Stability of Temperature and Conductivity Sensors of Argo Profiling Floats

After recalibration of the temperature and conductivity sensors of three Argo profiling floats recovered after operations for four to nine months, the results indicate that the floats basically showed no significant drift, either in temperature or salinity, and adequately fulfilled the accuracy requirement of the Argo project (0.005°C for temperature and 0.01 psu for salinity). Only the third float showed a significant offset in salinity of about −0.02 psu, as expected from comparison between the float data and the shipboard conductivity-temperature-depth data. This offset was caused by the operational error of the PROVOR-type float, in which the surface water was pumped immediately after the launch, fouling the conductivity sensor cell. This revised version was published online in July 2006 with corrections to the Cover Date.     

Validity of sea surface temperature observed with the TRITON buoy under diurnal heating conditions

In order to investigate the validity of buoy-observed sea surface temperature (SST), we installed special instruments to measure near-surface ocean temperature on the TRITON buoy moored at 2.07°N, 138.06°E from 2 to 13 March 2004, in addition to a standard buoy sensor for the regular SST measurement at 1.5-m depth. Large diurnal SST variations were observed during this period, and the variations of the temperatures at about 0.3-m depth could be approximately simulated by a one-dimensional numerical model. However, there was a notable discrepancy between the buoy-observed 1.5-m-depth SST (SST_1.5m) and the corresponding model-simulated temperature only during the daytime when the diurnal rise was large. The evaluation of the heat balance in the sea surface layer showed that the diurnal rise of the SST_1.5m in these cases could not be accounted for by solar heating alone. We examined the depth of the SST_1.5m sensor and the near-surface temperature observed from a ship near the buoy, and came to the conclusion that the solar heating of the buoy hull and/or a disturbance in the temperature field around the buoy hull would contribute to the excessive diurnal rise of the SST_1.5m observed with the TRITON buoy. However, the temperature around the hull was not sufficiently homogenized, as suggested in a previous paper. For the diurnal rise of the SST_1.5m exceeding 0.5 K, the daytime buoy data became doubtful, through dynamics that remain to be clarified. A simple formula is proposed to correct the unexpected diurnal amplitude of the buoy SST_1.5m.     

X-ray observation of the Jovian impacts of comet Shoemaker - Levy 9

An ASCA observation of the Jovian impact of the comet Shoemaker-Levy 9 is reported. Four impacts of H, L, Q1 and R were observed and four impacts of B, C, G, and Q2 were observed within 60 minutes after their impacts. No significant flaring of X-ray emission was observed. Upper limit X-ray fluxes of 90 % confidence level, averaged 5 minutes just after the impacts, were 2.4 × 10^–13 erg sec^–1 cm^–2, 3.5 × 10^–13 erg sec^–1 cm^–2, 1.6 × 10^–13 erg sec^–1 cm^–2 and 2.9 × 10^–13 erg sec^–1 cm^–2 for the impacts of H, L, Q1 and R, respectively, in the 0.5(0.7 for H and Q1)–10 keV energy range. However, a hint of X-ray enhancement around Jupiter from July 17 to July 19 was detected with about 2 6 × 10^–14 erg sec^–1 cm^–2 in the 0.5–10 keV energy range.     

灌溉后的黄土剪切特征变化

在中国甘肃省的黑方台阶地上从上世纪60年代开始出现人类定居和开垦活动,并自1968年发展为灌溉农业。随着灌溉的进行地面已出现沉陷和滑坡。地表沉陷是由灌溉水的充填引起黄土结构崩塌造成的。然而崩塌和湿润化对剪切特征的影响目前还不清楚。为了研究湿化后的黄土剪切特征的变化,进行了对马兰黄土未经扰动和重塑土样的直接剪切盒测试。结果显示未扰动土样的粘合力和内摩擦角在湿润化后都下降了,而所观察到的重塑土的弹度参数只有少许变化。未扰动土的不饱合粘合力,据认为其受胶结物质的影响,在饱合后消失了。经灌溉的土的不饱合强度参数与未灌溉土相比表现出差异,它们可能受土壤水分的强烈影响。     

Rare Earth, Major and Trace Elements in the Kunimiyama Ferromanganese Deposit in the Northern Chichibu Belt, Central Shikoku, Japan

