Implications of low-pass filtering on power spectra and autocorrelation functions of turbulent velocity signals

Filtering either through the electronics of an instrument or through digital procedure is performed routinely on geophysical data. When velocity fluctuations are measured in turbulent flows using electromagnetic current meters (ECMs), a builtin lowpass Butterworth filter of order n usually attenuates fluctuations at high frequencies. However, the effects of this filter may not be acknowledged in turbulence studies, thus impeding comparisons between data collected with different ECMs. This paper explores the implications of the filters on the characteristics of velocity signals, mainly on variance, power spectra, and correlation analyses. Variance losses resulting from filtering can be important but will vary with the order n of the Butterworth filter, decreasing as n increases. Knowing the filter response, it is possible to reconstruct the original signal spectrum to evaluate the effect of filtering on variance and to allow comparisons between data collected with different instruments. The autocorrelation function also is affected by filtering which increases the value of the coefficients in the first lags, resulting in an overestimation of the integral length scale of coherent structures. These important effects add to those related to size and shape differences in ECM sensors and must be taken into account in comparative studies.     

贵州和四川盆地云量的气候研究

贵州和四川盆地是我国云量最多的地区,素有“天无三日晴”和“蜀犬吠日”之说,盆地西缘的雅安古时还有“雅州天漏”的谚语。从全球日照百分率分布推知,川黔地区也是世界上天气最阴沉的地区之一。川黔之阴一向为国内外气象界所注意,本文根据1951—1980     

A preliminary stable isotope study on Mogok Ruby, Myanmar

The primary occurrence of ruby in the Mogok area, northern Myanmar is exclusively found in marble along with spinel–forsterite-bearing marble and phlogopite–graphite marble. These marble units are enclosed within banded biotite–garnet–sillimanite–oligoclase gneisses. Samples of these marbles collected for C–O stable isotope analysis show two trends of δ¹³C–δ¹⁸O variation resulting most likely from fluid–rock interactions. Ruby-bearing marble and phlogopite–graphite marble follow a trend with coupled C–O depletion, whereas spinel–forsterite-bearing marble follows a δ¹⁸O depletion trend with relatively constant δ¹³C values. Ruby formation might have resulted from CO₂-rich fluid–rock interaction, while spinel–forsterite-bearing marble was genetically related to CO₂-poor fluid–rock interaction. Both fluids may have arisen from external sources. Based on graphite Raman spectral thermometry, the estimated temperature for phlogopite–graphite marble, and probably ruby-bearing marble, was lower than 607 °C, and for spinel–forsterite-bearing marble, lower than 710 °C. Contrasting C/O diffusion between graphite/ruby/spinel/forsterite and calcite, local variations of isotopic compositions of newly formed minerals as a result of non-pervasive fluid infiltration, and open-system isotopic disturbance during cooling may have affected C-/O-isotopic fractionations between minerals. The estimated high formation temperatures for ruby and spinel/forsterite imply that the parental fluids may have been related to nearby igneous intrusions and/or metamorphic processes. Whether these two types of fluid were genetically related is unclear based on the present data.     

“Cretaceous black flysch” in the Pieniny Klippen Belt, West Carpathians: a case of geological misinterpretation

This is a critical assessment of the paper by Oszczypko et al. (2004: Cretaceous Research 25, 89–113), in which they tried to prove a mid-Cretaceous age for the Szlachtowa (“black flysch”) and Opaleniec Formations, in the Pieniny Klippen Belt, West Carpathians, both of which had previously been shown to be of Jurassic age. We argue that the mid-Cretaceous age assignment is a misinterpretation, primarily resulting from their field samples having been collected from some Cretaceous lithostratigraphic units, tectonically associated with the Jurassic formations, and/or from tectonic contact-breccias involving Jurassic and Cretaceous strata. In addition, we suggest that they have overlooked a number of significant palaeontological papers, published since 1962, which record the presence of in situ ammonites, aptychi, belemnites, thin-shelled bivalves (Bositra), gryphaeids, foraminifera, and ostracod assemblages, all indicating a Jurassic (mainly Aalenian), and not a Cretaceous, age for the Szlachtowa Formation, and also the in situ Jurassic (Bajocian) ammonites and thin-shelled bivalves (Bositra), Bositra-microfacies, and age-diagnostic foraminiferal assemblages of the Opaleniec Formation.Our presentation here of recently published dinocyst data from well-preserved assemblages further supports the Jurassic ages for the Szlachtowa (“black flysch”) and Opaleniec Formations.     

