Morphological analysis of the drainage system in the Eastern Alps

We study the morphology of the major rivers draining the Eastern Alps to test whether the active tectonics of this part of the orogen is reflected in the shape of channel profiles of the river network. In our approach we compare channel profiles measured from digital elevation models with numerically modelled channel profiles using a stream power approach. It is shown that regions of high stream power coincide largely with regions of highest topography and largest uplift rates, while the forelands and the Pannonian Basin are characterised by a significantly lower stream power. From stream power modelling we conclude that there is young uplift at the very east of the Eastern Alps, in the Bohemian Massif and in the Pohorje Range. The impact of the Pleistocene glaciations is explored by comparing properties of rivers that drain in proximal and distal positions relative to the ice sheet during the last glacial maximum. Our analysis shows that most knick points, wind gaps and other non-equilibrium features of catchments covered by ice during the last glaciations (Salzach, Enns) can be correlated with glacial processes. In contrast the ice free catchments of the Mur and Drava are characterized by channels in morphological equilibrium at the first approximation and are showing only weak evidence of the strong tectonic activity within these catchments. Finally, the channel profiles of the Adige and the divide between the upper Rhine and Danube catchments differ significantly from the other catchments. We relate this to the fact that the Adige and the Rhine respond to different base levels from the remainder of the Eastern Alps: The Adige may preserve a record from the Messininan base level change and the Rhine is subject to the base level lowering in the Rhine Graben.     

土壤中氟的形态分析

以宁夏盐池地区高氟土壤为例,采用连续提取法对土壤样品中各形态氟进行提取,离子色谱法测定各形态氟的含量。根据研究目的及土壤特点将氟的形态划分为水溶态、离子交换态、可还原态、可氧化态及残渣态5种形态;对各种形态连续提取过程中使用的提取液进行了选择。采用建立的方法获得提取土壤中F-的检出限为0.76μg/g;方法精密度(RSD,n=7)各形态氟为水溶态氟11.3%,离子交换态氟13.5%,可还原态氟10.7%,可氧化态氟8.9%。     

Wind wave-forced fine sediment erosion during the slack water periods in Hangzhou Bay,China

The shallow water wave simulation model-SWAN incorporated with a simple fine sediment erosion model is applied to Hangzhou Bay, China, to model the horizontal distribution of the maximum bottom orbital velocity and corresponding fine sediment erosion rates induced by: (1) southeasterly steady winds (5, 20 and 30 m/s), (2) southwesterly steady winds (5 and 20 m/s); (3) northwesterly steady winds (5 and 20 m/s); (4) east-southeasterly steady winds (5 and 20 m/s); (5) easterly steady winds (5 and 20 m/s) under closed and unclosed boundaries; and (6) unsteady winds during the slack water periods. Results suggest: (1) the steady wind wave-induced maximum bottom orbital velocities and corresponding fine sediment erosion rates generally increased with the increasing steady winds; (2) closed and unclosed boundary conditions had more significant influences on modeled fine sediment erosion rates under 5 m/s easterly steady winds than 20 m/s; and (3) steady and unsteady wind wave-induced maximum bottom currents could be significant in eroding fine sediment bed in Hangzhou Bay. The results show implications for geomorphology, sedimentology, coastal erosion, and environmental pollution mitigation in Hangzhou Bay.     

Environmental contamination of Zn,Cd, Ni,Cu, and Pb from industrial areas in Hamadan Province,western Iran

Eleven surface soil samples from calcareous soils of industrial areas in Hamadan Province, western Iran were analyzed for total concentrations of Zn, Cd, Ni, Cu and Pb and were sequentially extracted into six fractions to determine the bioavailability of various heavy metal forms. Total Zn, Cd, Ni, Cu and Pb concentrations of the contaminated soils were 658 (57–5,803), 125.8 (1.18–1,361), 45.6 (30.7–64.4), 29.7 (11.7–83.5) and 2,419 (66–24,850) mg kg⁻¹, respectively. The soils were polluted with Zn, Pb, and Cu to some extent and heavily polluted with Cd. Nickel values were not above regulatory limits. Copper existed in soil mainly in residual (RES) and organic (OM) fractions (about 42 and 33%, respectively), whereas Zn occurred essentially as RES fraction (about 69%). The considerable presence of Cd (30.8%) and Pb (39%) in the CARB fraction suggests these elements have high potential biavailability and leachability in soils from contaminated soils. The mobile and bioavailable (EXCH and CARB) fractions of Zn, Cd, Ni, Cu, and Pb in contaminated soils averaged (7.3, 40.4, 16, 12.9 and 40.8%), respectively, which suggests that the mobility and bioavailability of the five metals probably decline in the following order: Cd = Pb > Ni > Cu > Zn.     

The relationship between hydrodynamic properties and weathering of soils derived from volcanic rocks,Galapagos Islands (Ecuador)

The aim of this interdisciplinary study is to examine a component of the hydrological cycle in Galapagos by characterizing soil properties. Nine soil profiles were sampled on two islands. Their physical and hydrodynamic properties were analyzed, along with their mineralogical composition. Two groups of soils were identified, with major differences between them. The first group consists of soils located in the highlands (>350 m a.s.l.), characterized by low hydraulic conductivity (<10⁻⁵ m s⁻¹) and low porosity (<25%). These soils are thick (several meters) and homogeneous without coarse components. Their clay fraction is considerable and dominated by gibbsite. The second group includes soils located in the low parts of the islands (<300 m a.s.l.). These soils are characterized by high hydraulic conductivity (>10⁻³ m s⁻¹) and high porosity (>35%). The structure of these soils is heterogeneous and includes coarse materials. The physical properties of the soils are in good agreement with the variations of the rainfall according to the elevation, which appears as the main factor controlling the soil development. The clayey alteration products constrain soils physical and hydrodynamic properties by reducing the porosity and consequently the permeability and also by increasing water retention.     

