Metal levels in seston and marine fish flesh near industrial and metropolitan centres in South Australia.

Port Pirie is the site of the largest lead smelter in the world, depositing 250 t of zinc, and 100 t of lead annually into Spencer Gulf. Barker Inlet is adjacent to metropolitan Adelaide, and receives unknown quantities of urban and industrial discharges. Both areas are sites of major commercial and recreational fisheries, contained within delicately balanced marine wetland ecosystems, comprising large areas of mangrove and seagrass habitats. Aldrichetta forsteri and Sillago schomburgkii are major species within these fisheries and as estuarine-dependent species were chosen for this study as indicator species for the detection and monitoring of pollutant impacts in the nearshore marine ecosystems of South Australia. Seston sediment collectors were deployed at each site and analysed seasonally for the presence of cadmium, lead and copper. Flesh samples from A. forsteri and S. schomburgkii were examined seasonally for the presence of cadmium, lead and copper and the results correlated with levels found in the seston sediment at each site. Metal concentrations were also correlated with a biomarker of genotoxicity measured in the same animals (micronuclei in erythrocytes) that were reported previously. Seston levels of cadmium, lead and copper were highest at Port Pirie, followed by Barker Inlet and were lowest at Wills Creek, with cadmium undetectable at the latter site. Metals in seston varied considerably with season, with generally higher levels in winter samples. In fish flesh, metal levels followed broadly similar trends as for seston. Spearman rank correlations between metals in seston and in flesh were strongly positive. There was also a significant correlation between flesh concentrations of each metal and the frequency of micronuclei in erythrocytes. This study has shown that seston concentration of pollutant metals are high in areas of industrial activity, and that these levels are also reflected in metal content of fish flesh. Mean flesh levels of cadmium and copper did not exceed Australian health based maximum permitted levels of fish for human consumption, whereas flesh levels of lead in fish from Port Pirie and Barker Inlet exceeded these standards in each of the seasons monitored. This may represent a significant dietary source of lead in humans, especially at Port Pirie where human lead exposure from terrestrial sources is important. There may also be the potential for accumulation of metals in residents of metropolitan Adelaide whose diets are high in fish (and/or crustaceans), particularly estuarine-dependent species, such as A. forsteri and S. schomburgkii. The study also showed that a non-specific biomarker of genotoxicity (micronuclei in erythrocytes) is potentially useful as a monitoring technique in fish species to evaluate their exposure and genotoxic responses to pollutants in South Australian waters. These data represent a snapshot of the current situation in this area and may act as background levels against which future improvements or decrements in water quality may be compared.     

Urban land use mapping: A case study of ahmedabad city and its environs

Proper urban planning and effective implementation requires reliable urban land use statistics. In this context, satellite remote sensing data has been studied using both visual and digital techniques. A portable eight-band radiometer has been used to collect spectral signatures of surface features present in Ahmedabad city and its environs. Using these signatures a suitable approach employing visual and digital techniques has been developed for urban land use/sprawl mapping. Urban land-use maps of Ahmedabad city and its environs were prepared on 1:25,000 scale and for Ahmedabad Urban Development Authority Area on 1:50,000 scale using this methodology. It has been found that edge-enhancement techniques are useful to enhance the contrast among different urban land uses. Classification techniques such as MXL and Bayes classifiers are not successful in discriminating urban land uses. Tonal characteristics alongwith other elements of interpretation are required to classify urban land uses such as residential, industrial etc. Spatial distribution of various urban and uses and the space devoted to each urban land use has been brought out.     

Assessment of land degradation hazards,etah district,uttar pradesh using landsat data

To understand the nature of land degradation and factors responsible for it, investigations were carried out in Etah district with an area of 4.45 lakh hectares. For identification of soil/land degradation problems, multidate Landsat, TM spectral bands and FCC were used. It is observed that salt-affected soils are sharply depicted by light and dark gray mixed tone on band 3, while they are not clear on band 4. Flood plain and waterlogged soils are clearly observed on band 4. Band 6 (10.3 – 12.5 µm) helps in separation of broad zones of coarse and fine-textured soils, active flood plain of rivers, and eroded and gullied lands. The confusion between coarse-textured droughty soils and salt-affected areas in TM FCC (2, 3, 4) could be eliminated by use of band-6 data in combination with FCC. For delineation of problematic areas, two approaches were followed viz. (i) physiographic approach, and (ii) direct approach. In the physiographic approach landscape map associated with image characteristics was prepared. Further the image interpretation units were interpreted for land degradation hazards. With this approach physiography and soil relationship and the degradation problems vis-a-vis soil units could be established and ameliorative measures as per soil condition can be suggested. In direct approach, the problematic areas as per predetermined key were demarcated. Out of 4.45 lakh ha of the area, 1.99 lakh ha is affected by various soil degradation problems, like droughty soils, flooding hazard and salinity and alkalinity which cover 22.1%, 50.0% and 27.9%, respectively. To study the distribution of a salt-affected lands, major physiographic boundaries were superimposed over the land degradation map prepared by direct approach. It is observed that 81.5% of the salt-affected areas lie in the old alluvial plain while 18.5% is in recent flood plain.     

