Analysis of drivers governing temporal salinity and temperature variations in groundwater discharge from Altug Submarine Karst Cave (Kas-Turkey)

Salinity and temperature variations in groundwater discharge from the Altug submarine karst cave have been observed at 28 m below sea level for every 10 min between November 2004 and August 2005 to determine the drivers that govern the salinization. Comparisons between temporal trends of salinity and temperature with those of precipitation, air pressure, sea level and wind velocity revealed an apparent dominance of precipitation regime on the salinity and temperature variations. Spectral analyses applied to observations showed that the air pressure and sea level oscillations are affected by sun and moon tides which do not have an appreciable impact on the salinity and temperature variations. Annual rate of salinization in Altug cave seems inversely related to the inland groundwater head so that the maximum and minimum fresh water contributions occur at mid-spring and late-summer, respectively.     

Pore pressure profiles in fractured and compliant rocks1

Fluid permeability in fractured rocks is sensitive to pore-pressure changes. This dependence can have large effects on the flow of fluids through rocks. We define the permeability compliance γ= 1/k(k/δp_p)_pc, which is the sensitivity of the permeability k to the pore pressure p_p at a constant confining pressure p_c, and solve the specific problems of constant pressure at the boundary of a half-space, a cylindrical cavity and a spherical cavity. The results show that when the magnitude of permeability compliance is large relative to other compliances, diffusion is masked by a piston-like pressure profile. We expect this phenomenon to occur in highly fractured and compliant rock systems where γ may be large. The pressure profile moves rapidly when fluids are pumped into the rock and very slowly when fluids are pumped out. Consequently, fluid pressure, its history and distribution around injection and production wells may be significantly different from pressures predicted by the linear diffusion equation. The propagation speed of the pressure profile, marked by the point where δp_p/δx is a maximum, decreases with time approximately as and the amplitude of the profile also dissipates with time (or distance). The effect of permeability compliance can be important for fluid injection into and withdrawal from reservoirs. For example, excessive drawdown could cause near-wellbore flow suffocation. Also, estimates of the storage capacity of reservoirs may be greatly modified when γ is large. The large near-wellbore pressure gradients caused during withdrawal by large γ can cause sanding and wellbore collapse due to excessive production rates.     

Integrative propositions for adapting conservation policy to the impacts of climate change

Conservation policies have changed over time in response to changes in human and ecological drivers. The impacts of climate (and other) concurrent changes prompt consideration of further iterations for both conservation means and objectives. In this paper we bring together previous disparate literatures and apply them to the question of how to adapt conservation polices to suit an era of climate change impacts. Our approach is based on two assertions: (i) that the integration of specific natural and social science insights is essential for understanding and effectively responding to this challenge, and (ii) that in addition to adaptive conservation means (strategies), attention needs to be given to considering adaptive conservation objectives. Specifically, we convert a core set of natural and social science insights into analytical tools known as heuristics or rules of thumb. We then use the heuristics as a basis to offer a list of preliminary propositions that can help inform the development of new means and objectives. The propositions address key considerations including recalibrating management objectives, the role of disturbance in facilitating ecological transitions, and overarching topics relating to governance. The propositions are speculative, and so intended only to outline potential avenues for further empirical research and subsequent refinement. In the spirit of adaptation, we expect and welcome their revision.     

An evaluation of the relationship between physical/mechanical properties and mineralogy of landscape rocks as determined by hyperspectral reflectance

We investigated the relationships between mineral content and the physical and mechanical properties of landscape rock using a non-destructive remote sensing method applied in the laboratory. Using this technique, the spectral properties of the landscape rock could be collected at different wavelengths without harming the samples. Differences in spectral reflectance were compared with the physical and mechanical properties of the stone. Significant correlations were observed between reflectance values and the rocks’ mechanical and physical properties, with correlation coefficients of 95 to 99 %. However, establishing a correlation between two variables is not a sufficient condition to establish a causal relationship. Mineral densities and mineral content are characteristics used for the classification of landscape rock. We have concluded that although spectral signatures from landscape rock can be used for predicting which stones might have similar features when comparing two batches of stone, the high correlations we discovered cannot confirm a cause and effect relationship that would allow for the prediction of a rock’s physical and mechanical properties. Although this conclusion is disappointing, the mineral content and the significant correlations discovered by hyperspectral reflectance scanning can be used as supplementary information when comparing two samples of landscape rock.     

