排序方式: 共有23条查询结果,搜索用时 31 毫秒
1.
Crustal and upper mantle seismic structure of the Australian Plate, South Island, New Zealand 总被引:7,自引:0,他引:7
Anne Melhuish W. Steven Holbrook Fred Davey David A. Okaya Tim Stern 《Tectonophysics》2005,395(1-2):113-135
Seismic reflection and refraction data were collected west of New Zealand's South Island parallel to the Pacific–Australian Plate boundary. The obliquely convergent plate boundary is marked at the surface by the Alpine Fault, which juxtaposes continental crust of each plate. The data are used to study the crustal and uppermost mantle structure and provide a link between other seismic transects which cross the plate boundary. Arrival times of wide-angle reflected and refracted events from 13 recording stations are used to construct a 380-km long crustal velocity model. The model shows that, beneath a 2–4-km thick sedimentary veneer, the crust consists of two layers. The upper layer velocities increase from 5.4–5.9 km/s at the top of the layer to 6.3 km/s at the base of the layer. The base of the layer is mainly about 20 km deep but deepens to 25 km at its southern end. The lower layer velocities range from 6.3 to 7.1 km/s, and are commonly around 6.5 km/s at the top of the layer and 6.7 km/s at the base. Beneath the lower layer, the model has velocities of 8.2–8.5 km/s, typical of mantle material. The Mohorovicic discontinuity (Moho) therefore lies at the base of the second layer. It is at a depth of around 30 km but shallows over the south–central third of the profile to about 26 km, possibly associated with a southwest dipping detachment fault. The high, variable sub-Moho velocities of 8.2 km/s to 8.5 km/s are inferred to result from strong upper mantle anisotropy. Multichannel seismic reflection data cover about 220 km of the southern part of the modelled section. Beneath the well-layered Oligocene to recent sedimentary section, the crustal section is broadly divided into two zones, which correspond to the two layers of the velocity model. The upper layer (down to about 7–9 s two-way travel time) has few reflections. The lower layer (down to about 11 s two-way time) contains many strong, subparallel reflections. The base of this reflective zone is the Moho. Bi-vergent dipping reflective zones within this lower crustal layer are interpreted as interwedging structures common in areas of crustal shortening. These structures and the strong northeast dipping reflections beneath the Moho towards the north end of the (MCS) line are interpreted to be caused by Paleozoic north-dipping subduction and terrane collision at the margin of Gondwana. Deeper mantle reflections with variable dip are observed on the wide-angle gathers. Travel-time modelling of these events by ray-tracing through the established velocity model indicates depths of 50–110 km for these events. They show little coherence in dip and may be caused side-swipe from the adjacent crustal root under the Southern Alps or from the upper mantle density anomalies inferred from teleseismic data under the crustal root. 相似文献
2.
3.
4.
Selahattin Kadir A. Piril Önen-Hall S. Nihal Aydin Cengiz Yakicier Nurten Akarsu Murat Tuncer 《Environmental Geology》2008,54(2):391-409
The Cretaceous-Eocene volcano-sedimentary units of the Zonguldak region of the western Black Sea consist of subalkaline andesite
and tuff, and sandstone dominated by smectite, kaolinite, accessory chlorite, illite, mordenite, and analcime associated with
feldspar, quartz, opal-CT, amphibole, and calcite. Kaolinization, chloritization, sericitization, albitization, Fe–Ti-oxidation,
and the presence of zeolite, epidote, and illite in andesitic rocks and tuffaceous materials developed as a result of the
degradation of a glass shards matrix, enclosed feldspar, and clinopyroxene-type phenocrysts, due to alteration processes.
