近45 a来中国西北年极端高、低温的变化及对区域性增暖的响应

利用中国西北五省(区)1960-2004年129个台站逐日最低、最高温度资料,从中统计出年极端高温发生频次、年极端低温发生频次、年极端高温强度、年极端低温强度以及年极端高温和低温开始和结束日期,分析了它们近45 a来的变化情况。结果表明:近45 a来中国西北年极端高温发生频次的增加趋势是明显的,而年极端低温发生频次的减少趋势更显著;中国西北近45 a来年极端高温的强度在不断增强,而极端低温的强度在不断减弱;近45 a来中国西北年极端高温开始日期逐渐提前,结束日期逐渐推迟,而年极端低温的开始日期在逐渐推迟,结束日期在逐渐提前;年极端低温发生频次的减少对于西北区域增暖的响应比年极端高温发生频次增加更显著,而年极端低温强度的减弱要比年极端高温强度的增强对西北区域性增暖的响应偏弱,年极端高温发生频次的增加同年极端高温强度的增强对西北区域性增暖的响应程度基本相当。     

Effects of low molecular weight organic acids on sorption and desorption behavior of p-chlorophenol by yellow earth

Low molecular weight organic acids （LMWOAs） are important components of root exudates. They play an important role in immobilizing and remobilizing contaminants in rhizospheric soil. Effects of four LMWOAs on the sorption and desorption behavior of p-chlorophenol by yellow earth was studied in batch mode. The results showed that the previous application of LMWOAs to enhanced adsorption capacity of p-chlorophenol of the soil in the order of maleic acid〉malic acid〉oxalic acid〉citric acid. However, when LMWOAs were applied to soil where p-chlorophenol had been previously adsorbed, substantial p-chlorophenol was desorbed from soil by oxalic acid, whereas citric acid, malic acid and maleic acid didn＇t desorb as much p-chlorophenol from soil as deionized water.     

低阻油气储层测井解释方法研究

对低阻油气储层的测井响应特征和储层物性特征进行了研究,并针对研究区域低阻储层的特点,以岩心与测井数据的相关性为依据,提出了适合地区特点的储层参数解释方法。通过应用三水导电模型,提高了低阻储层的测井解释精度。     

基于GIS的供电台区经营综合评价

探讨了运用GIS技术对供电台区经营综合评价的实现方法,选取了业务属性和空间属性两个方面评价因子,介绍了从系统软硬件、评价实现过程及显示结果等方面评价过程的具体技术实现。     

不等电极距情况下高密度电阻率法的反演结果分析

通过高密度电阻率法的模型实验,得出不等电极距情况对直立高阻薄板和低阻球体反演结果的影响:缺失电极对它正下方的ρ_s影响最大,而异常形态主要在水平方向有明显的变化,异常体随电极缺失的位置有趋势变化,电极缺失的数目越多,异常形态变化越大,但是从整体来看反演剖面图基本相似。     

塔里木盆地阿克库勒地区石炭系卡拉沙依组成岩作用

阿克库勒地区卡拉沙依组碎屑岩储层的成分成熟度和结构成熟度均较低．储层的次生溶蚀孔隙所占比例远高了：原生孔隙，次生孔隙是储层的主要储集空间．样品数据统计显示，卡拉沙依组储层属于低孔、低渗储层类型．根据岩石薄片、铸体薄片观察及储层样品的扫描电镜和阴极发光分析结果，本区石炭系储层主要经历的成岩作用有压实（压溶）作用、胶结作用、溶蚀作用和交代作用，其中碳酸盐矿物的沉淀和溶蚀作用是本区卡拉沙依组储层所经历的最重要的成岩作用．成岩作用已达到晚成岩B期，早期方解石交代石英颗粒并发生大量溶蚀，生成大量次生孔隙，晚期方解石没有发生溶蚀．     

过硫酸铵氧化容量法测定矿石中锰方法的改进

采用过硫酸铵氧化容量法测定锰时,可在低酸度(0.18mol/LH2SO4、0.29mol/LH3PO4)和大体积(300mL)溶液中氧化Mn2 至Mn7 。所测得的结果十分稳定,回收率为100%。采用管理样分析验证方法,其结果与铋酸钠容量法结果一致。对于w(Mn)=11.36%的试样进行10次分析测定,RSD=0.33%。方法可测定w(Mn)≥0.01%的常见矿种样品。     

低频泥石流特征及防治 --以四川汶川县茶园沟为例

低频泥石流指30a以上发生1次的泥石流。尽管发生频率很低，但由于自身的特征及人们认识上的原因，其造l戒的人员伤亡和财产损失却居各类泥石流之首。对低频泥石流的研究在预防和减轻泥石流灾害方面有着重要意义。文章以2003年8月9日发生在四川汶川县茶园沟的泥石流为蒯，采用形态调查法和称重法等方法确定了流量、流速及重度。分析了其物质来源及形成的自然和人为原因，探讨了低频泥石流的特征。针对低频泥石流的低频性、破坏性和隐蔽性特点，同时考虑到低频泥石流沟的防治受保护对象的重要程度及资金投入等因素的限制，提出了进行泥石流危险性分区、搞好小流域水土深持、普及泥石流防灾减灾知识及加强监测和预警预报等措施，这对减轻低频泥石流区的灾害有一定的借鉴意义。     

Tests on low‐ductility RC frames under high‐ and low‐frequency excitations

The response of low‐ductility reinforced concrete (RC) frames, designed typically for a non‐seismic region, subjected to two frequencies of base excitations is studied. Five half‐scaled, two‐bay, two‐storey, RC frames, each approximately 5 m wide by 3.3 m high, were subjected to both horizontal and/or vertical base excitations with a frequency of 40 Hz as well as a lower frequency of about 4 Hz (close to the fundamental frequency) using a shake table. The imposed acceleration amplitude ranged from 0.2 to 1.2g. The test results showed that the response characteristics of the structures differed under high‐ and low‐frequency excitations. The frames were able to sustain high‐frequency excitations without damage but were inadequate for low‐frequency excitations, even though the frames exhibited some ductility. Linear‐elastic time‐history analysis can predict reasonably well the structural response under high‐frequency excitations. As the frames were not designed for seismic loads, the reinforcement detailing may not have been adequate, based on the crack pattern observed. The effect of vertical excitation can cause significant additional forces in the columns and moment reversals in the beams. The ‘strong‐column, weak‐beam’ approach for lateral load RC frame design is supported by experimental observations. Copyright © 2001 John Wiley & Sons, Ltd.     

低温电镀孕镶金刚石石油取心钻头研制与应用

该钻头用于坚硬地层取心。河南油田以往常用园柱聚晶、三角聚晶钻头以及烧结孕镶金刚石钻头，取心效率低、钻速慢、成本高。近两年采用低温电镀孕镶金刚石钻头取心后，平均单筒进尺由原来的4．20m／筒提高到7．62m/筒，平均取心机械钻速由原来的0．21m/h提高到的0.84m/h。该钻头生产工艺完全改变原来高温（1000℃以上）烧结为低温（室温）电镀工艺，极大地避免了金刚石热损伤，采用高强度大颗粒的金刚石，提高了取心机械钻速。