Effects of the geometry of two‐dimensional fractures on their hydraulic aperture and on the validity of the local cubic law

Flow through rough fractures is investigated numerically in order to assess the validity of the local cubic law for different fracture geometries. Two‐dimensional channels with sinusoidal walls having different geometrical properties defined by the aperture, the amplitude, and the wavelength of the walls' corrugations, the corrugations asymmetry, and the phase shift between the two walls are considered to represent different fracture geometries. First, it is analytically shown that the hydraulic aperture clearly deviates from the mean aperture when the walls' roughness, the phase shift, and/or the asymmetry between the fracture walls are relatively high. The continuity and the Navier–Stokes equations are then solved by means of the finite element method and the numerical solutions compared to the theoretical predictions of the local cubic law. Reynolds numbers ranging from 0.066 to 66.66 are investigated so as to focus more particularly on the effect of flow inertial effects on the validity of the local cubic law. For low Reynolds number, typically less than 15, the local cubic law properly describes the fracture flow, especially when the fracture walls have small corrugation amplitudes. For Reynolds numbers higher than 15, the local cubic law is valid under the conditions that the fracture presents a low aspect ratio, small corrugation amplitudes, and a moderate phase lag between its walls.     

Quaternary evolution of the Gulf of İzmit (NW Turkey): a sedimentary basin under control of the North Anatolian Fault Zone

The Quaternary evolution of the Gulf of İzmit, situated on the tectonically active North Anatolian Fault Zone (NAFZ), was investigated using seismic reflection, paleontologic, and sediment textural data. On the basis of seismic stratigraphic and sedimentologic-paleontologic interpretations, four depositional units were distinguished within the Plio-Quaternary sequence of the Gulf of İzmit. According to these data, Plio-Quaternary deposits supplied from the northern terrestrial area started to accumulate during a progradational phase, in a south-facing half-graben. A coarse-grained sedimentary unit prograding into the gulf from the south since 200 ka b.p. indicates a dramatic variation in the evolution of the gulf, with the initiation of a new strike-slip fault of the NAFZ and a corresponding uplift of the Armutlu Peninsula in the south of the gulf. During the evolution of this fault from a wide shear zone consisting of right-stepped strike-slip faults and pull-apart basins to a localized principal fault zone, sediments were deposited under the influence of northerly prograding terrestrial and shallow-marine conditions due to relative sea-level fluctuations in the Marmara Sea. During this period, the Gulf of İzmit was invaded mainly by Mediterranean and partly by Black Sea waters. In the latest glacial period, shallow areas in the gulf became subaerially exposed, whereas the central and western sub-basins of the gulf turned into lakes. The present evolution of the Gulf of İzmit is controlled by the after effects of the new rupture of the NAFZ and the estuarine nature of the gulf environment.     

3S技术与智能交通

地球空间信息技术是当前世界范围内发展最快的三大重要高新技术之一,随着其不断地发展和完善,其基础理论和技术方法已经日趋成熟,并正在从规划、国土、测绘、军事等专业应用向社会生活的众多行业和领域渗透和拓展,3S技术在交通领域的应用已成为当前国内外研究和应用的热点.着重介绍了地球空间信息技术在道路交通领域的应用背景,阐述了3S技术与道路交通结合的理论支撑和技术方法,进而介绍了其在交通管理、物流管理、智能导航、交通信息服务和交通安全等方面的典型应用,并展望了3S技术在现代交通领域的发展前景.     

应县木塔地基工程地质勘测与分析

对山西应县木塔环境地质进行了研究,弄清了地层年代及存在的断层;通过样品分析、标准贯入及静探等方法试验、测试,得出了塔院区塔基土的工程物理性质和力学性质、承载力;用地学层析成像技术探测了木塔的基础结构及塔院地基的分层结构。     

云南兰坪北部铜多金属矿化区成矿流体流动与矿化分带——流体包裹体和稳定同位素依据

滇西兰坪盆地北部发育了一类受逆冲推覆构造控制的浅成热液Cu—Ag—Pb-Zn矿化，形成了白秧坪、富隆厂、吴底厂、麻栗坪及金满、科登涧等大-中型矿床和矿点，并存在矿化分带。文章利用这些矿化脉体的流体包裹体和热液方解石的碳氧同位素组成资料，研究成矿流体与矿化分带的关系。结果表明，成矿流体主要属于NaCl-H2O成分体系，盐度ω(NaCleq)为2％～11％，形成温度为170～300℃，形成于1．8～3．8km深度内，这些相似性说明这类矿化的发生具有相似的流体性质和沉淀机制。热液方解石在δ^13C-δ^18O图解中呈近水平线展布的型式，指示流体源自地壳浅部的地下水系统，与海相灰岩等围岩作用形成了溶解碳以[HCO3^]-为主的成矿流体，流体与岩石的相互作用可能是成矿流体沉淀的主要机理。从西到东，流体包裹体的盐度-温度由高到低变化与矿化分带和逆冲推覆构造的根带→中带→锋带相配套，显示重力驱动流动可能是主要的流体流动机制。成矿流体在不同构造部位流动的通畅及流体．岩石系统的封闭-开放程度等流体流动性质与矿化发生的强度和规模有关，兰坪北部逆冲推覆构造中带的流体通畅地流动及沉淀时处于相对开放状态，有利于该区形成较大规模的浅成热液多金属矿化。     

