多因素复杂系统最佳因素权重确定的一种新思路——以深港西部通道工程深圳湾公路大桥为例

为了客观地反映各因素对目标问题的影响程度,本文首次提出了最佳因素权重概念。定义最佳因素权重为研究区域内系统质量处于极限状态时的各因素权重之组合。结合深港西部通道工程深圳湾公路大桥桥址比选方案,详细说明了本方法的研究思路及其确定方法。通过最佳因素权重方法,能客观地、定量地确定出多因素复杂系统中的最优场址。     

GPS-measured land subsidence in Ojiya City, Niigata Prefecture, Japan

Land subsidence caused by compression of clay layers in Ojiya City, Japan was measured by global positioning system (GPS) between 1 April 1996 and 31 December 1998.

Three baselines were selected in and around the city, and height difference on a WGS-84 ellipsoid was measured by GPS on each baseline. The ground at the GPS station in the city subsides and rebounds 7 cm every winter and spring, respectively. Measurement accuracy was 9.5 mm standard deviation. Ground water level was observed at a well near the GPS station. Regression analysis between total strain, calculated as ratio of the height difference displacement to the total thickness of the clay layers, and the layers' effective stress change with ground water level change gave good correlation. The slope of regression line 7.0×10⁻¹¹ m²/N was obtained as an average apparent coefficient of volume compressibility of the layers.     

Digital model of corrected accumulated flow for peak discharge data acquisition and drainage system design

The design of a drainage system for a roofing slate quarry was implemented by the enhancement of discharge peak estimation, and the uncertainty inevitably associated with the engineering model was reduced.

The development of a topographical, geological, and vegetation cover database developed from a Geographical Information System (GIS) allowed for the definition of the drainage network for a hydraulic system, along with the calculation of the runoff coefficient. This is applied to the digital model of accumulated flow (DMF) as a weight correction coefficient, using a matrix-based model at 5×5 m resolution. The new digital model of corrected accumulated flow (DMCF) is the result of combining the thematic maps with the map of slope <3%, which was previously created from the slope model. It is demonstrated that this new model allows to apply the “Rational Method” on cartographic units defined by the GIS.

The DMCF is compared with other traditional applications of the Rational Method based on the calculation of the discharge peak considering: (1) the drainage basin as a single watershed or (2) defining an average runoff coefficient in each sub-watershed. Both approaches have bigger discharge peaks than those obtained by the DMCF since the slope, lithology, and vegetation cover have average values, and the runoff coefficient is poorly defined, increasing the uncertainty in the discharge peak.     

An experimental investigation of LNAPL migration in an unsaturated/saturated sand

Accidental spills of hydrocarbons, such as Light Non-Aqueous Phase Liquids (LNAPLs), are one of the most common sources of subsurface contamination. Migration of LNAPL in a porous medium is influenced by various factors such as the number of fluids present in the unsaturated/saturated zones and the proportion of pores occupied by each fluid. The results for relationship between matric suction and degree of saturation are presented in this paper for water–air, water–LNAPL and LNAPL–air systems in a sand. A simple and reliable setup using Buchner funnel was designed to obtain these relations. It was found that the relationship between matric suction head and degree of saturation is hysteretic for all the fluid systems (water–air, water–LNAPL and LNAPL–air). Furthermore, the amount of hysteresis depended upon the fluid system, with the maximum hysteresis occurring for water–air system. The results suggest that the amount of trapped air depends upon the reversal degree of saturation from drying to wetting.     

Magnetotelluric Investigation of the Hydrothermal System and Heat Source in the Muine-Toyoha Geothermal Area, Hokkaido, Japan

Abstract. Magnetotelluric (MT) surveys were carried out around the Muine volcano, Hokkaido, Japan, where it is expected that the heat and metal source forming the polymetallic Ag-Pb-Zn-Cu-In Toyoha deposit is present at depth. Measurements were performed at 20 sites, 18 of which were located along a WSW-ENE profile traversing the north ridge of Mt. Muine. A resistivity model obtained from 2D inversion of the MT data shows subsurface specific conductive and resistive features. Conductive layers are present at the surface of Mt. Muine. The low resistivity is probably due to the clay-rich rocks associated with the hydrothermal alteration. A high resistivity layer, which corresponds to the pre-Tertiary Usubetsu Formation, crops out east of Mt. Muine and dips westward. At the west foot of Mt. Muine, relatively high resistive layers are widely exposed. The resistivity increases with depth and exceeds 1000 ohm-m. This fact indicates that this region is not influenced by the recent hydrothermal activity. An extremely conductive zone about 3–6 km wide and 6–9 km thick exists at a depth of 2 km below Mt. Muine. This zone mostly corresponds to an elastic wave attenuation zone detected by a seismic survey. It is interpreted as a large hydrothermal reservoir or melted magma, which is a heat source of the hydrothermal system in this area.     

Regional Fault Systems of Qaidam Basin and Adjacent Orogenic Belts

The purpose of this paper is to analyze the regional fault systems of Qaidam basin and ad-jacent orogenic belts. Field investigation and seismic interpretation indicate that five regional fault sys-tans occurred in the Qaidam and adjacent nment.qin belts, controlling the development and evolution of the Qaidam basin. These fault systems are: (1)north Qaidam-Qilian Mountain fault system; (2) south Qaidam-East Kunhm Mountain fault system;（3）Altun strike-slip fault system; (4) Elashan strike-slip fault system, and (5) Gansen-Xiaochaidan fault system. It is indicated that the fault systems controlled the orientation of the Qaidam basin, the formation and distribution of secondary faults within the basin,the migration of depocenters and the distribution of hydrocarbon accmnulation belt.     

沙尘暴天气监测预警服务业务系统设计思路及其实现

文中全面介绍了中国西北地区沙尘暴天气监测预警服务业务系统的设计思路及其先进性。该系统由沙尘天气资料库、沙尘天气监测预警和沙尘天气服务3个子系统构成。它的成功建设为西部大开发气象服务提供了有力的技术保障，为西部地区环境保护和环境监测奠定了基础。     

三江源生态环境监测研究

青海省生态环境监测系统主要由遍布全省各典型生态系统区的生态环境监测站网、卫星遥感信息接收处理系统，信息收集、处理、模拟、评价系统，综合信息服务与反馈等部分组成。建立环境监测系统的目的是对青海省的生态环境进行系统监测和评估，及时为各级政府、有关部门和公众提供准确、全面的生态环境监测信息，为生态环境保护和建设提供科学依据。青海省生态环境监测系统于2003年5月1日开始业务运行，目前尚处于起步阶段。     

PSP和TSP在数字制图系统开发中的运用

简要介绍了数字地图制图系统，结合在开发一个应用软件系统时所要面临的一些实际问题和困难，引入了软件工程思想中改进软件开发方式的个体软件过程(PSP)和群组软件过程(TSP)。     

现代通讯技术在自动化测量系统中的应用

介绍了基于现代通讯技术ADSL及GPRS的两种远程监控方式在自动化测量系统工程中的应用。获得的结论对于相关技术及专业的应用研究具有一定的借鉴作用。