A Step Towards Evaluation of the Seismic Response Reduction Factor in Multistorey Reinforced Concrete Frames

A seismic nonlinear time-history analysis was made for four-, six-, and eight-storey reinforced concrete buildings. These buildings were made as three-dimensional space frame structures with shear walls in both orthogonal directions. They have five bays with 4.8 m spacing each in the horizontal direction, and three bays with 4.2 m spacing each in the transversal direction. The frames were designed according to the Jordanian Seismic Code of practice for Seismic Zones 4, 3, 2, and 1 as proposed for Jordan by several authors. Time-history analysis was made using the El Centro (N-S) earthquake record of May 1940 as an actual earthquake excitation. The response reduction factor (R) that primarily consists of two factors that are the ductility reduction (Rµ) and the overstrength (), is obtained. It has been seen that the seismic zoning has a slight effect on the ductility reduction factor for different buildings, since it ranges from Zone 4 to Zone 1 as 2.37 to 2.52, 1.72 to 1.78, and 1.14 to 1.18 for four-, six-, and eight-storey buildings, respectively. Moreover, it is observed that, for different buildings and different seismic zones, the ductility reduction factor (Rµ) is slightly different from the system ductility factor (µ) especially for higher values of µ (i.e., Rµ µ). The response reduction factor, called overstrength (), was evaluated. The overstrength factor was found to vary with seismic zones (Z) , number of stories, and design gravity loads. However, the dependency on seismic zones was the strongest. The average overstrength of these buildings in Zones 4 and 1 was 2.61 and 6.94, respectively. The overstrength increased as the number of storeys decreased: overstrength of a four-storey building was higher than an eight-storey building by 36% in Zone 4, and 39% in Zone 1. Furthermore, buildings of the three heights had an average overstrength 165.9% higher in Zone 1 than in Zone 4. These observations have a significant implications for the seismic design codes which currently do not take into account the variation of the response reduction factor, R (i.e., ductility reduction factor times overstrength).     

Probabilistic seismic hazard zonation of Syria

Earthquake hazard maps for Syria are presented in this paper. The Peak Ground Acceleration (PGA) and the Modified Mercalli Intensity (MMI) on bedrock, both with 90% probability of not being exceeded during a life time of 50, 100 and 200 years, respectively are developed. The probabilistic PGA and MMI values are evaluated assuming linear sources (faults) as potential sources of future earthquakes. A new attenuation relationship for this region is developed. Ten distinctive faults of potential earthquakes are identified in and around Syria. The pertinent parameters of each fault, such as theb-parameter in the Gutenberg-Richter formula, the annual rate ₄ and the upper bound magnitudem ₁ are determined from two sets of seismic data: the historical earthquakes and the instrumentally recorded earthquake data (AD 1900–1992). The seismic hazard maps developed are intended for preliminary analysis of new designs and seismic check of existing civil engineering structures.     

On some problems of seismic crustal phase

ＯｎｓｏｍｅｐｒｏｂｌｅｍｓｏｆｓｅｉｓｍｉｃｃｒｕｓｔａｌｐｈａｓｅＨｕａｎ－ＣｈｅｎｇＧＥ（葛焕称）（ＳｅｉｓｍｏｌｏｇｉｃａｌＢｕｒｅａｕｏｆＪｉａｎｇｓｕＰｒｏｖｉｎｃｅ,Ｎａｎｊｉｎｇ２１００１４,Ｃｈｉｎａ）Ａｂｓｔｒａｃｔ：Ｉｎｔｈｉｓ...     

微震仪有线传输避雷研究

本文通过对雷电放电分析,研究解决微震仪有线传输的避雷问题,并介绍接收雷电信号控制传输线上电荷对地短路的“ＤＢＬ－１”避雷仪。     

合肥遥测台网地震速报系统

论述了适用于遥测地震台网大震速报的一套计算机处理系统,系统设计以《全国遥测台网观测技术规范》和《近震分析》理论为依据,实现了数据输入,震相选择,数据处理,地震定位,震级计算,结果输出及贮存等多项功能,达到了快速确定地震三要素,提高速报速度和精度之目的,是一个较完善的,实用的速报系统。     

A search for ultra-high energy counterparts to gamma-ray bursts

A small air shower array operating over many years has been used to search for ultra-high energy (UHE) gamma radiation ( 50 TeV) associated with gamma-ray bursts (GRBs) detected by the BATSE instrument on the Compton Gamma-Ray Observatory (CGRO). Upper limits for a one minute interval after each burst are presented for seven GRBs located with zenith angles < 20°. A 4.3 excess over background was observed between 10 and 20 minutes following the onset of a GRB on 11 May 1991. The confidence level that this is due to a real effect and not a background fluctuation is 99.8%. If this effect is real then cosmological models are excluded for this burst because of absorption of UHE gamma rays by the intergalactic radiation fields.     

