南黄海及相邻陆区松散沉积层磁性地层的研究

本文通过研究区5个钻孔松散沉积岩心磁性地层的划分对比,获知布容与松山极性带的界线,南黄海和陆区北部位于80.0—99.5m。陆区的南部此界线于270.4m深处。松山和高斯极性带的界线,海区未揭露到,其沉积起始时间都小于1.7Ma。而陆区的南、北部分别位于117m和328.2m。高斯和吉尔伯特极性带的界线,陆区北部为140m,而南部区为460.15m。沉积起始时间为3.4Ma。吉尔伯特底界仅北部陆区所揭示,为190.5m。松散沉积层与下伏白垩纪(?)石灰岩接触面位于400.35m,沉积起始时间约17.0Ma。     

Comparison of Strain-rate Dependent Stress-Strain Behavior from Ko-consolidated Compression and Extension Tests on Natural Hong Kong Marine Deposits

This article presents results from a series of K_o-consolidated compression and extension triaxial tests on specimens from undisturbed samples of Hong Kong Marine Deposits (HKMD). To investigate the strain-rate effects, a total of seven K_o-consolidated triaxial tests were conducted including four compression tests and three extension tests. After K_o-consolidation, the triaxial test specimens were sheared at step-changed axial strain rates under three different confining pressures of 50 kPa, 150 kPa, and 400 kPa, respectively. The step-changed strain rates were applied in the following order: +2%/h, +0.2%/h, +20%/h, -2%/h (unloading) and +2%/h (reloading) for the four compression tests and -2%/h, -0.2%/h, -20%/h, +2%/h (unloading) and -2%/h (reloading) for the three extension tests. The results are reported and analyzed in the paper. The results show that the strain rate effects, the stress-strain characteristics, and the effective stress paths of the specimens for tests in a compression state are different from those for tests in an extension stage. One order of magnitude increase in axial strain rate causes an average 8.6% increase in undrained shear strength for compression tests and a 12.1% increase for extension tests. It is also found that the failure mode of the specimens in compression is different from that in extension. The stress-strain behavior of specimens shows strain-softening and a clear shear band in compression tests, but strain-hardening without any clear shear band in extension tests for the same absolute value of axial strain.     

青岛市水环境污染及其防治对策

通过分析近几年青岛市地表，地下水水质监测资料，总结水环境污染地区分布规律，摸清水环境污染形成原因，对当前防污治污工作提出了对策建议。     

珠江三角洲及珠江口海区的空气微生物含量

１９９４年６，７月，调查了广州、深圳、珠海及珠江口海区的空气微生物粒子沉降量状况。发现空气微生物粒子总量、真菌粒子量、真菌粒子数／总菌粒子数百分比在三市中不一致。这三种数据一般是陆上的高于海上。随着距陆的增加，都市影响的减弱和海面的开阔，空气微生物含量呈减少之势，显示出海洋新鲜空气对陆上污染空气的调节、净化作用。文中还分析了空气微生物有关参数与气温、风力或相对湿度间的相关关系。     

开发胶东温泉地热水对环境的影响

根据地热水中阴离子的组分与温泉水类型，指出其中Ⅱ＿１、Ⅱ＿２：型水温高，日采水量大，矿化度高，水质复杂，相应的环境效应明显．提出地热水的大规模开采以及尾水的大量排放，对温泉周边的生态环境、工程环境、土壤及地下水等方面有明显的影响．     

Application of Microbial BOD Sensors in Marine Monitoring

A strain of yeast, which can endure high osmotic pressure, is employed for the sensitive material of the microbial BOD sensor. Two immobilization methods are used, I.e. Calcium alginate gel be ads and PV A gel beads. The results show that the PVA gel beads is better. The influences of osmosis and heavy metal ions on the yeast entrapped in the PVA gel beads are also studied in the experiment.     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.