Dynamic modelling of retrogressive landslides with emphasis on the role of clay sensitivity

This paper presents a detailed numerical study of the retrogressive failure of landslides in sensitive clays. The dynamic modelling of the landslides is carried out using a novel continuum approach, the particle finite element method, complemented with an elastoviscoplastic constitutive model. The multiwedge failure mode in the collapse is captured successfully, and the multiple retrogressive failures that have been widely observed in landslides in sensitive clays are reproduced with the failure mechanism, the kinematics, and the deposition being discussed in detail. Special attention has been paid to the role of the clay sensitivity on each retrogressive failure as well as on the final retrogression distance and the final run‐out distance via parametric studies. Moreover, the effects of the viscosity of sensitive clays on the failure are also investigated for different clay sensitivities.     

On the Nonlinear Thermal Evolution of Solar Corona Structures

The thermal evolution of structures is investigated for different values of the size of structure. A simplified cooling function and a constant heating mechanism are assumed. Analytical criteria for thermal instability are obtained. It is found that the response of the thermal structure not only depends on the amplitude of the disturbances, but also on whether the disturbance increases or decreases the initial steady temperature. Additionally, the evolution of the structure is examined numerically by using a time-dependent code under the assumption that the inertia terms are small. In particular, the analytical criteria obtained for thermal instability are verified.     

On the self-consistency of evolutionary synthesis models

Evolutionary synthesis models have been used to study the physical properties of unresolved populations in a wide range of scenarios. Unfortunately, their self-consistency is difficult to test and there are some theoretical open questions without an answer: (1) The change of the homology relations assumed in the computation of isochrones due to the effect of stellar winds (or rotation) and the discontinuities in the stellar evolution are not considered. (2) There is no consensus about how the isochrones must be integrated. (3) The discreteness of the stellar populations (that produce an intrinsic statistical dispersion) usually are not taken into account, and model results are interpreted in a deterministic way instead of a statistical one. The objective of this contribution is to present some inconsistencies in the computation and some cautions in the application of the results of such codes. This revised version was published online in August 2006 with corrections to the Cover Date.     

Quick-look assessments to identify optimal CO2 EOR storage sites

A newly developed, multistage quick-look methodology allows for the efficient screening of an unmanageably large number of reservoirs to generate a workable set of sites that closely match the requirements for optimal CO₂ enhanced oil recovery (EOR) storage. The objective of the study is to quickly identify miscible CO₂ EOR candidates in areas that contain thousands of reservoirs and to estimate additional oil recovery and sequestration capacities of selected top options through dimensionless modeling and reservoir characterization. Quick-look assessments indicate that the CO₂ EOR resource potential along the US Gulf Coast is 4.7 billion barrels, and CO₂ sequestration capacity is 2.6 billion metric tons. In the first stage, oil reservoirs are screened and ranked in terms of technical and practical feasibility for miscible CO₂ EOR. The second stage provides quick estimates of CO₂ EOR potential and sequestration capacities. In the third stage, a dimensionless group model is applied to a selected set of sites to improve the estimates of oil recovery and storage potential using appropriate inputs for rock and fluid properties, disregarding reservoir architecture and sweep design. The fourth stage validates and refines the results by simulating flow in a model that describes the internal architecture and fluid distribution in the reservoir. The stated approach both saves time and allows more resources to be applied to the best candidate sites.     

Mineralogy and geochemistry of the Texeo Cu–Co mine site (NW Spain): screening tools for environmental assessment

The Cu–Co–Ni Texeo mine has been the most important source of Cu in NW Spain since Roman times and now, approximately 40,000 m³ of wastes from mine and metallurgical operations, containing average concentrations of 9,263 mg kg⁻¹ Cu, 1,100 mg kg⁻¹ As, 549 mg kg⁻¹ Co, and 840 mg kg⁻¹ Ni, remain on-site. Since the cessation of the activity, the abandoned works, facilities and waste piles have been posing a threat to the environment, derived from the release of toxic elements. In order to assess the potential environmental pollution caused by the mining operations, a sequential sampling strategy was undertaken in wastes, soil, surface and groundwater, and sediments. First, screening field tools were used to identify hotspots, before defining formal sampling strategies; so, in the areas where anomalies were detected in a first sampling stage, a second detailed sampling campaign was undertaken. Metal concentrations in the soils are highly above the local background, reaching up to 9,921 mg kg⁻¹ Cu, 1,373 mg kg⁻¹ As, 685 mg kg⁻¹ Co, and 1,040 mg kg⁻¹ Ni, among others. Copper concentrations downstream of the mine works reach values up to 1,869 μg l⁻¹ and 240 mg kg⁻¹ in surface water and stream sediments, respectively. Computer-based risk assessment for the site gives a carcinogenic risk associated with the presence of As in surface waters and soils, and a health risk for long exposures; so, trigger levels of these elements are high enough to warrant further investigation.     

