Bedrock fission‐track analysis, high‐resolution petrography and heavy mineral analyses of sediments are used to investigate the relationships between erosion and tectonics in the Western Alps. Along the Aosta Valley cross‐section, exhumation rates based on fission‐track data are higher in the fault‐bounded western block than in the eastern block (0.4–1.5 vs. 0.1–0.3 mm yr−1). Erosion rates based on the analysis of bed‐load in the Dora Baltea drainage display the same pattern and have similar magnitudes in the relative sub‐basins (0.4–0.7 vs. 0.04–0.08 mm yr−1). Results highlight that climate, relief and lithology are not the controlling factors of erosion in the Western Alps. The main driving force behind erosion is instead tectonics that causes the differential upward motion of crustal blocks. 相似文献
A comparison is made of the light and colour curves of the SN 1987A in the first 280 days with the mean properties of type II supernovae. The conclusion is that even though it has H lines, and was not a typical type II supernova, but a peculiar object from a photometric point of view. The implications for inclusion of SN 1987A in the context of the usual Minkowski-Zwicky classification are explicitly discussed. 相似文献
The aim of this paper is to analyze the reactivation mechanism of ancient earth flows, with a view to gleaning information that can subsequently be utilized to formulate a risk-reduction strategy. All considerations made herein are the result of direct experience and observation of actual events which have occurred over the past few decades in the Northern Apennines. Particular attention has been paid to the analysis of the evolution of landslides during actual reactivation, acknowledging a typical, recurring succession of events that precede the failure of the slope. The hazard assessment of these large landslide bodies, which are of slope scale, constitutes a thorny problem, especially in view of the inapplicability of traditional deterministic models such as limit equilibrium stability analysis. Nevertheless, a site-specific assessment of probability of reactivation of these large and ancient earth flows is fundamental to effective land-use planning. 相似文献
Near-bottom normal incidence acoustic reflection data and sediment physical property data are used to study the relationships between acoustic reflections and sediment physical properties. A pinger-hydrophone experiment was performed to obtain the necessary acoustic reflection data. In addition, a standard piston core was retrieved in the acoustic survey area for physical property analysis. The piston core was sampled and 13 properties were measured at 55 locations within the top 12 m of the core. Correlation studies amongst the sediment physical properties resulted in the following strong correlations: acoustic impedance () and porosity (), (0.96); water content () and , (0.95); bulk density () and , (0.99).The empirical orthonormal function (EOF) method was employed for acoustic signal analysis. This method assumes no a-priori models of the sediment or causality. The EOF method reduced the acoustic data to 8 functions that contained 97.6% of the sample variance. The EOFs were subsequently analysed by using cepstrum analysis which reveals time delay information and enhances detecting zones of reflectivity. The result of the sediment physical property and cepstrum analysis indicates that zones of reflectivity are essentially zones of relatively high acoustic impedance, low porosity, and low phi (high mean grain size). 相似文献
The classic Lagrange's expansion of the solutionE(e, M) of Kepler's equation in powers of eccentricity is extended to highly eccentric orbits, 0.6627 ... <e<1. The solutionE(e, M) is developed in powers of (e–e*), wheree* is a fixed value of the eccentricity. The coefficients of the expansion are given in terms of the derivatives of the Bessel functionsJn(ne). The expansion is convergent for values of the eccentricity such that |e–e*|<(e*), where the radius of convergence (e*) is a positive real number, which is calculated numerically. 相似文献
This paper presents results recently obtained for generating site-specific ground motions needed for design of critical facilities. The general approach followed in developing these ground motions using either deterministic or probabilistic criteria is specification of motions for rock outcrop or very firm soil conditions followed by adjustments for site-specific conditions. Central issues in this process include development of appropriate attenuation relations and their uncertainties, differences in expected motions between Western and Eastern North America, and incorporation of site-specific adjustments that maintain the same hazard level as the control motions, while incorporating uncertainties in local dynamic material properties. For tectonically active regions, such as the Western United States (WUS), sufficient strong motion data exist to constrain empirical attenuation relations for M up to about 7 and for distances greater than about 10–15 km. Motions for larger magnitudes and closer distances are largely driven by extrapolations of empirical relations and uncertainties need to be substantially increased for these cases.
For the Eastern United States (CEUS), due to the paucity of strong motion data for cratonic regions worldwide, estimation of strong ground motions for engineering design is based entirely on calibrated models. The models are usually calibrated and validated in the WUS where sufficient strong motion data are available and then recalibrated for applications to the CEUS. Recalibration generally entails revising parameters based on available CEUS ground motion data as well as indirect inferences through intensity observations. Known differences in model parameters such as crustal structure between WUS and CEUS are generally accommodated as well. These procedures are examined and discussed. 相似文献