软弱夹层粘粒含量与抗剪强度参数的关系分析

分析表明,赋存环境相同、粘土矿物成分以伊利石为主的软弱夹层,在相同稠度状态下粘粒含量与抗剪强度参数具有很好的相关性。通过现场和大量的室内试验成果,建立了各种稠度状态下粘粒含量和抗剪强度参数之间的相关关系式,揭示了在研究粘粒含量对抗剪强度参数影响时,还应当考虑软弱夹层所处的天然状态。结合《温凝土重力坝设计规范》中提出的用粒度成分定量指标选取软弱结构面抗剪强度参数,对软弱夹层抗剪强度参数取值问题进行了探讨。     

河南省固始县柳林-长湾化探Pb、Zn异常评价方法及效果

对河南固始县1989年1/20万区域化探扫面资料进行二次开发,将异常区中的Pb、Zn(A g)地球化学异常重新筛选,评序后提出以排序第二的13-乙1号Pb、Zn(A g)异常为重点评价对象。评价结果显示,在南、北、中三个异常带中,均找到了新矿体,取得了一定的地质找矿效果。     

节理裂隙边坡锚注加固机制及特性研究

本文通过对节理裂隙边坡锚注加固模型的力学推导，得出锚注加固工法可以提高岩石边坡弱面抗剪强度和抗剪刚度的结论；指出锚注结构可以充分发挥锚杆和注浆体各自的材料潜能，从而避免锚杆单独作用所存在的弊端；结合某高速公路边坡加固工程，阐述了锚注加固工法的技术特点及工艺流程，指明压力注浆可以针对边坡岩体的薄弱环节，直接进行有效的处理，使边坡的稳定性得以提高，并就边坡锚注加固施工中存在的技术问题，提出相应的处理措施。     

不同生态系统CO2通量和浓度特征分析研究

本文利用1993～1994年日本国家农业环境研究所与中国科学院沙漠研究所合作在内蒙古奈曼地区实测的7种不同生态系统（沙丘、轻度放牧草原、中度放牧草原、重度放牧草原、无放牧草原、玉米田和大豆田）的净辐射、土壤热通量、两个高度的CO2浓度、温度、湿度和风速等资料，采用空气动力学方法，计算了CO2通量及其与环境和人为干扰因子的关系，并分析了不同下垫面的光合作用特征. 结果表明：各种下垫面CO2通量的共同特点是：在白天，CO2通量和梯度的输送方向是从大气向植被，在中午（11～13时）输送达到负的最大值； 在夜间，CO2通量和梯度输送方向与白天相反，是从植被向大气，在早晨（3～5时）达到正的最大值. 植被覆盖率及生物量不同的下垫面光合作用强度有明显差异，天气状况对光合作用也有一定影响.     

水压致裂地应力测试方法在云南大理-丽江铁路隧道工程中的应用

利用水压致裂地应力测试方法对实际工程区进行了地应力测量,确定了工程区隧道围岩现今的地壳应力状态,即原地应力的大小和方向.根据地应力分布特征,分析了隧道开挖过程中发生岩爆等地质灾害的可能性.地应力测量数据的分析结果可作为隧道衬砌的设计、断面的选择及轴线方位的确定的科学依据.     

掺入矿渣的水泥土强度模型试验研究及其配方优化

选取深港西部通道深圳侧接线工程范围内有代表性的淤泥土样,采用均匀设计U20(52×4)安排室内试验,建立了掺入矿渣水泥土的抗压强度回归模型;分析了混合固化剂掺入比、矿渣占固化剂的质量比和龄期及其交互作用对抗压强度的影响;模型预测值和室内平行试验的对比分析表明:该模型具有一定的可信度。模型表明矿渣占混合固化剂的质量比在一定区间内(40%~70%)对水泥土强度的增强效果显著,这与工程实践相吻合;为确定优化配比,建立了求解用多目标优化函数。考虑到现场条件与室内试验的差别,建立了12组相同配比的室内试块及现场搅拌桩对比试验,结果表明:现场搅拌桩的水泥土无侧限强度远低于室内水泥土试块强度,矿渣的增强作用与室内试验各龄期基本一致。     

A numerical study on 2-D compressive wave propagation in rock masses with a set of joints along the radial direction normal to the joints

