Inertial and hydrodynamic inertial loads on floating units

The analysis of the dynamic behavior of floating units usually employs a coordinate system with origin in the unit's center of gravity, which significantly simplifies the global mass matrix. Hydrodynamic coefficients are then computed considering the same coordinate system. However, to analyze other conditions of mass distribution and maintain the simplicity of a global mass matrix, it is necessary to determine again the hydrodynamic coefficients, thereby reducing the efficiency of the entire process. Another important point is that the geometries frequently used in floating units are such that the cross-terms of an added mass are relatively unimportant when compared with the main terms, and it is, therefore, common to use only some of them to analyze the unit's dynamic behavior. Recently, however, in the search for production systems suitable for water depths greater than 3000 m, other geometries have been considered in technical and economic feasibility studies. It is possible that for these new geometries all terms of the added mass matrix must be included in the analysis. This paper presents the full development used to determine the complete global mass matrix, the inertial and hydrodynamic inertial loads that make use of the added mass matrices considering any coordinate system and the six degrees of freedom, including all cross-terms.     

Nutrient budgets and trophic state in a hypersaline coastal lagoon: Lagoa de Araruama, Brazil

Lagoa de Araruama in the state of Rio de Janeiro, Brazil, is a hypersaline lagoon with salinity varying spatially from 45 to 56. We collected water samples during monthly cruises throughout the lagoon, and along the streams feeding the system, from April 1991 to March 1992. Nutrients and other water quality parameters exhibited great spatial and temporal variations. Mass balance calculations indicate large amounts of anthropogenic nutrient inputs. The data indicate that the lagoon currently is oligotrophic but is in a state of transition to become a mesotrophic system. Molar dissolved inorganic nitrogen:dissolved inorganic phosphorus (DIN/DIP) varied between 2.2:1 and 659:1 with a volume-weighted average of 22:1. The high DIN/DIP ratio contrasts with that found in nearby lagoons, suggesting that phytoplankton primary production is limited by phosphorus in Lagoa de Araruama. The major loss of DIP is apparently driven by biological assimilation and diagenic reactions in the sediments. Calculations indicate that the lagoon is slightly net autotrophic at +0.9 mol C m⁻² yr⁻¹. This suggests that the biomass of the primary producers is restricted by phosphorus availability. Phosphorus retention in the sediment and the hypersaline state of the lagoon prevent changes in autotrophic communities and the formation of eutrophic conditions.     

Fracture analysis in the south-western Corinth rift (Greece) and implications on fault hydraulic behavior

This paper reviews the data concerning the fracture network and the hydraulic characteristics of faults in an active zone of the Gulf of Corinth. Pressure gap measured through fault planes shows that in this area the active normal faults (Aigion, Helike) act, at least temporarily and locally, as transversal seal. The analysis of the carbonate cements in the fractures on both the hangingwall and the footwall of the faults also suggests that they have acted as local seals during the whole fault zone evolution. However, the pressure and the characteristics of the water samples measured in the wells indicate that meteoric water circulates from the highest part of the relief to the coast, which means it goes through the fault zones. Field quantitative analysis and core studies from the AIG-10 well have been performed to define both regional and fault-related fracture networks. Then laboratory thin section observations have been done to recognize the different fault rocks characterizing the fault zone components. These two kinds of approach give information on the permeability characteristics of the fault zone. To synthesize the data, a schematic conceptual 3D fluid flow modeling has been performed taking into account fault zone permeability architecture, sedimentation, fluid flow, fault vertical offset and meteoric water influx, as well as compaction water flow. This modeling allows us to fit all the data with a model where the fault segments act as a seal whereas the relays between these segments allow for the regional flow from the Peloponnese topographic highs to the coast.     

Permanent Scatterers for landslide investigations: outcomes from the ESA-SLAM project

Within the SLAM project (Service for Landslide Monitoring), launched in 2003 by the European Space Agency (ESA) the Permanent Scatterers (PS) technique, a multi-image interferometric approach, coupled with the interpretation of aerial-photos and optical satellite images, was carried out for landslide investigations. The PS analysis was applied at a regional scale as support for landslide inventory mapping and at local scale for the monitoring of single well-known slope movements. For the integration of the PS measurements within a landslide inventory the Arno river basin (Italy) was chosen as test site for the presence of a high number of mass movements (to date about 300 areas at high landslide risk and more than 27,000 individual landslides mapped by the institutional authorities). About 350 SAR images have been interferometrically processed by means of the PS technique, with the detection of about 600,000 PS. The use of optical images contributed spatial meaning to the point-wise information provided by the PS, making it easier to identify terrain features related to slope instability and the landslide boundaries. Here we describe the employed methodology and its impact in the updating of a preexisting landslide inventory. 6.8% of the total number of landslides were characterized by ground displacement measurements from the PS: 6.1% of already mapped landslides and 0.8% of new unstable areas detected through the PS analysis. Moreover, most of the PS are located in urban areas, showing that the proposed methodology is suitable for landslide mapping in areas with a quite high density of urbanization, but that over vegetated areas it still suffers from the limitations induced by the current space-borne SAR missions (e.g. temporal de-correlation). On the other hand, the use of InSAR for the monitoring of single slow landslides threatening built-up areas has provided satisfactory results, allowing the measurement of superficial deformations with high accuracy on the landslide sectors characterized by a good radar reflectivity and coherence.     

