodically about 2 m and its altitude changed from approximately 1648.3 m to about 1650.2 m. All these changes were mainly related to climate changes. In this study, the water level changes in the lake after 1860 are compared with the seismic activity of faults lying close to the basin. Temporal correlations of seismicity with the water level changes are very persuasive and dramatic, indicating hydrogeological triggering of the earthquakes. This study shows that 14 M ≥ 5.0 earthquakes and increasing number of 4.0 ≤ M < 5.0 earthquakes accompanied or followed the dramatic (about 1 m or larger) changes of the annual mean of the water level in the lake and that there was a tendency of M ≥ 4 earthquakes to occur between November and February, during which the lake level is low within a year.     

Fault rupture and stress changes associated with the November 27, 2005 Qeshm Island (Iran) earthquake (<Emphasis Type="Italic">M</Emphasis><Subscript>W</Subscript> = 6.0)

The November 27, 2005 Qeshm Island earthquake (M_w 6.0) occurred along the Zagros Thrust and Fold Belt which accommodates about half of the deformation caused by the Arabian and Eurasian Plates convergence. As typical for the belt, the earthquake was associated with buried reverse faulting and produced no surface rupture. Here, teleseismic broadband P velocity waveforms of the earthquake are inverted to obtain coseismic finite-fault slip distribution of the earthquake. It is obtained that rupture was controlled by failure of a single asperity with largest displacement of approximately 0.6 m, which occurred at a depth of 9 km. The slip model indicated radial rupture propagation from the hypocentre and confirmed blind reverse faulting within deeper part (below the depth of 6 km) of the sedimentary cover above the Hormuz Salt, lying between the cover and the basement, releasing a seismic moment of about 1.3?×?10¹⁸ Nm (M_W?=?6.0). The results also confirm that the Hormuz Salt behaves as a barrier for rupture propagation to the basement below and occurrence of the aftershock activity downdip from the rupture within the Hormuz Salt. Calculated Coulomb stress variations caused by the coseismic rupture indicates stress coupling between the 2005 Qeshm Island earthquake and both the largest aftershock several hours later and the 2008 Qeshm Island earthquake (M_W?=?5.9). The stress calculations further indicated stress load at the depth range (15–20 km) of the well-located aftershocks, corresponding to depths of the Hormuz Salt and top of the basement and providing plausible explanation for occurrence of the aftershocks within those layers.     

23 October 2011 Van, Eastern Anatolia, earthquake (M W 7.1) and seismotectonics of Lake Van area

The 23 October 2011 Van earthquake took place in the NE part of Lake Van area, surprisingly on a fault (the Van fault) that is not present in the current active fault map of Turkey. However, occurrence of such a large magnitude earthquake in the area is not surprising regarding the historical seismicity of the region. The comparison of the damage patterns suggests that the earthquake is much likely a recurrence of the 1715 Van earthquake. The finite fault modelling of the earthquake using teleseismic broadband body waveforms has shown that the earthquake rupture was unilateral toward SW, was mostly reverse faulting, confined to below the depth of 5 km, did not propagate offshore, and was dominated by a failure of a single asperity with a peak slip of about 5.5 m. The total seismic moment calculated for the model is 4.6?×?10¹⁹ Nm (M _W ?≈?7.1). The finite fault model coincides with the field observations indicating blind faulting and the vertical displacements over the free surface estimated from it correlate well with the maximum reported uplift along the coast of Lake Van above the hanging wall. The possible offshore continuations of the Van fault and some other faults lying its south are also discussed by assessing a previous offshore seismic reflection study and the earthquake epicentres and focal mechanisms.     

Seismic behaviour of the North Anatolian Fault beneath the Sea of Marmara (NW Turkey): implications for earthquake recurrence times and future seismic hazard

Possible long-term seismic behaviour of the Northern strand of the North Anatolian Fault Zone, between western extreme of the 1999 İzmit rupture and the Aegean Sea, after 400 AD is studied by examining the historical seismicity, the submarine fault mapping and the paleoseismological studies of the recent scientific efforts. The long-term seismic behaviour is discussed through two possible seismicity models devised from M _S ≥ 7.0 historical earthquakes. The estimated return period of years of the fault segments for M1 and M2 seismic models along with their standard deviations are as follows: F4 segment 255 ± 60 and 258 ± 12; F5 segment 258 ± 60 and 258 ± 53; F6 segment 258 ± 60 and 258 ± 53; F7 segment 286 ± 103 and 286 ± 90; F8 segment 286 ± 90 and 286 ± 36. As the latest ruptures on the submarine segments have been reported to be during the 1754–1766 earthquake sequence, and the 1912 mainshock rupture has been evidenced to extend almost all over the western part of the Sea of Marmara, our results imply imminent seismic hazard and, considering the mean recurrence time, a large earthquake to strike the eastern part of the Sea of Marmara in the next two decades.     

Stress history controls the spatial pattern of aftershocks: case studies from strike-slip earthquakes

International Journal of Earth Sciences - Earthquake ruptures perturb stress within the surrounding crustal volume and as it is widely accepted now these stress perturbations strongly correlates...     

The 2014 seismic hazard model of the Middle East: overview and results

The Earthquake Model of Middle East (EMME) Project aimed to develop regional scale seismic hazard and risk models uniformly throughout a region extending from the Eastern Mediterranean in the west to the Himalayas in the east and from the Gulf of Oman in the south to the Greater Caucasus in the North; a region which has been continuously devastated by large earthquakes throughout the history. The 2014 Seismic Hazard Model of Middle East (EMME-SHM14) was developed with the contribution of several institutions from ten countries. The present paper summarizes the efforts towards building a homogeneous seismic hazard model of the region and highlights some of the main results of this model. An important aim of the project was to transparently communicate the data and methods used and to obtain reproducible results. By doing so, the use of the model and results will be accessible by a wide community, further support the mitigation of seismic risks in the region and facilitate future improvements to the seismic hazard model. To this end all data, results and methods used are made available through the web-portal of the European Facilities for Earthquake Hazard and Risk (www.efehr.org).