This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features. 相似文献
The Three Gorges Project is the world's largest water conservancy project. According to the design standards for the 1,000‐year flood, flood diversion areas in the Jingjiang reach of the Yangtze River must be utilized to ensure the safety of the Jingjiang area and the city of Wuhan. However, once these areas are used, the economic and life loss in these areas may be very great. Therefore, it is vital to reduce this loss by developing a scheme that reduces the use of the flood diversion areas through flood regulation by the Three Gorges Reservoir (TGR), under the premise of ensuring the safety of the Three Gorges Dam. For a 1,000‐year flood on the basis of a highly destructive flood in 1954, this paper evaluates scheduling schemes in which flood diversion areas are or are not used. The schemes are simulated based on 2.5‐m resolution reservoir topography and an optimized model of dynamic capacity flood regulation. The simulation results show the following. (a) In accord with the normal flood‐control regulation discharge, the maximum water level above the dam should be not more than 175 m, which ensures the safety of the dam and reservoir area. However, it is necessary to utilize the flood diversion areas within the Jingjiang area, and flood discharge can reach 2.81 billion m3. (b) In the case of relying on the TGR to impound floodwaters independently rather than using the flood diversion areas, the maximum water level above the dam reaches 177.35 m, which is less than the flood check level of 180.4 m to ensure the safety of the Three Gorges Dam. The average increase of the TGR water level in the Chongqing area is not more than 0.11 m, which indicates no significant effect on the upstream reservoir area. Comparing the various scheduling schemes, when the flood diversion areas are not used, it is believed that the TGR can execute safe flood control for a 1,000‐year flood, thereby greatly reducing flood damage. 相似文献
Barley(Hordeum vulgare L.) is one of the earliest domesticated crop species and ranked as the fourth largest cereal production worldwide. Forward genetic studies in barley have greatly advanced plant genetics during the last century; however, most genes are identified by the conventional mapping method. Array genotyping and exome-capture sequencing have also been successfully used to target the causal mutation in barley populations, but these techniques are not widely adopted because of associated costs and partly due to the huge genome size of barley. This review summarizes three mapping cases of barley cuticle mutants in our laboratory with the help of RNA-sequencing. The causal mutations have been successfully identified for two of them and the target genes are located in the pericentromeric regions. Detailed information on the mapping-by-sequencing, mapping-and-sequencing, and RNA-sequencing assisted linkage mapping are presented and some limitations and challenges on the mapping assisted by RNA sequencing are also discussed. The alternative and elegant methods presented in this review may greatly accelerate forward genetics of barley mapping, especially for laboratories without large funding. 相似文献
Microbial degradation technologies have been developed to restore ground water quality in aquifers polluted by organic contaminants effectively in recent years. However, in course of the degradation, the formation of biofilms in ground water remediation technology can be detrimental to the effectiveness of a ground water remediation project. Several alternatives are available to a remedial design engineer, such as Permeable Reactive Barriers (PRBs) and in -situ bioremediation, Hydrogen Releasing Compounds (HRCs) barrier, Oxygen Releasing Compounds (ORCs) barrier etc. which are efficient and cost- effective technologies. Excessive biomass formation renders a barrier ineffective in degrading the contaminants, Efforts are made to develop kinetics models which accurately determine bio - fouling and bio - filn formation and to control excessive biomass formation. 相似文献
1 INTRODUCTION Blazars, including BL Lac objects, highly polarized and optically violently variable quasars,and flat-spectrum radio quasars (FSRQs), are characterized by highly variable non-thermalemission which dominates their characteristics from radio to y-ray bands. The mechanismbelieved to be responsible for their broadband emission is synchrotron radiation followed by in-verse Compton (IC) scattering at higher energies (e.g. Blandford & Konigl 1979). Relativisticbeaming of a jet… 相似文献
As well known, the methods of remote sensing and Bowen Ratio for retrieving surface flux are based on energy balance closure; however, in most cases, surface energy observed in experiment is lack of closure. There are two main causes for this: one is from the errors of the observation devices and the differences of their observational scale; the other lies in the effect of horizontal advection on the surface flux measurement. Therefore, it is very important to estimate the effects of horizontal advection quantitatively. Based on the local advection theory and the surface experiment, a model has been proposed for correcting the effect of horizontal advection on surface flux measurement, in which the relationship between the fetch of the measurement and pixel size for remote sensed data was considered. By means of numerical simulations, the sensitivities of the main parameters in the model and the scaling problems of horizontal advection were analyzed. At last, by using the observational data acquired in agricultural field with relatively homogeneous surface, the model was validated.