Experimental study on loss factor for corrugated plates by bandwidth method

The material loss factor for technically orthotropic plates was measured by half-power bandwidth method. Rectangular and trapezoidal corrugated plates of steel were considered. A simple isotropic steel plate was also considered for comparison of the results. The concept of single degree of freedom system was adopted. The tests were undertaken at very low frequency range (0–100) Hz. The plate models were suspended freely with two wires to minimize or prevent excessive extraneous energy dissipation. Out of plane point force, random in nature was applied to the top middle of the plates and the responses were measured from the middle point of the plates by FFT analyzer using miniature small mass accelerometer as sensor. The aim of these tests is to investigate the effects of bending rigidity and mode orders over material loss factor. The values of estimated modal damping loss factors are compared and tabulated for the plates models considered. Natural frequencies of some of the initial modes of the plates are also presented.It is observed that the higher the value of bending rigidity of the plates, the larger the values of loss factor of it. There was a significant increase in value of loss factor in corrugated plates to that of the isotropic plate.     

Results from a Multi-disciplinary Sedimentary Pilot Study of Tectonic Lake Iznik (NW Turkey) – Geochemistry and Paleolimnology of the Recent Past

A limnogeological reconnaissance study was carried out on Lake Iznik, located in the southeast of the Marmara region of Turkey, involving a seismic survey and collection of short sediment cores. This lake is located on the middle branch of the North Anatolian Fault Zone (NAFZ), a transform plate boundary between the Eurasian and Anatolian Plates. It is, therefore, tectonically active and offers an opportunity to investigate the interplay of sedimentary and seismo-tectonic processes, as well as climate change and human impact in the region. Short cores of the three sub-basins, maximum length of 35.5 cm, recovered non-laminated, blackish clays and silts with varying amounts of biogenic and minerogenic (allochthonous, autochthonous) material, which documented almost the last 80 years of deposition and environmental history. High sedimentation rates in the deeper core sections are accompanied by changes in land use (conversion of woodland to farmland) in the northern areas of Lake Iznik, which caused the deposition of more weathered material (high K/Na ratios) and higher contents of Mn in the lake. A tendency towards eutrophic conditions within the last 20 years is indicated by high nutrient content (N, TOC, P), decreasing C/N-ratios, and characteristic diatom and cladoceran associations. Also increased pollution is revealed by higher Pb, Cu, and Zn contents and increased supply of human and animal faeces (high coprostanol content) during the last two decades. But simultaneous lower sedimentation rates towards the core tops complicate the reconstruction of recent and past eutrophication and pollution states of Lake Iznik. This requires an extension of the pilot study and deeper sediment cores, to recover non-anthropogenic influenced sediment levels.     

Effect of environmental factors on the flora of alluvial fans in southern Sinai

The purpose of this study was to elucidate the floristic and structural characteristics of simple alluvial fan vegetation of southern Sinai and to relate them to environmental variation. The main question addressed was: how does the floristic composition of fan habitats, species richness and life-form vary in relation to environmental change? Thirty-seven alluvial fans, randomly selected in two mainwadis(WadiFeiran andWadiDahab) were analysed quantitively. Two-way Indicator Species Analysis (TWINSPAN) classification and Canonical Correspondence Analysis (CCA) were applied in successive stages of the data analysis to describe vegetational variation in relation to physical gradients. Seven main clusters of fans were defined on the basis of environmental variation. These clusters are divided into three main groups of species richness. Species richness varied along a moisture gradient. The richest fans were the driest habitats, indicating that maximum species richness did not occur at high moisture availability. The moisture gradient is a complex gradient correlated with elevation, slope, climatic aridity, soil texture and the nature of the soil surface. Fine sand, silt plus clay and calcium carbonate showed significant differences between the internal groups and subgroups of the first and second level of the TWINSPAN classification.     

Assessment of contaminants in Dubai coastal region, United Arab Emirates

Coastal uses and other human activities have inevitably impinged on the Gulf environment; therefore, these regions require continuous monitoring. The investigated area covered the maximum fragments of Dubai coastal region in the Arabian Gulf. The determination of major oxides and trace metal concentrations in Dubai sediments revealed three heavily and moderately contaminated regions. One is in the far northeastern part at Al-Hamriya Sts 1–3 and contaminated by Fe, Cu, Pb, and Zn; the second is in the mid-northeastern part at Dry Docks and contaminated by Cu, Ni, Pb, and Zn; and finally, the third is in the near southwestern part at Dubal and contaminated by Fe, Mg, Cr, Ni, and Zn. Al-Hamriya St 3 represented the highest values of Cu, Pb, and Zn, whereas Dubal exhibited the maximum values of Fe, Mg, Ba, Cr, Mn, Ni, and V. The anthropogenic discharge and natural deposits are the main sources of contamination. In general, all trace and major elements showed the minimal levels at Jebel Ali Sanctuary (Sts 11, 12, 13) except for Sr and Ca, which showed their maximum values. The highest concentrations of Ca and Sr are mainly attributed to carbonate gravel sands and sands, which cover most stations. Each of V and Ni showed negative correlation with TPH, which may be indicated that the source of oil contamination in the region is not related to crude oil but mostly attributable to anthropogenic sources. The significant positive correlation, which was found between trace metals and TOC indicates that organic matter plays an important role in the accumulation of trace metals in case of Cu, Zn, and Pb.     

