兰州—白银多目标地球化学调查野外工作方法浅析

多目标区域地球化学调查从调查区表层、深层采样土壤元素分布特征入手建立土壤元素地球化学分配机制,以景观、地貌及地质特征为基础,选择合理的采样位置,正确的采样方法、采样层位,应用掌上机（Pocket PC）及数字填图系统（Rgmap）采集野外样品,本文以兰州—白银黄土覆盖区景观区为例,对表层、深层采样方法和技术要求进行探讨,对全省开展多目标地球化学调查,特别是野外工作方法提供借鉴。     

山区房后边坡安全评价的探讨——以安溪县为例

由于地质灾害的突发性和引发因素的复杂性,在及时和有效地掌握潜在隐患部位上还亟待进一步探索与细化,力求防灾抗灾工作有的放矢,以确保人民群众的生命财产损失降到最低限度。本文就基于山区的基本特征和房后边坡潜在地质安全隐患基本信息调查,简要分析房后边坡孕灾致灾环境,并针对它们的影响程度,采取层次分析（AHP）等方法来确定安全评价因子权重和安全系数,对构造安全评价结构作进一步研究。     

碳酸盐型磷矿的反浮选工艺研究

针对某碳酸盐型磷矿,采用反浮选工艺流程进行试验研究,获得了低镁优质磷精矿。反浮选工艺具有药剂种类少,分选效率高,选矿技术指标先进,操作控制容易等优点,是选别碳酸盐型磷矿的先进浮选工艺。     

俯冲带榴辉岩的变形作用及其对俯冲-折返过程的意义

榴辉岩是大洋和大陆俯冲带的重要岩石类型,在研究俯冲带的形成过程、热结构、壳幔相互作用等方面有重要意义。通过对天然和实验样品中石榴子石、绿辉石等矿物的变形特征、变形机制、变形的影响因素等的综合分析,系统总结了高压变质带中榴辉岩矿物显微和超微变形研究的进展,探讨了榴辉岩的变形特征在恢复俯冲与折返过程研究中的意义及一些尚待解决的一些问题。     

SOME NEW UNDERSTANDINGS OF LAND-SURFACE PROCESSES IN ARID AREA FROM THE HEIFE*

The survey for the HEIFE(Atmosphere-Land Surface Processes Experiment at Heihe River Basin,Western China) is given in the paper.The following basic subjects for land-surface processes in arid areas are studied:(1) the general characteristics of the energy budget on ground surface in arid areas;(2) the parameterization of the land surface processes;(3) the interaction between oasis and its desert circumstances,a special phenomenon in arid areas.The analysis shows that the sensible heat flux in the surface energy budget is in the majority,and the latent heat flux may be neglected.The influence of atmospheric stratification stability on the turbulent transfer of energy and substance must be considered in parameterization of land surface processes in arid areas.The "cold island effect" phenomenon in oasis and the "humidity inversion" phenomenon in desert near oasis are the result of the interaction between them.The results would improve the understanding of land surface processes in arid areas.     

Oil and gas resource assessment: The linkage between geological analysis and discovery process model results

Two widely-used techniques to estimate the volume of remaining oil and gas resources are discovery process modeling and geologic assessment. Both were used in a recent national assessment of oil and gas resources of the United States. Parallel estimates were obtained for 27 provinces. Geological-based estimates can typically see into areas not available to discovery process models (that is areas with little or no exploration history) and thus, on average, yield higher estimates. However, a linear relation does exist between the mean estimates obtained from these two methods. In addition, other variables were found in a multiple regression model that explained much of the difference. Thus, it is possible to perform discovery process modeling and adjust the estimates to yield results that might be expected from geological-based assessments.     

