Surface renewal analysis for sensible and latent heat flux density

High frequency temperature measurements were recorded at five heights and surface renewal (SR) analysis was used to estimate sensible heat flux density (H) over 0.1 m tall grass. Traces of the temperature data showed ramp-like structures, and the mean amplitude and duration of these ramps were used to calculate H using structure functions. Data were compared with H values measured with a sonic anemometer. Latent heat flux density (E) was calculated using an energy balance and the results were compared with E computed from the sonic anemometer data. SR analysis provided good estimates of H for data recorded at all heights but the canopy top and at the highest measurement level, which was above the fully adjusted boundary layer.     

Transmission and reflection of Rayleigh waves at a thin low velocity vertical layer: A laboratory and theoretical study

A three-dimensional ultrasonic modelling was used to study the Rayleigh waves reflected from a thin low velocity vertical layer and those transmitted through the same zone. The reflection and transmission coefficients of the Rayleigh waves have been calculated by an approximate method based on the Green function technique. Nonrigid contact boundary conditions were used for the low velocity layer modelling. A rather good correspondence between the theoretical and experimental absolute values of the reflection and the transmission coefficients was obtained. Some discrepancies between experimental and theoretical results, in particular with regard to phase shifts, may be explained by a certain inadequacy of the theoretical model to the low velocity layer investigated by the ultrasonic modelling.     

漳州热田的对流热流和传导热流的研究

漳州地热系统属对流型地热系统.漳州热田是我国东南沿海地区目前所见热田中温度最高（121.5℃）的一个.地表热流值的研究表明,热田中心具有最大的实测热流值（359mw/m²）.本文根据热田内152个钻孔的测温资料和56块岩石样品的热导率数据,采用三种不同方法计算出漳州热田及其邻近地区的大地热流值,并讨论了热流值分布的特点.     

Thermal evolution of the orogenic lower crust during exhumation within a thickened Moldanubian root of the Variscan belt of Central Europe

At the eastern margin of the Bohemian Massif (Variscan belt of Central Europe), large bodies of felsic granulite preserve mineral assemblages and structures developed during the early stages of exhumation of the orogenic lower continental crust within the Moldanubian orogenic root. The development of an early steep fabric is associated with east–west-oriented compression and vertical extrusion of the high-grade rocks into higher crustal levels. The high-pressure mineral assemblage Grt-Ky-Kfs-Pl-Qtz-Liq corresponds to metamorphic pressures of ∼18 kbar at ∼850 °C, which are minimum estimates, whereas crystallization of biotite occurred at 13 kbar and ∼790 °C during decompression with slight cooling. The late stages of the granulite exhumation were associated with lateral spreading of associated high-grade rocks over a middle crustal unit at ∼4 kbar and ∼700 °C, as estimated from accompanying cordierite-bearing gneisses. The internal structure of a contemporaneously intruded syenite is coherent with late structures developed in felsic granulites and surrounding gneisses, and the magma only locally explored the early subvertical fabric of the felsic granulite during emplacement. Consequently, the emplacement age of the syenite provides an independent constraint on the timing of the final stages of exhumation and allows calculation of exhumation and cooling rates, which for this part of the Variscan orogenic root are 2.9–3.5 mm yr⁻¹ and 7–9.4 °C Myr⁻¹, respectively. The final part of the temperature evolution shows very rapid cooling, which is interpreted as the result of juxtaposition of hot high-grade rocks with a cold upper-crustal lid.     

Assessment of Marine Clay Improvement Under Reclamation Fills by in-situ Testing Methods

In ground improvement projects with prefabricated vertical drains, the duration of the preloading period is set in advance based on the predetermined time rate of consolidation of the compressible layer. If prediction is accurately done, the required degree of consolidation is met at the pre-determined preloading time. As such, there is a requirement for in-situ tests to be carried out just prior to the removal of surcharge to assess the degree of consolidation of the improved ground. In-situ tests were carried out after 23 months of surcharge loading at the In-Situ Test Site within the Changi East Reclamation Project in the Republic of Singapore. In-situ testing works in this research study comprises the use of field vane shear, piezocone, flat dilatometer and self-boring pressuremeter. The in-situ tests were carried out to determine the shear strength and degree of consolidation of the Singapore marine clay at Changi after 23 months of surcharge loading. The In-Situ Test Site consisted of a Vertical Drain Area as well as an untreated Control Area. Both areas were located adjacent to each other and were surcharged simultaneously to the same level and surcharge left in place for a period of 23 months. Comparison was made between the in-situ test results of the Vertical Drain Area and the untreated Control Area.     

山西霍山植物群落主要层LAI垂直分布规律

在山西霍山七里峪林场，采用间接的光学测量方法对沿着海拔分布的植物群落主要层叶面积指数（LAI）进行了测量，从不同的角度对LAI的垂直分布规律进行分析。结果表明：1．海拔不同，LAI表现出很大的差异，海拔1750m左右的LAI值大于较高与较低海拔的；对LAI和海拔之间的关系进行回归，得到LAI分布的拟合方程：y=b0＋b1x＋b2x^2＋b3x^3（R=0．712，P〈0．01）。2．同一海拔样带，阴坡LAI均大于阳坡，但对同种种群来说，阴坡树种平均胸径并不一定均大于阳坡。3．植被类型LAI比较表现为：低山针叶林〈低山灌丛〈落叶阔叶林〈落叶针叶林〈常绿针叶林；而主要群系LAI比较表现为：油松林（0．38）〈落叶松林（0．78）〈山杨林及其混交林（1．09）〈白桦林（2．00）〈辽东栎林及其混交林（3．73）。4．典型群落LAI值变化分析和人工林与天然林以，比较表明，LAI值在一定海拔达到最大值，这对于山西霍山人工林栽培和丰产林培育等具有重要意义。