Physical parameters of near-Earth asteroid 1982 DV

Visual and infrared observations were made of Amor asteroid 1982 DV during its discovery apparition. Broadband visual and near-infrared photometry shows that it is an S-class asteroid. Narrowband spectrophotometry shows an absorption feature due to olivine or pyroxene or both centered at 0.93 μm. Applying a nonrotating thermal model to 10-μm photometry, the geometric albedo is calculated to be approximately 0.27. The geometric albedo for a slowly rotating, rocky surface was calculated for 1 night to be 0.15, consistent with S-class asteroid albedos. Thus, 1982 DV is either one of the most reflective S-class asteroids known, or a significant amount of bare rock is exposed on the asteroid's surface. For the nonrotating model, ellipsoidal dimensions for 1982 DV are 3.5 × 1.4 × 1.4 km.     

Spectroscopic binaries near the North Galactic Pole paper 18: HD 118670

Photoelectric radial-velocity measurements show that HD 118670 is a double-lined spectroscopic binary in an orbit which is not quite circular and whose period is about 48 days. Spectral types of K0 V and K7 V would satisfy the photometry and the mass ratio; the mass function would then suggest the possibility of eclipses. However, actual spectral classification indicates a luminosity somewhat above the main sequence     

Investigation of Failure Mechanisms and Migration of Organic Chemicals at Wilsonville, Illinois

Ground water contamination was discovered in 1981 in a monitoring well at the Earthline disposal facility near Wilsonville, Illinois. Organic chemicals had migrated at a rate 100 to 1000 times greater than predicted when the site received its permit to operate in 1978. Postulated failure mechanisms included migration through previously unmapped permeable zones, subsidence of an underground mine, organic-chemical and clay-mineral interactions, acid-mine drainage and clay interactions, trench-cover settlement, and erosion.
In this investigation, the Illinois State Geological Survey found the primary reason for the rapid migration: the presence of previously undetermined fractures and joints in glacial till. The inaccurate predictions of hydraulic conductivity were based on laboratory-determined values that did not adequately measure the effects of fractures and joints on the transit time calculations. Field-measured hydraulic conductivity values were generally 10 to 1000 times greater than their laboratory-measured counterparts, thus largely accounting for the discrepancy between predicted and actual migration rates in the transit time calculations. The problem was compounded, however, by the burial of liquid wastes and by trench covers that allowed excess surface runoff to enter the trenches. Organic-chemical and clay-mineral interactions may also have exacerbated the problem in areas where liquid organic wastes were buried.     

Using ALSM to map sinkholes in the urbanized covered karst of Pinellas County,Florida—1, methodological considerations

Comparison of a database of interpreted sinkholes made using airborne laser swath mapping (ALSM) with databases of sinkholes made from interpretation of aerial photographs reveals substantial disagreement. The discrepancies involve the location, number, areas, and circularity of interpreted sinkholes. Methodological factors that contribute to the discrepancies include blockage of ALSM laser returns in thick vegetation, multi-path reflections, and misrepresentation of the true extent of sinkholes. Comparison of two ALSM-derived databases made (1) independently from versus (2) in combination with earlier air photo analysis in undeveloped regions had the following result: one-fourth of the sinkholes interpreted by using the composite method were missed by the independent analysis, and one-third of the sinkholes that were interpreted from the independent analysis were not interpreted as sinkholes using the composite method. Subjective interpretation leads to a high level of uncertainty such that the results of the remote sensing studies are suspect, if not invalid.     

Scaling analysis of deposition from turbidity currents

Many oil-bearing sedimentary deposits are formed by the settling of particles from turbidity currents. Modeling sedimentary processes that form these turbidites enables the calculation of properties such as extent, depth, porosity and permeability of hydrocarbon-bearing reservoirs. This paper estimates the extent and thickness of turbidites from the initial conditions of the turbidity flow. This is achieved by the application of scaling analysis of the partial differential equations that govern the dynamics of and deposition from turbidity currents. We apply the results of scaling analysis to five modern submarine fans. The predicted and actual values of the dimensions of the fan deposits match well. We then compare the derived results against tabulated sizes of ancient turbidites. The comparisons are good as long as we correctly identify the flow regimes in which the deposition took place. The good agreements observed in the two cases show that the estimates obtained using scaling analysis can provide useful first-guess values for the dimensions of the deposits.     

Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.     

Otec cold water pipe design for problems caused by vortex-excited oscillations

Vortex-excited oscillations of marine structures result in reduced fatigue life, large hydrodynamic forces and induced stresses, and sometimes lead to structural damage and to destructive failures. The cold water pipe of an Ocean Thermal Energy Conversion (OTEC) plant is nominally a bluff, flexible cylinder with a large aspect ratio (L/D = length/diameter), and is likely to be susceptible to resonant vortex-excited oscillations. The objective of this paper is to survey recent results pertaining to the vortex-excited oscillations of structures in general and to consider the application of these findings to the design of the OTEC cold water pipe. Practical design calculations are given as examples throughout the various sections of the report.This paper is limited in scope to the problems of vortex shedding from bluff, flexible structures in steady currents and the resulting vortex-excited oscillations. The effects of flow non-uniformities, surface roughness of the cylinder, and inclination to the incident flow are considered in addition to the case of a smooth cylinder in a uniform stream. Emphasis is placed upon design procedures, hydrodynamic coefficients applicable in practice, and the specification of structural response parameters relevant to the OTEC cold water pipe. There are important problems associated with the shedding of vortices from cylinders in waves and from the combined action of waves and currents, but these complex fluid/structure interactions are not considered in this paper.     

Patterns and controls of surface sediment distribution: west-central Florida inner shelf

The west-central Florida inner shelf represents a transition between the quartz-dominated barrier-island system and the carbonate-dominated mid-outer shelf. Surface sediments exhibit a complex distribution pattern that can be attributed to multiple sediment sources and the ineffectiveness of physical processes for large-scale sediment redistribution. The west Florida shelf is the submerged extension of the Florida carbonate platform, consisting of a limestone karst surface veneered with a thin unconsolidated sediment cover. A total of 498 surface sediment samples were collected on the inner shelf and analyzed for texture and composition. Results show that sediment consists of a combination of fine quartz sand and coarse, biogenic carbonate sand and gravel, with variable but subordinate amounts of black, phosphorite-rich sand. The carbonate component consists primarily of molluskan fragments. The distribution is patchy and discontinuous with no discernible pattern, and the transition between sediment types is generally abrupt. Quartz-rich sediment dominates the inner 15 km north of the entrance into Tampa Bay, but south of the Bay is common only along the inner 3 km. Elsewhere, carbonate-rich sediment is the predominate sediment type, except where there is little sediment cover, in which cases black, phosphorite-rich sand dominates. Sediment sources are likely within, or around the periphery of the basin. Fine quartz sand is likely reworked from coastal units deposited during Pleistocene sea-level high stands. Carbonate sand and gravel is produced by marine organisms within the depositional basin. The black, phosphorite-rich sand likely originates from the bioerosion and reworking of the underlying strata that irregularly crop out within the study area. The distribution pattern contains elements of both storm- and tide-dominated siliciclastic shelves, but it is dictated primarily by the sediment source, similar to some carbonate systems. Other systems with similar sediment attributes include cool-water carbonate, sediment-starved, and mixed carbonate/siliciclastic systems. This study suggests a possible genetic link among the three systems.