汕头海域海底光缆路由条件及评价

根据在东南亚至日本海底光缆汕头段（300m水深以浅）路由勘察中所获得的多波束、侧扫声纳、浅地层剖面、柱状取样等资料,结合勘察区的自然环境特征,对路由区的自然环境条件、海底工程地质条件进行了详细的分析,并对该段路由条件进行了综合评价。研究表明,此段路由在大陆架区域路由条件较好,适合海底光缆的铺设;在大陆架与大陆坡结合带路南条件相对较差,应做好应对措施。     

变面积差动电容式传感器的研究

介绍一款变面积式差动电容传感器.该传感器借助于两路相位相差180°的激励信号源作用于两固定极,使动摆片与定摆片之间形成电场.动摆片在进行摆动的过程中,在左右两固定摆中的面积会发生相应的变化,进而会产生电容量的改变.动摆片摆动角度的大小与动摆片在定片中的面积以及电容量的大小呈线性比例关系.通过交流电桥法可测量出该电容传感器的电容量的变化所对应的电压输出,并推算出动摆片位移角度的大小.实验验证了该设计的可行性.     

�˼������ڵ�Ӱ������ǷDZ���������������㷨�о�

??????????????????????????????????????????????????????????????????????????????????????С????????????????????????????????????????????????????????????????,??????????????????????????????????????????????壬??????????????????????????????????Ч???б???????ж?????????????????????????????????????δ?????????????????ó??????????????????????GRACE?????????????????????????????????????Ч??????????????????     

1980—2010年中国区域地面风速对能见度影响的地理分布特征

利用1980—2010年中国气象局576个气象站的能见度和日平均风速资料,分别分析了中国区域低能见度下风速的空间分布、能见度与风速之间的相关关系、风速变化对能见度变化的影响,讨论了城市化效应和近海地理位置对其影响程度。结果表明:在低能见度（小于10 km）状况下,从内蒙古到新疆东部的沙漠及干旱地区对应的是高风速,在广大东部、南部地区,特别是四川盆地地区对应的是低风速（2 m·s-1以下）;类似地理学的胡焕庸线,中国大陆存在一条东北—西南走向的界线,以此界线划分,能见度与风速关系呈现“东正西负”型分布。界线以西地区包括中国沙漠及相邻干旱及半干旱地区,一年四季中能见度和风速均呈负相关关系,尤其春季最为明显,这表明这些地区能见度的恶化主要取决于大风驱动的沙尘气溶胶排放及传输。在界线以东地区,能见度和风速呈正相关,并且其正相关以秋冬季最强;夏季,盛行的西南季风使能见度与风速关系的“东正西负”分界线北移且其正负相关均为最弱,说明夏季影响能见度的因素相对其他季节更为复杂;东部地区能见度的变化对风速变化响应较小;在四川盆地、贵州至广西和巴丹吉林沙漠地区能见度对风速响应更为敏感,在这些地区风速在对能见度影响中起到重要作用;大城市的能见度对风速响应的敏感程度略微高于中小城市及乡村,说明城市化影响存在但效果有限;近海岸地区因受海陆风影响,响应的敏感度较内陆小且季节变化不明显。     

基于场变量的边坡稳定分析有限元强度折减法?

有限元强度折减法在实施过程中往往要根据不同的折减系数手工修改输入文件,并不断进行试算,过程较繁琐。为了简化计算过程,提高计算效率,在有限元强度折减法的基础上,结合ABAQUS提供的场变量,提出一种适用于有限元强度折减计算的新方法--基于场变量的有限元强度折减法。通过在ABAQUS中设置岩土体黏聚力与内摩擦角为场变量的函数,场变量为增量步时间t的函数,从而通过控制增量步时间t实现黏聚力与内摩擦角的折减,通过一次计算即可求得边坡的安全系数,无需手工修改折减系数反复试算。结合有关文献对该方法用于边坡稳定分析的可行性进行了验证,并与二分法确定安全系数的计算效率进行了比较。结果表明：该方法求得的安全系数是有效可靠的,用于边坡稳定性的计算是可行的,简化了有限元强度折减法的计算过程,提高了计算效率。     

非饱和渗流问题的自适应欠松弛变量变换方法

在使用有限元方法求解非饱和土渗流问题时,土-水特征曲线和渗透率函数的强烈非线性经常会造成计算中出现迭代不收敛、计算误差大等问题。基于变量变换的思想,结合时间步长自适应技术提出了一种求解非饱和渗流问题的新方法--欠松弛RFT变换方法（ATUR1）。ATUR1方法通过变量变换,大大降低了Richards方程中未知数在空间和时间上的非线性程度,从而改善这种非线性所带来的计算收敛困难和精度差等问题。欠松弛技术的引入减少了迭代过程中的振荡现象,进一步提高了非线性迭代计算的效率。时间步长自适应技术则有效地控制整个计算过程的误差。数值算例结果说明,ATUR1可以有效地提高计算效率和精度,是一种准确有效的计算方法。     

Retrieving earthquake signature in grace gravity solutions

The GRACE satellites have been orbiting the Earth since 2002, monitoring the time variable gravity field. Some of the observed fluctuations are due to geodynamic causes, but they are often hidden in the complex signal, composed of hydrology, ocean, atmosphere, and geodynamics, the signal of geodynamic origin being usually the smallest. In addition, dealiasing residuals and noise make the separation of the signal from the different causes more difficult. We proposed a method based on the Empirical Orthogonal Function decomposition to extract the signal of physical origin, under the hypothesis that the physical signal is spatially more consistent than the noise and aliasing incomplete correction. We used synthetic geoid variations associated with earthquakes located at nearly 2000 positions at the Earth surface, based on several examples of large actual subduction events. We show that, with the present day accuracy, we can retrieve the geoid variations associated with more than 98 per cent of the earthquakes of magnitude 9 or above, around 60 per cent for magnitude 8.8, 40 per cent for magnitude 8.6 and 33 per cent for magnitude 8.3. Some events, with the right properties and location, can be detected with magnitude as low as 8. We then applied the method to the GRACE solutions, and retrieved the Hokkaido event (2003) and the Sumatra event (2004), which is in agreement with the retrieval rates mentioned here above.     

Luminescence dating of marine sediments from the Sea of Japan using quartz OSL and polymineral pIRIR signals of fine grains

Luminescence dating has long been used for chronological constraints on marine sediments due to the ubiquitous dating materials (quartz and feldspar grains) and its applicability over a relatively long time range. However, one of the main difficulties in luminescence dating on marine sediments is partial bleaching, which causes age overestimations. Especially, partial bleaching is typically difficult to be detected in the fine grain fraction (FG) of marine sediments. The recently developed feldspar post-IR IRSL (pIRIR) protocol can detect non-fading signals and thus avoid feldspar signal instability. In the current study, fine grains were extracted from a gravity core in the northern Sea of Japan, and the aim is to test the feasibility of using different luminescence signals with various bleaching rates to explore the bleaching conditions of fine grain fraction in marine sediments. The results suggest that the quartz OSL signal and polymineral pIRIR signals at stimulation temperatures of 150 °C and 225 °C (pIRIR₁₅₀ and pIRIR₂₂₅) of FG were well bleached prior to deposition. The OSL ages were used to establish a chronology for this sedimentary core and the resulting age-depth relationship is self-consistent and comparable with radiocarbon dates. We conclude that different luminescence signals with various bleaching rates can be used to test the bleaching conditions of fine grain fraction in marine sediments; and the luminescence dating can be applied to marine sediments with great potential.