Slow mass movement in the Kangchenjunga area, eastern Nepal Himalaya

Abstract   The rates of the accumulated and continuous displacement of solifluction lobes in the Kangchenjunga area, eastern Nepal Himalaya, were determined using glass fiber tubes and a strain probe. Ground temperature, precipitation and soil moisture were monitored at two sites, whose altitude differed by approximately 100 m, to understand the solifluction process. The average movement rate of the glass fiber tubes on a 31° slope at altitudes of 5412–5414 m a.s.l. was approximately 11 mm/year, being almost threefold greater than that observed on a 22° slope at 5322–5325 ma.s.l. There was no significant difference in the depth of displacement at these sites. The continuous displacement measurement near the ground surface at 5414 m showed permanent downslope movement from early July. Such movement may be attributed to additional moisture supply during the monsoon season. The amplitude of the displacement cycle was highest at the ground surface, and decreased to virtually zero at and below 20 cm in depth. Probable factors leading to the relatively slow rates of downslope displacement at the surface and depth at the studied altitudes are the lack of concurrence of the freeze–thaw cycles and the high moisture condition in the soil, and the low moisture retention capacity of the soil because of steep slopes and superficial desiccation. The rate of displacement may be more pronounced at altitudes above 5600 m because of the freeze–thaw cycles during the summer season.     

The effective number of cycles of earthquake ground motion

The seismic response of any system that accumulates damage under cyclic loading is dependent not only on the maximum amplitude of the motion but also its duration. This is explicitly recognized in methods for estimating the liquefaction potential of soil deposits. Many researchers have proposed that the effective number of cycles of the ground motion is a more robust indicator of the destructive capacity of the shaking than the duration. However, as is the case with strong‐motion duration, there is no universally accepted approach to determining the effective number of cycles of motion, and the different methods that have been proposed can give widely varying results for a particular accelerogram. Definitions of the effective number of cycles of motion are reviewed, classified and compared. Measurements are found to differ particularly for accelerograms with broad‐banded frequency content, which contain a significant number of non‐zero crossing peaks. The key seismological parameters influencing the number of cycles of motion and associated equations for predicting this quantity for future earthquakes are identified. Correlations between cycle counts and different duration measures are explored and found to be rather poor in the absence of additional parameters. Copyright © 2004 John Wiley & Sons, Ltd.     

Study on comparison between absolute and relative input energy spectra and effects of ductility factor

Introduction Estimation of an attenuation relationship for strong ground motion parameters has been an interesting research subject in the field of engineering seismology and has played a very important role in seismic safety evaluation, seismic zoning, seismic hazard evaluation of major constructions, etc. At present, the generally used parameters include peak acceleration, peak velocity and elastic response spectrum. Such parameters mentioned above are essentially independent of the duration…     

Study on simulating strong ground motion by fractal stochastic method

The time history of strong ground motion can be synthesized by empirical Green's function (EGF) method.Firstly a large seismic event is discretized into a series of subevents; secondly recordings of earthquakes with proper size and spatial distribution are chosen as time history (EGF) of those subevents; finally the EGFs are summated to get the time history of ground motion caused by the large event.     

Evaluation of current statistical approaches for predictive geomorphological mapping

Predictive models are increasingly used in geomorphology, but systematic evaluations of novel statistical techniques are still limited. The aim of this study was to compare the accuracy of generalized linear models (GLM), generalized additive models (GAM), classification tree analysis (CTA), neural networks (ANN) and multiple adaptive regression splines (MARS) in predictive geomorphological modelling. Five different distribution models both for non-sorted and sorted patterned ground were constructed on the basis of four terrain parameters and four soil variables. To evaluate the models, the original data set of 9997 squares of 1 ha in size was randomly divided into model training (70%, n=6998) and model evaluation sets (30%, n=2999).In general, active sorted patterned ground is clearly defined in upper fell areas with high slope angle and till soils. Active non-sorted patterned ground is more common in valleys with higher soil moisture and fine-scale concave topography. The predictive performance of each model was evaluated using the area under the receiver operating characteristic curve (AUC) and the Kappa value. The relatively high discrimination capacity of all models, AUC=0.85–0.88 and Kappa=0.49–0.56, implies that the model's predictions provide an acceptable index of sorted and non-sorted patterned ground occurrence. The best performance for model calibration data for both data sets was achieved by the CTA. However, when the predictive mapping ability was explored through the evaluation data set, the model accuracies of CTA decreased clearly compared to the other modelling techniques. For model evaluation data MARS performed marginally best.Our results show that the digital elevation model and soil data can be used to predict relatively robustly the activity of patterned ground in fine scale in a subarctic landscape. This indicates that predictive geomorphological modelling has the advantage of providing relevant and useful information on earth surface processes over extensive areas, such data being unavailable through more conventional survey methods.     

Archaeoseismic record at the ancient Roman City of Baelo Claudia (Cádiz, south Spain)