Abstract. Rare earth, major and trace element geochemistry is reported for the Kunimiyama stratiform ferromanganese deposit in the Northern Chichibu Belt, central Shikoku, Japan. The deposit immediately overlies greenstones of mid-ocean ridge basalt (MORB) origin and underlies red chert. The ferromanganese ores exhibit remarkable enrichments in Fe, Mn, P, V, Co, Ni, Zn, Y and rare earth elements (excepting Ce) relative to continental crustal abundance. These enriched elements/ Fe ratios and Post-Archean Average Australian Shale-normalized REE patterns of the ferromanganese ores are generally analogous to those of modern hydrothermal ferromanganese plume fall-out precipitates deposited on MOR flanks. However in more detail, Mn and Ti enrichments in the ferromanganese ores are more striking than the modern counterpart, suggesting a significant contribution of hydrogenetic component in the Kunimiyama ores. Our results are consistent with the interpretation that the Kunimiyama ores were umber deposits that primarily formed by hydrothermal plume fall-out precipitation in the Panthalassa Ocean during the Early Permian and then accreted onto the proto-Japanese island arc during the Middle Jurassic. The presence of strong negative Ce anomaly in the Kunimiyama ores may indicate that the Early Permian Panthalassa seawater had a more striking negative Ce anomaly due to a more oxidizing oceanic condition than today.     

Assimilation and Fractional Crystallization Controlled by Transport Process of Crustal Melt: Implications from an Alkali Basalt-Dacite Suite from Rishiri Volcano, Japan

Mechanisms of fractional crystallization with simultaneous crustalassimilation (AFC) are examined for the Kutsugata and Tanetomilavas, an alkali basalt–dacite suite erupted sequentiallyfrom Rishiri Volcano, northern Japan. The major element variationswithin the suite can be explained by boundary layer fractionation;that is, mixing of a magma in the main part of the magma bodywith a fractionated interstitial melt transported from the mushyboundary layer at the floor. Systematic variations in SiO₂ correlatewith variations in the Pb, Sr and Nd isotopic compositions ofthe lavas. The geochemical variations of the lavas are explainedby a constant and relatively low ratio of assimilated mass tocrystallized mass (‘r value’). In the magma chamberin which the Kutsugata and Tanetomi magmas evolved, a strongthermal gradient was present and it is suggested that the marginalpart of the reservoir was completely solidified. The assimilantwas transported by crack flow from the partially fused floorcrust to the partially crystallized floor mush zone throughfractures in the solidified margin, formed mainly by thermalstresses resulting from cooling of the solidified margin andheating of the crust. The crustal melt was then mixed with thefractionated interstitial melt in the mushy zone, and the mixedmelt was further transported by compositional convection tothe main magma, causing its geochemical evolution to be characteristicof AFC. The volume flux of the assimilant from the crust tothe magma chamber is suggested to have decreased progressivelywith time (proportional to t^–1/2), and was about 3 x 10^–2m/year at t = 10 years and 1 x 10^–2 m/year at t = 100years. It has been commonly considered that the heat balancebetween magmas and the surrounding crust controls the couplingof assimilation and fractional crystallization processes (i.e.absolute value of r). However, it is inferred from this studythat the ratio of assimilated mass to crystallized mass canbe controlled by the transport process of the assimilant fromthe crust to magma chambers. KEY WORDS: assimilation and fractional crystallization; mass balance model; magma chamber; melt transport; Pb isotope     

Comparative assessment of Japan's long-term carbon budget under different effort-sharing principles

This article assesses Japan's carbon budgets up to 2100 in the global efforts to achieve the 2?°C target under different effort-sharing approaches based on long-term GHG mitigation scenarios published in 13 studies. The article also presents exemplary emission trajectories for Japan to stay within the calculated budget.

