Effect of Inter-Column Spacing on Soil Stresses due to Vibro-Installed Stone Columns: Interesting Findings

This paper reveals the interesting relation between the inter-column spacing and the corresponding alteration of soil state of stresses due to the vibro-installation technique. This relation is inferred from analyses for load settlement records of various field load tests, performed for stone columns arrangements with different inter-column spacing values. In order to have adequate confidence in the findings, a well-documented case history, involving three columns patterns along with their relevant field and laboratory test results, is utilized for this study. Moreover, a well-tested finite element model, capable of simulating both elasto-plastic and time dependent soil deformations as well as pore water pressure building and dissipation, is employed in the analysis. Instead of determining the soil response to the test load, based on known initial soil stresses and material properties, the analysis is inversely posed to determine the soil initial stresses, based on the recorded settlements and the post-installation material properties. The alteration in the soil state of stress is represented by the increase in the post-installation horizontal to vertical stress ratio, K*, as a function of the inter-column spacing. It is found that this alteration experiences a systematic decrease in its magnitude as the inter-column spacing increases.     

Design of efficient base isolation for hammers and presses

Foundations supporting hammers and presses have to withstand powerful short-period impact loads. When designing these foundations, their vibration amplitudes and the forces transmitted to the supporting piles or soil medium must be reduced to meet serviceability and stability requirements. Mounting systems are often used to achieve this goal. The objectives of this paper are to investigate the efficiency of mounting systems for different foundation configurations and to provide practical guidance for their design. A comprehensive parametric study was conducted and the results were used to establish a set of charts for the design of efficient mounting systems.     

An experimental investigation of LNAPL migration in an unsaturated/saturated sand

Accidental spills of hydrocarbons, such as Light Non-Aqueous Phase Liquids (LNAPLs), are one of the most common sources of subsurface contamination. Migration of LNAPL in a porous medium is influenced by various factors such as the number of fluids present in the unsaturated/saturated zones and the proportion of pores occupied by each fluid. The results for relationship between matric suction and degree of saturation are presented in this paper for water–air, water–LNAPL and LNAPL–air systems in a sand. A simple and reliable setup using Buchner funnel was designed to obtain these relations. It was found that the relationship between matric suction head and degree of saturation is hysteretic for all the fluid systems (water–air, water–LNAPL and LNAPL–air). Furthermore, the amount of hysteresis depended upon the fluid system, with the maximum hysteresis occurring for water–air system. The results suggest that the amount of trapped air depends upon the reversal degree of saturation from drying to wetting.     

Barite deposition resulting from phototrophic sulfide-oxidizing bacterial activity

Barite (BaSO₄) deposits generally arise from mixing of soluble barium-containing fluids with sulfate-rich fluids. While the role of biological processes in modulating barium solubility has been shown, no studies have shown that the biological oxidation of sulfide to sulfate leads to barite deposition. Here we present an example of microbially mediated barite deposition in a continental setting. A spring in the Anadarko Basin of southwestern Oklahoma produces water containing abundant barium and sulfide. As emergent water travels down a stream to a nearby creek, sulfate concentration increases from 0.06 mM to 2.2 mM while Ba²⁺ concentration drops from 0.4 mM to less than 7 μM. Stable isotope analysis, microbial activity studies, and in situ experiments provide evidence that as sulfide-rich water flows down the stream, anaerobic, anoxygenic, phototrophic bacteria play a dominant role in oxidizing sulfide to sulfate. Sulfate then precipitates with Ba²⁺ producing barite as travertine, cements, crusts, and accumulations on microbial mats. Our studies suggest that phototrophic sulfide oxidation and concomitant sulfur cycling could prove to be important processes regulating the cycling of barium in continental sulfur-containing systems.     

Le Viséen supérieur d'Azarhare (Maroc central) : environnements de dépôt,datation et évolution diagénétique

The unexplored area of Azarhare in central Morocco is studied thanks to three sections composed of five lithological facies Main biostratigraphical and sedimentological results concern (1) the identification of Late Visean biozones, with important presence of problematic algae Ungdarella, (2) the regional extension of deposit sequences SD5, SD6 and SD7 previously defined, (3) and an analysis of the diagenetic kaolinite. To cite this article: A. Karim et al., C. R. Geoscience 337 (2005).     

Dissolution of calcitic marble and dolomitic rock in high iron concentrated acid mine drainage: application to anoxic limestone drains

Oxidation of sulphide mining waste can generate acid mine drainage (AMD) that has the potential to seriously affect the ecosystems. Acid mine drainage is characterised by a high acidity, high concentrations of sulphates and metals. To reduce the environmental impacts due to AMD, neutralisation using limestone drains is an option proposed in the literature and used around the world. The present study focuses on the influence of the carbonate rock mineralogy and their particle size on the neutralising capacity. The tests were performed in two different anoxic conditions: in batch reactors, and in columns having a hydraulic retention time of 15?h. The results showed that the neutralisation capacity of calcite was more important than for dolomitic rock, and smaller particle size gave higher alkalinity production (fine calcite dissolved faster in contact with AMD). A characterization of metal precipitate in sludge and in limestone coating was performed and demonstrated that gypsum, lepidocrocite and goethite were the predominant secondary minerals to be formed. Finally, this study underlines that anoxic limestone drain cannot be used alone to treat high iron concentrated AMD.     

