含煤层地质环境下地震波场的数值模拟

本文对含低速煤层地质环境下弹性波场多波多分量地震资料进行了二维数值模拟研究,对人工边界反射进行了有效处理,频散效应得到了有效的压制,对几种不同激发与观测排列方式下的弹性波资料进行了模型计算与分析。     

Measurements of peroxyacetylnitrate in the marine boundary layer over the Atlantic

The atmospheric concentration of peroxyacetylnitrate (PAN) was measured during a cruise of the R.S. Polarstern from Bremerhaven (Germany) to Rio Grande do Sul (Brazil) in September/ October 1988. The measurements were made in-situ by a combination of electron capture gaschromatography with a cryogenic preconcentration step. The theoretical lower limit of detection (3) was 0.4 ppt. The mixing ratios of PAN varied by more than three orders of magnitude from 2000 ppt in the English Channel to less than 0.4 ppt south of the Azores (38° N). South of 35° N, PAN levels were below the detection limit, except at 30–31° S off the eastern coast of South America. Here, PAN mixing ratios of 10 to 100 ppt were detected in continentally influenced air masses. Detectable levels of PAN were mostly observed in air masses of continental or high northern origin. Changes in the wind directions were usually associated with substantial changes in the PAN mixing ratios.     

短周期仪器记录在远震分析中的应用

地震泼由多种频率成份组成,在其传播过程中。由于地球介质的滤波作用,随着传播距离的增大。高频成份逐渐被衰减。周期越大的成份传播越远。因此,在地震观测上,不同频带的地震仪用于观测不同震中距范围的地震,使仪器较好地响应,就我国台网而言,短周期仪用于地方震、近震的监测,中长周期仪和长周期仪用于远震,极远震的监测,其中长周期仪偏重于记录极远震。但作者在实际分析工作中注意到,短周期仪的记录应用于远震,极远震的分析,显示出独特的作用,充分挖掘和利用短仪资料,将会更加丰富远震、极远震的震相资料。本文以高台地震台的资料为依据,从震中距和震级角度,与中长仪和长仪作比较,对短仪记录远震、极远震的震相及特征作了统计分析与初步探讨,并对新疆地区“影区”地震S波的记录、日本地区地震_PPcP等震相的出现提出了现象的存在,给出了相应的观测结果,以待步一步研究。     

南极长城站地区现代环境地球化学特征

本文通过环境背景值、风化壳地球化学、对流层(大气气溶胶)地球化学和人为地球化学异常,初步探讨了南极长城站地区的现代环境地球化学特征。分析表明:环境要素固有的地球化学性质、区域环境条件和自然环境演变之间具有深刻的内在联系。     

Transmission and reflection of Rayleigh waves at a thin low velocity vertical layer: A laboratory and theoretical study

A three-dimensional ultrasonic modelling was used to study the Rayleigh waves reflected from a thin low velocity vertical layer and those transmitted through the same zone. The reflection and transmission coefficients of the Rayleigh waves have been calculated by an approximate method based on the Green function technique. Nonrigid contact boundary conditions were used for the low velocity layer modelling. A rather good correspondence between the theoretical and experimental absolute values of the reflection and the transmission coefficients was obtained. Some discrepancies between experimental and theoretical results, in particular with regard to phase shifts, may be explained by a certain inadequacy of the theoretical model to the low velocity layer investigated by the ultrasonic modelling.     

云南大地热流及地热地质问题

本文报道了云南20多个大地热流测试数据。据热流分布特点并参考前人有关资料,结合地球物理测深资料、岩石热物性与放射性生热率测试数据,对各区地壳深度范围的温度、热流配分组成作了粗略分析,划分出各有特征的若干地质-热流区。云南普遍地热偏高(滇东南小范围除外)的主要原因是新构造运动强烈;怒江以西近代岩浆活动亦强烈,具有典型的板块交汇带的基本地热特点     

西安南郊丰水年秋季土壤水分研究

 通过对西安南郊丰水年秋季土壤含水量的测定，研究了地下0~6 m之间土壤含水量的变化与土壤干层的恢复问题。研究结果表明，丰水年西安南郊人工林下2~3 m的土壤含水量在20％左右，远远高于正常年份的土壤含水量，而且大于表层和深层的土壤含水量。分析得出，土壤干层发育较弱的地区在降水丰富的年份可以得到一定程度的恢复；西安地区基本适合进行人工造林；通过人工措施，增强降水入渗和土壤含水量，对树木成活和长期的生长应当具有明显的作用。     

Strength and stability of frictional sliding of gabbro gouge at elevated temperatures