An explosion in a borehole or an accidental explosion in a tunnel will generate a two-dimensional (2-D) compressive wave that travels through the surrounding rock mass. For the problem of 2-D compressive wave propagation in a rock mass with parallel joints in the radial direction normal to the joints, parametric studies on the transmission ratio and the maximum rebound ratio are performed in universal distinct element code. The variation of the transmission ratio with the ratio of joint spacing to wavelength is generalized into a characteristic curve, which can be used as a prediction model for estimating the transmission ratio. The relationship between the maximum rebound ratio and the influence factors is obtained in charts. The charts can be used as a prediction model for estimating the maximum rebound ratio. The proposed prediction models for estimating the transmission ratio and the maximum rebound ratio are applied to a field explosion test, Mandai test in Singapore. The minimum possible values of peak particle velocity (PPV) at the monitoring points are estimated by using the proposed prediction model for estimating the transmission ratio along the radial direction normal to the joints. On the other hand, the maximum possible values of PPV are estimated by using the proposed prediction model for estimating the maximum rebound ratio along the same radial direction. The comparison shows a good agreement between the field-recorded PPVs and the estimated range of PPVs given by the minimum possible PPVs and the maximum possible PPVs at the monitoring points in Mandai test. The good agreement between the estimated and field-recorded values validates the proposed prediction models for estimating peak particle velocity in a rock mass with a set of joints due to application of a compressive wave at the boundary of a tunnel or a borehole.     

Residual strength of slip zones of large landslides in the Three Gorges area, China

Slip zones of the large landslides in the Three Gorges area are commonly composed of fine-grained soils with substantial amount of coarse-grained particles, particularly gravel-sized particles. In this study, residual strength of the soils from slip zones of these landslides were examined in relation to their index properties based on a survey of 170 landslides. It was found that laboratory-determined residual friction angle using gravel-free fraction of the disturbed soils from the slip zones was closely related to clay content, liquid limit and plasticity index. On the other hand, in-situ residual friction angle of these soils (i.e. including gravel fraction) showed very weak correlations with clay content and Atterberg limits, but was largely dependent on gravel and fines (clays + silts) contents, increasing with gravels and decreasing with fines, and displayed strong linear correlation with the ratio of gravel to fines contents. These observations indicate that among the index properties, clay content and Atterberg limits can be used to estimate residual strength of the soils finer than 2 mm, but they are not appropriate evaluate the residual strength of the soils containing considerable amount of gravel-sized particles. For the latter, particle size distribution (particularly the ratio of gravel to fines contents) appears to be a useful index. Additionally, it was found that there was no identifiable correlation between relative abundance of individual major clay minerals and residual friction angles of both gravel-free fraction of disturbed and in-situ soils, suggesting that influence of clay minerals on residual strength of these soils can not be simply evaluated based on their abundance.     

型钢高强混凝土柱轴压比限值的试验研究

通过20个型钢高强混凝土柱的低周反复加载试验对其受力性能进行了研究，分析了剪跨比、轴压比、配箍率以及混凝土强度对型钢高强混凝土柱延性的影响，提出了不同剪跨比、不同配箍率的型钢高强混凝土柱的轴压比限值。其中，剪跨比大于2．0的型钢高强混凝土柱的轴压比限值由大、小偏心界限破坏时力的平衡条件并结合试验结果确定，而剪跨比小于2．0的型钢高强混凝土柱的轴压比限值则通过与剪跨比大于2．0的型钢高强混凝土柱的延性对比加以确定。     

土石混合料剪切面分形特征试验研究

土石混合料因具有良好的工程特性而被广泛应用于道路、堤坝等工程，填筑体受力后往往沿薄弱面发生剪切破￡混合料的抗剪强度成为稳定和变形分析的重要力学指标。由于土石混合料物质组成的复杂性、结构分布的不规律性及采柠困难性，且受检测仪器的限制，确定其强度指标较为困难。应用改进的直剪试验仪进行了不同类别、不同最大粒径土石福料的室内大型直剪试验，在获得强度指标同时，再现剪切面的实际情况，量测剪切面的起伏特征。根据分形几何学原理，切面具有良好的分形特征，应用三角形棱柱表面积覆盖法编程计算了剪切面的分形维数。初步建立了剪切面分形维数与福料杭萌强度之间的关系，用来快速预测土石混合料的强度指标。