On the use of horizontal acoustic Doppler profilers for continuous bed shear stress monitoring

Continuous monitoring of bed shear stress in large river systems may serve to better estimate alluvial sediment transport to the coastal ocean.Here we explore the possibility of using a horizontally deployed acoustic Doppler current profiler(ADCP) to monitor bed shear stress,applying a prescribed boundary layer model,previously used for discharge estimation.The model parameters include the local roughness length and a dip correction factor to account for sidewall effects.Both these parameters depend on river stage and on the position in the cross-section, and were estimated from shipborne ADCP data.We applied the calibrated boundary layer model to obtain bed shear stress estimates over the measuring range of the HADCP.To validate the results,co-located coupled ADCPs were used to infer bed shear stress,both from Reynolds stress profiles and from mean velocity profiles. From HADCP data collected over a period of 1.5 years,a time series of width profiles of bed shear stress was obtained for a tidal reach of the Mahakam River,East Kalimantan,Indonesia.A smaller dataset covering 25 hours was used for comparison with results from the coupled ADCPs.The bed shear stress estimates derived from Reynolds stress profiles appeared to be strongly affected by local effects causing upflow and downflow,which are not included in the boundary layer model used to derive bed shear stress with the horizontal ADCP.Bed shear stresses from the coupled ADCP are representative of a much more localized flow,while those derived with the horizontal ADCP resemble the net effect of the flow over larger scales.Bed shear stresses obtained from mean velocity profiles from the coupled ADCPs show a good agreement between the two methods,and highlight the robustness of the method to uncertainty in the estimates of the roughness length.     

Towards a Better Understanding of the Fibrolite Problem: the Effect of Reaction Overstepping and Surface Energy Anisotropy

Trachytes from the Euganean Hills District (Italy) contain metapeliticxenoliths that have been pyrometamorphosed during incorporationin the melt. In xenoliths containing sillimanite crystallizedduring a previous regional HT/LP metamorphism, fibrolite systematicallynucleates at the grain boundaries of sillimanite prisms andwithin plagioclase crystals. Ternary feldspar thermometry showsthat plagioclase in contact with sillimanite plots along the750°C solvus that reflects near-equilibrium conditions ofregional metamorphism. Plagioclase containing fibrolite plotscloser towards the 950°C solvus, reflecting the tendencyof plagioclase to re-equilibrate at high temperature duringpyrometamorphism by a fibrolite-forming reaction:     

The effects of ferromagnesian components on the paragonite-muscovite solvus: a semiquantitative analysis based on chemical data for natural paragonite-muscovite pairs

Chemical data for 139 natural paragonite-muscovite (Pg-Ms) pairs illustrate the effects of ferromagnesian components on the P-T-X topology of the Pg-Ms solvus. The pairs were selected on the basis of: reasonably accurate knowledge of the P-T conditions of formation; evidence for close approach to equilibrium at peak metamorphic conditions; exclusion of pairs in which paragonite contains more than 5 mol% margarite; and exclusion of pairs from polymetamorphic rocks that contain more than one set of cogenetic Pg-Ms pairs. Graphical analysis reveals considerable scatter in the data; nevertheless, it is evident that the muscovite limb of the solvus shifts markedly toward end-member muscovite with increasing pressure from approximately 7 kbar to 21 kbar. This shift is attributed to a pressure-induced increase of the ferromagnesian content of muscovite, which increases the size of the XII alkali site - to the effect that K is more readily accommodated than Na. The data also suggest that the paragonite limb of the solvus migrates slightly toward end-member paragonite with increasing pressure. Broadening of the Pg-Ms solvus with increasing pressure reflects increasingly nonideal Na-K mixing as the phengite content of muscovite increases. Due to the wide scatter of data for Pg-phengitic-Ms pairs, it is concluded that, at the present time, Pg-Ms solvus thermometry is only viable for quasibinary Pg-Ms pairs.