Sheet flow and suspension of sand in oscillatory boundary layers

after revisionTime-dependent measurements of flow velocities and sediment concentrations were conducted in a large oscillating water tunnel. The measurements were aimed at the flow and sediment dynamics in and above an oscillatory boundary layer in plane bed and sheet-flow conditions. Two asymmetric waves and one sinusoidal wave were imposed using quartz sand with D₅₀ = 0.21 mm. A new electro-resistance probe with a large resolving power was developed for the measurement of the large sediment concentrations in the sheet-flow layer. The measurements revealed a three layer transport system consisting of a pick-up/deposition layer, an upper sheet flow layer and a suspension layer.In the asymmetric wave cases the total net transport was directed “onshore” and was mainly concentrated in the thin sheet flow layer (< 0.5 cm) at the bed. A small net sediment flux was directed “offhore” in the upper suspension layer. The measured flow velocities, sediment concentrations and sedimenl fluxes showed a good qualitative agreement with the results of a (numerical) 1DV boundary-layer flow and transport model. Although the model did not describe all the observed processes in the sheet-flow and suspension layer, the computational results showed a reasonable agreement with measured net transport rates in a wide range of asymmetric wave conditions.     

Stability of waterfront retaining wall subjected to pseudo-static earthquake forces

Waterfront retaining walls supporting dry backfill are subjected to hydrostatic pressure on upstream face and earth pressure on the downstream face. Under seismic conditions, if such a wall retains a submerged backfill, additional hydrodynamic pressures are generated. This paper pertains to a study in which the effect of earthquakes along with the hydrodynamic pressure including inertial forces on such a retaining wall is observed. The hydrodynamic pressure is calculated using Westergaard's approach, while the earth pressure is calculated using Mononobe-Okabe's pseudo-static analysis. It is observed that when the horizontal seismic acceleration coefficient is increased from 0 to 0.2, there is a 57% decrease in the factor of safety of the retaining wall in sliding mode. For investigating the effect of different parameters, a parametric study is also done. It is observed that if φ is increased from 30° to 35°, there is an increase in the factor of safety in the sliding mode by 20.4%. Similar observations were made for other parameters as well. Comparison of results obtained from the present approach with [Ebeling, R.M., Morrison Jr, E.E., 1992. The seismic design of waterfront retaining structures. US Army Technical Report ITL-92-11. Washington DC] reveal that the factor of safety for static condition (k_h=0), calculated by both the approaches, is 1.60 while for an earthquake with k_h=0.2, they differ by 22.5% due to the consideration of wall inertia in the present study.     

Applications of AnnAGNPS model for soil loss estimation and nutrient loading for Malaysian conditions

The study evaluated the performance and suitability of AnnAGNPS model in assessing runoff, sediment loading and nutrient loading under Malaysian conditions. The watershed of River Kuala Tasik in Malaysia, a combination of two sub-watersheds, was selected as the area of study. The data for the year 2004 was used to calibrate the model and the data for the year 2005 was used for validation purposes. Several input parameters were computed using methods suggested by other researchers and studies carried out in Malaysia. The study shows that runoff was predicted well with an overall R² value of 0.90 and E value of 0.70. Sediment loading was able to produce a moderate result of R² = 0.66 and E = 0.49, nitrogen loading predictions were slightly better with R² = 0.68 and E = 0.53, and phosphorus loading performance was slightly poor with an R² = 0.63 and E = 0.33. The erosion map developed was in agreement with the erosion risk map produced by the Department of Agriculture, Malaysia. Rubber estates and urban areas were found to be the main contributors to soil erosion. The simulation results showed that AnnAGNPS has the potential to be used as a valuable tool for planning and management of watersheds under Malaysian conditions.     

Evaluation of three waterborne polymers as stabilizers for sandy soil

This study reports on waterborne polymer emulsion systems that were used for structural modification of sandy soils. The first emulsion used was a styrene-acrylic, copolymer emulsion; the second and third were vinyl-acrylic, copolymer-based emulsions. Specimens were prepared by adding different polymer emulsions to the sand and water in prescribed amounts. The performance of the different emulsion systems as sand stabilizers was estimated through measurement of the hydraulic conductivity and compressive strength. Measurements of hydraulic conductivity were conducted in a flexible membrane test apparatus. The hydraulic conductivity for the three emulsions decreased at different rates, with an increase in polymer content up to 3 wt. (i.e., % by weight). Additional increase of polymer content did not introduce significant decrease in hydraulic conductivity, and, at 5 wt.%, the three emulsions had essentially the same effect. Measurements made on dry cylindrical specimens disclosed remarkable enhancement in the mechanical behavior of the system. The compressive strength and modulus of elasticity of the examined emulsions increased with a higher concentration of polymer. Scanning electron microscope (SEM) revealed that the reduction in the permeability and the improved mechanical properties can be attributed to three dominant structural changes: the development of interconnecting ties between the sand particles, the development of adhesion between neighboring sand particles in contact, and the covering of the sand particles with a thin polymer film.     

