Internet‐Based GIS Mapping in Support of K‐12 Education

Internet‐based mapping provides a powerful alternative for successfully establishing GIS technology in the K‐12 education community, while simultaneously avoiding the traditional barriers associated with desktop GIS. Internet‐based GIS can support standards‐based inquiry methods of teaching and learning while providing basic analysis tools for studying and exploring geographic or scientific data in the classroom.     

The ordovician and other post-rosslare series Rocks in Southeast Co. Wexford

Ordovician sediments at Tagoat and Rosslare Harbour are re-described and their relationship to the underlying Rosslare Series discussed. A brief outline of their petrology is given, but it is shown that the fauna is in need of revision before reliable correlations can be made. Similar rocks are recorded near Tomhaggard; amongst these, spotted mudstones imply Ordovician or later intrusions. Undeformec dykes intrusive into the Rosslare Series are believed to be representatives of this phase.     

Development of Specimen Curing Procedures that Account for the Influence of Effective Stress During Curing on the Strength of Cemented Mine Backfill

Paste backfill used to provide ground support in underground mining is generated from full-stream tailings and is almost always placed underground with cement. For the backfill, both the rate of strength development and the final strength are important considerations for design, particularly when the backfill is subsequently exposed in the stope-mining sequence. There is strong evidence that strengths measured on specimens obtained from coring the in situ cemented backfill are much greater than laboratory-cured specimens with the same cement content. The paper reviews some of the experimental evidence showing that one of the major reasons for the different strength is the difference in effective stress acting on the backfill during curing. Laboratory specimens are (almost) always cured under zero total stress, so no effective stress develops. In contrast, backfill in a stope may cure under high effective stress, which develops due to either “conventional” consolidation in free-draining backfills, or to the so-called “self-desiccation” mechanism in fine-grained fills. Evidence is presented showing how the final strength is affected by applying stress to specimens at different stages of curing and at different rates. It is shown that a fully-coupled analysis of the filling behaviour is required to determine the appropriate effective stress regime to apply in curing laboratory specimens, where “fully-coupled” in this context means taking account of the interaction of consolidation/drainage rate, filling rate and cement hydration rate. Curing protocols for laboratory specimens are proposed, which would ensure that the strengths obtained are representative of in situ conditions.     

Polycyclic aromatic hydrocarbons in sediments,mussels and crustacea around a former gasworks site in Shoreham-by-Sea,UK

Concentrations of polycyclic aromatic hydrocarbons have been determined in sediments, mussels and crustacea in the vicinity of a former gasworks site by Shoreham Harbour, UK. Very high concentrations of PAH were found in the substrate, an ash-like material deposited on the former gasworks site, which exhibited a profile consistent with the major source of contamination being coal or coke tar produced during the period of gas production at the site. Elevated PAH concentrations were also found in mussels both from the beach below the former gasworks site, and from sites further to the east in Portslade and Hove. The significance of these concentrations were assessed using an approach which involved the calculation of benzo[a]pyrene equivalent conoentrations (BaPEs), summing concentrations of individual PAH on the basis of their comparative potency as carcinogens. BaPE ranged from values of, or close to, zero for crustacea, to 336 microg kg(-1) wet weight in mussels from Southwick Beach. The contaminated mussels are not exploited commercially but may be taken by casual gatherers, and notices have been posted to warn potential consumers.     

Polybrominated diphenyl ethers and polychlorinated biphenyls in sediments of southwest Taiwan: regional characteristics and potential sources

Very little information is available on the contamination of coastal sediments of Taiwan by PBDEs and PCBs. In this study, we determined the concentrations of 19 PBDE and 209 PCB congeners in 57 surface sediment samples to identify the possible sources of PBDEs and PCBs. The total PBDE and PCB concentrations ranged from below detection limit to 7.73 ng/g and 0.88-7.13 ng/g, respectively; these values are within the ranges observed for most coastal sediments worldwide. The PBDE congeners were dominated by BDE-209 (50.7-99.7%), with minor contributions from penta- and octa-BDEs. The signatures of PCB congeners suggested that PCB residues in Kaohsiung coast may be the legacy of past use or the result of ongoing inputs from the maintenance, repair and salvage of old ships. Principal component analysis of the congener-specific composition of PBDEs and PCBs revealed distinct regional patterns that are related to the use of commercial products.     

Preparation and Measurement of Cassiterite for Sn Isotope Analysis

Increased interest in the fractionation of Sn isotopes has led to the development of several techniques for preparing cassiterite (SnO₂, the primary ore of Sn) for isotopic analysis. Two distinct methods have been applied in recent isotopic studies of cassiterite: (a) reduction to tin metal with potassium cyanide (KCN) at high temperature (800 °C), with subsequent dissolution in HCl, and (b) reduction to a Sn solution with hydriodic acid (HI) at low temperature (100 °C). This study compares the effectiveness and accuracy of these two methods and contributes additional methodological details. The KCN method consistently yielded more Sn (> 70% in comparison with < 5%), does not appear to fractionate Sn isotopes at high temperatures over a 2‐hour period and produced consistent Sn isotope values at flux mass ratios of ≥ 4:1 (flux to mineral) with a minimum reduction time of 40 min. By means of a distillation experiment, it was demonstrated that HI could volatilise Sn, explaining the consistently low yields by this method. Furthermore, the distillation generated Sn vapour, which is up to 0.38‰ per mass unit different from the starting material, the largest induced Sn fractionation reported to date. Accordingly, the HI method is not recommended for cassiterite preparation for Sn isotopic analysis.     

Hydrothermal activity on the southern Mid-Atlantic Ridge: Tectonically- and volcanically-controlled venting at 4–5°S

We report results from an investigation of the geologic processes controlling hydrothermal activity along the previously-unstudied southern Mid-Atlantic Ridge (3–7°S). Our study employed the NOC (UK) deep-tow sidescan sonar instrument, TOBI, in concert with the WHOI (USA) autonomous underwater vehicle, ABE, to collect information concerning hydrothermal plume distributions in the water column co-registered with geologic investigations of the underlying seafloor. Two areas of high-temperature hydrothermal venting were identified. The first was situated in a non-transform discontinuity (NTD) between two adjacent second-order ridge-segments near 4°02′S, distant from any neovolcanic activity. This geologic setting is very similar to that of the ultramafic-hosted and tectonically-controlled Rainbow vent-site on the northern Mid-Atlantic Ridge. The second site was located at 4°48′S at the axial-summit centre of a second-order ridge-segment. There, high-temperature venting is hosted in an  18 km² area of young lava flows which in some cases are observed to have flowed over and engulfed pre-existing chemosynthetic vent-fauna. In both appearance and extent, these lava flows are directly reminiscent of those emplaced in Winter 2005−06 at the East Pacific Rise, 9°50′N and reference to global seismic catalogues reveals that a swarm of large (M 4.6−5.6) seismic events was centred on the 5°S segment over a  24 h period in late June 2002, perhaps indicating the precise timing of this volcanic eruptive episode. Temperature measurements at one of the vents found directly adjacent to the fresh lava flows at 5°S MAR (Turtle Pits) have subsequently revealed vent-fluids that are actively phase separating under conditions very close to the Critical Point for seawater, at  3000 m depth and 407 °C: the hottest vent-fluids yet reported from anywhere along the global ridge crest.