One-dimensional consolidation of soil under multistage load based on continuous drainage boundary

In engineering practice, a rapid loading rate can result in ground failure when the strength of soft soils is relatively low, and a multistage loading scheme is always utilized to deal with this situation. Firstly, under a multistage load and the continuous drainage boundary, an analytical solution of excess pore-water pressure and consolidation degree is obtained by virtue of the superposition formula of excess pore-water pressure, and a more general continuous drainage boundary under arbitrary time-dependent load is developed. Then, a comparison with existing analytical solutions is conducted to verify the present solution. A preliminary attempt on applying the continuous drainage boundary into the finite element model is made, and the feasibility of the numerical model for the one-dimensional consolidation under the continuous drainage boundary is verified by comparing the results calculated by FEM with that from present analytical solution. Finally, the consolidation behavior of soil is investigated in detail for different int erface parameters or loading scheme. The results show that, in land reclamation projects, a horizontal drain should be placed close to the boundary with a smaller interface parameter to improve the consolidation efficiency. The degree of consolidation is also related to the applied time-dependent load and interface parameters.     

Post‐Variscan exhumation of the Central Anti‐Atlas (Morocco) constrained by zircon and apatite fission‐track thermochronology

The origin of the Anti‐Atlas relief is one of the currently debated issues of Moroccan geology. To constrain the post‐Variscan evolution of the Central Anti‐Atlas, we collected nine samples from the Precambrian basement of the Bou Azzer‐El Graara inlier for zircon and apatite fission‐track thermochronology. Zircon ages cluster between 340 ± 20 and 306 ± 20 Ma, whereas apatite ages range from 171 ± 7 Ma to 133 ± 5 Ma. Zircon ages reflect the thermal effect of the Variscan orogeny (tectonic thickening of the ca. 7 km‐thick Paleozoic series), likely enhanced by fluid advection. Apatite ages record a complex Mesozoic–Cenozoic exhumation history. Track length modelling yields evidence that, (i) the Precambrian basement was still buried at ca. 5 km depth by Permian times, (ii) the Central Anti‐Atlas was subjected to (erosional) exhumation during the Triassic‐Early Cretaceous, then buried beneath ca. 1.5 km‐thick Cretaceous‐Paleogene deposits, (iii) final exhumation took place during the Neogene, contemporaneously with that of the High Atlas.     

Remote sensing and information value (IV) model for regional mapping of fluvial channels and topographic wetness in the Saudi Arabia

This study aims to map regions of near surface fluvial channels, mega-basins and topographic wetness in Saudi Arabia using remote sensing data and an information value (IV) model, which is a modified approach of weight of evidence. We used the new version of the Shuttle Radar Topographic Mission (SRTM) to delineate the fluvial channels, mega-basin, and slope. These hydrological parameters were used to index the topographic wetness of each mega-basin in the region based on IV in a Geographic Information System. We validated our method using the Space Imaging Radar-C and Landsat 8 images and compared the textural features (fluvial channels) evident from SRTM digital elevation model and to determine whether these patterns were different. Our results revealed that the region is drained by nine tributaries and that the Err Rub Al Khali and Sahba mega-basins have the highest value of the IV and topographic wetness values; the Arran and coastal mega-basins have the lowest value of the IV and topographic wetness values. An integrated approach is timely and economically effective and can be applied throughout the arid and semi-arid regions to help hydrologists and urban developers.     

Factors controlling the changes and spatial variability of <Emphasis Type="Italic">Junipers phoenicea</Emphasis> in Jabal Al Akhdar,Libya, using remote sensing and GIS

The Junipers phoenicea, which covers 70 % of the Jabal Al Akhdar (Green Mountain) in Cyrene on the northeast coast of Libya, has deteriorated over large scales. To deal with this problem, the images of the Landsat 7 Enhanced Thematic Mapper Plus (ETM+) and Landsat 8 Operational Land Imager (OLI) in conjunction with the Shuttle Radar Topography Mission (SRTM) digital elevation model (DEM) were used to map factors controlling the J. phoenicea mortality using a set of automated algorithms and tools. These factors include altitude, slope, aspect, curvature, drainage pattern, seawater intrusion, and land cover. As a first step, changes of J. phoenicea and land cover during the period from the year 2000 to 2015 were mapped. The results showed a sharp decline in J. phoenicea covering an area of 396 km² (22 %) of the total area. The result also showed that areas at a lower elevation with steep slope and faced to the south and southeast directions have a higher probability of J. phoenicea distribution. The spatial analysis showed a positive correlation between wetness and the intensity of J. phoenicea mortality. The results also show that altitude and slope have the most influencing power on the J. phoenicea morality. This study is of great help for decision makers and agriculture engineers and permits a better understanding of ecological and biomass changes in the Jabal Al Akhdar, Libya, over a regional scale.