Estimation of sediment sources using selected chemical tracers in the Perry lake basin,Kansas,USA

The ability to achieve meaningful decreases in sediment loads to reservoirs requires a determination of the relative importance of sediment sources within the contributing basins. In an investigation of sources of fine-grained sediment （clay and silt） within the Perry Lake Basin in northeast Kansas, representative samples of channel-bank sources, surface-soil sources （cropland and grassland）, and reservoir bottom sediment were collected, chemically analyzed, and compared. The samples were sieved to isolate the 〈63μt m fraction and analyzed for selected nutrients （total nitrogen and total phosphorus）, organic and total carbon, 25 trace elements, and the radionuclide cesium-137 （^137Cs）. On the basis of substantial and consistent compositional differences among the source types, total nitrogen （TN）, total phosphorus （TP）, total organic carbon （TOC）, and ^137Cs were selected for use in the estimation of sediment sources. To further account for differences in particle-size composition between the sources and the reservoir bottom sediment, constituent ratio and clay-normalization techniques were used. Computed ratios included TOC to TN, TOC to TP, and TN to TP. Constituent concentrations （TN, TP, TOC） and activities （^137Cs） were normalized by dividing by the percentage of clay. Thus, the sediment-source estimations involved the use of seven sediment-source indicators. Within the Perry Lake Basin, the consensus of the seven indicators was that both channel-bank and surface-soil sources were important in the Atchison County Lake and Banner Creek Reservoir subbasins, whereas channel-bank sources were dominant in the Mission Lake subbasin. On the sole basis of ^137Cs activity, surface-soil sources contributed the most free-grained sediment to Atchison County Lake, and channel-bank sources contributed the most fine-grained sediment to Banner Creek Reservoir and Mission Lake. Both the seven-indicator consensus and ^137Cs indicated that channelbank sources were dominant for Perry Lake and that channel-bank sources increased in importance with distance downstream in the basin.     

Long-term marine litter monitoring in the remote Great Australian Bight, South Australia

The Anxious Bay beach litter clearance is the longest running annual survey of ocean-based litter in Australia. It's remoteness from centres of human population and location (with respect to prevailing winds and currents) make it an ideal place for monitoring ocean or ship-based litter in Australia's southern oceans and particularly, the Great Australian Bight. Over the 1991-1999 period, a large but gradual decline in the amount of beach washed litter was recorded (with minor peaks recorded during the 1992 and 1994 surveys). Beach washed litter decreased by approximately 86%, from 344 kg recorded in 1991 (13.2 kg/km) to 49 kg in 1999 (i.e. 1.9 kg/km), reaching a maximum of 390 kg in 1992 (or 15 kg/km of beach). However, a sharp increase in litter was recorded in 2000 (i.e. 252 kg or 9.7 kg/km). This increase in litter yield in 2000 is probably due to stronger than average onshore surface flow (or Ekman Transport) in the western Eyre Peninsula and Bight region. Prior to the survey in 2000, the results appeared to indicate that ocean litter on Anxious Bay beach was beginning to level out at around 50-70 kg/year (i.e. 2-3 kg/km). As the beach surveys involve the assumption that the beach is completely cleared of litter, this may represent a baseline level for ocean-based litter in the region. The yields and type of litter collected from the annual survey indicates that the majority of litter washed ashore originates from commercial fishing activities within the Great Australian Bight. Most of the fishing-related litter was directly sourced to the Southern Rock Lobster Fishery (i.e. bait buckets, baskets, pots), the Great Australian Bight Trawl Fishery (i.e. codends, trawl nets) and the Southern Shark Fishery (i.e. monofilament gillnets and longlines). Between 1994 and 1999, large reductions were observed in the amount of bait straps (77% reduction), lobster bait baskets/buckets (86% reduction), nets/ropes (62% reduction) and floats/buoys (83% reduction). Significantly, fishing-related litter in the Bight has reduced at a slower rate than domestic litter. While the level of glass and soft plastics on the beach have both reduced by almost 93% (i.e. 103-7 kg and 119-8 kg, respectively), the level of hard plastics, has diminished at a slower rate, with reductions of only 75% (i.e. 122-30 kg). Some fisheries (i.e. rock lobster, Southern Shark Fishery) have shown marked reductions in fishing-related litter. This is probably due, to some extent, to significant reductions in fishing effort in the region, although this requires further investigation. The information from the Anxious Bay beach litter survey is crucial in monitoring trends in ocean litter in Australia's southern oceans and compliance with international litter regulations. While fishing-related litter remains the major source of ship-based or ocean litter in Australia's southern oceans, the continued reduction in ship-based litter since 1991 supports increasing compliance to MARPOL (Annex V) by commercial fisheries and shipping in the Great Australian Bight. While Australia participates in marine debris monitoring programs in the Antarctic (under CCAMLR), there is currently no national program or management framework to assess, manage and monitor ocean-based litter along Australia's coasts, and monitor compliance with MARPOL. Apart from the commitments under CCAMLR for Antarctic (and sub-Antarctic) marine environments, there are no other regional programs, guidelines or monitoring protocols or to assess and manage ocean litter in the Southern Ocean.