Response of soil aggregate disintegration to the different content of organic carbon and its fractions during splash erosion

Aggregate disintegration is a critical process in soil splash erosion. However, the effect of soil organic carbon (SOC) and its fractions on soil aggregates disintegration is still not clear. In this study, five soils with similar clay contents and different contents of SOC have been used. The effects of slaking and mechanical striking on splash erosion were distinguished by using deionized water and 95% ethanol as raindrops. The simulated rainfall experiments were carried out in four heights (0.5, 1.0, 1.5 and 2.0 m). The result indicated that the soil aggregate stability increased with the increases of SOC and light fraction organic carbon (LFOC). The relative slaking and the mechanical striking index increased with the decreases of SOC and LFOC. The reduction of macroaggregates in eroded soil gradually decreased with the increase of SOC and LFOC, especially in alcohol test. The amount of macroaggregates (>0.25 mm) in deionized water tests were significantly less than that in alcohol tests under the same rainfall heights. The contribution of slaking to splash erosion increased with the decrease of heavy fractions organic carbon. The contribution of mechanical striking was dominant when the rainfall kinetic energy increased to a range of threshold between 9 J m⁻² mm⁻¹ and 12 m⁻² mm⁻¹. This study could provide the scientific basis for deeply understanding the mechanism of soil aggregates disintegration and splash erosion.     

Study of horizontal drain effect on slope stability

Slope failure usually occurs when soil particles are unable to build a strong bond with each other and become loose because of the presence of water. Water pressure weakens the ties between the particles and they tend to slip. Therefore, this study focused on the use of horizontal drains to reduce water entry and control the ground water level as a method of slope stabilization. Several previous studies have shown that the use of horizontal drains to lower the water level in soil is one of the fastest and cheapest slope stabilization methods. The main objective of this study is to analyze the effect of horizontal drains on slope stability. Information on slope condition during the landslides which happened at Precinct 9, Putrajaya, Malaysia was used for analytical simulation. Seep/W and Slope/W analyses were carried out with GeoStudio version 2007 software. Slopes with and without horizontal drains were then compared in terms of groundwater level and factor of safety (FOS) values. Scenarios were created for seven types of soil namely: residual, clay, silt, loam, sandy loam, sandy clay loam, and silt clay loam for a case wise analysis. The effect of daily steady rainfall and realcondition rainfall was studied. These cases were studied to find the effectiveness of horizontal drains as a slope stabilization tool. The results revealed that when a drain was installed on a slope, the groundwater level dropped immediately and the safety factor of the slope increased. Sandy loam (sL) soil was identified as the best candidate for a horizontal drain. Its highly saturated hydraulic conductivity Ks facilitated groundwater drain through the horizontal drain effectively. Silt clay loam (scL) soil was identified as the least effective candidate.     

The ancient water system at the Upper city of Hasankeyf,Turkey

In this paper, the water distribution system at the Upper city of a well-preserved medieval town of Hasankeyf near the Tigris is questioned and its relation to the urban settlement pattern is assessed. The discussions are based on the cistern-intensive and available canal data collected within the residential borders of the Upper city in 2005. Being the third level features of the water system, the cisterns the majority of which are now attributable to the “conical, small and individual” typology, have shown that they were actively operated through the open rock-cut canals which were fed by the backbone of the distribution network—namely the siphon system, until recent times. Although a considerable number of converted cisterns hallmark shifts in the function of the water system and the changing conjectures over time, the blue prints of such a big “hydro-design” reveal the competence of semi-arid occupational environments in Upper Mesopotamia in showing how to cope with the topographical constraints and climatic disadvantages and turn these into an opportunity through the efficient use of terrain along with a carefully designed settlement area. That the Upper city now offers numerous water features makes this piece of land quite a representative of the regional works and shows the apex of the perception of ancient technology achieved with the siphon that could have been launched in the Roman era, and the state of art of planning ancient natural and man-made habitats.