Anthropogenic Impacts on Summer Precipitation in Central Arizona,U.S.A.

This article explores the possibility of urbanization‐ and irrigation‐induced increases in summer precipitation totals in central Arizona. Maximum precipitation impacts are hypothesized to occur downwind of the Phoenix area in the Lower Verde basin. Results from statistical tests indicate that summer precipitation totals in the Lower Verde basin are greater than totals in nearby basins. Precipitation totals in the basin also appear to be equivalent to totals at more monsoon‐impacted stations in eastern Arizona. While this research is preliminary, the results do provide encouraging evidence of the existence of anthropogenically enhanced summer precipitation in central Arizona.     

长江日流量混沌变化特性研究——Ⅰ相空间嵌入滞时的确定

为了以新途径探索长江水量变化规律并在此基础上做出预测,全面而系统地研究了宜昌站日流量混沌变化特性并建立了新预测模型.重点论述相空间嵌入滞时的确定.分析了传统的自相关函数法和真实矢量场法确定嵌入滞时的优劣,并提出以广义相关函数合理确定嵌入滞时的方法.研究结果表明广义相关函数法是一个合理又可操作的途径.     

Sediment deposition from flow at low gradients into a buffer strip—a critical test of re-entrainment theory

The spatial and size distribution of sediment deposited from short periods of overland flow due to the effect of a simulated grass buffer strip was measured for low slopes of 1.6, 3.4 and 5.1%. These data were analysed so as to critically evaluate two alternative models of the process of re-entrainment of recently deposited sediment. A model of re-entrainment, previously thought to be appropriate only for a steady-state or equilibrium situation, was found to give better agreement with experiments than did a model previously used in the literature on this subject.     

Drainage in finite-sized unsaturated zones

After the initiation of gravity drainage, water is often assumed to be either (a) draining under unit gradient, or (b) at capillary/gravity equilibrium. Both of these simplifications can be useful, but the regimes of validity of each assumption must be delineated. Water pressures are measured versus time and distance as water drains out of a 1.6 m long sand column to determine the relative effects of capillary and gravitational forces during drainage. For medium sized sands (0.15–0.3 mm in diameter), the capillary pressure is constant in space in a large region of the column for over 12 days, and the water continues to flow under unit gradient for relatively long time scales. Similar results are seen for finer sands, but with a much faster approach to equilibrium. Numerical simulations and analytical estimates are presented and compare favorably to the measurements. Together, the experimental, theoretical and analytical results are used to calculate when capillary/gravity equilibrium is reached as a function of porous media properties and length of the unsaturated zone. The ratio of the length of the unsaturated zone to the bubbling pressure is a key parameter in determining the drainage regime, and that even for relatively short unsaturated zones the equilibrium time scale can be on the order of years.     

Parameters affecting maximum fluid transport in large aperture fractures

We present results of laboratory experiments to study the behavior of liquids moving in unsaturated wide-aperture fractures. A 5-mm-thick glass plate cut with a 1.7-mm aperture was used as a fractured rock analog to study behavior of film and capillary droplet flow modes. Flow rates ranged between 0.6 and 6.0 ml/min. Variability in the ambient barometric pressure, resulting from weather conditions, seemed to play a role in the natural selection of flow mode. For droplet mode, constant input conditions resulted in highly variable transport properties within the fracture. The advancing meniscus exhibited a dynamic contact angle that was a function of the droplet speed and much larger than the static contact angle. Flow rate was reduced due to the larger contact angle. Analytical expressions for droplet velocity and flow capacity are presented as a function of the dynamic rather than the static contact angle.     

Laplace-transform analytic element solution of transient flow in porous media

A Laplace-transform analytic element method (LT-AEM) is described for the solution of transient flow problems in porous media. Following Laplace transformation of the original flow problem, the analytic element method (AEM) is used to solve the resultant time-independent modified Helmholtz equation, and the solution is inverted numerically back into the time domain. The solution is entirely general, retaining the mathematical elegance and computational efficiency of the AEM while being amenable to parallel computation. It is especially well suited for problems in which a solution is required at a limited number of points in space–time, and for problems involving materials with sharply contrasting hydraulic properties. We illustrate the LT-AEM on transient flow through a uniform confined aquifer with a circular inclusion of contrasting hydraulic conductivity and specific storage. Our results compare well with published analytical solutions in the special case of radial flow.     

