The impact of shrimp trawling and associated sediment resuspension in mud dominated, shallow estuaries

To address the relative importance of shrimp trawling on seabed resuspension and bottom characteristics in shallow estuaries, a series of disturbance and monitoring experiments were conducted at a bay bottom mud site (2.5 m depth) in Galveston Bay, Texas in July 1998 and May 1999. Based on pre- and post-trawl sediment profiles of ⁷Be; pore water dissolved oxygen and sulfide concentration; and bulk sediment properties, it was estimated that the trawl rig, including the net, trawl doors, and “tickler chain,” excavate the seabed to a maximum depth of approximately 1.5 cm, with most areas displaying considerably less disturbance. Water column profile data in the turbid plume left by the trawl in these underconsolidated muds (85–90% porosity; <0.25 kPa undrained shear strength) demonstrate that suspended sediment inventories of up to 85–90 mg/cm² are produced immediately behind the trawl net; an order of magnitude higher than pre-trawl inventories and comparable to those observed during a 9–10 m/s wind event at the study site. Plume settling and dispersion caused suspended sediment inventories to return to pre-trawl values about 14 min after trawl passage in two separate experiments, indicating particles re-settle primarily as flocs before they can be widely dispersed by local currents. As a result of the passage of the trawl rig across the seabed, shear strength of the sediment surface showed no significant increase, suggesting that bed armoring is not taking place and the trawled areas will not show an increase in critical shear stress.     

南黄海及相邻陆区松散沉积层磁性地层的研究

本文通过研究区5个钻孔松散沉积岩心磁性地层的划分对比,获知布容与松山极性带的界线,南黄海和陆区北部位于80.0—99.5m。陆区的南部此界线于270.4m深处。松山和高斯极性带的界线,海区未揭露到,其沉积起始时间都小于1.7Ma。而陆区的南、北部分别位于117m和328.2m。高斯和吉尔伯特极性带的界线,陆区北部为140m,而南部区为460.15m。沉积起始时间为3.4Ma。吉尔伯特底界仅北部陆区所揭示,为190.5m。松散沉积层与下伏白垩纪(?)石灰岩接触面位于400.35m,沉积起始时间约17.0Ma。     

混凝土的渗透性与耐久性

渗透性是混凝土耐久性中最重要的内容。论述了混凝土耐久性的影响因素、研究方法 ,以及混凝土渗透机理和渗透性与耐久性的关系。     

湄州湾沉积物地球化学特征

根据湄州湾表层沉积物70个样品18个化学成分的分析结果,得出:本海区沉积物属于海相陆源物,其中细颗粒主要来自台湾海峡,粗颗粒来自当地陆域;化学成分含量按聚类分析,可归为三组:粘土矿物组、碳酸盐组和分散组,微量元素Zn,Cr,Be,Cu和Sr的含量与地壳及台湾海峡相似,但低于胶州湾,说明该海区污染很少。     

Geochemistry and palaeo-oceanography of metalliferous and pelagic sediments from the Late Cretaceous Oman ophiolite

Metalliferous and pelagic sediments are exposed within and above the extrusive successions of the Upper Cretaceous Oman ophiolite which, on the basis of mostly geochemical evidence, is believed to have formed in an incipient marginal basin setting located above a NE-dipping subduction zone. The ophiolitic extrusives document various volcano-tectonic settings which include the axial zones of a spreading ridge, fault-controlled seamounts and off-axis volcanic edifices. Most of the Fe, Mn and trace metal-enriched sediments studied are interpreted as precipitates formed by oxidation of solutions derived from high-temperature sulphide-precipitating vents. The trace element content (e.g. REE and Sr) was largely scavenged from seawater. The sediments are similar to the dispersed metalliferous sediments on the flanks of modern spreading ridges, and the ‘basal’ sediments of DSDP wells and of other ophiolite complexes (e.g. Troodos, Cyprus).Distinctive mound structures located low in the lavas are attributed to percolation of sulphide-rich solutions into already deposited metalliferous oxide sediments. The resulting iron-silica rock was probably originally precipitated as ferruginous silicates.Major massive sulphides formed off-axis at the base of intermediate-basic edifices of volcanic arc affinities. Fe, Mn and trace metal enrichment in the sediment cover of a flat-topped seamount of axial lavas is interpreted as a dispersion halo around the largest massive sulphide orebody which is situated 5 km away (Lasail). Small massive sulphide bodies are common in the axial lavas particularly along major seafloor fault zones. The metalliferous sediments, locally precipitated near these vents, are ferromanganiferous, but trace metal-depleted.The metalliferous and pelagic sediment cover of the extrusive successions, generally, documents waning hydrothermal input after volcanism ended in the area.A model is discussed in which the ophiolite was created at a spreading axis above a subduction zone dipping away from the Arabian continental margin. With progressive subduction this crust approached the margin. Initially, calcareous sediment accumulated above the calcite compensation depth (CCD), but then non-calcareous radiolarites were deposited as the ophiolitic crust approached the continental margin where the CCD was higher and marginal upwelling possibly enhanced productivity. As the edge of the Arabian continental margin entered the trench, the over-riding ophiolite was regionally uplifted allowing short-lived chalk accumulation above the CCD. This was followed by volcaniclastic deposition related to the tectonic emplacement.     

