中国大陆科学钻探工程主孔100～2000 m 放射性产热元素的垂向分布特征及其成因

地球内部放射性产热元素U、Th及K(HPE)含量如何随深度的变化而变化是固体地球科学中的一个重要参数,在限定地壳的热和流变学结构、地球化学、岩石和构造模型中起关键性的作用。对HPE深部分布的认识主要来自于对大型花岗岩岩基的研究及对地表热流值和产热率之间关系的模拟,对高压-超高压变质地体的HPE随深度的分布缺乏认识。在苏鲁超高压变质带中实施的中国大陆科学钻探工程届时将提供超过5km的岩心,为确定苏鲁超高压带的HPE结构提供了最好的机会。对CCSD的100～2000m岩心的732块样品详细的放射性产热元素含量的测试及现今产热率计算的初步结果表明:(1)花岗质片麻岩具有最高的产热率,平均为1665×10-11W/kg;(2)副片麻岩(变沉积岩)具有中等的产热率,为994×10-11W/kg;(3)金红石榴辉岩及石榴石橄榄岩具有最低的产热率,为17×10-11～20×10-11W/kg;(4)放射性产热元素的浓度及相应的产热率随岩性的变化而变化,呈现阶梯状的分布特征。产热率随深度的变化特征表明CCSD主孔中的HPE三明治结构。该结构可能代表着高压-超高压变质地体中的典型HPE结构,比大型花岗岩岩基的HPE结构更复杂,与传统的HPE指数衰减分布模式不吻合。CCSD主孔中所揭示的三明治式HPE结构是大陆被动陆缘中的基性及超基性岩、沉积岩及花岗岩在深     

绿片岩三轴流变力学特性的研究(Ⅰ):试验结果

为了解锦屏一级水电站坝基绿片岩的流变力学特性，采用岩石全自动流变伺服仪对绿片岩进行了三轴压缩流变试验。基于试验结果，研究了绿片岩在不同围压作用下的轴向应变以及侧向应变随时间的变化规律，讨论了流变特性对岩石应力一应变曲线的影响，探讨了不同应力水平下的轴向以及侧向流变速率变化趋势，分析了不同围压下流变的破裂机制，掌握了绿片岩三轴流变的基本规律，从而为该水电站工程流变数值分析时参数的辨识提供了可靠的依据。     

斜交型不稳定谱点分布侧半圆定理及其增长率上界的估计

本对斜交型扰动不稳定谱点的分布做了理论分析，得到了该谱点分布的半圆定理一该谱点分布在复一面上以原点为圆心以R0为半径的上半平面上，同时还对该不稳定增长率的上界作了估计。发现水平永度越小，模式顶越高则该估计值越大；垂直风切变的增大和纬度的增高对该增长率的增大有正贡献；当层结稳定度减小时，最大增长率随相对最大增长率得增大而减小。     

中国西北部盆地岩石热导率和生热率特征

本文根据大量实测数据,首次系统地报道了中国西北地区塔里木盆地、准噶尔盆地和柴达木盆地内的岩石热导率、岩石放射性生热率数据及其分布特征.对600多个岩石热导率和100多个实测岩石生热率的统计分析表明,沉积盆地中岩石的热物理性质与其岩性、埋藏深度和地层时代密切相关.随深度和地层时代的加大,岩石热导率增大;塔里木盆地的岩石热导率的总体平均值最大,而柴达木盆地的最小.岩石生热率在上地壳的分布是随深度的增加而减小的,但在沉积盆地的深度范围内几乎不变,其分布是均匀的,仅不同岩性的生热率差别较大.估算的岩石放射性生热产生的热量可以占到盆地地表热流的25%～45%.因此,岩石热物理性质的参数不仅与盆地的地温分布和大地热流特征密切相关,还可以为该地区盆地热历史恢复及深部地球物理的研究提供有效的参数和边界条件.     

