Influence of gold mine on groundwater quality (Efemçukuru, Izmir, Turkey)

. Currently, exploration of gold ores is under discussion in Turkey, without considering its adverse affect on the environment. Studying the adverse affect on environment is extremely important because significant civic activities are already taking place on the geological units that contain gold ore bodies in Turkey. Such an area is located at the southeast of Izmir City (Turkey), and approximately 2-km-long gold-bearing ore veins occur close to the Efemçukuru Village. The objective of this study was to describe the characteristics and seasonal variation of the groundwater chemistry and pollution of the aquifer in the ore deposit site, and to determine the impact of ore deposits on groundwater quality. The gold-bearing formation is highly weathered and fractured. The fractures in the geological units control the permeability and the depth of groundwater in the area. The concentrations of Al, Ag, Cu, Cd, Cr, Fe, Pb, Mn, Zn, Ni, and Sb were determined for four well samples and two stream waters for wet and dry seasons. The results showed that the concentrations of most of these elements were below the USA EPA (Environmental Protection Agency) limits; however, Pb and Cd concentrations are slightly above the limits. The results indicate that minerals in gold bodies do not dissolve although the weathering of formations is high. The low concentration of elements in groundwater and streams may be attributed to the high velocity of ground and surface water.     

Assessment of radioactive contaminants in by-products from Yatagan (Mugla, Turkey) coal-fired power plant

. Coal-burning power plants in Turkey produce large quantities of coal-related wastes, which are collected through the use of various systems. Coal ash is presently accumulating in Turkey at a rate in excess of 10 million tons (t) annually. Roughly 1% of this is being used in a variety of products such as concrete, aggregate in stabilizing roadways, etc. When coal is burned, loss of material results in an increased concentration of most radionuclides found in the waste material. The object of this study is to analyze radiochemical element concentration of coal, bottom ash, and fly ash, and to evaluate the gross radium isotope activities in groundwaters around Yatagan Thermal Power Plant. The results show that the waste disposal site near the thermal power plant contains a major enhancement of radioactivity.     

Earthquake swarms preceding the 2000 eruption of Miyakejima volcano, Japan

The first sign of magma accumulating beneath Miyakejima, an island volcano in the northern Izu islands, Japan, came at around 18:00 on 26 June 2000, when a swarm of earthquakes was detected by a volcano seismic network on the island. Earthquakes occurred initially beneath the southwest flank near the summit and gradually migrated west of the island, where a submarine eruption occurred the next morning. Earthquakes then migrated further to the northwest between Miyakejima and Kozushima, another volcanic island and developed to the most intense earthquake swarm ever observed in and around Japanese archipelago. To better image how the initial magma intrusion occurred, we relocated hypocenters by using a station-correction method and a double-difference method. The relocated epicenters are generally concentrated near the upper bound of dyke intrusions inferred from geodetic studies throughout the initial stages of the 2000 eruption at Miyakejima from 26 to 27 June 2000. As for seismic activity westward off Miyakejima in the morning on 27 June, hypocenters from both a nationwide seismic network that were relocated by the double-difference method, and those from the volcano seismic network relocated by the station-correction method, formed a very shallow cluster that ascended slowly with time as it propagated northwestward from Miyakejima. This suggests that the dykes have both a radial and upward component of movement.Editorial responsibility: S. Nakada, T. Druitt     

Projected climate change scenario over California by a regional ocean–atmosphere coupled model system

This study examines a future climate change scenario over California in a 10-km coupled regional downscaling system of the Regional Spectral Model for the atmosphere and the Regional Ocean Modeling System for the ocean forced by the global Community Climate System Model version 3.0 (CCSM3). In summer, the coupled and uncoupled downscaled experiments capture the warming trend of surface air temperature, consistent with the driving CCSM3 forcing. However, the surface warming change along the California coast is weaker in the coupled downscaled experiment than it is in the uncoupled downscaling. Atmospheric cooling due to upwelling along the coast commonly appears in both the present and future climates, but the effect of upwelling is not fully compensated for by the projected large-scale warming in the coupled downscaling experiment. The projected change of extreme warm events is quite different between the coupled and uncoupled downscaling experiments, with the former projecting a more moderate change. The projected future change in precipitation is not significantly different between coupled and uncoupled downscaling. Both the coupled and uncoupled downscaling integrations predict increased onshore sea breeze change in summer daytime and reduced offshore land breeze change in summer nighttime along the coast from the Bay area to Point Conception. Compared to the simulation of present climate, the coupled and uncoupled downscaling experiments predict 17.5 % and 27.5 % fewer Catalina eddy hours in future climate respectively.     

