Tectonics of a fast spreading center: A Deep-Tow and sea beam survey on the East Pacific rise at 19°30′ S

Sea Beam and Deep-Tow were used in a tectonic investigation of the fast-spreading (151 mm yr^-1) East Pacific Rise (EPR) at 19°30 S. Detailed surveys were conducted at the EPR axis and at the Brunhes/Matuyama magnetic reversal boundary, while four long traverses (the longest 96 km) surveyed the rise flanks. Faulting accounts for the vast majority of the relief. Both inward and outward facing fault scarps appear in almost equal numbers, and they form the horsts and grabens which compose the abyssal hills. This mechanism for abyssal hill formation differs from that observed at slow and intermediate spreading rates where abyssal hills are formed by back-tilted inward facing normal faults or by volcanic bow-forms. At 19°30 S, systematic back tilting of fault blocks is not observed, and volcanic constructional relief is a short wavelength signal (less than a few hundred meters) superimposed upon the dominant faulted structure (wavelength 2–8 km). Active faulting is confined to within approximately 5–8 km of the rise axis. In terms of frequency, more faulting occurs at fast spreading rates than at slow. The half extension rate due to faulting is 4.1 mm yr^-1 at 19°30 S versus 1.6 mm yr^-1 in the FAMOUS area on the Mid-Atlantic Ridge (MAR). Both spreading and horizontal extension are asymmetric at 19°30 S, and both are greater on the east flank of the rise axis. The fault density observed at 19°30 S is not constant, and zones with very high fault density follow zones with very little faulting. Three mechanisms are proposed which might account for these observations. In the first, faults are buried episodically by massive eruptions which flow more than 5–8 km from the spreading axis, beyond the outer boundary of the active fault zone. This is the least favored mechanism as there is no evidence that lavas which flow that far off axis are sufficiently thick to bury 50–150 m high fault scarps. In the second mechanism, the rate of faulting is reduced during major episodes of volcanism due to changes in the near axis thermal structure associated with swelling of the axial magma chamber. Thus the variation in fault spacing is caused by alternate episodes of faulting and volcanism. In the third mechanism, the rate of faulting may be constant (down to a time scale of decades), but the locus of faulting shifts relative to the axis. A master fault forms near the axis and takes up most of the strain release until the fault or fault set is transported into lithosphere which is sufficiently thick so that the faults become locked. At this point, the locus of faulting shifts to the thinnest, weakest lithosphere near the axis, and the cycle repeats.     

基于空间数据库的山东城镇发展水平的空间统计分析

基于GIS空间数据库,对山东省108个城镇的综合发展水平进行了空间统计分析。首先选用了反映城市综合发展水平的14项指标,并进行了主成分分析,得出反映城镇综合发展水平的综合指标,并分析了山东省各城镇的综合发展水平与分布状况。然后利用该综合指标,对各个城镇进行了空间统计分析,通过计算全局空间自相关指标,分析认为山东省各城镇综合发展水平总体上未呈现空间相关关系;通过计算局部空间自相关指标,分析认为山东省68.5%的城镇分布存在非相似空间集聚特征。     

BP神经网络在局部似大地水准面精化的应用

针对高程拟合中的模型误差问题,采用BP神经网络方法进行拟合,可以减小模型误差,提高似大地水准面的精化精度。在焦作市局部似大地水准面精化算例中,BP神经网络高程拟合取得了良好的效果。     

半参数平差模型估计量的精度评定

将半参数估计理论引入测量数据处理理论中,利用Blight和Ott提出的思想,用多项式函数来表示半参数平差模型中的非参数分量,从而得到了半参数平差模型中参数分量和非参数分量的Bayes估计量,通过理论证明,半参数模型参数分量的Bayes估计为通常意义下高斯马尔可夫模型参数估计值与参数期望的加权平均,是一致、渐近无偏和渐近有效估计量,并且其方差小于参数模型中参数估计量的方差。在一定情况下推广了平差理论,具有一定的理论价值。     

