心墙堆石坝应力状态对渗流场影响的有限元分析

一般对土石坝进行渗流分析时都未考虑坝体的应力场对渗流场的影响。然而,在土石坝的蓄水过程中,坝体内的应力状态复杂且变化大,对渗流场的影响也较大。因此,忽略应力场对渗流场的影响必然造成一定的误差。用有限元方法对心墙堆石坝体蓄水过程中考虑和不考虑应力场影响的渗流场进行对比分析,计算结果表明,渗流-应力耦合作用下坝体局部压密变形,渗透流速减小,心墙下游出逸区域的水力坡降峰值明显高于非耦合值。因此,渗流分析时有必要考虑应力场的影响,否则会得出偏于危险且对工程不利的结果     

Torsionally coupled dynamic performance analysis of asymmetric offshore platforms subjected to wave and earthquake loadings

The dynamic equations of motion of asymmetric offshore platforms under three different environmental conditions:seismic action,wave action and their combination are established in this paper. In establishing these motion equations,three typical eccentricity types including mass eccentricity,rigidity eccentricity and their combination were considered,as are eccentricities that occur un-idirectionally and bi-directionally. The effects of the eccentricity type,the dynamic characteristics and the environmental conditions on the torsional coupling response of platforms are investigated and compared. An effort has also been made to analyze the inffluence of accidental eccentricity on asymmetric platforms with different eccentricity in two horizontally orthogonal directions. The results are given in terms of non-dimensional parameters,accounting for the uncoupled torsional to lateral frequency ratio. Numerical results reveal that the eccentricity type has a great inffluence on the torsionally coupled response under different environmental conditions. Therefore,it is necessary to consider the combination of earthquake and wave action in the seismic response analysis of some offshore platforms.     

非稳定渗流条件下非饱和土质边坡稳定性的矢量和分析法研究

研究可以同时考虑渗流、变形与稳定的非饱和土质边坡稳定性分析方法具有重要的理论意义及工程实用价值。基于Fredlund双应力变量理论进行非饱和非稳定渗流-应力耦合分析,同时与传统非耦合渗流方法确定的孔压场进行对比发现,两种方法确定的浸润线变化过程相近,堤底处孔压的最大相对误差为8.8%,验证了耦合分析结果的可靠性。将基质吸力对强度的贡献纳入黏聚力中得到坡体强度参数的空间分布规律,又基于滑面强度参数时空分布规律借助Matlab平台开发了非稳定渗流条件下非饱和土质边坡稳定性的矢量和法分析程序。以库水位下降条件下堤坡的稳定性分析为例,将不同方法的计算结果进行对比,发现文中方法搜索得到的滑面位置相对于传统方法要深缓,但总体位置相差不大,不同方法对应的安全系数相差不足0.096,验证了所提方法的合理性。     

真三轴气固耦合煤体渗流试验系统的研制及应用

为了更真实地模拟煤岩在掘进巷道迎头等环境下的应力状态,研究三向应力环境下煤岩的损伤变形及瓦斯渗流情况,自主研发了真三轴气-固耦合煤体渗流试验系统。该装置主要由真三轴压力室、液压伺服系统、气体渗流系统和监测与控制系统组成,采用的试件尺寸为200 mm×100 mm×100 mm,可施加的最大轴压(?1)为70 MPa、最大侧压（?2）为35 MPa、最大侧压（?3）为10 MPa、最大瓦斯压力为6 MPa。该装置具有以下特点：(1) ?1、?2采用刚性压头加载,?3采用柔性加载,三向应力分别独立加载;(2) 设计了刚柔性压头及传压滑杆,使得?1与?2方向压头在同时加载过程中互不干扰;(3) 通过伺服液压系统控制加载功能,使得装置性能稳定,应力与位移加载精确,易于控制;(4) 气体渗流系统采用蜂窝孔对试件进行面通气,确保试件进气端瓦斯压力均匀分布;(5) 采用多种高精度传感器进行监测,实时记录煤体所受应力值、变形量及瓦斯渗流量。用两种不同应力路径下的渗流试验对该系统准确性和可靠性进行了验证,结果表明,该装置性能稳定可靠。该装置可用于揭示煤与瓦斯在三向应力条件下的耦合作用机制,为防治瓦斯灾害及研究瓦斯抽采提供了可靠的试验基础。     

宽频带静电反馈倾斜仪正交耦合误差分析

分析和计算宽频带静电反馈倾斜仪测量中正交方向上的倾斜对测量结果的影响。结果表明,正交方向的倾斜使测量结果产生误差,需对仪器加以改进,以减小正交耦合误差。     

500 kV输电线路黄河大跨越塔基工程施工实践

500 kV输电线路黄河大跨越塔基工程分地下和地上两大部分,集多种施工工艺方法于一体。重点阐述了钻孔桩施工,支撑系统的选择,高桩承台模板的支护,地脚螺栓的安放和大体积承台砼的浇注等施工关键工序、技术难点和重点的具体控制方法。     

考虑渗流场作用下的隧道开挖分析

由于隧道的开挖,破坏了初始地应力场与渗流场。以圆形隧道为例,采用有限差分程序计算考虑渗流场作用时,隧道开挖后洞室周围应力场、孔隙水压力、位移场的分布情况,并对比计算了是否考虑渗流效应时位移场的差异,以及不同水位导致的位移场的不同分布状态。提出了相应的隧道防排水、设计与施工相关建议。     

关于JCX 3型井磁仪器及其资料整理

经参加全国危机矿山示范项目的实际工作,认为目前重庆地质仪器厂生产的新型JCX 3井中三分量磁测仪探头倾斜面向北时X读数正值最大,倾斜面向南时X读数负值最大,X分量指向井斜方向。两者在直角坐标系中虽然同样符合左手法则,但新老仪器的井下磁测传感器x、y坐标相差90°。因而,对于当前广泛在用的数十台JCX 3型仪器的测量结果,如果仍然套用建立在垂向系统基础上的矢量计算公式,就会导致应用和解释错误,因此有必要共同探讨。     

Predicting the displacement of triple pendulum™ bearings in a full‐scale shaking experiment using a three‐dimensional element

The accuracy of a series spring model to predict the peak displacement and displacement history of Triple Pendulum? (TP) bearings in a strongly shaken, full‐scale building is evaluated in this paper. The series spring model was implemented as a self‐contained three‐dimensional TP bearing element in OpenSees and is now available for general use. The TP bearing element contains the option for constant friction or a generalized friction model that accounts for the effect of instantaneous velocity and compression load on the friction coefficient. Comparison between numerical simulation and experimental data of a five‐story steel moment frame building shows that the peak displacement of isolation system can generally be predicted with confidence using a constant friction coefficient model. The friction coefficient model accounting for the effect of axial load and velocity leads to minor improvement over the constant friction coefficient models in some cases. Copyright © 2013 John Wiley & Sons, Ltd.     

On topographic core-mantle coupling

Abstract

The purpose of this note is two-fold: to draw attention to a perplexing difficulty connected with topographic core-mantle coupling, and to suggest tentatively an explanation. The difficulty is an apparent conflict between the most comprehensive theory of the coupling so far attempted (Anufriev and Braginsky, 1975a, b, 1977a, b) and recent explicit calculations based on magnetic and seismic information (Speith et al., 1986). It is argued that asymmetric deviations from Anufriev and Braginsky's basically axisymmetric model of the underlying core flow are capable of resolving the difficulty.