Flow and fracture maps for basaltic rock deformation at high temperatures

Understanding how the strength of basaltic rock varies with the extrinsic conditions of stress state, pressure and temperature, and the intrinsic rock physical properties is fundamental to understanding the dynamics of volcanic systems. In particular it is essential to understand how rock strength at high temperatures is limited by fracture. We have collated and analysed laboratory data for basaltic rocks from over 500 rock deformation experiments and plotted these on principal stress failure maps. We have fitted an empirical flow law (Norton’s law) and a theoretical fracture criterion to these data. The principal stress failure map is a graphical representation of ductile and brittle experimental data together with flow and fracture envelopes under varying strain rate, temperature and pressure. We have used these maps to re-interpret the ductile–brittle transition in basaltic rocks at high temperatures and show, conceptually, how these failure maps can be applied to volcanic systems, using lava flows as an example.     

Earthen barriers to control lava flows in the 2001 eruption of Mt. Etna

Preceded by four days of intense seismicity and marked ground deformation, a new eruption of Mt. Etna started on 17 July and lasted until 9 August 2001. It produced lava emission and strombolian and phreatomagmatic activity from four different main vents located on a complex fracture system extending from the southeast summit cone for about 4.5 km southwards, from 3000 to 2100 m elevation (a.s.l.). The lava emitted from the lowest vent cut up an important road on the volcano and destroyed other rural roads and a few isolated country houses. Its front descended southwards to about 4 km distance from the villages of Nicolosi and Belpasso. A plan of intervention, including diversion and retaining barriers and possibly lava flow interruption, was prepared but not activated because the flow front stopped as a consequence of a decrease in the effusion rate. Extensive interventions were carried out in order to protect some important tourist facilities of the Sapienza and Mts. Silvestri zones (1900 m elevation) from being destroyed by the lava emitted from vents located at 2700 m and 2550 m elevation. Thirteen earthen barriers (with a maximum length of 370 m, height of 10–12 m, base width of 15 m and volume of 25 000 m³) were built to divert the lava flow away from the facilities towards a path implying considerably less damage. Most of the barriers were oriented diagonally (110–135°) to the direction of the flow. They were made of loose material excavated nearby and worked very nicely, resisting the thrust of the lava without any difficulty. After the interventions carried out on Mt. Etna in 1983 and in 1991–1992, those of 2001 confirm that earthen barriers can be very effective in controlling lava flows.     

Fluid flow and mineralization of Youjiang Basin in the Yunnan-Guizhou-Guangxi area, China

Comprehensive studies, based on isotope geochemistry of C, H, O, S and Sr, chronology, common element and trace element geochemistry of fluid inclusions for the epithermal Au, As, Sb and Hg deposits in the Youjiang Basin and its peripheral areas, suggested that the ore fluid was the basin fluid with abundant metallic elements and the large-scale fluid flow of the same source in the late Yenshan stage was responsible for huge epithermal mineralization and silicification. The ore fluid flowed from the basin to the platform between the basin and the platform and migrated from the inter-platform basin to the isolated platform in the Youjiang Basin. The synsedimentary faults and paleokast surface acted respectively as main conduits for vertical and lateral fluid flow.     

Velocity structure of uppermost mantle beneath North China from Pn tomography and its implications

20301 Pn arrival time data are collected from the seismological bulletins of both national and regional seismic networks. Pn travel time residuals are tomographically inverted for the Pn velocity structure of uppermost mantle beneath North China. The result indicates that the average Pn velocity in North China is 7.92 km/s, and the velocity varies laterally from ?0.21 to +0.29 km/s around the average. The approximately NNE trending high and low velocity regions arrange alternatively west-eastward. From west to east we can see high velocity in the middle Ordos region, the Shanxi graben low, the Jizhong depression high, the west Shandong uplift and Bohai Sea low, and the high velocity region to the east of the Tanlu fault. In the southern boundary zone of the North China block, except for the high velocity in the Qingling Mountains region, the velocity is generally lower than the average. Obvious velocity anisotropy is seen in the Datong Cenozoic volcanic region, with the fast velocity direction in NNE-SSW. Notable velocity anisotropy is also seen around the Bay of Bohai Sea, and the fast velocity directions seem to show a rotation pattern, possibly indicating a flow-like deformation in the uppermost mantle there. The Pn velocity variations show a reversed correlation with the Earth's heat flow. The low Pn velocity regions generally show high heat flow, e.g., the Shanxi graben and Bohai Sea region. While the high Pn velocity regions usually manifest low heat flow, e.g., the region of Jizhong depression. This indicates that the Pn velocity variation in the study region is mainly aroused by the regional temperature difference in the uppermost mantle. Strong earthquakes in the crust tend to occur in the region with the abnormal low Pn velocity, or in the transition zone between high and low Pn velocity regions. The earthquakes in the low velocity region are shallower, while that in the transition zone are deeper.