Solution for a plane strain rough‐walled hydraulic fracture driven by turbulent fluid through impermeable rock

The impact of turbulent flow on plane strain fluid‐driven crack propagation is an important but still poorly understood consideration in hydraulic fracture modeling. The changes that hydraulic fracturing has experienced over the past decade, especially in the area of fracturing fluids, have played a major role in the transition of the typical fluid regime from laminar to turbulent flow. Motivated by the increasing preponderance of high‐rate, water‐driven hydraulic fractures with high Reynolds number, we present a semianalytical solution for the propagation of a plane strain hydraulic fracture driven by a turbulent fluid in an impermeable formation. The formulation uses a power law relationship between the Darcy‐Weisbach friction factor and the scale of the fracture roughness, where one specific manifestation of this generalized friction factor is the classical Gauckler‐Manning‐Strickler approximation for turbulent flow in a rough‐walled channel. Conservation of mass, elasticity, and crack propagation are also solved simultaneously. We obtain a semianalytical solution using an orthogonal polynomial series. An approximate closed‐form solution is enabled by a choice of orthogonal polynomials embedding the near‐tip asymptotic behavior and thus giving very rapid convergence; a precise solution is obtained with 2 terms of the series. By comparison with numerical simulations, we show that the transition region between the laminar and turbulent regimes can be relatively small so that full solutions can often be well approximated by either a fully laminar or fully turbulent solution.     

Active capture and anomalous adsorption: New mechanisms for the incorporation of heavy noble gases

Abstract— Active capture is a new process for the incorporation of large quantities of heavy noble gases into growing surfaces. Adsorption in the conventional sense involves surface bonding by polarization (Van der Waals forces). What is referred to as “anomalous adsorption” of heavy noble gases involves chemical bonds and can occur when other (more chemically active) species are not available to preempt sites with unfilled bonds. Anomalous adsorption has been observed under conditions of fracture, vacuum deposition and ionizing radiation. Active capture depends upon anomalous adsorption to retain noble gases on a surface long enough to be captured in a growing surface film as it is deposited. The fundamental principle may be the impingement onto the growing film with sufficient energy to liberate surface electrons (work function energy of a few electronvolts) so that they are retained by anomalous adsorption long enough to be entrapped in the growing surface. Trapping efficiencies of ?1% have been observed for Kr and Xe in laboratory experiments, implying a fundamentally new mechanism for the incorporation of heavy noble gases onto surfaces. It may play a role in explaining the large concentrations of planetary noble gases contained in phase‐Q.     

A spectroscopic study of the peculiar galaxy UGC 5600

We present our observations of the galaxy UGS 5600 with a long-slit spectrograph (UAGS) and a multipupil field spectrograph (MPFS) attached to the 6-m Special Astrophysical Observatory telescope. Radial-velocity fields of the stellar and gaseous components were constructed for the central region and inner ring of the galaxy. We proved the existence of two nearly orthogonal kinematic subsystems and conclude that UGC 5600 is a galaxy with an inner polar ring. In the circumnuclear region, we detected noncircular stellar motions and suspected the existence of a minibar. The emission lines are shown to originate in H II regions. We estimated the metallicity from the intensity ratio of the [N II]λ6583 and Hα lines to be nearly solar, which rules out the possibility that the polar ring was produced by the accretion of gas from a dwarf companion.     

Foraminiferal biostratigraphy and paleoenvironmental reconstruction at the Yaxcopoil‐1 drill hole,Chicxulub crater,Yucatán Peninsula

Abstract The Yaxcopoil‐1 (Yax‐1) drill hole comprises Cretaceous limestones and calcarenites, the K/P boundary cocktail unit (including impact breccia), and a Danian marly clay layer overlain by calcareous marls. The biostratigraphy, paleobathymetry, and environmental turnover across the K/P interval were inferred after analyzing the planktic and benthic foraminiferal assemblages. The Cretaceous samples only contain a few poorly preserved planktic foraminifera of a middle Campanian to Maastrichtian age, while low‐diversity benthic foraminiferal assemblages suggest a sufficient nutrient supply to the sea floor and a shallow neritic, occasionally stressed environment. The impact breccia and the redeposited suevite are overlain by a 46 cm‐thick dolomitic calcareous sandstone unit that contains scarce, reworked planktic foraminiferal specimens. This unit probably represents the uppermost part of the initial infill of the crater. The uppermost centimeters of this unit are bioturbated, and its top represents a hiatus that spans at least the G. cretacea, Pv. eugubina, and part of the P. pseudobulloides biozones. This unit is overlain by a 3–4 cm‐thick marly clay layer that represents a condensed layer. Benthic foraminiferal assemblages suggest a low food supply to the sea floor and environmental instability during the deposition of the marly clay layer. The increase in diversity of the assemblages indicates that the environmental conditions improved and stabilized from the G. compressa biozone toward the A. uncinata (P2) biozone. The Danian planktic and benthic foraminiferal assemblages indicate a deeper, probably bathyal environment.     

Coronal change at the south-west limb observed by Yohkoh on 9 November 1991, and the subsequent interplanetary shock at Pioneer Venus Orbiter

A spectacular change in the lower corona on the south-west limb has been found in solar images taken by the Yohkoh soft X-ray telescope. The event is characterized by a large topological change in magnetic field and a large intensity decrease observed after the X1. 1/1B flare on 9 November, 1991. A coronal mass ejection (CME) was observed by the Mark III K-coronameter (MK3) at the HAO/Mauna Loa Observatory. Both the MK3 (white-light) and soft X-ray observations showed that one leg of this CME was located above the flare site. An interplanetary shock associated with this event was observed by Pioneer Venus Orbiter, and, possibly, by IMP-8.Also Cooperative Institute for Research in the Environmental Sciences (CIRES), University of Colorado, Boulder, CO 80309, U.S.A.