Causes of Land Subsidence in the Kingdom of Saudi Arabia

The occurrence of land subsidence in the Kingdom Saudi Arabia is either natural or man-made. Natural land subsidence occurs due to the development of subterranean voids by a solution of host rocks in carbonate and evaporite terrains, over many areas of Saudi Arabia. Man-induced land subsidence is either due to the removal of groundwater in the agricultural areas or to wetting of unstable soils. Therefore, earth fissures and a lowering of the ground surface in unconsolidated sediments took place in alluvial plains and volcanic vent terrains. Unstable soils include Sabkha soils and loess sediments. These types of soils occur in coastal plains, desert areas and volcanic terrains. When this soil is wetted either during agricultural activities, waste disposal or even during a rain storm, subsidence takes place due to either the removal of salts from the Sabkha soil or the rearrangement of soil particles in loess sediments.     

Experimental Evaluation of Construction Waste and Ground Granulated Blast Furnace Slag as Alternative Soil Stabilisers

In this study, the effect of ground granulated blast furnace slag (GGBFS) and recycled construction waste (CW) on bentonite clay stabilisation were investigated. The unconfined compressive strength (UCS) of specimens was evaluated with different combinations of GGBFS and CW over various curing periods. A series of micro analysis tests consisting of scanning electron microscope, energy dispersive spectrometer and X-ray diffraction were also conducted to determine the microstructural arrangement and mineralogical effect of the stabilisation treatment. The UCS results showed an increment in strength after introduction of GGBFS and CW and the longer curing period produced more pronounced results. The optimum additive ratio was calculated as 5 % of slag and 20 % of construction waste under all curing conditions. The micro analytical results also indicated formation of structural bonds between admixtures and bentonite in stabilised specimens, as slag crystals and bentonite particles were observed to occupy the cavities and vesicles on the construction waste grains. However, the experimental data shows that the strength improvement is not significant with the addition of only construction waste.     

Geotechnical Hazards Associated with Desert Environment

The aridity of the Arabian Peninsula's deserts ranges between arid to hyperarid with hot dry climate, scarce precipitation and sparse vegetation. These harsh environmental conditions enhance some geomorphologic processes more than others, cause specific geotechnical problems, and increase desertification.From west to east, the general physiography of Saudi Arabia shows the Red Sea coastal plains and the escarpment foothills called Tihama followed by the Arabian Shield mountains, the Arabian Shelf plateau and finally the Arabian Gulf coastal plains. Sand moves by wind either as drifting sand or migrating dunes in four major sand seas, over the Arabian Shelf, and in the inter-mountain valleys, in the Arabian Shield causing problems of erosion and deposition. Human activities in the deserts may cause more instability to the sand bodies, enlarging the magnitude of the problem. Fine silty soil particles also move by wind, depositing loess mainly in selected areas downwind in the Tihama. These loess deposits subside and may form earth fissures by the process of hydrocompaction upon wetting. The addition of water can be either natural through storms or man-made through human agricultural or civil activities. Extensive sabkhas exist along the coastal plains of both the Red Sea and Arabian Gulf. The sabkha soil may also heave by salt re-crystallization or collapse by wetting. The shallow groundwater brines present in sabkhas also attack and corrode civil structures. Urbanization and excessive groundwater pumping may also deplete the fresh groundwater resources and may cause subsidence, ground fissuring and surface faulting as observed in some locations in the Arabian Shield. Although the average annual precipitation is very low, rain usually falls in the form of torrential storms, collected by dry valley basins and causing floods to unprotected downstream areas on the coastal plains of the Red Sea.The desert environment, being a fragile echo system, needs to be treated with care. Intercommunications between different national and international agencies and education of the layman should help to keep the system balanced and reduce the resulting environmental hazards. In addition, any suggested remedial measures should be planned with nature and engineered with natural materials.     

Karst Hazard Assessment of Eastern Saudi Arabia

Karst phenomena exist in areas in the eastern part of Saudi Arabia, forming solution features such as sinkholes, collapsed dolines and solution caverns, as a result of the chemical leaching of the carbonate and evaporite formations by percolating water. The instability of these karst phenomena could produce land subsidence problems. This paper reviews the geology of documented karstic rock units in Saudi Arabia and proposes a simple engineering classification of the solution features characteristic of limestone. Two case histories in the Dhahran area, eastern Saudi Arabia, will be used as examples for the application of a modified engineering classification.     

