Digital model of corrected accumulated flow for peak discharge data acquisition and drainage system design

The design of a drainage system for a roofing slate quarry was implemented by the enhancement of discharge peak estimation, and the uncertainty inevitably associated with the engineering model was reduced.

The development of a topographical, geological, and vegetation cover database developed from a Geographical Information System (GIS) allowed for the definition of the drainage network for a hydraulic system, along with the calculation of the runoff coefficient. This is applied to the digital model of accumulated flow (DMF) as a weight correction coefficient, using a matrix-based model at 5×5 m resolution. The new digital model of corrected accumulated flow (DMCF) is the result of combining the thematic maps with the map of slope <3%, which was previously created from the slope model. It is demonstrated that this new model allows to apply the “Rational Method” on cartographic units defined by the GIS.

The DMCF is compared with other traditional applications of the Rational Method based on the calculation of the discharge peak considering: (1) the drainage basin as a single watershed or (2) defining an average runoff coefficient in each sub-watershed. Both approaches have bigger discharge peaks than those obtained by the DMCF since the slope, lithology, and vegetation cover have average values, and the runoff coefficient is poorly defined, increasing the uncertainty in the discharge peak.     

登陆热带气旋的大暴雨天气与一般暴雨对比分析及其雨强增幅原因的初探

本文以９０１５号热带气旋登陆后造成的省淮以南大暴雨天气为例，与８闪一般暴雨天气的热力动力条件进行对比，分析它们之间的异同点，并利用二维点尺度力学模式对地面中尺度锋区引起民环流进行模拟试验，结果表明，在热带气旋伸向东北部一条辐合线的偏北旗帜的中尺度锋区驱动扰动涡旋，在涡旋的上升部位可对大暴雨有增幅作用。     

High Pressure-Differential Thermal Analysis and Ultrasonic Wave Amplitude Analysis of Ice-Water Equilibrium at 1.5-5.0GPa

Water is the most active component in all geological systems.It has an important effect on the physical properties of minerals and melts.It also plays a key role in the evolution of the Earth.Accurate thermodynamics data on water are currently confined to pressures below 1.0GPa and temperatures below 900℃.Presented in this paper are new data available on the P-T properties of water at pressures up to 5.0GPa,develoged from differential thermal analysis and ultrasonic wave amplitude analysis.It has been found that there may exist another ternary point at 3.0GPa and that ultrasonic wave amplitude change of ice-water transition shows two inflection points above 2.0GPa, consistent with the two peaks of differential thermal curves above 2.0GPa .It may be a new phenomenon which needs further study.     

Quantitative Tectonic Markers of Large Coastal Earthquakes in Fujian, Guangdong, Taiwan and Hainan——with a Discussion of Qualitative Indicators

This paper expounds the quantitative tectonic indicators and some qualitative indicators of large earthquakes in the coast areas of Fujian, Guangdong, Taiwan and Hainan. The main quantitative indicators include uplift amplitude of the Moho, Quaternary and Late Holocene coasts. The paper also gives a brief account of the research method on quantitative indicators of surface uplifted zones. Taiwan is a famous neotectonic zone and an area of large earthquakes in the world. There is only one large-earthquake area in each of Fujian, Guangdong and Hainan Provinces. Along the coast large earthquake areas there are certainly many remains of crustal activity. Among these remains, coast activity, taking the sea level as the accurate marker horizon, can determine not only the amplitude of coastal elevation and subsidence in a certain period, but also the cycle and rate of positive or negative movements.     

A new method of testing pile using dynamic P-S-curve made by amplitude of wave train

A new method of detecting the vertical bearing capacity for single-pile with high strain is discussed in this paper. A heavy hammer or a small type of rocket is used to strike the pile top and the detectors are used to record vibration graphs. An expression of higher degree of strain (deformation force) is introduced. It is testified theoretically that the displacement, velocity and acceleration cannot be obtained by simple integral acceleration and differential velocity when long displacement and high strain exist, namely when the pile phase generates a whole slip relative to the soil body. That is to say that there are non-linear relations between them. It is educed accordingly that the force P and displacement S are calculated from the amplitude of wave train and (dynamic) P-S curve is drew so as to determine the yield points. Further, a method of determining the vertical bearing capacity for single-pile is discussed. A static load test is utilized to check the result of dynamic test and determine the correlative constants of dynamic-static P(Q)-S curve. Foundation item: Key projects of the tenth Five-year Plan of Yunnan Province (documented Yunnan district [2002]54-02-02) and Geophysical Society of Yunnan Province.     

Metamorphism and metamorphic K–Ar ages of the Mesozoic accretionary complex in Northland, New Zealand