Estimation of air-overpressure produced by blasting operation through a neuro-genetic technique

Blasting operations usually produce significant environmental problems which may cause severe damage to the nearby areas. Air-overpressure (AOp) is one of the most important environmental impacts of blasting operations which needs to be predicted and subsequently controlled to minimize the potential risk of damage. In order to solve AOp problem in Hulu Langat granite quarry site, Malaysia, three non-linear methods namely empirical, artificial neural network (ANN) and a hybrid model of genetic algorithm (GA)–ANN were developed in this study. To do this, 76 blasting operations were investigated and relevant blasting parameters were measured in the site. The most influential parameters on AOp namely maximum charge per delay and the distance from the blast-face were considered as model inputs or predictors. Using the five randomly selected datasets and considering the modeling procedure of each method, 15 models were constructed for all predictive techniques. Several performance indices including coefficient of determination (R ²), root mean square error and variance account for were utilized to check the performance capacity of the predictive methods. Considering these performance indices and using simple ranking method, the best models for AOp prediction were selected. It was found that the GA–ANN technique can provide higher performance capacity in predicting AOp compared to other predictive methods. This is due to the fact that the GA–ANN model can optimize the weights and biases of the network connection for training by ANN. In this study, GA–ANN is introduced as superior model for solving AOp problem in Hulu Langat site.     

Did satellite imagery supersede aerial imagery? A perspective from 3D geopositioning accuracy

In this study, the geometric accuracy comparison of aerial photos and WorldView-2 satellite stereo image data is evaluated with the different number and the distribution of the ground control points (GCPs) on the basis of large scale map production. Also, the current situation of rivalry between airborne and satelliteborne imagery was mentioned. The geometric accuracy of Microsoft UltraCam X 45 cm ground sampling distance (GSD) aerial imagery and WorldView-2 data both with and without GCPs are also separately analyzed. The aerial photos without any GCP by only using global navigation satellite system (GNSS) and inertial measurement unit (IMU) data with tie points give an accuracy of ±1.17 m in planimetry and ±0.71 m in vertical that means nearly two times better accuracy than the rational polynomial coefficient (RPC) of stereo WorldView-2. Using one GCP affects the accuracies of aerial photos and WorldView-2 in different ways. While this situation distorts the aerial photo block, it corrects the shift effect of RPC in WorldView-2 and increases the accuracy. By using four or more GCPs, ½?pixel (～0.23 m) accuracy in aerial photos and 1 pixel (～0.50 m) accuracy in WorldView-2 can be achieved in horizontal. In vertical, aerial photos have 1 pixel (～0.55 m) and WorldView-2 has 1.5 pixels (～0.85 m) accuracy. These results show that Worldview-2 imagery can be used in the production of class I 1:5000 scale maps according to the ASPRS Accuracy Standards for Digital Geospatial Data in terms of geometric accuracy. It is concluded that the rivalry between aerial and satellite imagery will continue for some time in the future.     

Computing derivative information of sequentially coupled subsurface models

A generic framework for the computation of derivative information required for gradient-based optimization using sequentially coupled subsurface simulation models is presented. The proposed approach allows for the computation of any derivative information with no modification of the mathematical framework. It only requires the forward model Jacobians and the objective function to be appropriately defined. The flexibility of the framework is demonstrated by its application in different reservoir management studies. The performance of the gradient computation strategy is demonstrated in a synthetic water-flooding model, where the forward model is constructed based on a sequentially coupled flow-transport system. The methodology is illustrated for a synthetic model, with different types of applications of data assimilation and life-cycle optimization. Results are compared with the classical fully coupled (FIM) forward simulation. Based on the presented numerical examples, it is demonstrated how, without any modifications of the basic framework, the solution of gradient-based optimization models can be obtained for any given set of coupled equations. The sequential derivative computation methods deliver similar results compared to FIM methods, while being computationally more efficient.