High-sensitive measurement of uranium LIII-edge X-ray absorption near-edge structure (XANES) for the determination of the oxidation states of uranium in crustal materials

The uranium L_III-edge XANES spectra for natural rocks at the concentration range of 0.96–124 mg kg⁻¹ were measured using a log spiral bent crystal Laue analyzer (BCLA) combined with a multi-element Ge detector. It was found that the quality of the XANES spectra using the BCLA was greatly improved due to a reduction of interfering fluorescence from major components such as Rb and Sr. The ratio of signal to background intensities in the U L_III-edge XANES spectra increased by a factor of 2.9–17 with the use of the BCLA, which greatly enhanced the detection limit for the speciation of the oxidation states of U or the U(IV)/U(VI) ratio of natural samples. In addition, it was demonstrated that the fluorescence XANES method coupled with the BCLA enable determination of the speciation of U for various natural samples such as acidic igneous rocks, ferromanganese nodules, sediments, and some sedimentary rocks such as shale and limestone.     

Life habit of vesicomyid clam,Calyptogena soyoae,and hydrogen sulfide concentration in interstitial waters in Sagami Bay,Japan

In and around the beds of vesicomyid clam (Calytogena soyoae) located off Hatsushima Island in Sagami Bay, central Japan, hydrogen sulfide concentration in bottom water and interstitial water was measured every 10 cm from just above seafloor to 40 cm deep usingin situ separative dialysis bags. While hydrogen sulfide over 0.01 mmol/kg was not measured from the seawater just above the dense clam beds, the concentration of hydrogen sulfide increased rapidly below 10 cm deep. The results indicate that the habit of the clam is correlated with high concentration of hydrogen sulfide contained in pore waters of sediments between depths of 10 and 20 cm from the bottom surface. Concentrations of hydrogen sulfide ranging from approximately 0.05 mmol/kg to 0.6 mmol/kg might be suitable requirement for the habitat ofC. soyoae.     

Mercury distribution in seawater in Minamata Bay and the origin of particulate mercury

Horizontal and vertical distributions of mercury were determined in seawater in Minamata Bay and Yatsushiro Sea. The concentrations of total and particulate mercury respectively ranged from 56–285 ng l^–1 and 2.1–506 ng l^–1. They were both highest in the inner most part of Minamata Bay where the sediment was most heavily polluted, and decreased with increasing distance from there. Vertically, an evident increase in concentration was observed near the bottom. A good agreement was found between the mercury content in suspended matter and that in fine sediment particles.These facts show that the particulate mercury is supplied mostly from the bottom sediment, and that it is spreading offshore with dispersing in seawater. This process would eventually result in the pollution of sediment in Yatsushiro Sea.     

Application of the Single-Bubble Airgun Technique for OBS-Data Acquisition Across the Jan Mayen Ridge,North Atlantic

A 140 km long wide-angle seismic profile has been acquired by use of 6 Ocean Bottom Seismographs across the Jan Mayen Ridge, North Atlantic. The profile was acquired twice; once with a traditionally tuned standard source and secondly with a somewhat smaller source tuned on the first bubble pulse. Analysis of the frequency content of the data reveals that the single-bubble source within the 10-15 Hz frequency range generates a signal with a level about 5 db above that of the standard source. These differences can partly be related to differences in airgun depth. The higher output level for these frequencies enables the single-bubble source to resolve intra-crustal structures with a higher degree of certainty, when compared to the data acquired by use of the standard source array. The standard source seems to generate slightly more energy for frequencies around 6 Hz, probably due to the use of a large 1200 in/sup3 gun in this array. These low frequencies a re of importance for mapping of lower crustal and upper mantle structures, and it is recommended that this is taken into account when seismic sources for mapping of deep crustal and upper mantle structures are designed.     

Degradation of lubricating oils by marine bacteria observed by quantitative mass spectrometry

Bacterial degradation of the hydrocarbons of lubricating oils was investigated by mass spectrometric analysis which gives both total amount and the composition of hydrocarbon types of residual oil. An unused lubricating oil, which mainly consisted of hydrocarbon types with only a small percentage ofn-alkanes, was degraded by marineBacillus sp. andPseudomonas sp. with 55 % and 25 % decreases in 10 days, respectively. Susceptibility of respective hydrocarbon types to biodegradation was in the following order: alkanes > non-condensed cycloalkanes, mono-aromatics > condensed cycloalkanes. A used lubricating oil of different brand showed a larger decrease than the unused oil. Both species of bacteria degraded large portions of alkane fraction of Arabian light crude oil.     

