Some consequences of meteoroid impacts on Saturn's rings

High-velocity impacts of interplanetary meteoroids on Saturn's rings are discussed. It is shown that the neutral gas emitted by impact vaporization may be responsible, to a large part, for the observed neutral ring atmosphere. Both the predicted neutral gas injection rate and the gas temperature (or kinetic energy) are compatible with the measurements (see Broadfoot, A. L., B. R. Sandel, D. E. Shemansky, J. B. Holberg, G. R. Smith, D. F. Strobel, J. C. McConnell, S. Kumar, D. M. Hunten, S. K. Atreya, T. M. Dohnahne, H. W. Moos, J. L. Bertaux, J. E. Blamont, R. B. Pomphrey, and S. Linik, Science212, 206–211, 1981). Heavy ejecta particles produce a particulate ring “halo”. The physical properties of this halo are calculated, and it appears to be identical with the tenous particle population discussed by Baum and Kreidl (1982). Erosion of Saturn's ring particles, the resulting mass balance, and regolith formation are estimated. This provides some constraints on surface properties and optical albedo.     

The ion-composition of the plasma produced by impacts of fast dust particles

The composition of the impact plasma produced by fast dust particles (v > 1 km/sec) hitting an Au or W target was measured both with a model of the HELIOS micrometeoroid experiment (low electric field at the target) and a high field detector. The plasma composition and the total plasma charge depend strongly on the impact velocity and the electric field strength at the target. Spectra of 9 different projectile-target combinations were analysed. Two types of spectra could be observed, depending on the projectile material. (1) Spectra of metals and hard dielectrics (Mohs' hardness ? 5). Particle constituents of low ionisation energy (e · u ? 7eV, e.g. Na, K, Al) dominate the spectra of these materials at impact velocities below 10 km/sec. At higher speed the relative intensities change and new ions with higher ionisation energies appear. (2) Spectra of soft dielectrics (Mohs' hardness < 3). Below 9 km/sec these materials produced less total charge than did the others. The highest masses were detected at 74 amu. The relative abundance of ions with low ionization energies such as Li, Na, K, etc. is comparatively small. Negative ions were also observed in the impact plasma. Their total number was found to be approximately 3–6% of that of the positive ions at 6 km/sec particle speed.     

Bifurcation points in close binary evolution: Medium-mass binaries

The remaining core hydrogen burning lifetime after case B of mass transfer of the secondary (mass gaining) component in a medium mass close binary star is estimated, for mediummass binaries with primaries in the mass range 5M to 9M . From the comparison of this quantity with the helium burning time-scale of the remnant primary a critical mass ratioq _c is derived such that for larger values ofq, mass transfer from the secondary towards the primary starts before the latter has evolved into a white dwarf. Consequences for the advanced stages of medium mass binaries are discussed.     

Synchronous aperture synthesis observations of pulsars

By modifying the online software of the Westerbork Synthesis Radio Telescope it is possible to sample the radio emission from a field containing a pulsar synchronously with the pulsed signal. Recording the emission from eight separate temporal windows, we can simultaneously observe both the on-pulse and off-pulse signals. We are using this technique for three different kinds of pulsar investigation: (a) to check and improve the positions of some pulsars; (b) to look for unpulsed components; and (c) to search for weak extended emission around pulsars. Observations have been carried out at 6, 21, 49, and 92 cm. Examples of results from all three types of investigation are given.Paper presented at the 11th European Regional Astronomical Meetings of the IAU on New Windows to the Universe, held 3–8 July, 1989, Tenerife, Canary Islands, Spain.     

Investigation of the electrostatic charging of dust particles in a Paul-trap

Dust particles (glass, tungsten, and nickel) with sizes ranging from 0.25 to 3m were levitated in a Paul-trap and charged by ions or electrons. For ions the particle potential is limited at field strength of about 1×10⁹ V m^–1 by a temperature-dependent discharge mechanism. The particles interaction with 2 to 20 keV electrons always leads to positive surface potentials which can be explained in terms of a decreased absorption of electrons by small particles. Micrometer sized agglomerates were used for the investigation of the electrostatic fragmentation. Fragmentation takes place in a twofold manner: small surface flufl can be removed or the parent particle can be disrupted into smaller agglomerates.Paper presented at the 11th European Regional Astronomical Meetings of the IAU on New Windows to the Universe, held 3–8 July, 1989, Tenerife, Canary Islands, Spain.     

A combined study of macroseismic data and focal mechanisms applied to the West-Bohemian earthquake,Czechoslovakia

The main shock of the West-Bohemian earthquake swarm, Czechoslovakia, (magnitudem=4.5, depthh=10 km) exhibits an irregular areal distribution of macroseismic intensities 6° to 7° MSK-64. Four lobes of the 6° isoseismal are found and the maximum observed intensity is located at a distance of 8 km from the instrumentally determined epicentre. This distribution can be explained by the energy flux of the directS wave generated by a circular source, the hypocentral location and focal mechanism of which are taken from independent instrumental studies. The theoretical intensity, which is assumed to be logarithmically proportional to the integrated squared ground-motion velocity (i.e.,I=const+log v ² (t)dt), fits the observed intensity with an overall root-mean-square error less than 0.5°. It is important that the present intensity data can also be equally well explained by the isotropic source. The fit was attained by means of a horizontally layered model though large fault zones and an extended sedimentary basin suggest a significant lateral heterogeneity of the epicentral region. The results encourage a broader application of the simple modelling technique used.     