Evidence of early generation of liquid hydrocarbon from suberinite as visible under the microscope

The early generation of liquid hydrocarbons from suberinite can be clearly observed under the microscope. The generation of this oil-like material, mainly in the form of exsudatinite, from the maceral suberinite occurs at a maturity level of about 0.4% vitrinite reflectance. Hydrocarbons appear to be naturally expelled from coal initially through sweating and agglomeration of suberinite which subsequently forms exsudatinite. It is suggested that extensive expulsion of exsudatinite causes cracks to develop in vitrinite whereas limited expulsion of exsudatinite will only impregnate the vitrinite matrix. If cracks are formed, it is possible they could progressively develop to form an exsudatinite-crack network. The formation of such a network is believed to represent an effective way of hydrocarbon expulsion from coal source rocks.     

Eocene tonalite–granodiorite from the Havza (Samsun) area,northern Turkey: adakite-like melts of lithospheric mantle and crust generated in a post-collisional setting

ABSTRACT

Eocene intermediate to felsic plutons of different sizes and compositions are widespread in the Eastern Pontides Orogenic Belt in northern Turkey. Of these, the Ta?l?k Tepe pluton in the Havza (Samsun) area is fine-to-medium-grained, with granular, porphyritic, and micrographic textures, and include mafic microgranular enclaves (MMEs). LA-ICP-MS U-Pb zircon dating yielded emplacement ages of 42.9 (± 1.4) and 40.5 (± 1.3) Ma for the host granodioritic pluton and the dioritic MMEs, respectively. Petrochemically, the host pluton has I-type, high-K calc-alkaline, and metaluminous-to-slightly peraluminous features (A/CNK = 0.95–1.06). The host pluton also shows geochemical features of adakite-like rocks with high SiO₂ (67–68 wt%) and Al₂O₃ (15.5–16.0 wt%) content and Ba/La (17–23), Sr/Y (40.7–61.6), and La_N/Yb_N (14.4–23.7) ratios and low Y (8.2–9.9 ppm) and Yb_N (3.1–4.4) contents. Whole-rock major and trace element variations suggest that fractional crystallisation played a significant role in the pluton evolution. The N-MORB normalised trace element patterns of the pluton are similar to those of MMEs with enrichment in large-ion lithophile elements, Th and Ce, and negative Nb and Ti anomalies. Chondrite-normalised rare earth element plots show moderate-to-highly enriched concave patterns (La_N/Lu_N = 14.2–21.6) with insignificant negative Eu anomalies (Eu_N/Eu* = 0.86–1.14), all of which imply hornblende fractionation during magmatic evolution. The pluton samples have ⁸⁷Sr/⁸⁶Sr ratios of 0.704767 to 0.704927, ¹⁴³Nd/¹⁴⁴Nd ratios of 0.512767–0.512774, εNd values of (+2.52) – (+2.65), and δ¹⁸O values of 7.9–9.7‰. The isotopic compositions of the host pluton and MMEs are similar to I-type granitoids derived from mantle sources. The MMEs show incomplete magma mixing/mingling, representing small bodies of mafic parental magma. Combined with regional studies, these new data suggest that the parental magma of the studied adakite-like pluton was generated from the lithospheric mantle and then modified by fractional crystallisation and assimilation in a post-collisional setting.     