The association of feldspar and glass with smectite and kaolinite, and the suborientation of feldspar-edged, subparallel kaolinite
plates to fracture axes may exhibit an authigenic smectite or kaolinite. Increased alteration degree upward in which Al, Fe,
and Ti are gained, and Si, Na, K, and Ca are depleted, is due to the alteration following possible diagenesis and hydrothermal
activities. Micromorphologically, fibrous mordenite in the altered units and the presence of needle-type chrysotile in the
residential buildings in which cancer cases lived were detected. In addition, the segregation pattern of cancer susceptibility
in the region strongly suggested an environmental effect and a genetic influence on the increased cancer incidence in the
region. The most likely diagnosis was Li-Fraumeni syndrome, which is one of the hereditary cancer predisposition syndromes;
however, no mutations were observed in the p53 gene, which is the major cause of Li-Fraumeni syndrome. The micromorphology
observed in the altered units in which cancer cases were detected may have a role in the expression of an unidentified gene,
but does not explain alone the occurrence of cancer as a primary cause in the region. 相似文献
5.
6.
7.
8.
9.
Robert Graves Thomas H. Jordan Scott Callaghan Ewa Deelman Edward Field Gideon Juve Carl Kesselman Philip Maechling Gaurang Mehta Kevin Milner David Okaya Patrick Small Karan Vahi 《Pure and Applied Geophysics》2011,168(3-4):367-381
CyberShake, as part of the Southern California Earthquake Center??s (SCEC) Community Modeling Environment, is developing a methodology that explicitly incorporates deterministic source and wave propagation effects within seismic hazard calculations through the use of physics-based 3D ground motion simulations. To calculate a waveform-based seismic hazard estimate for a site of interest, we begin with Uniform California Earthquake Rupture Forecast, Version 2.0 (UCERF2.0) and identify all ruptures within 200?km of the site of interest. We convert the UCERF2.0 rupture definition into multiple rupture variations with differing hypocenter locations and slip distributions, resulting in about 415,000 rupture variations per site. Strain Green Tensors are calculated for the site of interest using the SCEC Community Velocity Model, Version 4 (CVM4), and then, using reciprocity, we calculate synthetic seismograms for each rupture variation. Peak intensity measures are then extracted from these synthetics and combined with the original rupture probabilities to produce probabilistic seismic hazard curves for the site. Being explicitly site-based, CyberShake directly samples the ground motion variability at that site over many earthquake cycles (i.e., rupture scenarios) and alleviates the need for the ergodic assumption that is implicitly included in traditional empirically based calculations. Thus far, we have simulated ruptures at over 200 sites in the Los Angeles region for ground shaking periods of 2?s and longer, providing the basis for the first generation CyberShake hazard maps. Our results indicate that the combination of rupture directivity and basin response effects can lead to an increase in the hazard level for some sites, relative to that given by a conventional Ground Motion Prediction Equation (GMPE). Additionally, and perhaps more importantly, we find that the physics-based hazard results are much more sensitive to the assumed magnitude-area relations and magnitude uncertainty estimates used in the definition of the ruptures than is found in the traditional GMPE approach. This reinforces the need for continued development of a better understanding of earthquake source characterization and the constitutive relations that govern the earthquake rupture process. 相似文献
10.
Seventeen coudé spectrograms (dispersion 20 A mm–1) of the Lyrae-type eclipsing binary V 367 Cygni (P=18.6 d) have been studied. The observations were made at the Haute Provence Observatory during a period of almost two years (May 1973–March 1975). An anomalous behavior for the radial velocities of the spectrograms taken during one cycle (406) was observed; it is suggested that gas eruption under form of prominences may explain it. The spectrum is dominated by shell lines very similar to those present in the spectrum of the supergiant A9 Ia Aurigae. The underlying stellar spectrum is classified as A5 I on the basis of the intensity of the sole clearly visible stellar line, 4481 MgII, of the wings of the stellar Balmer lines, and an estimate of the intensity of the stellarK line. The radial velocity curves for the shell lines of CaII, HI, metallic ions and neutral iron, as well as the phase dependence of the microturbulence, indicate stratification in the shell. 相似文献