Abstract A southwest dipping Mesozoic accretionary complex, which consists of tectonically imbricated turbiditic mudstone and sandstone, hemipelagic siliceous mudstone, and bedded cherts and basaltic rocks of pelagic origin, is exposed in northern North Island, New Zealand. Interpillow limestone is sometimes contained in the basaltic rocks. The grade of subduction‐related metamorphism increases from northeast to southwest, indicating an inverted metamorphic gradient dip. Three metamorphic facies are recognized largely on the basis of mineral parageneses in sedimentary and basaltic rocks: zeolite, prehnite‐pumpellyite and pumpellyite‐actinolite. From the apparent interplanar spacing d₀₀₂ data for carbonaceous material, which range from 3.642 to 3.564 Å, the highest grade of metamorphism is considered to have attained only the lowermost grade of the pumpellyite‐actinolite facies for which the highest temperature may be approximately 300°C. Metamorphic white mica K–Ar ages are reported for magnetic separates and <2 µm hydraulic elutriation separates from 27 pelitic and semipelitic samples. The age data obtained from elutriation separates are approximately 8 m.y. younger, on average, than those from magnetic separates. The age difference is attributed to the possible admixture of nonequilibrated detrital white mica in the magnetic separates, and the age of the elutriation separates is considered to be the age of metamorphism. If the concept, based on fossil evidence, of the subdivision of the Northland accretionary complex into north and south units is accepted, then the peak age of metamorphism in the north unit is likely to be 180–130 Ma; that is, earliest Middle Jurassic to early Early Cretaceous, whereas that in the south unit is 150–130 Ma; that is, late Late Jurassic to early Early Cretaceous. The age cluster for the north unit correlates with that of the Chrystalls Beach–Taieri Mouth section (uncertain terrane), while the age cluster for the south unit is older than that of the Younger Torlesse Subterrane in the Wellington area, and may be comparable with that of the Nelson and Marlborough areas (Caples and Waipapa terranes).     

Estimating the seismic displacement of friction pendulum isolators based on non‐linear response history analysis

A procedure for developing equations that estimate the isolator displacement due to strong ground motion is applied to buildings isolated with the friction pendulum system. The resulting design equations, based on rigorous non‐linear analysis, offer an alternative to the iterative equivalent‐linear methods used by current U.S. building codes. The governing equations of the system are reduced to a form such that the median normalized displacement of the system due to an ensemble of ground motions is found to depend on only the isolation period—a function of the curvature of the isolator—and the friction force at incipient slip normalized by peak ground velocity. The normalization is effective in minimizing the dispersion of the normalized displacement for an ensemble of ground motions, implying that the median normalized displacement is a reliable estimate of response. The design equations reflect the significant (20 to 38%) increase in displacement when the excitation includes two lateral components of ground motion instead of just one component. Equivalent‐linear methods are shown to underestimate by up to 30% the exact median displacement determined by non‐linear response history analysis for one component of ground motion, and building codes include at most a 4.4% increase for a second component. Copyright © 2003 John Wiley & Sons, Ltd.     

鄂尔多斯盆地苏里格庙气田上古生界盒8段地质与地球物理响应特征

苏里格庙气田主要产气层为上古生界石盒子组盒8段，属于三角洲平原分流河道沉积。复合砂体近南北向展布；单砂体的厚度变化大，非均质性明显，储渗变化大。盒8段含气砂岩在AVO资料上有明显反映；在综合测井资料上，盒8段表现出自然伽玛测井值、密度测井值、补偿中子测井值都偏低，电阻率、声波时差测井值较高，出现了大幅度的自然电位异常。利用核磁共振测井技术测得苏里格庙区某井盒8段3555．9m～3559．6m为气层，3560．6m～3572m为气水层，与生产实践吻合得很好。     

某滑坡软弱夹层抗剪强度取值方法的研究

文章主要针对软弱夹层抗剪强度取值所存在的争议，通过对贵州新街子滑坡的软弱夹层分别选择比例极限、屈服极限及峰值作为剪应力值，采用最小二乘法获得比例抗剪强度、屈服抗剪强度和峰值抗剪强度。以参数选取中应用较为成熟的反分析方法推求力学性质参数c、φ值作为判据对以上3种参数进行比较。计算结果表明：本滑坡软弱夹层中由于含泥量较大，而且粘塑性较强，屈服抗剪强度和反分析得到的抗剪强度偏差最小，比例抗剪强度偏差最大，峰值抗剪强度居中。并以此3种抗剪强度进行天然状态下滑坡稳定性验算，结果表明选用比例极限抗剪强度与当前滑坡的地质现象不符，选用峰值极限抗剪强度安全储备较低，而选取屈服极限抗剪强度最为合理。用此参数进行设计，滑坡已经得到了良好的治理。在取值研究中认为采用试验与反分析相结合的方法确定滑坡稳定性计算参数是比较合理的。以上结论为滑坡中软弱夹层抗剪强度取值的选择提供了重要的依据。     

Blast Induced Damage and Dynamic Behaviour of Hangingwalls in Bench Stoping

This paper presents the results of a comprehensive monitoring program designed to investigate the extent of blast induced damage experienced by rock masses extracted by bench stoping methods. An array of triaxial geophones and extensometers were used to monitor blast vibration attenuation and measure hangingwall deformations during stope extraction. In addition, pre and post surveys of the hangingwall rock mass were conducted using a TV borehole camera and cavity survey instrumentation. These surveys were later used to calibrate damage profiles into the stope hangingwalls.

Peak particle velocity, hangingwall deformation measurements and stope surveys were used to develop a site specific damage model that allowed engineers to asses drilling and blasting configurations to minimise the extent of pre-conditioning and damage. In addition the study included the analysis of the frequency response, displacements and accelerations experienced by the excavation as extraction and mine filling progressed. This work aimed at improving our understanding of the influence of blasting on the dynamic behaviour of stope hangingwalls.

The study demonstrated that estimates of the maximum extent of rock mass pre-conditioning and/or damage made through the application of the Holmberg-Persson approach compared well with measured results. In addition, the study found that dynamic loading imparted on an exposed hangingwall from subsequent stope blasting was also expected to contribute to rock mass weakening and that mine filling was crucial to arrest further deterioration. Hangingwall accelerations were used to demonstrate that larger openings may be more susceptible to dynamic loading.