Seismic studies of the Brasília fold belt at the western border of the São Francisco Craton, Central Brazil, using receiver function, surface-wave dispersion and teleseismic tomography

The Tocantins Province in Central Brazil is composed of a series of SSW–NNE trending terranes of mainly Proterozoic ages, which stabilized in the Neoproterozoic in the final collision between the Amazon and São Francisco cratons. No previous information on crustal seismic properties was available for this region. Several broadband stations were used to study the regional patterns of crustal and upper mantle structure, extending the results of a recent E–W seismic refraction profile. Receiver functions and surface wave dispersion showed a thin crust (33–37 km) in the Neoproterozoic Magmatic Arc terrane. High average crustal Vp/Vs ratios (1.74–1.76) were consistently observed in this unit. The foreland domain of the Brasília foldbelt, on the other hand, is characterized by thicker crust (42–43 km). Low Vp/Vs ratios (1.70–1.72) were observed in the low-grade foreland fold and thrust zone of the Brasília belt adjacent to the São Francisco craton. Teleseismic P-wave tomography shows that the lithospheric upper mantle has lower velocities beneath the Magmatic Arc and Goiás Massif compared with the foreland zone of the belt and São Francisco craton. The variations in crustal thickness and upper mantle velocities observed with the broadband stations correlate well with the measurements along the seismic refraction profile. The integration of all seismic observations and gravity data indicates a strong lithospheric contrast between the Goiás Massif and the foreland domain of the Brasília belt, whereas little variation was found across the foldbelt/craton surface boundary. These results support the hypothesis that the Brasília foreland domain and the São Francisco craton were part of a larger São Francisco-Congo continental plate in the final collision with the Amazon plate.     

Advanced interpretation of interferometric SAR data to detect,monitor and model ground subsidence: outcomes from the ESA-GMES Terrafirma project

Land subsidence is a common natural hazard striking extensive areas worldwide, with severe impacts on economy and environment. Subsidence has been recognized as one of geohazards needing research efforts and knowledge transfer at international level, especially when urban fabrics and infrastructures are directly involved in the land settling. Policies and solutions for land subsidence management can be different. Despite this variability, where mitigation methods need to be adopted, mapping, monitoring and simulation of subsidence have to precede their design and implementation. In this framework, Earth Observation (EO) and remote sensing have a major role to play. Satellite Synthetic Aperture Radar Interferometry, thanks to its wide spatial coverage and its millimeter accuracy, provides a valuable contribution in the management of hazard posed by subsidence-related deformation. The ESA-GMES Terrafirma project (2003–2014) has worked for the promotion of the persistent scatterer interferometry, a family of techniques ideally suited for the assessment of magnitude of surface deformations associated with subsidence phenomena. Within the Terrafirma Project a series of products, based on the integration of EO technologies and in situ data, has been established and delivered to a wide community of end user. Three case studies, outcomes of the Terrafirma project, are presented: the wide area of Rome (Italy), the Anthemountas basin and the Kalochori village (Greece). These case studies have been selected with the purpose of showing the essential contribution of interferometric data during the main activities that must be covered when dealing with geohazard investigations (i.e., mapping, monitoring and modeling). These three case studies are meant to be representative of the suite of services delivered by the Terrafirma project to specific end users with the legal mandated to manage the geohazard.     

An orthotropic interface damage model for simulating drying processes in soils

The study of drying process in soils has received an increased attention in the last few years. This is very complex phenomenon that generally leads to the formation and propagation of desiccation cracks in the soil mass. In recent engineering applications, high aspect ratio elements have proved to be well suited to tackle this type of problem using finite elements. However, the modeling of interfaces between materials with orthotropic properties that generally exist in this type of problem using standard (isotropic) constitutive model is very complex and challenging in terms of the mesh generation, leading to very fine meshes that are intensive CPU demanding. A novel orthotropic interface mechanical model based on damage mechanics and capable of dealing with interfaces between materials in which the strength depends on the direction of analysis is proposed in this paper. The complete mathematical formulation is presented together with the algorithm suggested for its numerical implementation. Some simple yet challenging synthetic benchmarks are analyzed to explore the model capabilities. Laboratory tests using different textures at the contact surface between materials were conducted to evaluate the strengths of the interface in different directions. These experiments were then used to validate the proposed model. Finally, the approach is applied to simulate an actual desiccation test involving an orthotropic contact surface. In all the application cases the performance of the model was very satisfactory.