Resistivity of reservoir sandstones and organic rich shales on the Barents Shelf:Implications for interpreting CSEM data

Marine controlled source electromagnetic(CSEM)data have been utilized in the past decade during petroleum exploration of the Barents Shelf,particularly for de-risking the highly porous sandstone reservoirs of the Upper Triassic to Middle Jurassic Realgrunnen Subgroup.In this contribution we compare the resistivity response from CSEM data to resistivity from wireline logs in both water-and hydrocarbon-bearing wells.We show that there is a very good match between these types of data,particularly when reservoirs are shallow.CSEM data,however,only provide information on the subsurface resistivity.Careful,geology-driven interpretation of CSEM data is required to maximize the impact on exploration success.This is particularly important when quantifying the relative re-sistivity contribution of high-saturation hydrocarbon-bearing sandstone and that of the overlying cap rock.In the presented case the cap rock comprises predominantly organic rich Upper Jurassic-Early Cretaceous shales of the Hekkingen Formation(i.e.a regional source rock).The resistivity response of the reservoir and its cap rock become merged in CSEM data due to the transverse resistance equivalence principle.As a result of this,it is imperative to understand both the relative contributions from reservoir and cap rock,and the geological sig-nificance of any lateral resistivity variation in each of the units.In this contribution,we quantify the resistivity of organic rich mudstone,i.e.source rock,and reservoir sandstones,using 131 exploration boreholes from the Barents Shelf.The highest resistivity(＞10,000 Ωm)is evident in the hydrocarbon-bearing Realgrunnen Subgroup which is reported from 48 boreholes,43 of which are used for this study.Pay zone resistivity is primarily controlled by reservoir quality(i.e.porosity and shale fraction)and fluid phase(i.e.gas,oil and water saturation).In the investigated wells,the shale dominated Hekkingen Formation exhibits enhanced resistivity compared to the background(i.e.the underlying and overlying stratigraphy),though rarely exceeds 20Ωm.Marine mudstones typically show good correlation between measured organic richness and resistivity/sonic velocity log signatures.We conclude that the resistivity contribution to the CSEM response from hydrocarbon-bearing sandstones out-weighs that of the organic rich cap rocks.     

Pressure dependence on partition coefficients for trace elements between olivine and the coexisting melts

Partition coefficients between olivine and melt at upper mantle conditions, 3 to 14 GPa, have been determined for 27 trace elements (Li, Be, B, Na, Mg, Al, Si, P, K, Ca, Sc, Ti, V, Cr, Mn, Fe, Co, Ni, Cu, Rb, Sr, Y, Zr, Cs, Ba, La and Ce) using secondary-ion mass-spectrometry (SIMS) and electron-probe microanalysis (EPMA). The general pattern of olivine/melt partitioning on Onuma diagrams resembles those reported previously for natural systems. This agreement strongly supports the argument that partitioning is under structural control of olivine even at high pressure. The partition coefficients for mono- and tri-valent cations show significant pressure dependence, both becoming larger with pressure, and are strongly correlated with coupled substitution into cation sites in the olivine structure. The dominant type of trace element substitution for mono- and tri-valent cations into olivine changes gradually from (Si, Mg)↔(Al, Cr) at low pressure to (Si, Mg)↔(Al, Al) and (Mg, Mg)↔(Na, Al) at high pressure. The change in substitution type results in an increase in partition coefficients of Al and Na with pressure. An inverse correlation between the partition coefficients for divalent cations and pressure has been observed, especially for Ni, Co and Fe. The order of decreasing rate of partition coefficient with pressure correlates to strength of crystal field effect of the cation. The pressure dependence of olivine/melt partitioning can be attributed to the compression of cation polyhedra induced by pressure and the compensation of electrostatic valence by cation substitution. Received: March 6, 1997 / Revised, accepted: March 12, 1998     

Comparison of Near Coastal Significant Wave Height Measurements from SARAL/AltiKa with Wave Rider Buoys in the Indian Region

Significant Wave Height (SWH) measurement data from the AltiKa Radar Altimeter (RA) for the first 13 cycles of satellite coverage are compared with the SWH from Wave Rider Buoys (WRB) located at nine stations along the Indian coast to assess the performance of the altimeter over the coastal region. AltiKa SWH observations within a 30-minute interval and 50 km distance from WRBs are found to be over estimated by 6%, the Root Mean Square Error (RMSE) is 0.36 m, the Scatter Index (SI) is 26%, and the correlation coefficient (r) is 0.91. Relaxing the distance criteria by 50 km leads to increase in RMSE and deterioration of r to 0.89. There is a marked difference in the statistics on the comparison pairs pooled separately for the buoys near west and east coasts, with the latter showing RMSE error 26% more than the former. The method of Cressman weights adopted to correct for the errors arising out of the temporal and spatial differences in altimeter and buoy data comparison pairs resulted in reduction of RMSE by 5% and 25%, respectively, for the 30-minute and 50 km criteria and 4% and 56% for the 30-minute and 100 km criteria.     

A high-resolution ocean-atmosphere coupled downscaling of the present climate over California

A fully coupled regional ocean-atmosphere model system that consists of the regional spectral model and the regional ocean modeling system for atmosphere and ocean components, respectively, is applied to downscale the present climate (1985–1994) over California from a global simulation of the Community Climate System Model 3.0 (CCSM3). The horizontal resolution of the regional coupled modeling system is 10 km, while that of the CCSM3 is at a spectral truncation of T85 (approximately 1.4°). The effects of the coupling along the California coast in the boreal summer and winter are highlighted. Evaluation of the sea surface temperature (SST) and 2-m air temperature climatology shows that alleviation of the warm bias along the California coast in the global model output is clear in the regional coupled model run. The 10-m wind is also improved by reducing the northwesterly winds along the coast. The higher resolution coupling effect on the temperature and specific humidity is the largest near the surface, while the significant impact on the wind magnitude appears at a height of approximately 850-hPa heights. The frequency of the Catalina Eddy and its duration are increased by more than 60 % in the coupled downscaling, which is attributed to enhanced offshore sea-breeze. Our study indicates that coupling is vital to regional climate downscaling of mesoscale phenomena over coastal areas.