Finite Element Modeling of Swelling Soil Pressures Using Joint/Interface Elements

There could be some discontinuities in a soil media such as layers, earth structures, cracks, and fissures so that estimation of stresses and deformations in these types of soil masses are somewhat different from continuous masses. The discontinuities in a soil mass could be considered as a special link between two blocks. Transmitted swelling pressures affected by the soil properties of the backfill especially at the interface between the backfill and retaining wall. In order to estimate the transmitted swelling pressure distribution behind a retaining wall, using with interface element, a new finite element model and a code (SWELPRES) have been developed. To evaluate the effect of backfill characteristics and interface element from the transmitted lateral swelling pressures, four cases of thickness of backfills with or without interface elements are investigated.     

Effect of wetting–drying cycles on swelling behavior of lime stabilized sand–bentonite mixtures

In the present study, influence of wetting–drying cycles on swelling pressures of sand–bentonite mixtures used in the construction of sanitary landfills to have an impermeable liner was investigated before and after lime treatment of the mixtures. Swelling pressure tests were conducted to see if the swelling pressures were affected by wetting–drying cycles. First series of specimens were prepared as a mixture of sand and bentonite only. In the first series of specimens, sand was mixed with bentonite in various proportions with their optimum water contents and compacted by using standard proctor energy. In the second series of the specimens, lime in various proportions was added to the mixtures of sand–bentonite. Then, the sand–bentonite mixtures stabilized by lime were compacted with the standard proctor energy at their optimum moisture contents. Five wetting–drying cycles were performed on each specimen and values of swelling pressures were measured at the end of each cycle. Results of swelling pressure tests indicated that the swelling pressure is decreased when lime is added to the mixtures. In addition, decrements were observed on swelling pressures by wetting–drying cycles. The results of the experiments of this investigation showed that the beneficial effect of lime stabilization to control the swelling pressures was partly lost by the wetting–drying cycles. However, the test results indicated that the swelling pressures of the specimens made of sand–bentonite mixtures stabilized by lime were lower than the swelling pressures of the specimens made of only sand–bentonite mixtures.     

Landslide susceptibility mapping by frequency ratio and logistic regression methods: an example from Niksar–Resadiye (Tokat,Turkey)

Turkey confronts loss of life and large economic losses due to natural disasters caused by its morphologic structure, geographical placement, and climate characteristics. The Kuzulu (Koyulhisar) landslide, which caused loss of life and property on 17th March 2005, occurred in an area near the country’s most important active fault, the North Anatolian Fault Zone. To mitigate and prevent landslide damages, prediction of landslide susceptibility areas based on probabilistic methods has a great importance. The purpose of this study was to produce a landslide susceptibility map by the logistic regression and frequency ratio methodologies for a 733-km² area near the North Anatolian Fault Zone from the southeast of Niksar to Resadiye in Tokat province. Conditioning parameters, such as elevation, slope gradient, slope aspect, distance to streams, roads, and faults, drainage density, and fault density, were used in the analysis. Before susceptibility analysis, the landslides observed in the area were separated into two groups for use in analysis and verification, respectively. The susceptibility maps produced had five different susceptibility classes such as very low, low, moderate, high, and very high. To test the performance of the susceptibility maps, area under curve (AUC) approach was used. For the logistic regression method, the AUC value was 0.708; while for the frequency rate method, this value was 0.744. According to these AUC values, it could be concluded that the two landslide susceptibility maps obtained were successful.     

Artificial neural networks and fuzzy logic based control of spillway gates of dams

In this paper a new and efficient control method based on fuzzy logic is proposed for real‐time operation of spillway gates of a reservoir during any flood of any magnitude up to the probable maximum flood. Artificial neural networks are used to model the non‐linear relationship among the main variables of the reservoir under consideration. In order to demonstrate the performance of the proposed method, we simulate the control system using different probable overflow hydrographs. The results of the proposed control method are compared with the results of the conventional control methods. The results obtained from the simulations indicate that the proposed method exhibits superior performance over the conventional reservoir flood operation, with much more flexible results. Copyright © 2004 John Wiley & Sons, Ltd.     

Impact of wetting–drying cycles on the hydraulic conductivity of liners made of lime-stabilized sand–bentonite mixtures for sanitary landfills

In this study, an investigation was performed to determine if lime-stabilized sand–bentonite mixtures are appropriate for the construction of sanitary landfills liners. For this aim, the hydraulic conductivity tests were conducted in the laboratory on sand–bentonite mixtures and lime-stabilized sand–bentonite mixtures to evaluate the effect of wetting–drying cycles. The hydraulic conductivity tests were performed to see if their hydraulic conductivities are affected by wetting–drying cycles. First series of specimens have been prepared as a mixture of sand and bentonite only. In the first series of specimens, sand was mixed with bentonite in proportions of 20, 30, 40, and 50 %. In the second series of the specimens, lime in proportions of 1, 2 and 3 % by weight was added to the mixtures of sand–bentonite in proportions of 20, 30, 40, and 50 %. From the results of the tests, it was observed that while optimum water content increased, maximum dry density decreased with addition of lime to the sand–bentonite mixtures. Generally, the hydraulic conductivity increased with the addition of lime to the mixtures but at low percentages of lime (1–2 %), however, slight decreases in k were recorded. It was also observed that the wetting–drying cycles on the permeability test indicate cure effect on specimens with addition of lime which resulted in decreased the hydraulic conductivity.     