Effects of sediment properties on surface-generated ambient noise in a shallow ocean

Surface-generalized ambient noise in a shallow ocean waveguide with a sediment layer possessing a specific class of density and sound speed distributions capable of describing a realistic seabed environment is considered in this analysis. This class of non-uniform sediment layer has the density and sound speed distributions varying with respect to depth as a generalized-exponential and an inverse-square function, respectively. The study invokes a formulation developed by Kuperman and Ingenito (Kuperman, W. A., Ingenito, F., 1980. Spatial correlation of surface-generated noise in a stratified ocean. J. Acoust. Soc. Am., 67, 1988-1996.) for surface noise generation, in conjunction with the analytical solutions for the Helmholtz equation corresponding to the sediment layer, to arrive at an analytical expression convenient for numerical implementation. The intensity and spatial correlation of the noise sound field are analyzed with respect to the variation of the system parameters, including frequency, sediment layer thickness, sound speed gradient, with emphasis on the effects of sediment properties on the ambient noise field. The results have demonstrated that the intensity of the noise field is relatively sensitive to the variation of the parameters, but the spatial correlation is affected to a less extent, suggesting that the energy distribution, rather than the spatial structure, of the noise field is more susceptible to the environmental variations.     

度量泥炭腐殖化度的一种简便方法:泥炭灰度

介绍了一种度量泥炭腐殖化程度简便易得的指标——灰度。通过将同一剖面灰度测量结果与传统的腐殖化度测量结果进行对比，发现二者的变化具有较强的相关性，说明导致二者变化的因素大致相同。泥炭赋色物质鉴定的实验表明腐殖质含量变化是引起灰度在剖面上变化的原因，从而进一步论证了用灰度值作为泥炭腐殖化程度指标的可行性。     

Geoacoustic Characterisation of Fine-grained Sediments using Single and Multiple Reflection Data

Fine-grained sediments commonly occur in areas of the continental shelf where wave and current energy are weak. Bulk density, compressional wave speed and attenuation are fundamental physical properties of these sediments required for predicting the response of the seabed for diverse branches of marine science. The traditional coring approach is time and labor-intensive, with large uncertainties associated with sediment disturbance in the sampling phase. Acoustic methods offer the advantages of remote sensing, i.e., sampling the sediment structure without mechanical disturbance and a significantly larger seabed coverage rate per unit time. Two different acoustic methods are described: one using short-range single-bounce interactions with the seabed, and the second using long-range modal propagation to infer the sediment properties. The relative strengths and sensitivities of each approach are explored through simulations guided by experience with measured data.     

A Preliminary Study of Shear Wave in Seafloor Surface Sediments

This article preliminarily reports and analyses the transmission characteristics and behaviors of shear wave in the offshore seafloor surface sediments in China, discusses the relationships between the physical and mechanical features of the shear wave and the compression wave, and compares the testing results with that of Hamilton and Chen et al. The result shows that the shear wave can be tested if the seafloor surface sediment has tangent modulus. The shear wave velocity ranges from 50-600 m/s and the measuring frequency from 50-200 kHz. The sound velocity rate of shear wave and compression wave can be used to appraise the stress-strain feature of seafloor surface sediments. This study provides a basis for further describing and appraising the seafloor sedimentary acoustic-mechanical feature and building a geological-acoustic model on China's offshore sea area.     

耿贝尔逻辑模型在极值风速和有效波高联合概率分布中的应用

首先介绍了耿贝尔逻辑模型，采用该模型对南海海域的涠州岛海洋站的风速和有效波高实测数据进行了分析，结果表明耿贝尔逻辑模型较好地描述了年极值风速和有效波高两随机变量的联合分布；采用得到的极值风浪联合概率分布推算了不同重现期的极值风速和波高，表明考虑风速和波高相关性对设计荷载的确定有显著影响。由于耿贝尔逻辑模型具有函数结构简单，参数估计方便，因此有望成为极值风速和波高联合分布的较理想概率模型。