碱消解-高效液相色谱-电感耦合等离子体质谱法测定生物样品中的甲基汞和乙基汞

建立了碱消解-高效液相色谱-电感耦合等离子体质谱联用系统测定生物样品中甲基汞(MeHg)与乙基汞(EtHg)的分析方法。为提高灵敏度,选用微流量的PFA雾化器,在优化的检测条件下,MeHg及EtHg检出限可达到0.036μg/L和0.03μg/L;线性范围达到4个数量级,两条工作曲线线性相关系数为1。对1.78μg/L MeHg、1.65μg/L EtHg的混合标准溶液重复测定7次,色谱峰面积的相对标准偏差(RSD)分别为1.79%和1.44%。对标准物质BCR 464(金枪鱼)的分析结果表明,测定值与标准值基本吻合,但略低于标准值;甲基汞和乙基汞的加标回收率分别为85.9%和84.5%。高效液相色谱与质谱联用技术的高灵敏度和低检出限能够满足生物样品中汞形态定量分析的要求。     

徐州土壤多环芳烃的环境地球化学迁移特征

选择江苏徐州黄棕壤进行不同深度层位多环芳烃含量的定量分析,研究并探讨了多环芳烃在土壤深度剖面中的地球化学迁移特征。研究结果显示,多环芳烃在徐州土壤剖面中主要集中在地表0~20 cm内。其中低环多环芳烃化合物的迁移能力较强,4~6环等高环化合物相对较难迁移,主要残留于地表生态系统环境中。     

激光拉曼光谱法分析多种显微组分荧光变化及其应用

利用激发488 nm激光的氩离子激光器作为RENISHAW inVia型激光拉曼光谱仪的光源,建立了多种显微组分荧光变化(FAMM)分析方法,并对镜质体反射率明显抑制的东营凹陷有效烃源岩进行了测定。结果表明,东营凹陷有效烃源岩的有机质类型越好,镜质体反射率抑制程度越高,有效烃源岩的真实成熟度应主要处于0.64%~1.30%,而不是实测镜质体反射率所反映的0.37%~1.10%。     

高、低煤阶煤层气藏地质特征及控气作用差异性研究

高、低煤阶煤层气地质特征及控气作用差异性是研究煤层气富集成藏的重要组成部分,是煤层气勘探开发理论研究过程中重要的基础性研究领域之一。本文以中国沁水、阜新盆地和美国粉河盆地等典型的含气盆地为例,探讨了高、低煤阶煤层气的储层物性差异,分析了构造控气和水文地质控气作用的差异性。研究表明,高煤阶气藏含气量高,CH4百分含量高,δ13C1值大于-38.75‰,储层渗透率变化小,储层改造难,构造热事件对煤层气的生成、富集贡献大,持续的水动力使气藏遭到破坏,且破坏幅度大,现今地下水格局对气藏的形成具有一定的影响;低煤阶气藏含气量低,CH4百分含量低,δ13C1值大于-49.11‰,储层渗透率变化大,储层易改造,煤热演化史及煤阶影响着煤层气的生成、富集,在煤层气生成过程中活跃的水动力是甲烷生成的主要的水文地质条件之一,但持续的水动力使气藏遭到破坏,且破坏幅度小,而合适的地层水矿化度则是低煤阶煤层气生成的重要条件,地下水格局对气藏的调整和改造起到决定性的影响。     

Delineation of groundwater protection zones by the backward particle tracking method: theoretical background and GIS-based stochastic analysis

The backward particle tracking method, an effective and powerful tool that can be used to delineate groundwater protection zones, is presented. The theoretical background and insights on the applicability of this method are provided. Moreover, the present work enriches the backward particle tracking method with an uncertainty analysis concerning the porosity values, applying a Monte Carlo (MC) approach, coupled with the use of geographical information systems (GIS). As an application example, a wellfield in the Komotini area, Greece, is investigated. The present study may serve as a potential guideline for wellfield delineation, particularly in areas like Greece where lack of data related to the hydrogeological system is often a problem.     

Use of sinkhole and specific capacity distributions to assess vertical gradients in a karst aquifer

The carbonate-rock aquifer in the Great Valley, West Virginia, USA, was evaluated using a database of 687 sinkholes and 350 specific capacity tests to assess structural, lithologic, and topographic influences on the groundwater flow system. The enhanced permeability of the aquifer is characterized in part by the many sinkholes, springs, and solutionally enlarged fractures throughout the valley. Yet, vertical components of subsurface flow in this highly heterogeneous aquifer are currently not well understood. To address this problem, this study examines the apparent relation between geologic features of the aquifer and two spatial indices of enhanced permeability attributed to aquifer karstification: (1) the distribution of sinkholes and (2) the occurrence of wells with relatively high specific capacity. Statistical results indicate that sinkholes (funnel and collapse) occur primarily along cleavage and bedding planes parallel to subparallel to strike where lateral or downward vertical gradients are highest. Conversely, high specific capacity values are common along prominent joints perpendicular or oblique to strike. The similarity of the latter distribution to that of springs suggests these fractures are areas of upward-convergent flow. These differences between sinkhole and high specific capacity distributions suggest vertical flow components are primarily controlled by the orientation of geologic structure and associated subsurface fracturing.