Experimental study on loss factor for corrugated plates by bandwidth method

The material loss factor for technically orthotropic plates was measured by half-power bandwidth method. Rectangular and trapezoidal corrugated plates of steel were considered. A simple isotropic steel plate was also considered for comparison of the results. The concept of single degree of freedom system was adopted. The tests were undertaken at very low frequency range (0–100) Hz. The plate models were suspended freely with two wires to minimize or prevent excessive extraneous energy dissipation. Out of plane point force, random in nature was applied to the top middle of the plates and the responses were measured from the middle point of the plates by FFT analyzer using miniature small mass accelerometer as sensor. The aim of these tests is to investigate the effects of bending rigidity and mode orders over material loss factor. The values of estimated modal damping loss factors are compared and tabulated for the plates models considered. Natural frequencies of some of the initial modes of the plates are also presented.It is observed that the higher the value of bending rigidity of the plates, the larger the values of loss factor of it. There was a significant increase in value of loss factor in corrugated plates to that of the isotropic plate.     

Metamorphic and deformational imprint of Cambrian–Lower Ordovician rifting in the Ossa-Morena Zone (Iberian Massif, Spain)

The high-temperature metamorphism recorded in the Valuengo and Monesterio areas constitutes a rare occurrence in the Ossa-Morena Zone of Southwest Iberia, where low-grade metamorphism dominates. The metamorphism of the Valuengo area has been previously considered either Cadomian or Variscan in age, whereas that of Monesterio has been interpreted as a Cadomian imprint. However, these areas share important metamorphic and structural features that point towards a common tectonometamorphic evolution. The metamorphism of the Valuengo and Monesterio areas affects Late Proterozoic and Early Cambrian rocks, and is syn-kinematic with a top-to-the-north mylonitic foliation, which was subsequently deformed by early Variscan folds and thrusts. The U–Pb zircon age (480±7 Ma) we have obtained for an undeformed granite of the Valuengo area is consistent with our geological observations constraining the age of the metamorphism. We propose that this high-temperature metamorphic imprint along a NW–SE ductile extensional shear zone is related to the crustal extension that occurred in the Ossa-Morena Zone during the Cambro-Ordovician rifting. In the same way, the tectonothermal effect of the preorogenic rifting stage may have been wrongly attributed to orogenic processes in other regions as well as in this one.     

Assessment of pollution sources in the southeastern of the Riyadh and its impact on the population/Saudi Arabia

The rapid growth of Riyadh—capital of Saudi Arabia—is pushing the area to more pollution and incentive for reorganization. The aim of this research is to assess air pollutants in southeast of Riyadh and detect opinion of the population about their environment. The assessment was done by analyzing 405 questionnaires, evaluating thermal band of Landsat 8, and spatial analyzing of particular matter and chemicals in 19 air samples by geostatistical tool in the ArcMap. Most of the inhabitants stated that they are suffering from bad odor, sewage leakage, and dust mainly from a cement factory. The thermal band of Landsat clarified the location of the pollution sources mainly the 1st industrial city, Yammama Cement Factory, and power plant in Farouq area. The ordinary kriging maps showed that the highest concentration of PM₁₀ (>403 μg/m³) lied to the northern and western side of the study area and caused a health issue to most inhabitants.     

Late Cretaceous–Early Paleogene tectonic events at Farafra-Abu Minqar Stretch,Western Desert,Egypt: results from calcareous plankton

This work depends on integrated high-resolution calcareous plankton nannofossil and foraminiferal biostratigraphic analyses for three Upper Cretaceous-Lower Paleogene successions at Farafra-Abu Minqar area, Western Desert, Egypt. These sections are distributed in a north-south geologic profile as follows: El Aqabat, North Gunna, and Abu Minqar. Lithostratigraphically, four formations are recorded in the study area, namely, Khoman (at base), Dakhla, Tarawan, and Esna (at top). In the north at El Aqabat section, Khoman Formation (carbonate facies) is only represented which changes partially toward the south to Dakhla Formation (siliciclastic facies). In the extreme south at Abu Minqar section, it changes completely into siliciclastic facies of Dakhla Formation. Biostratigraphically, seven calcareous nannofossil and eleven planktonic foraminiferal zones represent the Late Cretaceous-Early Paleogene are identified. Based on the occurrence or missing of these zones accompanied with the field criteria resulted in detecting four tectonic events. These tectonic events took place at the Cretaceous/Paleogene (K/Pg), the Danian/Selandian (D/S), the Selandian/Thanetian (S/T), and the Paleocene/Eocene (P/E) boundaries. These tectonic events are related to the impact of the Syrian Arc System. Four sequence boundaries (SB1, SB2, SB3, and SB4) are defined in the Late Cretaceous-Early Paleogene sequence in the Farafra-Abu Minqar area.     