天然气溶解过程中组分分馏模型及其应用

天然气不同组分在水中溶解度的差异,导致溶解相与残留游离相天然气组分组成不同,即发生组分的溶解分馏效应。溶解分馏效应在天然气水溶运移、溶解散失等过程中均有发生。揭示天然气组分的溶解分馏规律、建立定量分馏模型,有助于天然气气源对比和成藏过程示踪。以Henry定律为依据,对不同组分溶解特征分析,提出了溶解度分数的概念,并建立了溶解分馏模型。根据该模型和各组分的溶解度分数和天然气溶解量,可计算各组分的溶解分馏量,恢复天然气初始组成特征。计算表明,威远震旦系气藏初期的天然气组成为:CH4为72.70%,C2H6为0.09%,CO2为22.41%,N2为4.07%,干燥系数(C1/C1-5)为99.876%。溶解作用使天然气中CO2含量显著降低,烃类气体含量增加,而天然气干燥系数降低。结果有助于天然气成因判识和气源对比等。     

单侯井田构造发育规律及其对煤层开采的影响

从区域构造入手,对单侯井田构造进行分析,认为井田内断层发育以走向NW—NE、落差≤5m的小型正断层为主,且主要分布于大中型构造的两侧．特别是在其弧形转折带附近往往形成“羽”状雁列的小断层密集带。断层垂向上多分布于4—7号煤层之间的厚煤层发育区,其严重破坏了煤层的连续及完整性,是影响煤层开采的最主要因素之一。井田褶皱构造相对不发育,以短轴小型背、向斜为主,均属缓波状褶曲,对煤层的开采无影响或影响较小。根据井田地质构造发育程度,对其进行预测及分区评价：井田东部为强烈的构造挤压带,以发育走向NW-近EW—NE向的大型逆掩断层为特点,构造最复杂;井田西北部是相对较轻微的构造挤压带,以发育走向NE向的逆断层为特征,构造较复杂;井田南部以发育近SN或NNW向正断层为主,构造相对简单。评价结果对矿井设计及采区与工作面布置有一定的指导作用。     

Estimation of statistical parameters for censored lognormal hydraulic conductivity measurements

Field tests of hydraulic conductivity (e.g., injection test, pumping test, etc.) in low permeability formations are subject to censoring due to the detection limit of the instruments used. An iterative method of estimating the mean and variance of hydraulic conductivity data with a presumed log-normal distribution function is presented. This method accounts for the data that are actually below the lower detection limit (called truncated data) and thus gives distribution parameters that are more representative for the underlying distribution. The proposed method is then tested on two simulated normally distributed random datasets having different variances. The results show that the means and variances estimated by the proposed method are very accurate. Finally, the method is used to estimate the mean and variance of hydraulic conductivity data from single hole water injection tests in a fractured geological formation.     

利用主成分分析改善土地利用变化的遥感监测精度——以珠江三角洲城市用地扩张为例

近年来,珠江三角洲由于经济的快速发展,城市用地急剧增加,利用多时相的遥感图,可以定量地监测这种城市化的现象。但理,由一般的遥感动态监测方法所得的结果往往夸大变化的程度,以及获得一些不合理的结论．该文提出主成分分析的方法来改善遥感动态监测的精度。将该方法应用应用于珠江三角洲发展最快的东莞市,获得了较满意的结果。     

北京云蒙山地区花岗岩穹隆及伸展构造的探讨

北京云蒙山花岗岩为一中生代侵入的花岗岩穹隆,花岗岩穹隆的叶理普遍发育,叶理轨迹基本平行于穹隆的外部边界,并显示出从核部到边部逐渐增强,东南侧明显强于西北侧的特点。变形构造研究显示,花岗岩穹隆的边部及围岩中普遍存在不同层次及不同运动方向的伸展构造。东南侧以具河防口－水峪伸展型韧性剪切带为特征,剪切运动标志显示为从ＮＷ－ＳＥ的正剪切运动,有限应变分析估算其剪切位移量在１０ｋｍ以上,剪切带上部被河防口正