Flood hazard delineation combining geomorphological and hydrological methods: an example in the Northern Iberian Peninsula

Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km² of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph) in the Sarria River basin (155 km², NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number) by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling (one-phase, one-dimensional and steady flow) in a 4 km² urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both methods. Originally presented at the Sixth International Conference on Geomorphology.     

Background concentrations of elements in surface soils and their changes as affected by agriculture use in the desert-oasis ecotone in the middle of Heihe River Basin,North-west China

The concentrations of twenty four chemical elements in the surface layer of natural desert soils and the cultivated farmland soils were measured at a desert-oasis ecotone in the middle of Heihe river basin, north-west China. Background values were estimated for (a) major elements (Si 335.3 g kg^− 1, Al 49.4 g kg^− 1, Fe 19.1 g kg^− 1, Ca 29.4 g kg^− 1, Mg 8.9 g kg^− 1, K 20.1 g kg^− 1, Na 17.5 g kg^− 1 and P 0.338 g kg^− 1), (b) heavy metals and non-metals (Cr 55.8 mg kg^− 1, Mn 404.8 mg kg^− 1, Ni 17.7 mg kg^− 1, Cu 5.1 mg kg^− 1, Zn 33.7 mg kg^− 1, Pb 15.5 mg kg^− 1 and As 5.2 mg kg^− 1) and (c) other trace elements (Ti 2.0 mg kg^− 1, V 55.3 mg kg^− 1, Co 5.7 mg kg^− 1, Rb 82.4 mg kg^− 1, Sr 232.9 mg kg^− 1, Y 14.7 mg kg^− 1, Zr 194.9 mg kg^− 1, Nb 7.8 mg kg^− 1 and Ba 720.6 mg kg^− 1). After natural desert soil was cultivated for agricultural use, significant changes in element concentrations occurred under tillage, irrigation and fertilisation management. Compared to natural soil, the for the levels of Si, K, Na, Sr, Zr and Ba decreased, and no changes were observed for Rb, while the values of the other 17 elements increase in agricultural soil from 1.2 to 3.5 times. However, their absolute concentrations are still low, suggesting that the arable soil in this region remains comparatively a clean soil. The increased silt, clay and organic carbon content, under long-term irrigation, enriched the fine-grained materials, and application of fertilisers and manure contributed to the accumulation of most elements in arable soil. The accumulation of elements in agricultural soil increased with increasing cultivation years and extent of soil development.     

Soil erosion susceptibility assessment and validation using a geostatistical multivariate approach: a test in Southern Sicily

A certain number of studies have been carried out in recent years that aim at developing and applying a model capable of assessing water erosion of soil. Some of these have tried to quantitatively evaluate the volumes of soil loss, while others have focused their efforts on the recognition of the areas most prone to water erosion processes. This article presents the results of a research whose objective was that of evaluating water erosion susceptibility in a Sicilian watershed: the Naro river basin. A geomorphological study was carried out to recognize the water erosion landforms and define a set of parameters expressing both the intensity of hydraulic forces and the resistance of rocks/soils. The landforms were mapped and classified according to the dominant process in landsurfaces affected by diffuse or linear water erosion. A GIS layer was obtained by combining six determining factors (bedrock lithology, land use, soil texture, plan curvature, stream power index and slope-length factor) in unique conditions units. A geostatistical multivariate approach was applied by analysing the relationships between the spatial distributions of the erosion landforms and the unique condition units. Particularly, the density of eroded area for each combination of determining factors has been calculated: such function corresponds, in fact, to the conditional probability of erosion landforms to develop, under the same geoenvironmental conditions. In light of the obtained results, a general geomorphologic model for water erosion in the Naro river basin can be depicted: cultivated areas in clayey slopes, having fine-medium soil texture, are the most prone to be eroded; linear or diffuse water erosion processes dominate where the topography is favourable to a convergent or divergent runoff, respectively. For each of the two erosion process types, a susceptibility map was produced and submitted to a validation procedure based on a spatial random partition strategy. Both the success of the validation procedure of the susceptibility models and the geomorphological coherence of the relationships between factors and process that such models suggest, confirm the reliability of the method and the goodness of the predictions.     

Finite Element Modeling of Swelling Soil Pressures Using Joint/Interface Elements

There could be some discontinuities in a soil media such as layers, earth structures, cracks, and fissures so that estimation of stresses and deformations in these types of soil masses are somewhat different from continuous masses. The discontinuities in a soil mass could be considered as a special link between two blocks. Transmitted swelling pressures affected by the soil properties of the backfill especially at the interface between the backfill and retaining wall. In order to estimate the transmitted swelling pressure distribution behind a retaining wall, using with interface element, a new finite element model and a code (SWELPRES) have been developed. To evaluate the effect of backfill characteristics and interface element from the transmitted lateral swelling pressures, four cases of thickness of backfills with or without interface elements are investigated.