Wave-induced porewater pressure in a seabed with inhomogeneous permeability

We have developed an analytical treatment for the wave-induced response of a seabed with inhomogeneous permeability, by employing the boundary layer approximation. By assuming an exponential function for vertically distributed permeability, the inhomogeneous consolidation equation was formulated as Bessel's differential equation. Subsequently, we proposed some representative quantities for examining the effects of inhomogeneity of permeability. The main effects of inhomogeneity are that the boundary layer becomes thinner and the phase delay in the direction of depth becomes larger as the inhomogeneity becomes significant. In addition, it was shown that the boundary layer is properly evaluated by using the averaged permeability.     

波流共存场中多向随机波浪传播变形数学模型

基于波作用量守恒方程建立了波流共存场中多向随机波浪传播变形数学模型,模型中考虑了波浪绕射的影响和水流引起的波浪弥散多普勒效应,应用包含水流和地形影响的激破波模式计算波浪破碎的能量耗散,采用一阶上迎风有限差分格式离散控制方程。分别计算了有无近岸流情况下单向和多向随机波浪的波高分布,考虑水流影响的数值计算结果与物理模型实验数据吻合良好,比较分析表明,所建立的数学模型能够复演由于离岸流引起的波高增大,可用于波流共存场多向随机波浪传播变形的模拟和预报。     

Experimental study on the velocity of fragments in collisional breakup

The motion of fragments following a catastrophic destruction by either a normal or an oblique impact at 2.5–2.9 km sec^?1 into cubic and spherical basalt targets was studied with a high-speed framing camera. Velocities at the antipodes of the targets vary as (E/M)^0.75 (E = impact energy; M = target mass) and are lower than 200 m sec^?1 at E/M ? 10⁹ ergs g^?1. Excluding fine-grained particles from the impact site, 70 to 80% by mass fraction of the fragments have velocities lower than twice the antipodal velocity. Comminution and ejection energies wasted in this mass fraction were a few percent of the impact energy at E/M ? 5 × 10⁷ ergs g^?1. During a catastrophic impact into asteroids some of the fragmented bodies can be reconcentrated by mutual gravitation.     

Microseismicity Induced by Heavy Rainfall Around Flooded Vertical Ore Veins

—?Microseismicity (M?M?M?M??6 were also monitored at a crustal movement monitoring station located several hundred meters from the veins. It was found that the opening of the vertical ore veins primary led to significant strain and tilt, but not to seismicity, because the delay and the longer duration of the seismicity were significant. Most seismic events involve thrusting mechanisms that are consistent with the present stress state of E-W-oriented tectonic compression, but are not consistent with the opening of the deepest ore vein. Interstingly, all the events within a few months of the heavy rainfall occurred near the faults that offset the deepest ore veins, wheareas all those events located away from the deepest ore veins occurred many months after the heavy rainfall. Consequently, the delayed diffusion of water appears to have played a dominant role in reducing rock strength, which led to seismicity in the Ikuno mine.     

Finite-element Simulation of Seismic Ground Motion with a Voxel Mesh

— Accurate simulation of seismic ground motion for three-dimensionally complex topography and structures is one of the most important goals of strong motion seismology. The finite-element method (FEM) is well suited for this kind of simulation, since traction-free conditions are already included in the formulation, and the Courant condition is less strict than for the finite-difference method (FDM). However, the FEM usually requires both large memory and computation time. These limitations can be overcome by using a mesh consisting of voxels (rectangular prisms) with isotropy built into the explicit formulation of the dynamic matrix equation. Since operators in the voxel FEM are the combinations of ordinary FDM operators and additional terms, the method keeps accuracy of the same order as FDM and the terms relax the Courant condition. The voxel FEM requires a similar amount of memory and only takes 1.2～1.4 times longer computation time. The voxel mesh can be generated considerably faster than the popular tetrahedral mesh. Both ground motions and static displacements due to a point or line source can be calculated using the voxel FEM approach. Comparisons with the reflectivity method and theoretical solutions demonstrate the successful implementation of the method, which is then applied to more complex problems.