The literature data allow for an in-depth analysis of four effort-sharing categories. For a 450?ppm CO₂e stabilization level, the remaining carbon budgets for 2014–2100 were negative for the effort-sharing category that emphasizes historical responsibility and capability. For the other three, including the reference ‘Cost-effectiveness’ category, which showed the highest budget range among all categories, the calculated remaining budgets (20th and 80th percentile ranges) would run out in 21–29 years if the current emission levels were to continue. A 550?ppm CO₂e stabilization level increases the budgets by 6–17 years-equivalent of the current emissions, depending on the effort-sharing category. Exemplary emissions trajectories staying within the calculated budgets were also analysed for ‘Equality’, ‘Staged’ and ‘Cost-effectiveness’ categories. For a 450?ppm CO₂e stabilization level, Japan's GHG emissions would need to phase out sometime between 2045 and 2080, and the emission reductions in 2030 would be at least 16–29% below 1990 levels even for the most lenient ‘Cost-effectiveness’ category, and 29–36% for the ‘Equality’ category. The start year for accelerated emissions reductions and the emissions convergence level in the long term have major impact on the emissions reduction rates that need to be achieved, particularly in the case of smaller budgets.

Policy relevance

In previous climate mitigation target formulation processes for 2020 and 2030 in Japan, neither equity principles nor long-term management of cumulative GHG emissions was at the centre of discussion. This article quantitatively assesses how much more GHGs Japan can emit by 2100 to achieve the 2?°C target in light of different effort-sharing approaches, and how Japan's GHG emissions can be managed up to 2100. The long-term implications of recent energy policy developments following the Fukushima nuclear disaster for the calculated carbon budgets are also discussed.     

Internal Microanatomy and Zoological Affinity of the Early Cambrian Olivooides

The early Cambrian pentamerous microfossil Olivooides/Punctatus in South China, which is characterized by a diagnostic stellate tubular apex, has been well-known for its almost complete development sequence that can be confidently traced from embryos and hatched juveniles, to conical adults. However, its zoological affinity remains highly controversial. Here we describe the internal microanatomic structures of the soft-body inside the peridermal theca of Olivooides multisulcatus Qian, 1977, including interradial pairs of tentacles, adradial and perradial frenula, perradial oral marginal lappets and twins of perradial gastric saccule-like humps as well as a circular velarium with striated coronal muscles. Particularly, one specimen shows bifurcated velarial canals along the bell aperture. Both the components of the soft-body and the external theca (or cyst) are arranged in perfect pentaradial symmetry. These characteristics are more compatible with those of living cubomedusans and co-occurring Cambrian athecate embryonic cubozoans. Concerning the presence of peridermal theca, Olivooides most likely represents an extinct thecate stem-group cubomedusae but devoid of both perradial eyes and specialized pedalia. The well-grown soft body inside the peridermal tube displays a set of mixed features of both polyp and medusa.     

The effects of possible contamination by sample holders on samples to be returned by Hayabusa2

Chemical compositions of materials used for new sample holders (vertically aligned carbon nanotubes [VACNTs] and polyimide film), which were developed for the analysis of Hayabusa2‐return samples, were determined by instrumental neutron activation analysis and/or instrumental photon activation analysis, to estimate contamination effects from the sample holders. The synthetic quartz plate used for the sample holders was also analyzed. Ten elements (Na, Al, Cr, Mn, Fe, Ni, Eu, W, Au, and Th) and 14 elements (Na, Al, K, Sc, Ti, Cr, Zn, Ga, Br, Sb, La, Eu, Ir, and Au) could be detected in the VACNTs and polyimide film, respectively. The VACNT data show that contamination by this material with respect to the Murchison meteorite is negligible in terms of the elemental ratios (e.g., Fe/Mn, Na/Al, and Mn/Cr) used for the classification of meteorites due to the extremely low density of VACNTs. However, for the Au/Cr ratio, even small degrees (1.7 wt%) of contamination by VACNTs will change the Au/Cr ratio. Elemental ratios used for the classification of meteorites are only influenced by large amounts of contamination (>60 wt%) of polyimide film, which is unlikely to occur. In contrast, detectable effects on Ti isotopic compositions are caused by >0.1 and >0.3 wt% contamination by VACNTs and polyimide film, respectively, and Hf isotopic changes are caused by >0.1 wt% contamination by VACNTs. The new sample holders (VACNTs and polyimide film) are suitable for chemical classification of Hayabusa2‐return samples, because of their ease of use, applicability to multiple analytical instruments, and low contamination levels for most elements.