Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.     

Fast genetic mapping in barley: case studies of cuticle mutants using RNA-sequencing

Barley(Hordeum vulgare L.) is one of the earliest domesticated crop species and ranked as the fourth largest cereal production worldwide. Forward genetic studies in barley have greatly advanced plant genetics during the last century; however, most genes are identified by the conventional mapping method. Array genotyping and exome-capture sequencing have also been successfully used to target the causal mutation in barley populations, but these techniques are not widely adopted because of associated costs and partly due to the huge genome size of barley. This review summarizes three mapping cases of barley cuticle mutants in our laboratory with the help of RNA-sequencing. The causal mutations have been successfully identified for two of them and the target genes are located in the pericentromeric regions. Detailed information on the mapping-by-sequencing, mapping-and-sequencing, and RNA-sequencing assisted linkage mapping are presented and some limitations and challenges on the mapping assisted by RNA sequencing are also discussed. The alternative and elegant methods presented in this review may greatly accelerate forward genetics of barley mapping, especially for laboratories without large funding.     

SDSS J143030.22-001115.1： A Misclassified Narrow-line Seyfert 1 Galaxy with Flat X-ray Spectrum

We used multi-component profiles to model the Hβ and [OⅢ]λλ4959,5007 lines of SDSS J143030.22-001115.1, a narrow-line Seyfert 1 galaxy (NLS1) in a sample of 150 NLS1 candidates selected from the Sloan Digital Sky Survey (SDSS), Early Data Release (EDR). After subtracting the Hβ contribution from narrow line regions (NLRs), we found that its full width half maximum (FWHM) of broad Hβ line is nearly 2900km s~(-1) , significantly larger than the customarily adopted criterion of 2000 km s~(-1) . With its weak Fe Ⅱ multiples, we believe that SDSS J143030.22-001115.1 should not be classified as a genuine NLS1. When we calculate the virial black hole masses of NLS1s, we should use the Hβ linewidth after subtracting the NLR component.     

Multistep matched-field inversion for broad-band data from ASIAEX2001

This paper discusses the results of geoacoustic inversion carried out using explosive charge data from the Asian Seas International Acoustic Experiment (ASIAEX) East China Sea (ECS) Experiment. A multifrequency incoherent matched-field inversion processor and a genetic algorithm (GA) are used for the inversion. A multistep matched field inversion approach is presented, which makes use of the varying sensitivities of wave fields at various frequencies to reduce the inversion problem into a sequence of smaller inversions with fewer unknowns to estimate at each stage. Different parameters are estimated using data at different frequencies according to their sensitivities. Inversion results for different areas in the ECS region are summarized and compared with core data.     

湘西州地质旅游资源及其开发建议

系统地介绍了湘西州的地质旅游资源特征,指出切实保护和合理开发利用湘西州丰富的地质旅游资源,将旅游业作为支柱产业是发展该州经济的合理之举,进而提出了保护和开发该州地质旅游资源的8条建议.     

Progresses in geology and hazards analysis of Tianchi Volcano

A number of different lahars have been recognized from a systematic survey of a mapping project. The high setting temporamre feature of the deposits indicates a relationship between the lahar and the Millennium eruption event of Tianchi Volcano. The lahars caused a dramatic disaster. Recognize of the huge avalanche scars and deposits around Tianchi Volcano imply another highly destructive hazard. Three types of different texture of the avalanche deposits have been recognized. There was often magma mixing processes during the Millennium eruption of Tianchi Volcano, indicating a mixing and co-eruption regime of the eruption.     

广西难处理金矿固化焙烧氰化提金试验

通过对广西六梅金矿、明山金矿、金牙金矿含高砷高硫难浸金矿石进行固化焙烧—氰化提金的试验研究 ,获得了砷、硫固定率分别为 99.0 3%、97.0 4 % ,金浸出率 92 .35 %的较好指标 ,为这类难浸金矿的开发 ,展示了一种经济有效的途径     

Theory of stability, and regulation and control of ecological system in oasis

Starting with analysis on the evolving course of oasis and the characteristics and evolution of transitional zone between oasis and desert, in consideration of ecological elements including plant stomata resistance, area covered by vegetation, and physical elements including albedo of vegetation and bare soil, atmosphere temperature, and humidity, under the condition of the balance among net radiation flux, latent heat flux, and sensible heat flux, the following are calculated: temperatures of vegetation and bare soil in different conditions, as well as the evapotranspiration rate of ecosystem. Analysis on evapotranspiration rate indicates that it depends on both the climate of environment and the physiological and ecological conditions of plants. On certain conditions, the evapotranspiration rate of transitional zone between oasis and desert (i.e. area covered by vegetation less than 20%), in some parameter domains, appears in bifurcation or multiequilibrium state. Meanwhile, in such area, ecosystem is extremely unstable. Any minor change to the balance will cause either increase or reduction of area covered by vegetation in ecosystem, on the basis of discussion on the emergency of these phenomena. This paper is attempting to propose an effective way of destruction and rebuilt ecosystem in transitional zone. The way is to control the evaporation of plant through selecting anti-drought country plant with big stomata resistance, and modify the roughness of the underlying surface in ecosystem by establishing rational interspace structure of plant community, so as to put the degenerative ecosystem into the natural succession track. This primary theory is being verified through observation and analysis on historical data.     

Statistical analysis of sand grain/bed collision process recorded by high-speed digital camera

A high‐speed digital camera was employed to record the sand grain/bed collision process. With image processing and a statistical method, a series of parameters of the collision process were obtained. The results show that the collision process of a grain with rebounding can be represented by two parameters: the kinetic energy restitution coefficient and the collision angle. Both parameters satisfy a normal distribution, and they are dependent on one another. With an increase of the collision angle, the distribution of the kinetic energy restitution gradually reduces from a broad to a narrow range with low values. The percentage of vertical velocity restitution coefficients greater than 1 can reach 70% or more, which ensures that the settling time of the sand grains in the air increases and that they receive more energy from the air to progress the saltation movement.     

Zircon U–Pb and Hf isotopic study of gneissic rocks from the Chinese Altai: Progressive accretionary history in the early to middle Palaeozoic

Gneissic rocks in the Chinese Altai Mountains have been interpreted as either Paleozoic metasedimentary rocks or Precambrian basement. This study reports geochemical and geochronological data for banded paragneisses and associated gneissic granitoids collected along a NE–SW traverse in the northwestern Chinese Altai. Petrological and geochemical data suggest that the protoliths of the banded gneisses were possibly immature sediments with significant volcanic input and that the gneissic granitoids were derived from I-type granites formed in a subduction environment. Three types of morphological features can be recognized in zircons from the banded gneisses and are interpreted to correlate with different sources. Zircons from five samples of banded paragneiss cluster predominantly between 466 and 528 Ma, some give Neoproterozoic ages, and a few yield discordant Paleoproterozoic to Archean ages. Zircon Hf isotopic compositions indicate that both juvenile/mantle and crust materials were involved in the generation of the source rocks from which these zircons were derived. In contrast, zircons occur ubiquitously as elongated euhedral prismatic crystals in the four samples of the gneissic granitoids, and define single populations for each sample with mean ages between 380 and 453 Ma. The general absence of Precambrian inheritance and positive zircon ?Hf values for these granitoids suggest insignificant crustal contribution to the generation of the precursor magmas. Our data can be interpreted in terms of a progressive accretionary history in early to middle Palaeozoic times, and the Chinese Altai may possibly represent a magmatic arc built on a continental margin dominated by Neoproterozoic rocks.