抽水引起的含水层水平应变──地裂缝活动新机理

基于Darcy -Gersevanov广义渗流关系式 ,本文首先导出了单井定流量抽水引起的泰斯承压含水层水平运动和应变解析表达式 ,并据此提出了抽水诱发地裂缝活动的含水层水平应变新机理 ,其主要观点为 :受井栅的约束阻挡作用 ,抽水活动将在含水层内部形成近井径向挤压区和远井径向拉张区两个应变区域 ,随着抽水时间的增长 ,近井径向挤压区将逐渐向外扩展 ;当地裂缝及其下伏断层或裂隙位于抽水活动引起的径向拉张应变区域时 ,地裂缝将出现加速活动 ;反之 ,当地裂缝处于抽水活动引起的径向挤压应变区域时 ,地裂缝活动反而受到抑制。上述地裂缝活动机理通过大同机车工厂现场抽水实验得到了初步证实。     

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

25～75℃酸性NaCl溶液中方铅矿的溶解动力学

在25～75℃、pH=0.43～2.45的1mol/LNaCl溶液中进行了方铅矿的溶解动力学实验。发现在远平衡条件下,方铅矿的溶解速率r与氢离子活度犤H+犦呈线性关系,溶解速率方程(速率定律)为:r=k犤H+犦,即对H+而言,溶解反应为一级。其中速率常数k为2.344×10-7mol/m2·s(25℃)、1.380×10-6mol/m2·s(50℃)、7.079×10-6mol/m2·s(75℃)。溶解反应的活化能为43.54kJ/mol,方铅矿的溶解机理为表面化学反应,速率决定步骤为表面配合物的离解。     

An experimental study of grain scale melt segregation mechanisms in two common crustal rock types

Creation of pathways for melt to migrate from its source is the necessary first step for transport of magma to the upper crust. To test the role of different dehydration‐melting reactions in the development of permeability during partial melting and deformation in the crust, we experimentally deformed two common crustal rock types. A muscovite‐biotite metapelite and a biotite gneiss were deformed at conditions below, at and above their fluid‐absent solidus. For the metapelite, temperatures ranged between 650 and 800 °C at P_c=700 MPa to investigate the muscovite‐dehydration melting reaction. For the biotite gneiss, temperatures ranged between 850 and 950 °C at P_c=1000 MPa to explore biotite dehydration‐melting under lower crustal conditions. Deformation for both sets of experiments was performed at the same strain rate (ε.) 1.37×10^?5 s^?1. In the presence of deformation, the positive ΔV and associated high dilational strain of the muscovite dehydration‐melting reaction produces an increase in melt pore pressure with partial melting of the metapelite. In contrast, the biotite dehydration‐melting reaction is not associated with a large dilational strain and during deformation and partial melting of the biotite gneiss melt pore pressure builds more gradually. Due to the different rates in pore pressure increase, melt‐enhanced deformation microstructures reflect the different dehydration melting reactions themselves. Permeability development in the two rocks differs because grain boundaries control melt distribution to a greater extent in the gneiss. Muscovite‐dehydration melting may develop melt pathways at low melt fractions due to a larger volume of melt, in comparison with biotite‐dehydration melting, generated at the solidus. This may be a viable physical mechanism in which rapid melt segregation from a metapelitic source rock can occur. Alternatively, the results from the gneiss experiments suggest continual draining of biotite‐derived magma from the lower crust with melt migration paths controlled by structural anisotropies in the protolith.     

Fluid permeability of sedimentary rocks in a complete stress–strain process

The permeability of sedimentary rocks during triaxial compression tests was investigated to relate it to the complete strain–stress process. It was found that the permeability was not constant, but varied with the stress and strain states in the rocks. Prior to the peak strength, the permeability decreases with increasing load. A dramatic increase in permeability occurs during the strain softening period. In the present study, in situ measurements of fluid flow and pressure in floor strata was carried out in a double longwall mining face in the Yangzhuang colliery. These measurements show that both the strata pressure and the position with respect to the mining face influence the hydrogeologic properties. The permeability increased in the floor strata behind the mining face because those mining induced fractures opened as the strata pressure decreased. To better understand this change in hydraulic behavior around the mining faces, 3-D numerical modeling was carried out. The model provides the general picture of the stress distribution and failure zone both in the floor and roof strata. The field and model results demonstrate the importance of changes in the stress and strain states on the hydrogeology of a site.     

地震前兆时空非均匀性指标Cv值的实验检验

在双向加载条件下，对两种构造和介质不同的岩石标本进行变形实验，测量了标本表面不同部位的应变．在此基础上，利用王晓青和陈学忠等提出的描述地震前兆非均匀分布的参量————Cv值，分析了标本变形失稳过程中应变异常的分布，以期从实验角度检验Cv值方法并探讨其物理意义．研究表明，Cv值的变化与岩石变形特征的变化有关，是描述前兆分布非均匀性的一种有效指标；Cv值在失稳发生前先异常上升，然后下降，并在Cv值恢复过程中或恢复后伴随着失稳事件的发生．因此，Cv值是一种有效的预报指标．