Rupture process of large earthquakes in the northern Mexico subduction zone

The Cocos plate subducts beneath North America at the Mexico trench. The northernmost segment of this trench, between the Orozco and Rivera fracture zones, has ruptured in a sequence of five large earthquakes from 1973 to 1985; the Jan. 30, 1973 Colima event (M _s 7.5) at the northern end of the segment near Rivera fracture zone; the Mar. 14, 1979 Petatlan event (M _s 7.6) at the southern end of the segment on the Orozco fracture zone; the Oct. 25, 1981 Playa Azul event (M _s 7.3) in the middle of the Michoacan gap; the Sept. 19, 1985 Michoacan mainshock (M _s 8.1); and the Sept. 21, 1985 Michoacan aftershock (M _s 7.6) that reruptured part of the Petatlan zone. Body wave inversion for the rupture process of these earthquakes finds the best: earthquake depth; focal mechanism; overall source time function; and seismic moment, for each earthquake. In addition, we have determined spatial concentrations of seismic moment release for the Colima earthquake, and the Michoacan mainshock and aftershock. These spatial concentrations of slip are interpreted as asperities; and the resultant asperity distribution for Mexico is compared to other subduction zones. The body wave inversion technique also determines theMoment Tensor Rate Functions; but there is no evidence for statistically significant changes in the moment tensor during rupture for any of the five earthquakes. An appendix describes theMoment Tensor Rate Functions methodology in detail.The systematic bias between global and regional determinations of epicentral locations in Mexico must be resolved to enable plotting of asperities with aftershocks and geographic features. We have spatially shifted all of our results to regional determinations of epicenters. The best point source depths for the five earthquakes are all above 30 km, consistent with the idea that the down-dip edge of the seismogenic plate interface in Mexico is shallow compared to other subduction zones. Consideration of uncertainties in the focal mechanisms allows us to state that all five earthquakes occurred on fault planes with the same strike (N65°W to N70°W) and dip (15±3°), except for the smaller Playa Azul event at the down-dip edge which has a steeper dip angle of 20 to 25°. However, the Petatlan earthquake does prefer a fault plane that is rotated to a more east-west orientation—one explanation may be that this earthquake is located near the crest of the subducting Orozco fracture zone. The slip vectors of all five earthquakes are similar and generally consistent with the NUVEL-predicted Cocos-North America convergence direction of N33°E for this segment. The most important deviation is the more northerly slip direction for the Petatlan earthquake. Also, the slip vectors from the Harvard CMT solutions for large and small events in this segment prefer an overall convergence direction of about N20°E to N25°E.All five earthquakes share a common feature in the rupture process: each earthquake has a small initial precursory arrival followed by a large pulse of moment release with a distinct onset. The delay time varies from 4 s for the Playa Azul event to 8 s for the Colima event. While there is some evidence of spatial concentration of moment release for each event, our overall asperity distribution for the northern Mexico segment consists of one clear asperity, in the epicentral region of the 1973 Colima earthquake, and then a scattering of diffuse and overlapping regions of high moment release for the remainder of the segment. This character is directly displayed in the overlapping of rupture zones between the 1979 Petatlan event and the 1985 Michoacan aftershock. This character of the asperity distribution is in contrast to the widely spaced distinct asperities in the northern Japan-Kuriles Islands subduction zone, but is somewhat similar to the asperity distributions found in the central Peru and Santa Cruz Islands subduction zones. Subduction of the Orozco fracture zone may strongly affect the seismogenic character as the overlapping rupture zones are located on the crest of the subducted fracture zone. There is also a distinct change in the physiography of the upper plate that coincides with the subducting fracture zone, and the Guerrero seismic gap to the south of the Petatlan earthquake is in the wake of the Orozco fracture zone. At the northern end, the Rivera fracture zone in the subducting plate and the Colima graben in the upper plate coincide with the northernmost extent of the Colima rupture zone.     

钾霞石制备体系碱性滤液的利用技术

为处理钾长石水热制备钾霞石所产生的碱性滤液,本文采用水热法,考察了氢氧化铝溶解时间、晶化时间、晶化温度、水碱比对钾霞石产率和白度的影响,并对合成钾霞石物相进行了表征。结果表明,合成钾霞石的最佳条件为,氢氧化铝溶解时间为1.5 h,晶化时间为4 h,晶化温度280℃,水碱比为1.8。XRD结果表明,产物为钾霞石粉体。傅里叶变换红外光谱表明,Al(OH)₃中的Al在水热条件下进入到Si—O骨架中形成了Si—O—Al官能团,从而印证了钾霞石的合成。差热分析结果表明,合成钾霞石具有良好的热稳定性。氮气吸附结果表明,合成钾霞石比表面积为5.18 m²/g,平均孔径为32.98 nm。实现了钾长石水热制备钾霞石所剩碱性滤液的资源化利用,并为钾长石水热制备钾霞石提供了一种母液循环的思路,使水热制备钾霞石工业化成为一种可能。     

Research on temporal and spatial distribution, evolutionary character and mechanism of crustal deformation field before and after the Tangshan earthquake

Ｒｅｓｅａｒｃｈｏｎｔｅｍｐｏｒａｌａｎｄｓｐａｔｉａｌｄｉｓｔｒｉｂｕ┐ｔｉｏｎ,ｅｖｏｌｕｔｉｏｎａｒｙｃｈａｒａｃｔｅｒａｎｄｍｅｃｈａｎｉｓｍｏｆｃｒｕｓｔａｌｄｅｆｏｒｍａｔｉｏｎｆｉｅｌｄｂｅｆｏｒｅａｎｄａｆｔｅｒｔｈｅＴａｎｇｓｈａｎ...