综合利用地震多参数预测油气藏

以吉林省境内红星构造带(已发现油田)和杨柳青构造带(未发现油田)为试验区,首先利用地震地层学方法,研究间接参数特征,确定有利相带和有效圈闭,并在有效圈闭上选择了39个2×2cm时窗。在时窗内提取与地震波动力学有关的信息,即频率、振幅、频谱能量等,然后对这种信息进行统计计算,获得振幅方差等九个参数并对其进行综合分析,从已知油气藏出发,对未知圈闭油气状况进行了三级预测,指出了最有利的勘探靶区。     

Some breakage characteristics of ultra-fine wet grinding with a centrifugal mill

A centrifugal mill is a high-power intensity media mill that can be used for ultra-fine grinding, employing centrifugal forces generated by gyration of the axis of the mill tube in a circle. The mill charge motion is quite different depending on the ratio of the gyration diameter to the mill diameter (G / D ratio), varying from a motion similar to that of a conventional tumbling media mill to that of a vibration mill. In this study, a centrifugal mill was constructed with an arrangement where the gyration diameter could be readily adjusted. The batch grinding characteristics of three different minerals (limestone, talc and illite) in water with dispersing agent were investigated at various G / D ratios. It was found that the optimum G / D ratio in terms of the specific energy consumption to give a desired fineness of product was different for the three minerals. This was due to their different reactions to the breakage mechanisms provided by the mill charge motion at varying G / D ratios. The size distributions became progressively narrower at increased grinding times, and particles finer than about 0.1 μm were not detected even for prolonged grinding times. Measurement of specific surface areas indicated that this was not due to an artifact of the size measurements by laser diffractometry. This implies that there is a limitation in which particles finer than 0.1 μm are not produced under the conditions tested in this type of mill, but further investigation is needed for experimental verification of this limit of comminution.     

On the role of heat flow, lithosphere thickness and lithosphere density on gravitational potential stresses

Gravitational potential stresses (GPSt) are known to play a first-order role in the state of stress of the Earth's lithosphere. Previous studies focussed mainly on crust elevation and structure and little attention has been paid to modelling GPSt using realistic lithospheric structures. The aim of the present contribution is to quantify gravitational potential energies and stresses associated with stable lithospheric domains. In order to model realistic lithosphere structures, a wide variety of data are considered: surface heat flow, chemical depletion of mantle lithosphere, crustal thickness and elevation. A numerical method is presented which involves classical steady-state heat equations to derive lithosphere thickness, geotherm and density distribution, but additionally requires the studied lithosphere to be isostatically compensated at its base. The impact of varying surface and crustal heat flow, topography, Moho depth and crust density on the signs and magnitudes of predicted GPSt is systematically explored. In clear contrast with what is assumed in most previous studies, modelling results show that the density structure of the mantle lithosphere has a significant impact on the value of the predicted GPSt, in particular in the case of thick lithospheres. Using independent information from the literature, the method was applied to get insights in the state of stress of continental domains with contrasting tectono-thermal ages. The modelling results suggest that in the absence of tectonic stresses Phanerozoic and Proterozoic lithospheres are spontaneously submitted to compression whereas Archean lithospheres are in a neutral to slightly tensile stress state. These findings are in general in good agreement with global stress measurements and observed geoid undulations.     

High-resolution shallow seismic identification of gas escape features in the sediments of Loch Tay, Scotland: tectonic and microbiological associations

High-resolution seismic reflection profiles (3·5 kHz) have revealed the presence of extensive interstitial gas accumulation within the sedimentary sequences of Loch Tay, Scotland, as identified by acoustic turbidity masking the seismic stratigraphy. Within the central section of the loch, in the deepest water area directly above the zone of the seismically active Loch Tay Fault, focused flows of gas through the sediment pile to the loch bed via chimneys and pockmarks, together with gas seeps within the water column, have been identified. Microbiological observations indicate that the gas is biogenic CH₄, produced by both chemoautotrophic (which use CO₂ as a source of carbon and H₂ as a source of energy) and aceticlastic species (which use acetate as a source of carbon and energy) of methanogens in the fine-grained, organic rich deposits that have been focused into the zone of accumulation in the deep central part of the loch. The spatial distribution of the gas escape features suggests that earthquake movements along the Loch Tay Fault are responsible for facilitating focused gas escape in this part of the loch, by the creation of new pathways and conduits through the sediment pile, along which gas can migrate upwards and exit into the water column. Relict pockmarks and associated chimneys identified in the seismic records indicate that gas escape has been taking place since Pleistocene times though the precise timings cannot be ascertained. This is the first time that such features have been reported from a lake in the UK.