Geological and geophysical exploration of the groundwater aquifers of As Suqah area, Makkah district, Western Arabian Shield, Saudi Arabia

As Suqah area is a NW–SE trending wadi present in the west central part of the Arabian Shield. It comprises Precambrian–Cambrian basement rocks, Cretaceous–Tertiary sedimentary succession, Tertiary–Quaternary basaltic lava flows, and Quaternary–Recent alluvial deposits. The magnetic anomalies indicated the presence of many recent local buried faults. These affected the distribution of the clastic sedimentary succession and seem to have controlled the deep groundwater aquifers. Groundwater movement is towards the west and northwest, following in general the surface drainage system. Hydraulic gradient varies greatly from one point to another depending on the pumping rates and cross-sectional area of the aquifer in addition to its transmissivity. The detailed results of the resistivity and seismic measurements were integrated with those obtained from test holes drilled in the study area. Groundwater occurs mainly in two water-bearing horizons, the alluvial deposits and within the clastic sedimentary rocks of Haddat Ash Sham and Ash Shumaysi formations. The shallow zone is characterized with a saturated thickness of 3–20 m and water is found under confined to semi-confined conditions. Water levels were encountered at depths varying from 3 to 16 m in the alluvial wadi deposits and from 18 to 62 m in the sedimentary succession. The combinations of vertical electrical sounding, horizontal electrical profiling, and drilling led to the identification of groundwater resources in the study area. Resistivity soundings clearly identified the nature of the lithological depth and proved useful at identifying water-bearing zones. Significantly, the majority of the groundwater was found within the deep confined aquifer gravelly sandstone, rather than in the shallow unconfined aquifer.     

Adaptation of climate variability/extreme in arid environment of the Arabian peninsula by rainwater harvesting and management

Water management in Saudi Arabia is facing major challenges due to the limited water resources and increasing uncertainties caused by climate change. The rainfall and temperature records of the Saudi meteorological data for more than three decades were analyzed for policy suggestions in water sectors based on the changing rainfall patterns. The trends in the annual aridity and rain indices were also examined to define the changing climate conditions and for determining the dry months in different cities of the Kingdom. An increased annual and maximum rainfall was observed for six cities while a decreasing trend in both annual and maximum rainfall was observed for the same number of cities highlighting the variability of rainfall in the whole region. An increasing maximum rainfall with decreasing annual rainfall was observed for the rest of the cities signifying the more extreme rainfall evens and resulting floods of short durations. The changing rainfall trends were also observed for different months during 31 years of the recorded period in addition to the varying climate pattern for different cities within the same district. Finally, these preliminary assessments of any systematic changes in view of the increased rain intensities and extreme climate events are viewed to demonstrate the value rainwater harvesting and management as a local adaptation to the climate variability and extreme in the Kingdom.     

Integration of ASTER and landsat TM remote sensing data for chromite prospecting and lithological mapping in Neyriz ophiolite zone,south Iran

Chromite deposits in Iran are located in the ophiolite complexes, which have mostly podiform types and irregular in their settings. Exploration for podiform chromite deposits associated with ophiolite complexes has been a challenge for the prospectors due to tectonic disturbance and their distribution patterns. Most of Iranian ophiolitic zones are located in mountainous and inaccessible regions. Remote sensing approach could be applicable tool for choromite prospecting in Iranian ophiolitic zones with intensely rugged topography, where systematic sampling and conventional geological mapping are limited. In this study, Landsat Thematic Mapper (TM) and Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) satellite data were used for chromite prospecting and lithological mapping in the Neyriz ophiolitic zone in the south of Iran. Image transformation techniques, namely decorrelation stretch, band ratio and principal component analysis (PCA) were applied to Landsat TM and ASTER data sets for lithological mapping at regional scale. The RGB decorrelated image of Landsat TM spectral bands 7, 5, and 4, and the principal components PC1, PC2 and PC3 image of ASTER SWIR spectral bands efficiently showed the occurrence of major lithological units in the study area at regional scale. The band ratios of 5/3, 5/1, 7/5 applied on ASTER VNIR‐SWIR bands were very useful for discriminating most of rock units in the study area and delineation of the transition zone and mantle harzburgite in the Neyriz ophiolitic complex. Spectral Angle Mapper (SAM) technique was implemented to ASTER VNIR‐SWIR spectral bands for detecting minerals of rock units and especially delineation of the transition zone and mantle harzburgite as potential zones with high chromite mineralization in the Neyriz ophiolitic complex. The integration of information extracted from the image processing algorithms used in this study mapped most of lithological units of the Neyriz ophiolitic complex and identified potential areas of high chromite mineralization (transition zone and mantle harzburgite) for chromite prospecting targets in the future. Furthermore, image processing results were verified by comprehensive fieldwork and laboratory analysis in the study area. Accordingly, result of this investigation indicate that the integration of information extracted from the image processing algorithms using Landsat TM and ASTER data sets could be broadly applicable tool for chromite prospecting and lithological mapping in mountainous and inaccessible regions such Iranian ophiolitic zones.