Determining the hard rock groundwater pathway in Golgohar complex formation using hydrochemical data in AHP

Thirty percent of present industrial water consumption of the Golgohar Iron Ore Mine (GIOM) is supplied from a hard rock well (PW-A15) and the rest from 25 wells located in 4 disconnected alluvial aquifers. This well is drilled in the metamorphic complex of Golgohar formation. Attempts have been made to develop extraction of water from other hard rocks existing in the area with no success. Therefore, extensive researches have been carried out to find the pathway, or a provision pathway of water discharged from this well. To study the hydrochemical similarity of this water with other water resources, 122 water samples from an area of 7132 km² were collected from the existing pumping wells, piezometers, mine exploration bore holes, and three salt pans in the vicinity of the area for hydrochemical analysis. The analyses were performed for concentration of major ions and some minor elements. Furthermore, the spatial distribution of ion concentration was plotted in the GIS to delineate the similarity of the PW-A15 water with other water sources and their hydrochemical neighborhood by analytical hierarchy process (AHP). The AHP was performed in two steps: first, iso-concentration maps of seven major ions, eight minor elements, and TDS were used to produce an AHP map (Map1) using weights for different hydrochemical parameters; and second, a similarity index (SI) map was prepared by performing a suggested clustering approach in SPSS using K-means clustering, which was overlaid on Map1 producing Map2. The result of AHP Map2 was then overlaid on the iso-potential map of the sampled locations in GIS software using a mask operator. Therefore, the zones having the most similarity and higher hydraulic potential than PW-A15 were nominated as the zones which possibly could recharge this well, and the groundwater (GW) pathway was proposed. The result of the study method showed to be successful and will be used as a guide for future exploration drillings.     

The effects of integrals on the totality of solutions of dynamical systems

Regions of possible motions are established for dynamical systems possessing time-independent Hamiltonians or for systems which are reducible to that form by means of integrals of the motion using only extended point transformations. The method is applied to the problem of three bodies in a plane and surfaces of zero velocity are found. The governing parameters are the energy, angular momentum and the masses of the participating bodies. The analytical and geometrical properties of these surfaces provide qualitative results for given constants of the motion.     

A 48-kyr-long slip rate history for the Jordan Valley segment of the Dead Sea Fault

We investigate the late Quaternary active deformation along the Jordan Valley segment of the left-lateral Dead Sea Fault and provide new insights on the behaviour of major continental faults. The 110-km-long fault segment shows systematic offsets of drainage systems surveyed at three sites along its southern section. The isotopic dating of six paleoclimatic events yields a precise chronology for the onset of six generations of gully incisions at 47.5 ka BP, 37.5 ka BP, 13 ka BP, 9 ka BP, 7 ka BP, and 5 ka BP. Additionally, detailed mapping and reconstructions provide cumulative displacements for 20 dated incisions along the fault trace. The individual amounts of cumulative slip consistently fall into six distinct classes. This yields: i) an average constant slip rate of 4.7 to 5.1 mm/yr for the last 47.5 kyr and ii) a variable slip rate ranging from 3.5 mm/yr to 11 mm/yr over 2-kyr- to 24-kyr-long intervals. Taking into account that the last large earthquake occurred in AD 1033, we infer 3.5 to 5 m of present-day slip deficit which corresponds to a Mw  7.4 earthquake along the Jordan Valley fault segment. The timing of cumulative offsets reveals slip rate variations critical to our understanding of the slip deficit and seismic cycle along major continental faults.