Influence of the Load Wavelength on the Permeability of a Viscosity Interface in the Mantle

Assuming a radially stratified Newtonian mantle in a steady-state approximation, we demonstrate that the permeability of a viscosity interface at 660-km depth strongly depends on the wavelength of buoyancy forces driving the flow. The flow induced by long-wavelength loads penetrates through the boundary freely even if the viscosity increases by two orders. In contrast, the boundary is practically impermeable for short-wavelength loads located in the upper mantle. Thus, a stepwise increase of viscosity is a significant obstacle for small descending features in the upper mantle, but huge upper mantle downwellings, or upwellings formed in the-lower mantle can overcome it easily. This indicates that certain care is necessary in interpreting the seismic structure of the mantle by means of flow models. The global tomographic image includes only the first few degrees of the harmonic series and, consequently, its interpretation in terms of a present-day flow field results in a predominantly whole-mantle circulation even for extreme viscosity contrasts.     

A comprehensive model inter-comparison study investigating the water budget during the BALTEX-PIDCAP period

Summary A comparison of 8 regional atmospheric model systems was carried out for a three-month late summer/early autumn period in 1995 over the Baltic Sea and its catchment area. All models were configured on a common grid using similar surface and lateral boundary conditions, and ran in either data assimilation mode (short term forecasts plus data assimilation), forecast mode (short term forecasts initialised daily with analyses) or climate mode (no re-initialisation of model interior during entire simulation period). Model results presented in this paper were generally post processed as daily averaged quantities, separate for land and sea areas when relevant. Post processed output was compared against available analyses or observations of cloud cover, precipitation, vertically integrated atmospheric specific humidity, runoff, surface radiation and near surface synoptic observations. The definition of a common grid and lateral forcing resulted in a high degree of agreement among the participating model results for most cases. Models operated in climate mode generally displayed slightly larger deviations from the observations than the data assimilation or forecast mode integration, but in all cases synoptic events were well captured. Correspondence to near surface synoptic quantities was good. Significant disagreement between model results was shown in particular for cloud cover and the radiative properties, average precipitation and runoff. Problems with choosing appropriate initial soil moisture conditions from a common initial soil moisture field resulted in a wide range of evaporation and sensible heat flux values during the first few weeks of the simulations, but better agreement was shown at later times. Received September 8, 2000 Revised April 3, 2001     

Iron-hydroxide clogging of public supply wells receiving artificial recharge: near-well and in-well hydrological and hydrochemical observations

Clogging of water wells by iron-hydroxide incrustations due to mixing of anoxic and oxic groundwater is a common well-ageing problem. The relation between well operation (on and off), the spatial and temporal variations in hydrochemistry outside and inside a supply well, and the distribution of clogging iron-hydroxides were studied in an artificial recharge well field in the Netherlands. Camera inspection, high-resolution multi-level water sampling outside the well and detailed in-well pH/EC/O₂ profiles revealed remarkable patterns. During pumping, the top of the upper well screen abstracted oxic filtrate, although the larger part of the in-well water column was anoxic. The column rapidly turned oxic after shutdown due to a downward short-circuiting of oxic water via the well. Within 15 d it became anoxic due to the slow advance of anoxic lake filtrate created by local changes in flow direction as the neighboring wells continued to pump. Severe clogging occurred where the oxic filtrate entered the well, while half-clogging of the upper well screen occurred due to less inflow of oxic filtrate on the lake side. Transport of iron flocs and bacterial slimes after shutdown seemed to clog the lower part of the well screen. Frequent on/off switching should be avoided in iron-clogged wells.     

Fluid inclusion and cathodoluminescence studies on fluorite from the Kerio valley, Kenya

The Kerio valley lies between the Elgeyo escarpment and the Tugen hills which mark the western margin of the Kenya rift valley. The main fluorite deposits are located in the southern part of the valley at Kimwarer, Choff and Kamnaon.Three types of inclusion fillings were identified: Liquid+Vapour, Liquid+Daughter Minerals and Liquid. The L+V type is dominant. Inclusions occur as clusters, trails along the crystal growth zones and as isolated ones. Low salinities, apparently lower than the 5% wt. NaCl equivalent, were established. Homogenization temperatures suggest that fluorite mineralization took place at different stages and at temperatures between 120 and 180 °C. Isolated readings above 180°C may be referring to the original inclusions in limestone. These measurements and the absence of CO₂ in the inclusions, as well as the occurrence of vugs and crustifications with fluorite, suggest that mineralization took place at relatively shallow depths.Emission spectrum lines representing Eu²⁺, Dy³⁺, Tb³⁺ and Sm³⁺ in fluorite were identified. Sm³⁺ was detected only in the pinkish luminescence of veined fluorite, whereas the pinkish zone in banded fluorite contains Tb³⁺. Eu²⁺ which gives the strongest emission lines in the blue part of the visible spectrum, apparently is responsible for the strong blue cathodoluminescence (CL) in fluorite. The dominance of Eu²⁺ peaks further points to the fact that fluorite mineralization in the Kerio valley took place in an environment that was enriched in Lanthanide Rare Earth Elements (LREE). The presence of rare earths and radioactive elements in fluorite points towards their enrichment in the environment of fluorite mineralization. A juvenile origin of mineral forming solutions is proposed.Two generations of fluorite were established: allotriomorphic fluorite, forming the matrix, and the idiomorphic variety, occurring either in barite or in druzes in early fluorite. Barite in turn forms idiomorphic crystals in allotriomorphic fluorite. Relics of calcite occur in both K-feldspars and in early fluorite. Oxides and hydroxides of Fe, Mn, Ti and Al commonly occur in open spaces in fluorite. Of significance is the presence of gold in fluorite. Fluorite mineralization is of hydrothermal origin in the post-Miocene era and was formed as a result of metasomatic replacement of marble and open space fillings.     