This study represents the first paleoseismic approach in Spain in which archaeological remains are considered. The ancient Roman city of Baelo Claudia (1st–4th centuries AD), located at the axial zone of the Gibraltar Strait (Cadiz, south Spain), contains abundant disrupted architectural relics and ground collapses (i.e. landsliding, liquefacion) probably related to historic earthquake damage of intensity IX–X MSK. The archaeological stratigraphy of the city evidence two major episodes of abrupt city destruction bracketed in AD 40–60 and AD 350–395 separated by an intervening horizon of demolition for city rebuilding, otherwise characteristic for many earthquake-damaged archaeological sites in the Mediterranean. The second episode led the eventual city abandonment, and it is evidenced by good examples of column collapse, distortion, failure and breakdown of house and city walls, and pavement warping and disruptions documented during different archaeological excavations, which can be catalogued as secondary coseismic effects. Main damaged relicts observable today are the set of pop-up like arrays and warping developed in the ancient Roman pavement. Their analysis indicate an anomalous westwards ground displacement oblique to the main gentle southward slope of the topography, as also evidence failures, collapses and breakdown of walls and columns, suggesting that stress acted in a broad SW–NE/WSW–ENE orientation consistent whit the expectable motion along the largest NE–SW strike-slip faults of the zone, which in turn can be catalogued as seismic sources of moderate events (ca. 5 mb). Major disruptions and city abandonment were hesitantly related to relatively far strong earthquakes occurred during the late 4th century AD in the Mediterranean or western coast of Iberia by Menanteau et al. [Menanteau, L., Vanney, J.R., Zazo, C., 1983. Belo II : Belo et son environment (Detroit de Gibraltar), Etude physique d'un site antique. Pub. Casa de Velazquez, Serie Archeologie 4., Ed. Broccard, París.]. However, this study indicates that the occurrence of close moderate earthquakes jointly with the unstable character of the ground at the zone (site effect) is a more reliable hypothesis to explain the observed deformations.     

Understory and small trees contribute importantly to stemflow of a lower montane cloud forest

Stemflow (Sf) measurements in tropical rain and montane forests dominated by large trees rarely include the understory and small trees. In this study, contributions of lower (1‐ to 2‐m height) and upper (>2‐m height and <5‐cm diameter at breast height [DBH]) woody understory, small trees (5 < DBH < 10 cm), and canopy trees (>10‐cm DBH) to Sf per unit ground area (Sf_a) of a Mexican lower montane cloud forest were quantified for 32 days with rainfall (P) during the 2014 wet season. Rainfall, stemflow yield (Sf_y), vegetation height, density, and basal area were measured. Subsequently, stemflow funneling ratios (SFRs) were calculated, and three common methods to scale up Sf_y from individual trees to the stand level (tree‐Sf_y correlation, P‐Sf_y correlation, and mean‐Sf_y extrapolation) were used to calculate Sf_a. Understory woody plants, small trees, and upper canopy trees represented 96%, 2%, and 2%, respectively, of the total density. Upper canopy trees had the lowest SFRs (1.6 ± 0.5 Standard Error (SE) on average), although the lower understory had the highest (36.1 ± 6.4). Small trees and upper understory presented similar SFRs (22.9 ± 5.4 and 20.2 ± 3.9, respectively). Different Sf scaling methods generally yielded similar results. Overall Sf_a during the study period was 22.7 mm (4.5% of rainfall), to which the understory contributed 70.1% (15.9 mm), small trees 10.6% (2.4 mm), and upper canopy trees 19.3% (4.4 mm). Our results strongly suggest that for humid tropical forests with dense understory of woody plants and small trees, Sf of these groups should be measured to avoid an underestimation of overall Sf at the stand level.     

Rain on snow induced urban floods in cold maritime climate: Risk,indicators and trends

Urban floods pose a societal and economical risk. This study evaluated the risk and hydro-meteorological conditions that cause pluvial flooding in coastal cities in a cold climate. Twenty years of insurance claims data and up to 97 years of meteorological data were analysed for Reykjavík, Iceland (64.15°N; <100 m above sea level). One third of the city's wastewater collection system is combined, and pipe grades vary from 0.5% to 10%. Results highlight semi-intensive rain (<7 mm/h; ≤3 year return period) in conjunction with snow and frozen ground as the main cause for urban flood risk in a climate which undergoes frequent snow and frost cycles (avg. 13 and 19 per season, respectively). Floods in winter were more common, more severe and affected a greater number of neighbourhoods than during summer. High runoff volumes together with debris remobilized with high winds challenged the capacity of wastewater systems regardless of their age or type (combined vs. separate). The two key determinants for the number of insurance claims were antecedent frost depth and total precipitation volume per event. Two pluvial regimes were particularly problematic: long duration (13–25 h), late peaking rain on snow (RoS), where snowmelt enhanced the runoff intensity, elongated and connected independent rainfall into a singular, more voluminous (20–76 mm) event; shorter duration (7–9 h), more intensive precipitation that evolved from snow to rain. Closely timed RoS and cooling were believed to trigger frost formation. A positive trend was detected in the average seasonal snow depth and volume of rain and snowmelt during RoS events. More emphasis, therefore, needs to be placed on designing and operating urban drainage infrastructure with regard to RoS co-acting with frozen ground. Furthermore, more detailed, routine monitoring of snow and soil conditions is important to predict RoS flood events.     

Measurement of stream cross section using ground penetration radar with Hilbert–Huang transform

This study presents a new method to measure stream cross section without having contact with water. Compared with conventional measurement methods which apply instruments such as sounding weight, ground penetration radar (GPR), used in this study, is a non‐contact measurement method. This non‐contact measurement method can reduce the risk to hydrologists when they are conducting measurements, particularly in high flow period. However, the original signals obtained by using GPR are very complex, different from studies in the past where the measured data were mostly interpreted by experts with special skill or knowledge of GPR so that the results obtained were less objective. This study employs Hilbert–Huang transform (HHT) to process GPR signals which are difficult to interpret by hydrologists. HHT is a newly developed signal processing method that can not only process the nonlinear and non‐stationary complex signals, but also maintain the physical significance of the signal itself. Using GPR with HHT, this study establishes a non‐contact stream cross‐section measurement method with the ability to measure stream cross‐sectional areas precisely and quickly. Also, in comparison with the conventional method, no significant difference in results is found to exist between the two methods, but the new method can considerably reduce risk, measurement time, and manpower. It is proven that the non‐contact method combining GPR with HHT is applicable to quickly and accurately measure stream cross section. Copyright © 2013 John Wiley & Sons, Ltd.