To investigate the strength of frictional sliding and stability of mafic lower crust, we conducted experiments on oven-dried gabbro gouge of 1 mm thick sandwiched between country rock pieces (with gouge inclined 35° to the sample axis) at slip rates of 1.22 × 10^− 3 mm/s and 1.22 × 10^− 4 mm/s and elevated temperatures up to 615 °C. Special attention has been paid to whether transition from velocity weakening to velocity strengthening occurs due to the elevation of temperature.Two series of experiments were conducted with normal stresses of 200 MPa and 300 MPa, respectively. For both normal stresses, the friction strengths are comparable at least up to 510 °C, with no significant weakening effect of increasing temperature. Comparison of our results with Byerlee's rule on a strike slip fault with a specific temperature profile in the Zhangbei region of North China shows that the strength given by experiments are around that given by Byerlee's rule and a little greater in the high temperature range.At 200 MPa normal stress, the steady-state rate dependence a − b shows only positive values, probably still in the “run-in” process where velocity strengthening is a common feature. With a normal stress of 300 MPa, the values of steady-state rate dependence decreases systematically with increasing temperature, and stick-slip occurred at 615 °C. Considering the limited displacement, limited normal stress applied and the effect of normal stress for the temperatures above 420 °C, it is inferred here that velocity weakening may be the typical behaviour at higher normal stress for temperature above 420 °C and at least up to 615 °C, which covers most of the temperature range in the lower crust of geologically stable continental interior. For a dry mafic lower crust in cool continental interiors where frictional sliding prevails over plastic flow, unstable slip nucleation may occur to generate earthquakes.     

Seismic lamination and anisotropy of the Lower Continental Crust

Seismic lamination in the lower crust associated with marked anisotropy has been observed at various locations. Three of these locations were investigated by specially designed experiments in the near vertical and in the wide-angle range, that is the Urach and the Black Forrest area, both belonging to the Moldanubian, a collapsed Variscan terrane in southern Germany, and in the Donbas Basin, a rift inside the East European (Ukrainian) craton. In these three cases, a firm relationship between lower crust seismic lamination and anisotropy is found. There are more cases of lower-crustal lamination and anisotropy, e.g. from the Basin and Range province (western US) and from central Tibet, not revealed by seismic wide-angle measurements, but by teleseismic receiver function studies with a P–S conversion at the Moho. Other cases of lamination and anisotropy are from exhumed lower crustal rocks in Calabria (southern Italy), and Val Sesia and Val Strona (Ivrea area, Northern Italy). We demonstrate that rocks in the lower continental crust, apart from differing in composition, differ from the upper mantle both in terms of seismic lamination (observed in the near-vertical range) and in the type of anisotropy. Compared to upper mantle rocks exhibiting mainly orthorhombic symmetry, the symmetry of the rocks constituting the lower crust is either axial or orthorhombic and basically a result of preferred crystallographic orientation of major minerals (biotite, muscovite, hornblende). We argue that the generation of seismic lamination and anisotropy in the lower crust is a consequence of the same tectonic process, that is, ductile deformation in a warm and low-viscosity lower crust. This process takes place preferably in areas of extension. Heterogeneous rock units are formed that are generally felsic in composition, but that contain intercalations of mafic intrusions. The latter have acted as heat sources and provide the necessary seismic impedance contrasts. The observed seismic anisotropy is attributed to lattice preferred orientation (LPO) of major minerals, in particular of mica and hornblende, but also of olivine. A transversely isotropic symmetry system, such as expected for sub-horizontal layering, is found in only half of the field studies. Azimuthal anisotropy is encountered in the rest of the cases. This indicates differences in the horizontal components of tectonic strain, which finally give rise to differences in the evolution of the rock fabric.     

Variscan to eo-Alpine events recorded in European lower-crust zircons sampled from the French Massif Central and Corsica, France

Ion-microprobe U–Pb zircon dating of lower-crust metasedimentary granulite are reported on samples from two localities in Europe in order to determine (a) how this environment recorded the Variscan and eo-Alpine events, and (b) whether the transition between the two orogenic cycles was continuous or separated by a gap. The samples come from enclaves hosted by Miocene volcanoes at Bournac in the French Massif Central, and from the granulitic metasedimentary basement of the Alpine Santa Lucia nappe in Corsica, on the South European paleomargin of the Ligurian branch of the Tethys Sea. The zircon ages from Bournac range between 630 and 430 Ma and between 380 and 150 Ma with a major frequency peak at 285 Ma; the zircons older than 430 Ma are interpreted as detrital, whereas those younger than 380 Ma are considered to have formed by metamorphic processes after burial in the lower crust. Zircon ages from Santa Lucia range from to 356 to 157 Ma, with exception of one inherited Archean grain, and are interpreted like the younger Bournac zircons as having been formed by metamorphic processes.

In a granulite metamorphic environment, as opposed to an anatectic environment, new zircon growth can occur in the solid state. Once Zr has been incorporated into zircon, however, it is difficult to remobilize without dissolution; thus Zr available for new zircon growth must result from the breakdown of Zr-bearing minerals during prograde and/or retrograde events. In this light, the U–Pb zircon-age probability curves are interpreted as markers for major tectonometamorphic events, as suggested by the close correspondence between peaks in the curve and geological events recorded in the upper-crust, such as magma emplacement and basin subsidence.

Evidence of a tectonometamorphic gap between the Variscan and Alpine orogeneses is provided by the Santa Lucia zircon-age probability curve, which reveals a probable interlude during the Variscan–Alpine transition between 240 and 210 Ma. Here, the peak at 240 Ma is interpreted as the very beginning of crustal extension and the low at 210 Ma as a period of quiescence prior to the formation of an active margin and oceanization.