Transient release of Ni,Mn and Fe from mixed metal sulphides under oxidising and reducing conditions

The potential release of metals from anoxic sediments exposed to oxygen was investigated by using a synthetic preparation of metal sulphides dominated by solid phase FeS. The technique of DGT (diffusive gradients in thin-films) was used to measure sulphide and Fe, Mn and Ni in the anoxic metal-sulphide slurry, which had a pH of 6.4. Speciation calculations based on these data showed there was moderate supersaturation with respect to amorphous FeS in the solution phase. Measurements made using DGT with a range of diffusion layer thicknesses showed that when Fe, Mn and Ni are removed from solution there is fairly rapid (minutes) release from the solid phase, that is reasonably well sustained. This presumed desorptive release will be responsible for elevated concentrations of some metals in solution when sediments are resuspended. Oxidation of the slurry by bubbling with air rapidly (hours) removed Fe, Mn and Ni from the pore water solution. While Fe concentrations in solution remained low after the removal, Mn and Ni were transiently released. These results were consistent with initial rapid oxidation of Fe(II) to oxyhydroxides, which remove Mn(II) and Ni by adsorption. The slower oxidation of FeS then releases Mn and Ni, but these too are eventually removed by adsorption to iron oxyhydroxides. These data suggest that oxidation of metal sulphides will contribute to the release of metals from sediment disturbed by dredging or remedial aeration, but it is likely to be short lived, with complete removal within a day.     

Denudation and cooling of the Lake Teletskoye Region in the Altai Mountains (South Siberia) as revealed by apatite fission-track thermochronology

Lake Teletskoye occupies a narrow graben located in the northwestern sector of the Altai fold belt in South Siberia. The lake basin is thought to have formed during the Pleistocene as a distant result of the Cenozoic collision of India and Eurasia that caused a tectonic reactivation of the Palaeozoic Gorny–Altai (GA) and West Sayan (WS) blocks.The present work reports of a pilot fission-track study performed on 13 apatite separates collected from rocks that were sampled along two profiles in close proximity of the lake. The age–length data and AFT thermochronological modelling reveal two important phases of cooling in the Altai Mountains, a first one during the Late Jurassic–Early Cretaceous and a second one that started in the Miocene–Pliocene and that persists until today. The first event is interpreted to result from uplift-induced denudation probably related to the closure of the Mongol–Okhotsk Ocean; the second event can be linked to the young Cenozoic movements that lie at the origin of the formation of the Lake Teletskoye basin.     

Evidence for compressionally induced high subsidence rates in the Kurile Basin (Okhotsk Sea)

A combined volcanological, geochemical, paleo-oceanological, geochronological and geophysical study was undertaken on the Kurile Basin, in order to constrain the origin and evolution of this basin. Very high rates of subsidence were determined for the northeastern floor and margin of the Kurile Basin. Dredged volcanic samples from the Geophysicist Seamount, which were formed under subaerial or shallow water conditions but are presently located at depths in excess of 2300 m, were dated at 0.84±0.06 and 1.07±0.04 Ma with the laser ⁴⁰Ar/³⁹Ar single crystal method, yielding a minimum average subsidence rate of 1.6 mm/year for the northeast basin floor in the Quaternary. Trace element and Sr–Nd–Pb isotope data from the volcanic rocks show evidence for contamination within lower continental crust and/or the subcontinental lithospheric mantle, indicating that the basement presently at 6-km depth is likely to represent thinned continental crust. Average subsidence rates of 0.5–2.0 mm/year were estimated for the northeastern slope of the Kurile Basin during the Pliocene and Quaternary through the determination of the age and paleo-environment (depth) of formation of sediments from a canyon wall. Taken together, the data from the northeastern part of the Kurile Basin indicate that subsidence began in or prior to the Early Pliocene and that subsidence rates have increased in the Quaternary. Similar rates of subsidence have been obtained from published studies on the Sakhalin Shelf and Slope and from volcanoes in the rear of the Kurile Arc. The recent stress field of the Kurile Basin is inferred from the analysis of seismic activity, focal mechanism solutions and from the structure of the sedimentary cover and of the Alaid back-arc volcano. Integration of these results suggests that compression is responsible for the rapid subsidence of the Kurile Basin and that subsidence may be an important step in the transition from basin formation to its destruction. The compression of the Kurile Basin results from squeezing of the Okhotsk Plate between four major plates: the Pacific, North American, Eurasian and Amur. We predict that continued compression could lead to subduction of the Kurile Basin floor beneath Hokkaido and the Kurile Arc in the future and thus to basin closure.     

A search for soft X-ray emission from stellar sources

With the soft X-ray detector (0.2–0.284 keV) aboard the Astronomical Netherlands Satellite (ANS) we have searched for X-ray emission from hot star coronae and peculiar stars. On Sirius ( CMa) and Capella ( Aur) X-ray emission has been measured at 6 and 5 level, respectively, above background. In all other cases the search revealed no evidence for soft X-ray emission. Upper limits to the luminosities of about 25 star coronae (main-sequence stars, (sub)giants, and supergiants) and of 4 peculiar stars ( Sco, Lyr, P Cyg, and Car) have been obtained.Paper presented at the COSPAR/IAU Symposium on Fast Transients in X-and Gamma-Rays, held at Varna, Bulgaria, 29–31 May, 1975.