The evolution of massive close binaries

The results of evolutionary computations for massive binary systems (initial masses of the primary 10M ) with mass ratios between 0.3 and 0.8 are summarized and compared with observations in order to verify how far one can go with the conservative assumption of mass exchange. It is found that conservative mass exchange leads to acceptable first-order models of W-R and massive X-ray binaries. However, the comparison between this theory and observation reveals that for the observed systems (W-R and X-ray binaries) a preference exists for low intial mass ratios; moreover, the X-ray luminosities of the theoretical models are systematically too low, though this may be due to the adopted wind model. In addition, the influences of several parameters (distance between the components, chemical composition, primary mass, mass ratio and atmosphere) are examined. These parameters influence the remnant mass and any further evolution only marginally. Attention is also given to the effect on the system parameters of a supernova explosion of the remnant of the mass-losing component. For a large range of systems a disruption probability smaller than 25% is found.     

New Generation of Probabilistic Seismic Hazard Assessment for the Area Cologne/Aachen Considering the Uncertainties of the Input Data

A new earthquake catalogue for central, northern and northwestern Europe with unified M_w magnitudes, in part derived from chi-square maximum likelihood regressions, forms the basis for seismic hazard calculations for the Lower Rhine Embayment. Uncertainties in the various input parameters are introduced, a detailed seismic zonation is performed and a recently developed technique for maximum expected magnitude estimation is adopted and quantified. Applying the logic tree algorithm, resulting hazard values with error estimates are obtained as fractile curves (median, 16% and 84% fractiles and mean) plotted for pga (peak ground acceleration; median values for Cologne 0.7 and 1.2 m/s² for probabilities of exceedence of 10% and 2%, respectively, in 50 years), 0.4 s (0.8 and 1.5 m/s²) and 1.0 s (0.3 and 0.5 m/s²) pseudoacclerations, and intensity (I₀ = 6.5 and 7.2). For the ground motion parameters, rock foundation is assumed. For the area near Cologne and Aachen, maps show the median and 84% fractile hazard for 2% probability of exceedence in 50 years based on pga (maximum median value about 1.5 m/s²), and 0.4 s (>2 m/s²) and 1.0 s (about 0.8 m/s²) pseudoaccelerations, all for rock. The pga 84% fractile map also has a maximum value above 2 m/s² and shows similarities with the median map for 0.4 s. In all maps, the maximum values fall within the area 6.2–6.3° E and 50.8–50.9° N, i.e., east of Aachen.     

An Mw based earthquake Catalogue for central, northern and northwestern Europe using a hierarchy of magnitude conversions

Data from 25 local catalogues and 30special studies of earthquakes in central,northern and northwestern Europe have beenincorporated into a Databank. The dataprocessing includes discriminating eventtypes, eliminating fake events and dupletsand converting different magnitudes andintensities to M_w if this is not givenby the original source. The magnitudeconversion is a key task of the study andimplies establishment of regressionequations where no local relations exist.The Catalogue contains tectonic events fromthe Databank within the area44°N–72°N,25°W–32°E and the time period1300–1993. The lower magnitude level forthe Catalogue entries is setat M_w == 3.50. The area covered by thedifferent catalogues are associated withpolygons. Within each polygon only datafrom one or a small number of the localcatalogues, supplemented by data fromspecial studies, enter the Catalogue. Ifthere are two or more such catalogues orstudies providing a solution for an event,a priority algorithm selects one entry forthe Catalogue. Then M_w is calculatedfrom one of the magnitude types, or frommacroseismic data, given by the selectedentry according to another priority scheme.The origin time, location, M_w magnitude and reference are specified for eachentry of the Catalogue. So is theepicentral intensity, I₀, if providedby the original source. Following thesecriteria, a total of about 5,000earthquakes constitute the Catalogue.Although originally derived for the purposeof seismic hazard calculation within GSHAP,the Catalogue provides a data base for manytypes of seismicity and seismic hazardstudies.     

Stratigraphy of the upper cretaceous and lower tertiary strata in the Tethyan Himalayas of Tibet (Tingri area,China)

The 1500-m-thick marine strata of the Tethys Himalaya of the Zhepure Mountain (Tingri, Tibet) comprise the Upper Albian to Eocene and represent the sedimentary development of the passive northern continental margin of the Indian plate. Investigations of foraminifera have led to a detailed biozonation which is compared with the west Tethyan record. Five stratigraphic units can be distinguished: The Gamba group (Upper Albian - Lower Santonian) represents the development from a basin and slope to an outer-shelf environment. In the following Zhepure Shanbei formation (Lower Santonian - Middle Maastrichtian), outer-shelf deposits continue. Pebbles in the top layers point to beginning redeposition on a continental slope. Intensified redeposition continues within the Zhepure Shanpo formation (Middle Maastrichtian - Lower Paleocene). The series is capped by sandstones of the Jidula formation (Danian) deposited from a seaward prograding delta plain. The overall succession of these units represents a sea-level high at the Cenomanian/Turonian boundary followed, from the Turonian to Danian, by an overall shallowing-upward megasequence. This is followed by a final transgression — regression cycle during the Paleocene and Eocene, documented in the Zhepure Shan formation (?Upper Danian - Lutetian) and by Upper Eocene continental deposits. The section represents the narrowing and closure of the Tethys as a result of the convergence between northward-drifting India and Eurasia. The plate collision started in the Lower Maastrichtian and caused rapid changes in sedimentation patterns affected by tectonic subsidence and uplift. Stronger subsidence and deposition took place from the Middle Maastrichtian to the Lower Paleocene. The final closure of remnant Tethys in the Tingri area took place in the Lutetian.