Assessment of the consecutive harmful dinoflagellate blooms during 2015 in the Izmit Bay (the Marmara Sea)

A series of red tides were observed during 2015 in the Izmit Bay(the Marmara Sea) which is located in the most industrialized and populated region of Turkey. Six samplings were carried out in this area following the red tides.Nitrite-N, nitrate-N, ammonia, silica and orthophosphate concentrations were analyzed spectrophotometrically.Physicochemical conditions were measured by CTD probe. Plankton quantification was performed using counting chambers under microscopes. Prorocentrum micans was the most abundant species, except on May 14,2015, when Noctiluca scintillans was dominant. The abundance of P. micans reached average 18×10~6 ind./L on May 3, 2015 in the Karamürsel station, simultaneously with elevated levels of NH_3 and o-PO_4~(3–). The sample was also abundant in dead amphipods((72±12) ind./L) that had been covered by mucilage aggregates produced by P.micans. The highest biomass(calculated by carbon) was recorded as(268±26.0) mg/L on May 14 in the Hereke station. Beside the anthropogenic wastewater discharges, unknown sources and resuspensions caused increases in nutrient levels. After long term northeaster gusts(35 km/h for 5 d) an upwelling occurred on November 6, 2015 after wind-induced sediment resuspension. Although nutrient discharges remarkably decreased over 30 years through established wastewater treatment plants, harmful phytoplankton blooms still occur. Comparing the present results with other studies in nearby Mediterranean seas reveals that the most intense harmful dinoflagellate bloom in recent years occurred in the Izmit Bay. Therefore, additional protection measures necessary for a cleaner Izmit Bay. These incidents also demonstrate that contaminants, accumulated in sediment,may have long-lasting effects on enclosed marine ecosystems.     

Experimental and numerical investigation of slope stabilization by stone columns

In this study, an investigation has been performed on a small-scaled laboratory model and its numerical model by the code of PLAXIS to see the effect of stone columns (SCs) placed vertically in a soft soil slope in terms of slope stability, bearing capacity, and settlements. Also, several hypothetical cases have been examined by the code. Effect of s/D ratios (distance between the vertical axes of SCs/diameter of SCs) was also investigated on slope stability, ultimate bearing capacity, and settlement of a footing rested on top of the slope on the laboratory model. Firstly, ultimate bearing capacity and settlement properties of soil were determined for unreinforced soil that is no SCs were considered. Then, some values of soil were determined after the installation of stone columns with various ratios of s/D. The ratios of s/D were 2, 3, 3.5, and 4. The tests carried out on the laboratory model were simulated and numerically analyzed in two dimensions under plain-strain conditions by Mohr?CCoulomb model. In the analyses, PLAXIS computer code, which is based on finite elements method, has been employed. Then, a parametric investigation was carried out to see the effect of SCs on the stability of the slope. In the parametric investigation, several hypothetical cases that were one layer of soil and two layers of soil with the presence of water in the reservoir side of the slopes were examined. The analyses in the investigation were performed by the PLAXIS code for various slope angles ??, ratios of c/(??H), and ratios of s/D. From the test results of the laboratory model, and the results obtained from the numerical analyses, it was observed that the bearing capacity of the footing constructed on the top of the slope in soft soil was increased; settlements were decreased after the improvement with SCs. From the analyses performed, it was found that the SCs increased the stability of slope 1.18- to 1.62-fold as a relative effect of different parameters.     

A comparison of landslide susceptibility mapping of the eastern part of the North Anatolian Fault Zone (Turkey) by likelihood-frequency ratio and analytic hierarchy process methods

The North Anatolian Fault is known as one of the most active and destructive fault zones which produced many earthquakes with high magnitudes both in historical and instrumental periods. Along this fault zone, the morphology and the lithological features are prone to landslides. Kuzulu landslide, which is located near the North Anatolian Fault Zone, was triggered by snow melting without any precursor, occurred on March 17, 2005. The landslide resulted in 15 deaths and the destruction of about 30 houses at Kuzulu village. There is still a great danger of further landslides in the region. Therefore, it is vitally important to present its environmental impacts and prepare a landslide susceptibility map of the region. In this study, we used likelihood-frequency ratio model and analytical hierarchy process (AHP) to produce landslide susceptibility maps. For this purpose, a detailed landslide inventory map was prepared and the factors chosen that influence landslide occurrence were: lithology, slope gradient, slope aspect, topographical elevation, distance to stream, distance to roads, distance to faults, drainage density and fault density. The ArcGIS package was used to evaluate and analyze all the collected data. At the end of the susceptibility assessment, the area was divided into five susceptibility regions, such as very low, low, moderate, high and very high. The results of the analyses were then verified using the landslide location data and compared with the probability model. For this purpose, an area under curvature (AUC) and the seed cell area index assessments were applied. An AUC value for the likelihood-frequency ratio-based model 0.78 was obtained, whereas the AUC value for the AHP-based model was 0.64. The landslide susceptibility map will help decision makers in site selection and the site-planning process. The map may also be accepted as a basis for landslide risk-management studies to be applied in the study area.     

Investigation of heavy metal pollutants at various depths in the Gulf of Izmit

In this study, we report results concerning the accumulation of heavy metals in seawater from Izmit Bay. The bay was divided into the three parts: the eastern, the central and the western basins. The goal of this study was to determine levels of heavy metals at various depths in the bay between April 2008 and May 2010. Liquid–liquid extractions were performed on seawater samples. An atomic absorption spectrophotometer was used to measure levels of six metals: lead, cadmium, chromium, iron, manganese and zinc. We applied our results to evaluate the status of pollution in the Gulf of Izmit. Significant seasonal differences in metal concentrations and higher concentrations of many metals in water near the shore are evidence for uncontrolled release of pollutants in the water.