Impact of lightning on organic matter-rich soils: influence of soil grain size and organic matter content on underground fires

A detailed study was carried out on a piece of land that had been struck by lightning during the violent rainstorm that raged over the Island of S?o Miguel (Azores Archipelago) in late October 2006. Temperature and gas measurements (CO₂, CO, H₂S and CH₄) were performed in four study trenches, dug in an area of ∼3 m², where an underground fire had been initiated by the impact with a lightning stroke, followed by the emission of a column of gases and smoke. The soil under study was originally a well-pedogenized about 80 cm thick bed, made of volcanic clayey to silty tephra fallouts and contained 5.5–9.7% of organic matter. The underground fire was monitored for one week and revealed a peak release of 404 ppm CO and 3.4% CO₂ originating from a horizon located about 45 cm under the soil surface. Measurements of temperature, performed one week after the impact, indicated a maximum value of 326°C inside the soil, while 516.5°C were measured on the surface of a lava block interred about 20 cm under the surface. Subsequently, a stratigraphic and sedimentologic study proved the role of the grain-size of the soil and of the organic matter content of the different horizons of the impact area, in determining the ratio between anoxic/oxidised combustion conditions and in the progress of the process itself. It was also noticed that combustion was not total all over in the soil bed and that the process had slightly migrated toward SW during the observation period. The combustion process went on for about ten days, in spite of several other violent rainstorms, until it was artificially extinguished through the excavations made to obtain study trenches. This particular circumstance evidenced the potential natural hazard represented by this kind of atmospheric event, especially in a land where the volcanic nature of the soil may easily mislead inexperienced observers and, consequently, delay proper action.     

Biaxial test simulations using a packing of polygonal particles

The mechanical response of cohesionless granular materials under monotonic loading is studied by performing molecular dynamic simulations. The diversity of shapes of soil grains is modelled by using randomly generated convex polygons as granular particles. Results of the biaxial test obtained for dense and loose media show that samples achieve the same void ratio at large strains independent of their initial density state. This limit state resembles the so‐called critical state of soil mechanics, except for some stress fluctuations, which remain for large deformations. These fluctuations are studied at the micro‐mechanical level, by following the evolution of the co‐ordination number, force chains and the fraction of the sliding contacts of the sample. Copyright © 2007 John Wiley & Sons, Ltd.     

Mineralogy and geochemistry of platinum-group elements in the Aguablanca Ni-Cu deposit (SW Spain)

Summary The Aguablanca Ni-Cu-(PGE) magmatic sulphide deposit is associated with a magmatic breccia located in the northern part of the Aguablanca gabbro (SW, Iberia). Three types of ores are present: semi-massive, disseminated, and chalcopyrite-rich veined ore. The principal ore minerals are pyrrhotite, pentlandite and chalcopyrite. A relatively abundant platinum-group mineral (PGM) assemblage is present and includes merenskyite, melonite, michenerite, moncheite and sperrylite. Moreover, concentrations of base and precious metals and micro-PIXE analyses were obtained for the three ore-types. The mineralogy and the mantle-normalised chalcophile element profiles strongly suggest that semi-massive ore represents mss crystallisation, whereas the disseminated ore represents an unfractionated sulphide liquid and the chalcopyrite-rich veined ore a Cu-rich sulphide liquid. Palladium-bearing minerals occur commonly enclosed within sulphides, indicating a magmatic origin rather than hydrothermal. The occurrences and the composition of these minerals suggest that Pd was initially dissolved in the sulphides and subsequently exsolved at low temperatures to form bismutotellurides. Negative Pt and Au anomalies in the mantle-normalised chalcophile element profiles, a lack of Cu-S correlation and textural observations (such as sperrylite losing its euhedral shape when in contact with altered minerals) suggest partial remobilisation of Pt, Au and Cu by postmagmatic hydrothermal fluids after the sulphide crystallisation. Authors’ addresses: R. Pi?a, L. Ortega, R. Lunar, Departamento de Cristalografía y Mineralogía, Facultad de Geología, Universidad Complutense de Madrid, ES-28040 Madrid, Spain; F. Gervilla, Facultad de Ciencias, Instituto Andaluz de Ciencias de la Tierra, Universidad de Granada-CSIC, Avda. Fuentenueva, s/n, ES-18002 Granada, Spain     

Temporal variability of Pb fluxes and bioturbation in shelf sediments beneath the high primary production area off Concepción, central-southern Chile (36°S)

We estimated monthly fluxes of ²¹⁰Pb in shelf sediments beneath a high productivity area off central-southern Chile (36°S) during 1 year (September 2002-August 2003). Sediment cores were obtained using a multiple corer and were analyzed mainly for ²¹⁰Pb, total pigments, and macrofauna abundance. The ²¹⁰Pb inventories and fluxes were estimated for surface sediments (0-5 cm) and bioturbation coefficients were inferred using chlorophyll-a (reactive) profiles. In general, ²¹⁰Pb content was inversely correlated with phytodetritus fluxes. High photosynthetic pigment contents in surface sediments were consistently associated with lower ²¹⁰Pb contents. Macrofaunal activity responded to oxygen and organic matter supplies at the sediment surface, generally concentrated in the first centimeters, but particularly so during months of high organic matter fluxes and deficient bottom water oxygen conditions. At this study site, several processes involved in the ²¹⁰Pb surface distribution make it difficult to accurately estimate ages at the surface. We postulate that the organic fluxes promote changes in the faunal activity, which, in combination with sediment resuspension and water circulation over the shelf, produce seasonal variations in the ²¹⁰Pb inventories.     

Measuring and modelling temporal trends of 226Ra in waters of a Spanish estuary affected by the phosphate industry

The presence and temporal evolution (1990-2001) of (226)Ra in a tidal estuary affected by the phosphate industry has been investigated. Water samples collected in the course of four separate sampling campaigns were analysed for (226)Ra content using a gas flow proportional counter following Ba coprecipitation. Two (226)Ra sources have been identified: direct discharges from the industrial complex and run-off from a phosphogypsum pile. Although activity levels are similar, or even higher, than those found in other environments affected by the phosphate industry, there has been a general decrease in contamination since direct discharges ceased in 1998 due to new regulations from the EU. However, sediments are now acting as a source of Ra to the water column due to redissolution processes. A numerical model of the estuary has been developed to describe quantitatively the experimental results. The model solves the hydrodynamics and the dispersion equation of (226)Ra including interactions with sediments. Model results are, in general, in good agreement with observations.