礁膜配子放散条件的研究

本文报道了礁膜配子的放散与温度、光照、比重的关系。结果表明，自然海区的礁膜在白天大量放散配子。配子放散的适宜温度为１９－２１℃；光照为２０００－５０００ｌｘ时能促进配子大量放散出来；配子放散的适宜比重为１．０５－１．０２５；这些研究结果将为礁膜人工育苗提供一些科学依据。     

九州西侧海域129°E断面的流速和温盐结构特征

根据中、日合作黑潮调查研究期间（1987－1993年）在九州西侧海域获得的水文资料，计算了129°E断面的地转流速和流量。着重提出129°E断面北侧存在一支较稳定的西向流；分析这支西向流的去向，指出它是向对马暖流输送黑潮水的重要途径；给出了这支西向流及黑潮通过该断面的流速、流轴、流幅及流量的变化特征。     

台风"杜鹃"影响期间福建大风天气的特点及成因

台风“杜鹃”影响期间，福建大风天气出现的比较早，而且范围比较大．本文通过对天气尺度的环境场、具有代表性的单站资料的对比分析，寻求大风出现的原因．还深入利用MM5模式对台风的气压场、风场、流场等进行数值模拟，分析结果表明台湾地形倒槽的形成对此次大风天气出现有着重要的作用，此外从流场分型的角度进一步分析台湾地形倒槽的形成原因．     

哀牢山-红河断裂带中段应变分析

对哀牢山—红河断裂带中段和平—水塘剖面、墨江—元江剖面和其它地段的岩石应变及磁组构进行了分析，表明应变强度的校正磁各向异性度PJ从断裂带向西至三叠系明显降低，变形强度向西迅速减弱。磁化率椭球体主轴展布反映出剪切带内、外变形方式的改变。剪切带内，以水平走滑运动为主；向西则以水平缩短为主。在应变分析中，对断裂带内的S—C组构两组面理夹角、杏仁体和石榴石应变标志体进行了测量，结果显示，剪切带内的磁组构和岩石组构间关系较差。此外，还对这两条剖面中的三叠系进行了应变和磁组构分析，找出了它们与磁化率椭球体对应轴率间的相关性。     

The permeability of faults within siliciclastic petroleum reservoirs of the North Sea and Norwegian Continental Shelf

Faulting in Middle Jurassic reservoirs occurred at shallow depth during regional extension. Clean sandstones (<15% clay) deformed without significant grain fracturing and permeability reduction. Faults in impure sandstones (15–40% clay) experienced significant syn-deformation compaction and permeability reduction. Enhanced compaction during deeper burial reduced their permeabilities further from an average of 0.05 mD at <2.5 km to 0.001 mD at >4 km. Clay-rich sediments (>40% clay) deformed to produce clay smears with very low permeabilities (<0.001 mD). Faulting in the Rotliegendes occurred at greater depth during both basin extension and inversion. Extensional faulting produced cataclasites with permeability reductions of <10–>10⁶; their permeabilities range from 0.2 to 0.0001 mD and are inversely related to their maximum burial depth. Faults formed or reactivated during inversion experienced permeability increase. These results can be extrapolated to other hydrocarbon reservoirs if differences in stress and temperature history are taken into account.The permeability of most (>80%) faults is not sufficiently low, compared to their wallrock, to retard single-phase fluid flow on a km-scale. Nevertheless, most faults could retard the flow of a non-wetting phase if present at low saturations. It may be necessary to incorporate the two-phase fluid flow properties of fault rocks into reservoir simulators using upscaling or pseudoisation techniques. Fault property data should be calibrated against production data before it can be used confidently.     

Estimation of Land Subsidence Based on Groundwater Flow Model

This article presents an approach for estimating land subsidence due to withdrawal of groundwater. The proposed method calculates the groundwater seepage in 3-D-condition and calculates the land subsidence one-dimensionally. The governing equation on groundwater seepage is based on the three-dimensional mass conservation law and the principle of effective stress. The land subsidence calculation method is derived based on the following assumptions: (1) displacements occur only in the vertical direction, and (2) in vertical direction the total stresses do not change. The governing equation is solved by numerical method, i.e., finite element method (FEM) in spatial discretization and finite difference method (FDM) in time series discretization. In FEM Galerkin method is adopted and in FDM, lumped matrix method is employed. The proposed method is calibrated via analyzing 1-D consolidation problem and the results are compared with those from Terzaghi's one-dimensional consolidation theory and oedometer test. The proposed method is employed to analyze the consolidation of a soft layer due to withdrawal of groundwater from an aquifer under it. Moreover, this method is also applied to a field case of land subsidence due to groundwater pumping in a gas production field in Japan. The analytical results are compared with the field observed data. The results show that this approach simulates the field case well.     

Sediment movement under unidirectional flows: an assessment of empirical threshold curves

A selection of threshold data sets from previous investigations is used to re-examine, selectively, some of the empirical curves that are most commonly used for the prediction of sediment threshold. Simple analytical formulae are derived describing single line curves for mean threshold values and envelopes for the initial movement of discrete particles and the commencement of mass sediment transport phases of the critical condition.The complexity of factors governing the prevailing conditions at threshold, together with the randomness of events, limits deterministic solutions; however, the curves provide an approach that can be used readily in practical applications. In contrast, the envelope presentation is more of a stochastic approach to the definition of threshold. It recognises that there is no definitive threshold condition under which a particular particle size can be displaced, but rather that a range of threshold values exist.The empirical threshold relationships were derived on the basis of a relatively large amount of data. However, the sources utilised have interpreted the ‘critical condition’ in various ways, implying that the formulae must be treated with caution in applications.