Crystal chemical significance of chemical zoning in dissakisite-(Ce)

Dissakisites from Trimouns dolomite mine, France, have two kinds of single crystals: chemical-zoned and homogeneous types. Back-scattered electron microprobe (BSE) images of these dissakisites reveal both Ca–Al rich dark zones and Fe-ΣREE rich bright zones. Crystal structures of three dark and two bright zones in a chemical-zoned dissakisite and of a homogeneous zone in unzoned dissakisite were refined to individual R indices (about 3.0–5.0%) based on 1,400 observed [|F ₀| > 4σF ₀] reflections measured with MoKα X-radiation using the single crystal diffractometer. The differences in brightness between their BSE images arise from those in coupled substitutions of the elements occupying A2 and M3 sites. The main reason for these differences is that ten-coordinated A2 polyhedra and M3 octahedra are directly linked through their shared edge, which creates a great potential for making this coupled substitution. This zoning indicates that formation of the whole zoned crystal, where each zone could be grown steadily with its crystallographic axes mutually parallel to each other, may be identified as autoepitaxy.     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

Detection of systematic errors in XBT data and their correction

Comparison experiment between XBT of T-7 probe and CTD was conducted at 15 stations in the sea area centered on 29°N, 135°E in December 1985. There were systematic errors in XBT temperature profiles in comparison with CTD temperature profiles. The main cause of errors was attributed to an error in the free-fall speed of the XBT probes which was provided by the XBT maker. A previous equation for depth correction proposed by Heinmilleret al. (1983) could not give effective correction for our data. A new equation between the probe depth and the elapsed time from landing of the probe on the water was obtained by the method of adjusting temperature gradients of XBT profiles to those of CTD profiles. This equation agreed with the theoretical result given by Seaver and Kuleshov (1982) much better than that of Heinmilleret al. (1983). Systematic errors due to a scatter of values of the reference resistance and variation of B-constant of thermistors used in XBT also seemed to exist. After an adjustment using the temperature difference between XBT and CTD in the mixed layer with depths of about 100 m, the standard deviation of temperature difference between XBT and CTD from the surface to the depth of 750 m was 0.14°C.     

Contamination of organotin compounds and imposex in molluscs from Vancouver,Canada

Gastropods and bivalves were collected at 15 sites at Vancouver and Victoria, Canada between 24 May and 7 June, 1999, to establish tissue concentrations of butyltin and phenyltin compounds, to record imposex symptoms in gastropods, and to assess the present status of organotin contamination around Vancouver. No neogastropods (such as Nucella lima) were found around Vancouver. Neogastropod populations could have been extirpated by severe TBT contamination in Vancouver, as relatively high concentrations of TBT were detected in tissues of Mytilus trossulus from Vancouver, and the neogastropods distributed in Vancouver might be sensitive to TBT. Recovery from imposex, however, was observed in neogastropod populations from three sites at Victoria and Mission Point. TBT contamination has continued around Vancouver, arising from continuous use of TBT in antifouling paints for vessels larger than 25 m in length; however, TBT has decreased around Victoria and Mission Point. Different patterns of TBT accumulation in tissue were observed among the bivalve species from Vancouver. The highest TBT concentration detected in Tresus capax suggested some possible adverse effects. TBT was the most predominant butyltin component in almost all bivalve specimens surveyed, suggesting a low rate of TBT metabolism. Phenyltin compounds were not detected in any molluscan specimens in this study.     

Detecting fluctuations of the Kuroshio axis south of Japan using TOPEX/POSEIDON altimeter data

Sea surface dynamic topography (SSDT) can be divided into temporal mean SSDT and fluctuation SSDT. The former is approximated with a climatological mean SSDT and the latter is derived from satellite altimetry data, to give an approximated total SSDT (called a composite SSDT). The method is applied to detecting fluctuations of the Kuroshio axis south of Japan using TOPEX/POSEIDON altimeter data from the first year mission in 1992–1993. The fluctuation SSDT averaged over a wide area south of Japan clearly shows an annual cycle with an amplitude of about 15 cm. Temporal changes of SSDT along a subsatellite track crossing the Kuroshio compare moderately well with those estimated from repeated hydrographic observations, although there is a discrepancy of unknown origin. The composite SSDT also compares well with SSDT estimated from the same hydrographic data. Horizontal distribution of the surface geostrophic velocity component normal to subsatellite tracks is derived every ten days from the composite SSDT. Most locations of estimated strong eastward geostrophic velocities coincide well with locations of the Kuroshio axis determined every 15 days fromin situ surface velocity measurements on various vessels; for example, a fairly large meander of the Kuroshio south of Honshu is clearly detected. It is concluded that the composite SSDT can be used reliably to detect fluctuations of the Kuroshio axis south of Japan.     

Pumpellyite in Low-grade Metamorphism

The regional metamorphism of the Kant? Mountains in Japan producedrocks of the following facies, with rising temperature: chloritefacies, pumpellyite-chlorite facies, glauco-phane-schist facies,and greenschist facies. This relationship is compared with theprogressive metamorphic zones in other regions where pumpellyitehas been found. Almost similar relations appear to hold in manymetamorphic terrains. Pumpellyites in glaucophanitic metamorphicterrains have, generally, low Fe'/R'R ratios. Physical andchemical conditions responsible for the formation of pumpellyiteare also discussed.