Downscaling and projection of precipitation from general circulation model predictors in an equatorial climate region by the automated regression-based statistical method

The authors have applied an automated regression-based statistical method, namely, the automated statistical downscaling (ASD) model, to downscale and project the precipitation climatology in an equatorial climate region (Peninsular Malaysia). Five precipitation indices are, principally, downscaled and projected: mean monthly values of precipitation (Mean), standard deviation (STD), 90th percentile of rain day amount, percentage of wet days (Wet-day), and maximum number of consecutive dry days (CDD). The predictors, National Centers for Environmental Prediction (NCEP) products, are taken from the daily series reanalysis data, while the global climate model (GCM) outputs are from the Hadley Centre Coupled Model, version 3 (HadCM3) in A2/B2 emission scenarios and Third-Generation Coupled Global Climate Model (CGCM3) in A2 emission scenario. Meanwhile, the predictand data are taken from the arithmetically averaged rain gauge information and used as a baseline data for the evaluation. The results reveal, from the calibration and validation periods spanning a period of 40 years (1961–2000), the ASD model is capable to downscale the precipitation with reasonable accuracy. Overall, during the validation period, the model simulations with the NCEP predictors produce mean monthly precipitation of 6.18–6.20 mm/day (root mean squared error 0.78 and 0.82 mm/day), interpolated, respectively, on HadCM3 and CGCM3 grids, in contrast to 6.00 mm/day as observation. Nevertheless, the model suffers to perform reasonably well at the time of extreme precipitation and summer time, more specifically to generate the CDD and STD indices. The future projections of precipitation (2011–2099) exhibit that there would be an increase in the precipitation amount and frequency in most of the months. Taking the 1961–2000 timeline as the base period, overall, the annual mean precipitation would indicate a surplus projection by nearly 14~18 % under both GCM output cases (HadCM3 A2/B2 scenarios and CGCM3 A2 scenario). According to the model simulation, the September–November periods might be the more significant months projecting the increment of the precipitation amount around over 50 %, while the precipitation deficit would be seen in March–May periods.     

Changes to the Surface Level Solar Ultraviolet-B Radiation Due to Haze Perturbation

The South-East Asian region experienced a haze episode in 1994 which was widely believed to be due to widespread forest fires in Sumatra and Kalimantan (Indonesia). Broadband measurements of the surface level solar ultraviolet-B, UV-A and Global radiation at Penang (Malaysia) are used to study the effect of the 1994 haze on effective UV-B irradiance. We find that during the haze episode, there is enhanced absorption of surface level UV-B radiation. The effect of haze on UV-A and Global radiation is much less. The reduction in absolute noon time UV-B irradiance (mostly cloud free) during the 1994 haze period was 23% relative to the UV-B irradiance during thecorresponding haze-free period in 1995. Even though the noon time radiation data minimizes the cloud effect in the results presented some cloud effect is still present.     

How effective is the new generation of GPM satellite precipitation in characterizing the rainfall variability over Malaysia?

We investigated the potential of the new generation of satellite precipitation product from the Global Precipitation Mission (GPM) to characterize the rainfall in Malaysia. Most satellite precipitation products have limited ability to precisely characterize the high dynamic rainfall variation that occurred at both time and scale in this humid tropical region due to the coarse grid size to meet the physical condition of the smaller land size, sub-continent and islands. Prior to the status quo, an improved satellite precipitation was required to accurately measure the rainfall and its distribution. Subsequently, the newly released of GPM precipitation product at half-hourly and 0.1° resolution served an opportunity to anticipate the aforementioned conflict. Nevertheless, related evidence was not found and therefore, this study made an initiative to fill the gap. A total of 843 rain gauges over east (Borneo) and west Malaysia (Peninsular) were used to evaluate the rainfall the GPM rainfall data. The assessment covered all critical rainy seasons which associated with Asian Monsoon including northeast (Nov. - Feb.), southwest (May - Aug.) and their subsequent inter-monsoon period (Mar. - Apr. & Sep. - Oct.). The ability of GPM to provide quantitative rainfall estimates and qualitative spatial rainfall patterns were analysed. Our results showed that the GPM had good capacity to depict the spatial rainfall patterns in less heterogeneous rainfall patterns (Spearman’s correlation, 0.591 to 0.891) compared to the clustered one (r = 0.368 to 0.721). Rainfall intensity and spatial heterogeneity that is largely driven by seasonal monsoon has significant influence on GPM ability to resolve local rainfall patterns. In quantitative rainfall estimation, large errors can be primarily associated with the rainfall intensity increment. 77% of the error variation can be explained through rainfall intensity particularly the high intensity (> 35 mm d^-1). A strong relationship between GPM rainfall and error was found from heavy (~35 mm d^-1) to violent rain (160 mm d^-1). The output of this study provides reference regarding the performance of GPM data for respective hydrology studies in this region.