5－（4－羧基苯偶氮）－8－（对甲苯磺酰氨基）－喹啉与金显色反应研究及应用

以８－氨基喹啉为母体，合成了新试剂５－（４－羧基苯偶氮）－８－（对甲苯磺酰氨基）－喹啉（ＣＰＴＳＱ），研究了它与Ａｕ的显色反应，在ＣＴＭＡＢ存在下，于ｐＨ１０～１３的ＮａＯＨ介质中，ＣＰＴＳＱ与Ａｕ形成２：１紫蓝色络合物，最大吸收峰位于６１０ｎｍ，摩尔吸光系数１．０×ｌ０５Ｌ·ｍｏｌ－１·ｃｍ－１，Ａｕ含量在０～１．２ｍｇ／Ｌ内符合比尔定律。方法选择性好，灵敏度高，操作简便，已用于金矿石样品中Ａｕ的测定，结果满意。     

时间剖面上小断层的计算机自动检测

煤田地震勘探一直探寻着对小断层的自动检测方法，因受各种因素的影响，至今尚无良策。本文介绍了多元地震参数的模式识别方法，并通过模型及实测资料成功地检测到１０ｍ以下小断层。     

华南西部晚二叠世碳同位素地层学研究

对黔桂地区７条晚二叠世碳酸盐岩型煤系剖面进行了碳酸盐岩碳氧同位素测定，发现晚二叠世吴家坪阶与长兴阶碳酸盐岩的δ１３Ｃ值有明显差异，前者δ１３Ｃ多大于３．０‰，后者多小于３．０‰，进一步对晚二叠世δ１３Ｃ的变化原因的分析表明，δ１３Ｃ的变化可能与晚古生代末期聚煤作用的减弱密切相关，后者造成自然界碳库中的１２Ｃ的富集，从而使得海水以及在其中沉淀出的碳酸盐岩中的δ１３Ｃ值降低。此外，植物光合作用从大气中吸收ＣＯ２的量也随陆地植被减少而减少，结果造成大气中的ＣＯ２的大量富集，从而进一步产生温室效应，制约生物界的发展。联系到这一阶段生物界的衰亡灭绝，可以认为温室效应是晚二叠世生物逐渐衰亡及晚二叠世末群体灭绝的主要原因之一。     

益阳市矿泉水的基本特征及形成机理探讨

益阳市矿泉水是一种弱酸、弱碱性、低矿化、富含偏硅酸的ＨＣＯ３－Ｃａ天然优质饮料矿泉水。它赋存于武陵期海底裂隙式喷溢形成的基性火山岩－细碧玄武岩的构造断裂和半风化层的风化裂隙之中。矿泉水水量起源于多途，化学成分形成于多因，是多因复成的产物。     

Molecular modeling of the 10-Å phase at subduction zone conditions

Molecular dynamics (MD) modeling of the 10-Å phase, Mg₃Si₄O₁₀(OH)₂·xH₂O, with x=2/3, 1.0 and 2.0 shows complex structural changes with pressure, temperature and water content and provides new insight into the structures and stabilization of these phases under subduction zone conditions. The structure(s) of this phase and its role as a reservoir of water in the mantle have been controversial, and these calculations provide specific predictions that can be tested by in situ diffraction studies. At ambient conditions, the computed structures of talc (x=0) and the 10-Å phases with x=2/3 and 1.0 are stable over the 350-ps period of the MD simulations. Under these conditions, the 10-Å phases show phlogopite-like layer stacking in good agreement with previously published structures based on powder X-ray diffraction data for samples quenched from high-pressure and high-temperature experiments. The calculations show that the 10-Å phase with x=2.0 is unstable at ambient conditions. The computed structures at P=5.5 GPa and T=750 K, well within the known stability field of the 10-Å phase, change significantly with water content, reflecting changing H-bonding configurations. For x=2/3, the layer stacking is talc-like, and for x=1.0, it is phlogopite-like. The calculations show that transformation between these two stackings occurs readily, and that the talc-like stacking for the x=2/3 composition is unlikely to be quenchable to ambient conditions. For x=2.0, the layer stacking at P=5.5 GPa and T=750 K is different than any previously proposed structure for a 10-Å phase. In this structure, the neighboring basal oxygens of adjacent magnesium silicate layers are displaced by b/3 (about 3 Å) resulting in the Si atoms of one siloxane sheet being located above the center of the six-member ring across the interlayer. The water molecules are located 1.2 Å above the center of all six-member rings and accept H-bonds from the OH groups located below the rings. The b/3-displaced structure does not readily transform to either the talc-like or phlogopite-like structure, because neither of these stackings can accommodate two water molecules per formula unit. There is likely to be a compositional discontinuity and phase transition between the b/3-displaced phase and the phase with phlogopite-like stacking. The simulations reported here are the first to use the recently developed CLAYFF force field to calculate mineral structures at elevated pressures and temperatures.